Use of biosurfactants from urban wastes compost in textile dyeing and soil remediation

A compost isolated humic acid-like (cHAL) material was pointed out in previous work for its potential as auxiliary in chemical technology. Its potential is based on its relatively low 0.4gL(-1) critical micellar concentration (cmc) in water, which enables cHAL to enhance the water solubility of hydrophobic substances, like phenanthrene, when used at higher concentrations than 0.4gL(-1). This material could be obtained from a 1:1 v/v mixture of municipal solid and lignocellulosic wastes composted for 15 days. The compost, containing 69.3% volatile solids, 39.6% total organic C and 21C/N ratio, was extracted for 24h at 65 degrees C under N2 with aqueous 0.1molL(-1) NaOH and 0.1molL(-1) Na4P2O7, and the solution was acidified to separate the precipitated cHAL in 12% yield from soluble carbohydrates and other humic and non-humic substances. In this work two typical applications of surfactants, i.e., textile dyeing (TD) and soil remediation by washing (SW), were chosen as grounds for testing the performance of the cHAL biosurfactant against the one of sodium dodecylsulfate (SDS), which is a well established commercial synthetic surfactant. The TD trials were carried out with nylon 6 microfiber and a water insoluble dye, while the SW tests were performed with two soils contaminated by polycyclic aromatic hydrocarbons (PAH) for several decades. Performances were rated in the TD experiments based on the fabric colour intensity (DeltaE) and uniformity (sigmaDeltaE), and in the SW experiments based on the total hydrocarbons concentration (CWPAH) and on the residual surfactant (Cre) concentrations in the washing solution equilibrated with the contaminated soils. The results show that both cHAL and SDS exhibit enhanced performance when applied above their cmc values. However, while in the TD case a significant performance effect was observed at the surfactants cmc value, in the SW case the required surfactants concentration values were equivalent to 25-125xcmc for cHAL and to 4-22xcmc for SDS. The vis-a-vis comparison of the two surfactants gave the following results: in the TD case the cHAL biosurfactant at 0.4gL(-1) yields good colour intensity and equal colour uniformity as SDS at 5gL(-1), in the SW case cHAL was found to enhance CWPAH by a factor of 2-4 relative to SDS with one soil, whereas with the other soil the two surfactants behaved similarly. The Cre data, however, showed that both soils absorbed by far more SDS (68-95%) than cHAL (12-54%). The results point out intriguing technological and environmental perspectives deriving from the use of compost isolated biosurfactants in the place of synthetic surfactants.     

Toxicological effects of marine palytoxin evaluated by FETAX assay

The FETAX (frog embryo teratogenesis assay Xenopus) is considered a useful bioassay to detect health hazard substances. In the study of the marine toxin palytoxin (PTX), FETAX has revealed evident impacts on embryo mortality, teratogenesis and growth at the two highest (370 and 37nM) concentrations used. Significant mortality rates, peaks in the number of malformed embryos and delays in growth were found, while the total sample number fell by about 80% at the end of the assay with the concentrated dose. The histological analysis to evaluate the morpho-functional induced modifications demonstrated damage to the nervous and muscle tissue, a general reduction in the size of the main inner visceral organs and severe injury to the heart structure in some specimens. No inflammatory response was observed.     

An inter-laboratory study to test the ability of amendments to reduce the availability of Cd, Pb, and Zn in situ

An international inter-laboratory research program investigated the effectiveness of in situ remediation of soils contaminated by cadmium, lead and zinc, measuring changes in soil and soil solution chemistry, plants and soil microbiota. A common soil, from mine wastes in Jasper County MO, was used. The soil was pH 5.9, had low organic matter (1.2 g kg(-1) C) and total Cd, Pb, and Zn concentrations of 92, 5022, and 18 532 mg kg(-1), respectively. Amendments included lime, phosphorus (P), red mud (RM), cyclonic ashes (CA), biosolids (BIO), and water treatment residuals (WTR). Both soil solution and NH4NO3 extractable metals were decreased by all treatments. Phytotoxicity of metals was reduced, with plants grown in P treatments having the highest yields and lowest metal concentration (0.5, 7.2 and 406 mg kg(-1) Cd, Pb, and Zn). Response of soil micro-organisms was similar to plant responses. Phosphorus addition reduced the physiologically based extraction test Pb from 84% of total Pb extracted in the untreated soil to 34.1%.     

Sustainable development in the BRICS countries: an efficiency analysis by data envelopment

There is much concern about the social and environmental impacts caused by the economic growth of nations. Thus, to evaluate the socio-economic performance of nations, economists have increasingly addressed matters related to social welfare and the environment. It is within the scope of this context that this work discusses the performance of countries in the BRICS group regarding sustainable development. The objective of this study regards evaluating the efficiency of these countries in transforming productive resources and technological innovation into sustainable development. The proposed objective was achieved by using econometric tools as well as the data envelopment analysis method to then create economic, environmental, and social efficiency rankings for the BRICS countries, which enabled to carry out comparative analyses on the sustainable development of those countries. The results of such assessments can be of interest for more specific scientific explorations.     

Coastal erosion and shore protection: A brief historical analysis

Since the Neolithic, humans have gathered along coastal plains, where they had to face sea level rise and subsidence without the technology to oppose these processes. When sea level stabilized, approx. 6.000 yr. B.P., coastal colonization was allowed, but where mountain deforestation was carried out river sediment input increased tremendously: settlements were disconnected from the shore and harbour siltation occurred. Shore erosion was a limited process at the time and local solutions were adopted: clay dikes, wood piles, fascinates and rock revetments. Along the Mediterranean, in China and Japan the construction of more complex structures has been documented since the Middle Ages. Further human development, with river bed quarrying, wetland reclamation, dam construction and mountain re-afforestation, favoured a coastal erosion that nowadays threatens most world coasts. From the Venetian “Murazzi” to the recent 114-km-long concrete element defence at the Yellow river delta, shore protection structures evolved following the different needs (protect coastal communication routes, urban and industrial settlements, tourist resorts). Beach nourishment, previously performed with inland quarried materials, is now intensively carried out with marine aggregates. The vernacular solution, left to undeveloped countries, has been recently revaluated by “green engineering”. However, with Sea Level Rise, the debate of whether to defend, accommodate or retreat is open.     

Advanced in situ spectroscopic techniques and their applications in environmental biogeochemistry: introduction to the special section

Understanding the molecular-scale complexities and interplay of chemical and biological processes of contaminants at solid, liquid, and gas interfaces is a fundamental and crucial element to enhance our understanding of anthropogenic environmental impacts. The ability to describe the complexity of environmental biogeochemical reaction mechanisms relies on our analytical ability through the application and developmemnt of advanced spectroscopic techniques. Accompanying this introductory article are nine papers that either review advanced in situ spectroscopic methods or present original research utilizing these techniques. This collection of articles summarizes the challenges facing environmental biogeochemistry, highlights the recent advances and scientific gaps, and provides an outlook into future research that may benefit from the use of in situ spectroscopic approaches. The use of synchrotron-based techniques and other methods are discussed in detail, as is the importance to integrate multiple analytical approaches to confirm results of complementary procedures or to fill data gaps. We also argue that future direction in research will be driven, in addition to recent analytical developments, by emerging factors such as the need for risk assessment of new materials (i.e., nanotechnologies) and the realization that biogeochemical processes need to be investigated in situ under environmentally relevant conditions.     

Environmental sustainability and the integration of different methods for its assessment

The aim of this paper is to propose a research framework, based on the joint use of three widely used methods: EMergy Evaluation (EME), Ecological Footprint Analysis (EFA) and Greenhouse Gas Inventory (GHGI), that are applied to assess the environmental sustainability of a region. The results of application of these methods to several Italian Provinces enabled us to compare their sustainability, and to test the methods with respect to sustainability requirements at local and global level. The outcomes suggest that the proposed framework provides an organic evaluation of regional systems based on key aspects, such as resources depletion, consumption patterns, waste production and absorption.