Environmental monitoring of historical change in arsenic deposition with tree bark pockets

ICP-MS analysis recorded historical change (c. 1846 to 2002) in the arsenic concentration of bark included within the trunks (tree bark pockets) of two Japanese oak trees (Quercus crispula), collected at an elevated location approximately 10 km from the Ashio copper mine and smelter, Japan. The arsenic concentration of the bark pockets was 0.016 +/- 0.003 microg cm(-2) c. 1846 (n = 5) and rose 50-fold from c. 1875 to c. 1925, from approximately 0.01 to 0.5 microg cm(-2). The rise coincided with increased copper production in Ashio from local sulfide ores, from 46 tons per year in 1877 to 16,500 tons per year in 1929. Following a decline in arsenic concentration and copper production, in particular during the Second World War, a second peak was observed c. 1970, corresponding to high levels of production from both local (6,000 tons per year) and imported (30,000 tons per year) ores, smelted from 1954. Compared to the local ores, the contribution of arsenic from imported ores appeared relatively low. Arsenic concentrations declined from c. 1970 to the present following the closure of the mine in 1974 and smelter in 1989, recording 0.058 +/- 0.040 microg cm(-2) arsenic (n = 5) in surface bark collected in 2002. The coincident trends in arsenic concentration and copper production indicated that the bark pockets provided an effective record of historical change in atmospheric arsenic deposition.     

Production of hydrogen by steam gasification of dehydrochlorinated poly(vinyl chloride) or activated carbon in the presence of various alkali compounds

Steam gasification of dehydrochlorinated poly(vinyl chloride) (PVC) or activated carbon was carried out in the presence of various alkali compounds at 3.0 MPa and 560°C–660°C in a batch reactor or in a semi-batch reactor with a flow of nitrogen and steam. Hydrogen and sodium carbonate were the main products, and methane and carbon dioxide were the minor products. Yields of hydrogen were high in the presence of sodium hydroxide and potassium hydroxide. The acceleration effect of the alkali compounds on the gasification reaction was as follows: KOH > NaOH > Ca(OH)₂ > Na₂CO₃. The rate of gasification increased with increasing partial steam pressure and NaOH/C molar ratio. However, the rate became saturated at a molar ratio of NaOH/C greater than 2.0.     

Survey on readability of online information for upgrading understandability of biomass energy technology

Waste management contributes to renewable energy such as biodiesel production from processes of various types of biomass including vegetable oils, animal fats, and waste of edible oil. Successful waste management effort is influenced by people concern about benefit of waste management including for renewable energy from biomass. It involves their understanding initiated by literacy on biomass energy. To help increase literacy on waste recycle and biomass energy technology, we study readability of online information regarding biomass energy in Indonesian language (Bahasa Indonesia). Indonesia is considered as one of biomass-rich country with a little utilization for energy. The readability is studied by combining two approaches: measurement by readability standard and survey on readability confirming measurement by the standard. This study focuses on the confirmation survey readability standard measured on biomass online information in Indonesian language. In the survey, 19 online text materials were read by respondents and they were asked to give their impression whether the texts are easy or difficult to understand. From this study, what factors influence understandability of text information are shown. The results could be a guidance for preparing text information to raise people concern on waste recycle and renewable energy in general.     

Analysis of running child pedestrians impacted by a vehicle using rigid-body models and optimization techniques

Lack of information from vehicle-to-child pedestrian impacts provides considerable challenges when developing vehicle countermeasures for the pediatric population. Crash reconstructions of real-world incidents provide useful information about the vehicle damage and injury outcome but do not permit definitive and quantitative measures of the impact severity given the high level of uncertainty in the initial conditions of the pedestrian and the vehicle prior the impact. This paper develops an advanced methodology for reconstructing child pedestrian–vehicle impacts that combines the crash data with multi-body simulations and optimization techniques for identifying the pedestrian posture and vehicle speed prior to impact. For the child pedestrian posture, a continuous sequence of the running gait was developed based on the literature data and simulations. Using vehicle damage information from an actual child pedestrian crash, an objective function was developed that minimized the difference between vehicle and pedestrian contact points for the simulated child postures, pedestrian, and vehicle speeds. Simulated annealing and genetic optimization algorithms were used to identify sets of potential solutions for the pedestrian and vehicle initial conditions. Local minimums were observed for several response surfaces of the objective function which shows the non-convex nature of the crash reconstruction optimization problem with the chosen objective function. Based on the results of the real-world reconstruction, this study indicates that numerical simulations coupled with heuristic optimization algorithms can be used to reconstruct child pedestrian and vehicle pre-impact conditions.     

Impact of gamma irradiation on the transformation efficiency for extracellular plasmid DNA

Extracellular DNA is omnipresent in aquatic environments and is thought to be a genetic material for horizontal gene transformation between microorganisms. We studied the impact of gamma irradiation on the transformation efficiency (transformants number per ng of DNA per ml) of extracellular DNA. Plasmid pEGFP as a model extracellular DNA was irradiated by gamma rays. The transformation efficiency decreased with the increase in radiation dose. A total dose of 10Gy is normally not lethal for microorganisms but certainly affects the transformation efficiency of extracellular DNA. The decrease in the efficiency would be induced by strand breaks of extracellular DNA because the yield of both single-strand breaks (SSBs) and double-strand breaks (DSBs) increased with the increase in radiation dose. The relative transformation efficiency of SSBs and DSBs to that of covalently closed circles (CCCs) was 30.3% and 0.2%, respectively. This impact on natural transformation suggests an inability of microorganisms to acquire new characteristics which should be normally acquired.     

Comparison of marginal abatement cost curves for 2020 and 2030: longer perspectives for effective global GHG emission reductions

This study focuses on analyses of greenhouse gas (GHG) emission reductions, from the perspective of interrelationships among time points and countries, in order to seek effective reductions. We assessed GHG emission reduction potentials and costs in 2020 and 2030 by country and sector, using a GHG emission reduction-assessment model of high resolution regarding region and technology, and of high consistency with intertemporal, interregional, and intersectoral relationships. Global GHG emission reduction potentials relative to baseline emissions in 2020 are 8.4, 14.7, and 18.9 GtCO₂eq. at costs below 20, 50, and 100 $/tCO₂eq., corresponding to +19, −2, and −7 %, respectively, relative to 2005. The emission reduction potential for 2030 is greater than that for 2020, mainly because many energy supply and energy-intensive technologies have long lifetimes and more of the current key facilities will be extant in 2020 than in 2030. The emission reduction potentials in 2030 are 12.6, 22.0, and 26.6 GtCO₂eq. at costs below 20, 50, and 100 $/tCO₂eq., corresponding to +19, −2, and −7 %, respectively, relative to 2005. The emission reduction potential for 2030 is greater than that for 2020, mainly because many energy supply and energy-intensive technologies have long lifetimes and more of the current key facilities will be extant in 2020 than in 2030. The emission reduction potentials in 2030 are 12.6, 22.0, and 26.6 GtCO₂eq. at costs below 20, 50, and 100 /tCO₂eq., corresponding to +33, +8, and −3 %, respectively, relative to 2005. Global emission reduction potentials at a cost below 50 $/tCO₂eq. for nuclear power and carbon capture and storage are 2.3 and 2.2 GtCO₂eq., respectively, relative to baseline emissions in 2030. Longer-term perspectives on GHG emission reductions toward 2030 will yield more cost-effective reduction scenarios for 2020 as well.     

Carbon emission reduction and cost–benefit of methane digester systems on hog farms in China

Three different sizes of hog farms were selected to analyze the carbon emissions reduction and the cost–benefit of three methane digester systems. The sizes of the digesters are 2,200, 2,200 and 800 m³, respectively. The sales of slaughter hogs from them are 50,000, 35,000 and 10,000 head, respectively. The carbon emissions reductions were 5,237, 4,017, and 1,334 tons, respectively. The results show that while the methane digester systems have a significant effect on carbon emissions reduction, it is difficult to operate the systems sustainably. If the carbon emissions reduction can be traded at high enough prices in the carbon offset markets, then the systems will be profitable and sustainable. Newly established China's domestic carbon offset market could provide this possibility, but more government support is needed. In addition, this study shows that scale economies make the digester adoption relatively more profitable for larger farms than smaller ones.     

PCBs,PBDEs and dioxin-related compounds in floor dust from an informal end-of-life vehicle recycling site in northern Vietnam: contamination levels and implications for human exposure

Floor dusts from Vietnamese end-of-life vehicle (ELV)-processing households were investigated to elucidate the contamination levels and exposure risk of polychlorinated biphenyls (PCBs), polybrominated diphenyl ethers (PBDEs) and dioxin-related compounds (DRCs). The concentrations were in order of PBDEs (260–11,000, median 280 ng/g overall) > PCBs (19–2200, median 140 ng/g) > dioxin-like PCBs (8.8–450, median 22 ng/g) ? polybrominated dibenzo-p-dioxin/dibenzofurans (PBDD/Fs, 2000–28,000, median 8500 pg/g) > polychlorinated dibenzo-p-dioxin/dibenzofurans (PCDD/Fs, 440–4100, median 1800 pg/g) > MoBPCDD/Fs (1.9–1200, median 250 pg/g). Concentrations of PCBs and DRCs were higher than those reported for Vietnamese urban houses, indicating ELV processing as a significant source of these contaminants. Higher concentrations of PCBs relative to PBDEs suggest the abundance of old electrical capacitors/transformers in ELVs. The PBDD/F and PCDD/F profiles were indicative of DecaBDE-containing materials and combustion sources, respectively. PBDFs, PCDFs and DL-PCBs were the most important dioxin-like toxic equivalent (TEQ) contributors. The estimated PCB and TEQ intake doses from dust ingestion approached or exceeded the reference doses for children living in some ELV-processing households, indicating potential health risk. More comprehensive risk assessment of the exposure to PCBs and DRCs is required for residents of informal ELV recycling sites.