Sperm-depleted males influence the reproductive behaviour of conspecifics

In many insect species, sperm-depleted males (SDMs, i.e. males that have exhausted their sperm after a given number of matings) remain sexually active and continue to mate females. Here, we investigated the behavioural modifications that occur in both sexes of the parasitoid Asobara tabida Nees (Hymenoptera: Braconidae), after matings by fertile males and sperm-depleted males. We show that (i) virgin females, mated females and females mated to a SDM exhibited different behaviours and that (ii) males responded differently to females depending on whether the females had previously mated with an SDM or not. Our findings demonstrate that SDM influenced the reproductive behaviour of both males and females, especially with regard to male responsiveness and female attractiveness. These findings are discussed in the context of adaptive behaviour and fitness maximization in both males and females.     

Determination of the origin of groundwater nitrate at an air weapons range using the dual isotope approach

Nitrate is one of the most common contaminants in shallow groundwater, and many sources may contribute to the nitrate load within an aquifer. Groundwater nitrate plumes have been detected at several ammunition production sites. However, the presence of multiple potential sources and the lack of existing isotopic data concerning explosive degradation-induced nitrate constitute a limitation when it comes to linking both types of contaminants. On military training ranges, high nitrate concentrations in groundwater were reported for the first time as part of the hydrogeological characterization of the Cold Lake Air Weapons Range (CLAWR), Alberta, Canada. Explosives degradation is thought to be the main source of nitrate contamination at CLAWR, as no other major source is present. Isotopic analyses of N and O in nitrate were performed on groundwater samples from the unconfined and confined aquifers; the dual isotopic analysis approach was used in order to increase the chances of identifying the source of nitrate. The isotopic ratios for the groundwater samples with low nitrate concentration suggested a natural origin with a strong contribution of anthropogenic atmospheric NOx. For the samples with nitrate concentration above the expected background level the isotopic ratios did not correspond to any source documented in the literature. Dissolved RDX samples were degraded in the laboratory and results showed that all reproduced degradation processes released nitrate with a strong fractionation. Laboratory isotopic values for RDX-derived NO(3)(-) produced a trend of high delta(18)O-low delta(15)N to low delta(18)O-high delta(15)N, and groundwater samples with nitrate concentrations above the expected background level appeared along this trend. Our results thus point toward a characteristic field of isotopic ratios for nitrate being derived from the degradation of RDX.     

Hemp-based adsorbents for sequestration of metals: a review

Environmental Chemistry Letters - With the increasing focus on renewable materials and sustainability issues, the development of non-conventional materials from natural resources and possessing...     

A laboratory exposure procedure for screening pulp and paper mill effluents for the potential of causing increased mixed function oxidase activity in fish

To better understand the relationships between pulp manufacturing processes and mixed function oxidase (MFO) enzyme induction in fish, a practical and standardized exposure procedure is required. This study was undertaken to develop a laboratory-based exposure procedure to quantify the relative MFO induction potencies of different types of pulp and paper mill effluents. One major consideration in developing the procedure was to ensure that the protocol was practical so that tests could be performed in a short time, with small volumes of effluents and using simple experimental conditions. A series of concentration-response and time-course experiments were conducted to find the minimum time and effluent concentration which could distinguish the ability of different effluents to cause significant MFO induction in rainbow trout in the laboratory. Experiments were also conducted to determine the effects of biotic and abiotic factors such as loading density, fish size and feeding regime. This study showed that the exposure of rainbow trout in the laboratory to 10% concentration of secondary-treated effluent for 96 h caused significant increases in hepatic MFO activity. The magnitude of MFO induction was comparable to other field and laboratory observations. While fish size, loading density and feeding regime were found to affect the test results, consistent responses within a laboratory using this protocol are possible, provided that these factors are standardized. Therefore, the short-term exposure approach described in this paper could be a relevant tool for assessing the ability of different types of pulp and paper mill effluents to cause MFO induction in fish.     

Evaluation of caged freshwater mussels as an alternative method for environmental effects monitoring (EEM) studies

On three occasions between 1998 and 2000, freshwater mussels were collected by divers in Lake Memphremagog during the spring and transplanted to various locations in the St-Fran?ois River (Quebec, Canada). Mussel growth was monitored by comparing total weight and length at the beginning and end of the exposure period. In 1998, mussels were caged for 60 days at 10 stations, including locations receiving treated effluents from three pulp and paper mills. Overall, there was an apparent trend of increased mussel growth from upstream to downstream along the river. However, mussels caged downstream from the effluent discharge of a bleached kraft pulp and paper mill grew more slowly than those caged immediately upstream in the river. In 1999 and 2000, we further investigated the situation in the vicinity of this bleached kraft mill. The measurements again indicated that growth of mussels in the effluent plume from this mill was reduced in comparison to sites upstream. Overall, in terms of growth, the caged mussels responded both positively and negatively to different environmental conditions. Compared with other monitoring approaches used at these sites during the same period, the caged mussel experiment results were consistent with the trends observed with the benthic invertebrate survey but not with the trends observed for fish.     

Displacement and sweep efficiencies in a DNAPL recovery test using micellar and polymer solutions injected in a five-spot pattern

Soil washing with micellar solutions is a promising alternative for the remediation of DNAPL source zones. As with any flushing technology, the success of soil washing with micellar solutions depends in a very large part on the ability of the solution to contact the contaminant (sweep efficiency) and then on the efficiency of contaminant removal once this contact is made (displacement efficiency). We report here on a field test where a micellar solution was used to recover a DNAPL in an open five-spot pattern in which polymer solutions were also injected before and after the washing solution to improve sweep efficiency. The washing solution formulation was optimised in the laboratory prior to the test to obtain good dissolution capacity. For a high-concentration and low-volume soil flushing remediation test such as the one performed (0.8 pore volumes of actual washing solution injected), slug sizing of the washing solution is critical. It was evaluated by an analytical solution. In a five-spot pattern, the displacement efficiency of the washing solution was observed to vary in the porous medium as a function of the radial distance from the injection well because: (1) the volume of the washing solution flowing through a section of the test cell changes (maximum close to the injection well and minimal at the pumping wells); (2) the in situ velocity changes (maximum at the wells and minimum between the wells) and; (3) the contact time of the washing solution with the NAPL changes as a function of the distance from the injection well. The relative importance of the recovery mechanisms, mobilisation and dissolution, was also observed to vary in the test cell. The reduced velocity increased the contact time of the washing solution with the DNAPL enhancing its dissolution, but the decrease of the capillary number caused less mobilisation. The washing process is much more extensive around the injection well. The use of an injection-pumping pattern allowing a complete sweep of the remediated area is essential. Following a comprehensive characterisation, modeling is an efficient tool to design the injection-pumping scheme and to optimise injection and pumping rates providing the best areal sweep. The vertical sweep can be controlled by using a polymer solution (Xanthan gum). The polymer solution also has a positive effect on front stability between the solutions injected. The injection rate of the polymer solution that follows the washing solution must be kept minimal initially to prevent dilution of the washing solution by fingering.     

Use of a low-cost biosorbent to remove pesticides from wastewater

A lignocellulosic substrate (LS) obtained from our local agroindustry was used as a low-cost and effective adsorbent for the removal of pesticides from wastewaters. The studied pesticides were terbumeton (N-(1,1-dimethyl)-Nethyl-6-methoxy-1,3,5-triazine-2,4-diamine), desethyl terbumeton (N-(1,1-dimethylethyl)-6-methoxy-1,3,5-triazine-2,4-diamine), dimetomorph (4-[3-(4-chlorophenyl)-3-(3,4-dimethoxyphenyl)acryloyl]morpholine), and isoproturon (3-(4-isopropylphenyl)-1,1-dimethylurea). Batch and column experiments were conducted as a function of pH and pesticide concentration under laboratory and industrial conditions. The concentration range studied for the pesticides varied from 2 x 10(-7) to 3 x 10(-4) mol L(-1). The influence of organic and inorganic pollutants was assessed by studying the retention of pesticide in the presence of copper(II) and a surfactant. These experiments indicated that LS is an efficient adsorbent toward the investigated pesticides and has little influence of the other pollutants. The kinetic adsorptions are fast, and the amounts of adsorbed pesticide varied from 1 to 8 g kg(-1) of LS. These retention capacities show that LS can provide a simple, effective, and cheap method for removing pesticides from contaminated waters. Thus, this biomaterial may be useful for cleaning up polluted waters.     

Environmental impacts of training activities at an air weapons range

Within Canada, it has been recognized in the last decade that military training activities may have impacts on the environmental quality of training ranges. However, impacts of activities specific to Air Force Bases have not yet been intensely documented. A hydrogeological study was accomplished at the Cold Lake Air Weapons Range, Alberta, to evaluate the environmental impacts of using bombs, rockets, strafing, and open burning/open detonation (OB/OD) on the quality of soil, ground water, surface water, and lake sediments. Samples were analyzed for metals, anions, ammonium perchlorate (NH(4)ClO(4)), and energetic materials (EM). It was found that training activities did not result in measured values being exceeded on the basis of guidance values for surface water and lake sediments. Contamination by metals was mostly limited to soils, and some metals may be related to the use of bombs (Cd, Cu, Pb), strafe (Cu), and rockets (As, Ba, Cd, Cr, Cu, Fe, Ni, Pb, U, V, Zn). TNT (2,4,6-trinitrotoluene) was the main EM found in soils, while RDX (hexahydro-1,3,5-trinitro-1,3,5-triazine) was more common in ground water. Both are related to live bombing, while nitroglycerine (NG) is related to rocket use and was detected in soils only. Aluminum, nitrate, and ammonium perchlorate detected in ground water may be related to live bombing or rockets. OB/OD operations resulted in the presence of various EM in soils, and of perchlorate and nitrate in ground water. Contamination by metals and explosives in soils was localized around the targets and varied significantly in time; however, in ground water it was more constant and may persist for a period of several years after a target has been removed.     

Phytotoxicity of nitroaromatic energetic compounds freshly amended or weathered and aged in sandy loam soil

The toxicities of 2,4,6-trinitrotoluene (TNT), 1,3,5-trinitrobenzene (TNB), 2,4-dinitrotoluene (2,4-DNT), and 2,6-dinitrotoluene (2,6-DNT) to terrestrial plants alfalfa (Medicago sativa L.), Japanese millet (Echinochloa crusgalli L.), and perennial ryegrass (Lolium perenne L.) were determined in Sassafras sandy loam soil using seedling emergence, fresh shoot, and dry mass measurement endpoints. A 13-week weathering and aging of energetic materials in soils, which included wetting and drying cycles, and exposure to sunlight of individual soil treatments, was incorporated into the study design to better reflect the soil exposure conditions in the field than toxicity determinations in freshly amended soils. Definitive toxicity tests showed that dinitrotoluenes were more phytotoxic for all plant species in freshly amended treatments based on EC20 values for dry shoot ranging from 3 to 24mgkg(-1) compared with values for TNB or TNT ranging from 43 to 62mgkg(-1). Weathering and aging of energetic materials (EMs) in soil significantly decreased the toxicity of TNT, TNB or 2,6-DNT to Japanese millet or ryegrass based on seedling emergence, but significantly increased the toxicity of all four EMs to all three plant species based on shoot growth. Exposure of the three plant species to relatively low concentrations of the four compounds initially stimulated plant growth before the onset of inhibition at greater concentrations (hormesis).     

Assessing the biological status of fish in a river receiving pulp and paper mill effluents

This study compared the use of sentinel species- and community-based field approaches for assessing the biological status of fish living in a river receiving pulp and paper mill effluents. Three approaches were compared. Two approaches used sentinel species. One of these involved an internal/external examination of the fish that leads to the calculation of a fish health assessment index (HAI) and the other involved biochemical measurements of hepatic mixed function oxidase (MFO) activity and plasma steroid levels. The third approach characterized the fish community structure according to an index of biotic integrity (IBI). The comparison focused on how the methods respond to the hypothesis that recent process modifications/effluent treatment changes, resulting in demonstrable improvements in effluent quality, have beneficial effects on fish. Neither of the approaches using sentinel fish indicated clear mill-related influences either before or after the process modifications/effluent treatment changes. There was no evidence of depressed plasma steroids and increased MFO activity in fish frequently associated with mill effluent exposure in previous studies. While the HAI was higher at stations downstream from two mills, this could not be linked to effluent exposure alone. In contrast, the study of community structure showed a substantial improvement in fish assemblages at all the mill sites.