Photocatalytic degradation of acetaminophen in modified TiO2 under visible irradiation

This study investigated the photocatalytic degradation of acetaminophen (ACT) in synthetic titanium dioxide (TiO₂) solution under a visible light (λ >440 nm). The TiO₂ photocatalyst used in this study was synthesized via sol–gel method and doped with potassium aluminum sulfate (KAl(SO₄)₂) and sodium aluminate (NaAlO₂). The influence of some parameters on the degradation of acetaminophen was examined, such as initial pH, photocatalyst dosage, and initial ACT concentration. The optimal operational conditions were also determined. Results showed that synthetic TiO₂ catalysts presented mainly as anatase phase and no rutile phase was observed. The results of photocatalytic degradation showed that LED alone degraded negligible amount of ACT but with the presence of TiO₂/KAl(SO₄)₂, 95 % removal of 0.10-mM acetaminophen in 540-min irradiation time was achieved. The synthetic TiO₂/KAl(SO₄)₂ presented better photocatalytic degradation of acetaminophen than commercially available Degussa P-25. The weak crystallinity of synthesized TiO₂/NaAlO₂ photocatalyst showed low photocatalytic degradation than TiO₂/KAl(SO₄)₂. The optimal operational conditions were obtained in pH 6.9 with a dose of 1.0 g/L TiO₂/KAl(SO₄)₂ at 30 °C. Kinetic study illustrated that photocatalytic degradation of acetaminophen fits well in the pseudo-first order model. Competitive reactions from intermediates affected the degradation rate of ACT, and were more obvious as the initial ACT concentration increased.     

SOIL MOISTURE SENSORS FOR CONTINUOUS MONITORING1

ABSTRACT: Certain physical and chemical properties of soil vary with soil water content. The relationship between these properties and water content is complex and involves both the pore structure and constituents of the soil solution. One of the most economical techniques to quantify soil water content involves the measurement of electrical resistance of a dielectric medium that is in equilibrium with the soil water content. The objective of this research was to test the reliability and accuracy of fiberglass soil-moisture electrical resistance sensors (ERS) as compared to gravimetric sampling and Time Domain Reflectometry (TDR). The response of the ERS was compared to gravimetric measurements at eight locations on the USDA-ABS Walnut Gulch Experimental Watershed. The comparisons with TDR sensors were made at three additional locations on the same watershed. The high soil rock content (≥45 percent) at seven locations resulted in consistent overestimation of soil water content by the ERS method. Where rock content was less than 10 percent, estimation of soil water was within 5 percent of the gravimetric soil water content. New methodology to calibrate the ERS sensors for rocky soils will need to be developed before soil water content values can be determined with these sensors.     

Uranium bioassay and radioactive dust measurements at some uranium processing sites in Egypt--health effects

The safety of radiation workers in the uranium mining industry requires close and continuous monitoring of their working conditions. In this study, external radiation surveillance, radioactive dust monitoring and the bioassay of uranium were carried out in some processing sites. As dust represents one of the most important sources of radiation exposure in mills and mines, dust monitoring and bioassays were performed for a sample of workers on the production lines. The concentration of uranium in air ranged from 22.6 x 10(-7) to 11.1 x 10(-5) Bq cm-3, and the exposure levels ranged from 1 to 80 microSv h-1. Laser fluorimetric determination of uranium in urine samples showed concentrations in the range 8.4-29.2 micrograms L-1. Renal function parameters, such as serum creatinine and urea, and hematological parameters were determined in an attempt to correlate them with radiation exposure and the health status of the workers. Urine specimens collected from workers at the ore crushing and separation site showed elevated concentrations of uranium (up to 29.2 micrograms L-1) and a strong correlation between these concentrations and the registered serum creatinine. The mean uranium excretion in the investigated group was more than 20 times the occupational exposure decision level for urine uranium of 0.8 microgram L-1.     

Water Appropriation Systems for Adapting to Water Shortages in Iraq

Climate variability and population growth have intensified the search internationally for measures to adapt to fluctuations in water supplies. An example can be found in the lower part of the transboundary Tigris‐Euphrates Basin where water shortages in 2008‐2009 resulted in high economic costs to irrigation farmers. Losses to irrigators in the lower basin have made a compelling case to identify flexible methods to adapt to water shortage. Few published studies have systematically examined ways to enhance the flexibility of water appropriation systems to adapt to water shortage. This article addresses an ongoing challenge in water governance by examining how profitability at both the farm and basin levels is affected by various water appropriation systems. Four water appropriation systems are compared for impacts on farm income under each of three water supply scenarios. Results show that a (1) proportional sharing of water shortages among provinces and (2) unrestricted water trading rank as the top two appropriation systems. The shadow price of water for irrigation rises from zero at a full water supply level to US$93/1,000 m³ when supply falls to 20% of full levels. Similar methods could be used to analyze challenges facing the design or implementation of water appropriation systems in the world's irrigated regions.     

The Impact of Unilateral Commitment on Transboundary Pollution

To reach a common target of environmental quality, countries can choose to commit to a stream of pollution abatement right from the beginning of the game or decide upon abatement at each moment of time. Though most of the previous literature studies homogeneous strategies where no country or all countries commit to a (same) predefined policy, reality goes along a different way: some countries make more efforts than others to reduce pollutant emission. The main novelty of this paper resides in the introduction of this kind of heterogeneous strategic behavior currently observed among large pollution nations. We find that the pollution level can be lower under heterogeneous than under homogeneous strategies. A stringent environmental quality target will induce the committed player to produce an abatement effort that more than compensates the free-riding attitude of the non-committed player.     

Removal of congo red and basic violet 1 by chir pine (Pinus roxburghii) sawdust,a saw mill waste: batch and column studies

The efficiency of chir pine sawdust (CPS) for adsorptive removal of the dyes, congo red (CR) and basic violet 1 (BV), from aqueous solution was evaluated using batch and column studies. The equilibrium was attained in 60 min for CR and 45 min for BV. The adsorption of BV obeyed the Langmuir isotherm model while the Freundlich isotherm fitted the equilibrium data of CR adsorption. The Langmuir monolayer adsorption capacities (Q_o) of CPS for BV and CR were 11.3 and 5.8 g kg^?1, respectively. The kinetic data for CR were best fitted to the Lagergren pseudo-first-order model and for BV to the pseudo-second-order model. The intra-particle diffusion was found to be the rate-controlling step for CR adsorption, while the adsorption kinetics of BV were controlled by both intra-particle and liquid-film diffusion. The thermodynamic parameters indicated that the adsorption process was spontaneous and endothermic in nature. The adsorption activation energy (E_a) for CR (124 kJ mol^?1) implied chemical adsorption while that for BV (5.4 kJ mol^?1) indicated physical adsorption. An increase in the Thomas model constant (K_Th) with increasing flow indicated that for both dyes the mass transport resistance decreased during adsorption. Thus, CPS may be an efficient low-cost adsorbent for decolorization of dye-containing wastewaters.     

How to Consider the Value of Farm Animals in Breeding Goals. A Review of Current Status and Future Challenges

The objective of this paper is to outline challenges associated with the inclusion of welfare issues in breeding goals for farm animals and to review the currently available methodologies and discuss their potential advantages and limitations to address these challenges. The methodology for weighing production traits with respect to cost efficiency and market prices are well developed and implemented in animal breeding goals. However, these methods are inadequate in terms of assessing proper values of traits with social and ethical values such as animal welfare, because such values are unlikely to be readily available from the product prices and costs in the market. Defining breeding goals that take animal welfare and ethical concerns into account, therefore, requires new approaches. In this paper we suggest a framework and an approach for defining breeding goals, including animal welfare. The definition of breeding goals including values related to animal welfare requires a multidisciplinary approach with a combination of different methods such as profit equations, stated preference techniques, and selection index theory. In addition, a participatory approach involving different stakeholders such as breeding organizations, food authorities, farmers, and animal welfare organizations should be applied. We conclude that even though these methods provide the necessary tools for considering welfare issues in the breeding goal, the practical application of these methods is yet to be achieved.     

Bacterial contamination and health risks of drinking water from the municipal non-government managed water treatment plants

Water quality and bacterial contamination from 18 drinking water municipal plants in three locations at Giza governorate were investigated. The average total count of bacteria detected after four stages of treatments in the investigated plants was 32 CFU/1 mL compared to 2330 cfu/mL for raw water, with a reduction percentage of 98.6. Although there is a relatively high removal percent of bacterial contamination from the water sources, however, several bacterial pathogens were identified in the produced water prepared for drinking including Enterococcus faecalis, Escherichia coli, Pseudomonas aeruginosa, and Shigella spp. After 3 days of water incubation at 30 °C, the amount of bacterial endotoxins ranged from 77 to 137 ng/mL in the water produced from the municipal plants compared to 621–1260 ng/mL for untreated water. The main diseases reported from patients attending different clinics and hospitals during summer 2014 at the surveyed locations and assuredly due to drinking water from these plants indicated that diarrheas and gastroenteritis due to E. coli and Campylobacter jejuni constituted 65.7% of the total patients followed by bacillary dysentery or shigellosis due to Shigella spp. (7.9%) and cholera due to Vibrio cholera (7.2%). There was an increase in serum aspartate aminotransferase (AST), alanine aminotransferase (ALT), and alkaline phosphatase (ALP) as well as urea and creatinine values of guinea pigs consuming water produced from the non-governmental plants for 6 months indicating remarkable liver and kidney damages. Histological sections of liver and kidney from the tested animal revealed liver having ballooning degeneration of hepatocytes and distortion and fragmentation of the nuclei, while the section of the kidney showed irregularly distributed wrinkled cells, degenerated Bowman’s capsule, congested blood vessels, and inflammatory cells.