Improved desalination by polyamide membranes containing hydrophilic glutamine and glycine

Environmental Chemistry Letters - Water desalination and recycling of wastewater is a key challenge to meet water shortage issues. Thin film composite polyamide membranes are widely used for...     

Fungicidal values of bio-oils and their lignin-rich fractions obtained from wood/bark fast pyrolysis

Pine wood, pine bark, oak wood and oak bark were pyrolyzed in an auger reactor. A total of 16 bio-oils or pyrolytic oils were generated at different temperatures and residence times. Two additional pine bio-oils were produced at the National Renewable Energy Laboratory in a fluidized-bed reactor at different temperatures. All these bio-oils were fractionated to obtain lignin-rich fractions which consist mainly of phenols and neutrals. The pyrolytic lignin-rich fractions were obtained by liquid-liquid extraction. Whole bio-oils and their lignin-rich fractions were studied as potential environmentally benign wood preservatives to replace metal-based CCA and copper systems that have raised environmental concerns. Each bio-oil and several lignin-rich fractions were tested for antifungal properties. Soil block tests were conducted using one brown-rot fungus (Gloeophyllum trabeum) and one white-rot fungus (Trametes versicolor). The lignin-rich fractions showed greater fungal inhibition than whole bio-oils for a impregnation solution 10% concentration level. Water repellence tests were also performed to study wood wafer swelling behavior before and after bio-oil and lignin-rich fraction treatments. In this case, bio-oil fractions did not exhibit higher water repellency than whole bio-oils. Comparison of raw bio-oils in soil block tests, with unleached wafers, at 10% and 25% bio-oil impregnation solution concentration levels showed excellent wood preservation properties at the 25% level. The good performance of raw bio-oils at higher loading levels suggests that fractionation to generate lignin-rich fractions is unnecessary. At this more effective 25% loading level in general, the raw bio-oils performed similarly. Prevention of leaching is critically important for both raw bio-oils and their fractions to provide decay resistance. Initial tests of a polymerization chemical to prevent leaching showed some success.     

An Analysis of the Annual and Seasonal Trends of Air Quality Index of Delhi

The Air Quality Index (AQI) is an index for reporting daily air quality. A study on the annual and seasonal variations of Air Quality Index over a period of 9 years (1996-2004) based on daily averaged concentration data of criteria air pollutants has been conducted for Delhi. An attempt has been made to quantify the changes in the AQI on annual and seasonal (winter, summer, monsoon and post monsoon) basis for 9 years. Measurements for the seven monitoring sites (Nizamuddin, Ashok Vihar, Shahzada Baug, Shahadara, Janakpuri, Sirifort and ITO) in Delhi were analysed and trends were also compared amongst these sites. Maximum Operator Function method was used to compute the Air Quality Index of the above areas and percentage variations in different severity class is discussed which provides in depth analysis of the trends. The best air quality was depicted by Shahzada Baug followed by Shahdara, both of these were classified as industrial areas indicating that policy measures relating to the industries in the city during past years have helped in improving the air quality. The air quality in other areas have improved slightly in the span of nine years but still remains critical indicating continued rigorous efforts in this direction. Increased traffic density seems to have resulted into the worst air quality at ITO in the city amongst all the monitoring stations. There is a shift for the worst AQI in the city from winter to summer season in a time span of these nine years. Change of season for worst AQI from Winter to Summer may also be likely due to increased photochemical reactions playing major role with change in the nature of emissions imposed due to different control measures such as CNG implementation, significant shift to LPG in domestic sector etc. calling for a detailed study, those which started after the year 2000. After the year 2000, there is a significant increase in the Nitrogen-dioxide (NO(2)) concentration at all stations. ITO which has shown continuous exponential increase in pollution levels has first time showed a declining AQI trend in the year 2004 and one of the contributing factors could have been the Delhi metro (initiated in 2002) passing through congested neighbouring areas causing traffic decongestion here. In general, the areas which are farthest from metro route viz., Siri-fort, Nizamuddin, Janakpuri etc. did not record declining AQI in 2003 onwards as happened with stations closer to Metro route such as Ashok Vihar and ITO. An attempt has been made to quantify the reasons that lead to the changes in the values of the AQI.     

Heavy metals in the SPM of air in the environment surrounding a ferro-alloy industrial plant in India

Prices for ferro-alloys have hardened due to the closure of plants in developed countries on account of increasingly stringent pollution control legislation, resulting in a higher cost of production. A ferro-alloy industry with a capacity of 80000 MT per annum was selected to study the nature of pollution. Because of the objectionable nature of polluting air in and around the plant it was located in a rural area where there was no other industry. The area was agriculturally active and there was no effective control system for this plant.The quality of ambient air around the plant site is discussed in this paper along with the meteorological conditions. The maximum concentration of suspended particulate matter (SPM) was 768 µg/NM³ downwind of the plant, minimum 184 µg/NM³, and the average was more than 446 µg/NM³. The presence of heavy metals, viz. Fe, Mn, Cr and Pb, was also assessed. The concentration of Fe was 50 µg/NM³ downwind and 10 µg/NM³ upwind. The concentration of other metals followed a similar trend.     

Implications of Land Use Changes on Carbon Dynamics and Sequestration—Evaluation from Forestry Datasets, India

Forests and soils are a major sink of carbon, and land use changes can affect the magnitude of above ground and below ground carbon stores and the net flux of carbon between the land and the atmosphere. Studies on methods for examining the future consequences of changes in patterns of land use change and carbon flux gains importance, as they provide different options for CO₂ mitigation strategies. In this study, a simulation approach combining Markov chain processes and carbon pools for forests and soils has been implemented to study the carbon flows over a period of time. Markov chains have been computed by converting the land use change and forestry data of India from 1997 to 1999 into a matrix of conditional probabilities reflecting the changes from one class at time t to another class time t+1. Results from Markov modeling suggested Indian forests as a potential sink for 0.94 Gt carbon, with an increase in dense forest area of about 75.93 Mha and decrease of about 3.4 Mha and 5.0 Mha in open and scrub forests, if similar land use changes that occurred during 1997–1999 would continue. The limiting probabilities suggested 34.27 percent as dense forest, 6.90 as open forest, 0.4 percent mangrove forest, 0.1 percent scrub and 58 percent as non-forest area. Although Indian forests are found to be a potential carbon sink, analysis of results from transition probabilities for different years till 2050 suggests that, the forests will continue to be a source of about 20.59 MtC to the atmosphere. The implications of these results in the context of increasing anthropogenic pressure on open and scrub forests and their contribution to carbon source from land use change and forestry sector are discussed. Some of the mitigation aspects to reduce greenhouse gas emissions from land use change and forestry sector in India are also reviewed in the study.     

Design parameters for fixed bed reactors of activated carbon developed from fertilizer waste for the removal of some heavy metal ions

Activated carbon, developed from fertilizer waste, has been used for the removal of Hg²⁺, Cr⁶⁺, Pb²⁺, and Cu²⁺. Mass transfer kinetic approach has been successfully applied for the determination of various parameters necessary for designing a fixed-bed absorber. Parameters selected are the length of the (PAZ) primary adsorption zone (δ), total time involved for the establishment of primary adsorption zone (t_x), mass rate of flow to the absorber (F_m), time for primary adsorption zone to move down its length (t_δ), amount of adsorbate adsorbed in PAZ from breakpoint to exhaustion (M_s), fractional capacity (f), time of initial formation of PAZ (t_f) and per cent saturation of column at break point. Chemical regeneration has been achieved with 1 M HNO₃.     

Potential use of Caulerpa fastigiata biomass for removal of lead: kinetics, isotherms, thermodynamic, and characterization studies

The present study attempts to analyze the biosorption trend of biosorbent Caulerpa fastigiata (macroalgae) biomass for removal of toxic heavy metal ion Pb (II) from solution as a function of initial metal ion concentration, pH, temperature, sorbent dosage, and biomass particle size. The sorption data fitted with various isotherm models and Freundlich model was the best one with correlation coefficient of 0.999. Kinetic study results revealed that the sorption data on Pb (II) with correlation coefficient of 0.999 can best be represented by pseudo-second-order. The biosorption capacity (q _e ) of Pb (II) is 16.11?±?0.32 mg g^?1 on C. fastigiata biomass. Thermodynamic studies showed that the process is exothermic (ΔH° negative). Free energy change (ΔG°) with negative sign reflected the feasibility and spontaneous nature of the process. The SEM studies showed Pb (II) biosorption on selective grains of the biosorbent. The FTIR spectra indicated bands corresponding to –OH, COO^?, –CH, C?=?C, C?=?S, and –C–C– groups were involved in the biosorption process. The XRD pattern of the C. fastigiata was found to be mostly amorphous in nature.     

The cause and consequences of road mortality of herpetofauna in durgapur,West Bengal,India

The mortality rate of herpetofauna due to road accidents in one of the busiest tarmacked metalled roads of Durgapur, an industrial town of West Bengal, India was studied. Road survey for 27 days covering a total distance of 94.5 km was conducted. Within this span of time and the total stretch of road, 354 amphibians belonging to 6 species and 133 reptiles belonging to 11 species were observed to be killed in road-accidents. Among amphibians, Duttaphrynus melanostictus and amongst the reptiles Hemidactylus spp. were killed in highest numbers. The stretch of road under survey passed through different habitat patches like’s agricultural land, human habitation, dumping area, fragmented forest and wetland. On an average, 18 herpetofauna was noted to be killed daily. It was difficult to identify the species as the key characters were missing in the remains in a few cases of road casualties. High road mortality of herpetofauna would surely affect the balance of adjoining ecosystems as well as may be crucial for the local herpetofaunal population attributes.     

Insights into aqueous carbofuran removal by modified and non-modified rice husk biochars

Biochar has been considered as a potential sorbent for removal of frequently detected pesticides in water. In the present study, modified and non-modified rice husk biochars were used for aqueous carbofuran removal. Rice husk biochars were produced at 300, 500, and 700 °C in slow pyrolysis and further exposed to steam activation. Biochars were physicochemically characterized using proximate, ultimate, FTIR methods and used to examine equilibrium and dynamic adsorption of carbofuran. Increasing pyrolysis temperature led to a decrease of biochar yield and increase of porosity, surface area, and adsorption capacities which were further enhanced by steam activation. Carbofuran adsorption was pH-dependant, and the maximum (161 mg g^?1) occurred in the vicinity of pH 5, on steam-activated biochar produced at 700 °C. Freundlich model best fitted the sorption equilibrium data. Both chemisorption and physisorption interactions on heterogeneous adsorbent surface may involve in carbofuran adsorption. Langmuir kinetics could be applied to describe carbofuran adsorption in a fixed bed. A higher carbofuran volume was treated in a column bed by a steam-activated biochar versus non-activated biochars. Overall, steam-activated rice husk biochar can be highlighted as a promising low-cost sustainable material for aqueous carbofuran removal.