Effect of vegetation type on throughfall deposition and seepage flux

This paper compares different vegetation types (coniferous and deciduous forest, grassed and pure heathland) in terms of input (throughfall deposition) and output (seepage flux) in a region with intermediate nitrogen load (+/-20kg Nha(-1)y(-1) via bulk precipitation) in comparable conditions in north Belgium. Coniferous forest (two plots Pinus sylvestris and two plots Pinus nigra) received significantly higher nitrogen and sulphur throughfall deposition than deciduous forest and heathland. Grassed and pure heathland had significantly highest throughfall quantities of Ca(2+) and Mg(2+), respectively. The observed differences in throughfall deposition between the different vegetation types were not univocally reflected in the ion seepage flux. Considerable seepage fluxes of NO(3)(-), SO(4)(2-), Ca(2+) and Al(III) were only found under the P. nigra plots. We discuss our hypothesis that the P. nigra forests already evolved to a situation of N saturation, while the other vegetation types did not.     

A Comparative Study Between Technological Properties of Cashew Tree Gum and Arabic Gum

Arabic gum (AG) is the most common emulsifier used for beverage emulsions. Cashew tree gum (CG) is a biological macromolecule that has been proposed as a substitute for the AG, although their technological properties comparison is still necessary. The aim of this study was to evaluate an isolation method for CG, and then evaluate CG technological properties in comparison to AG. The CG isolation methodology was improved using a small solvent amount. CG zeta-potential ranged from +8.0 mV (pH 2) to ?9.7 mV (pH 5), while the electric charge in solution of AG ranged from ?2.7 mV (pH 2) to ?28.6 mV (pH 6). As compared to AG, the CG showed a 50 % higher swelling, a 36 % lower oil absorption capacity, a slightly lower (4–8 %) solubility and lower consistency. CG is a feasible polyelectrolyte, promotes lower consistency solutions, and exhibits good swelling property.     

Preparation and Characterization of Clay Nanocomposites of Plasticized Starch and Polypropylene Polymer Blends

Plasticized starch (PLS) is a renewable, degradable, and inexpensive polymer, but it suffers from poor mechanical properties. The mechanical properties can be improved by blending PLS with polyolefins, nonetheless, at high PLS content, the mechanical properties remain poor. Here we show that addition of clay can greatly improve the mechanical properties of PLS/polypropylene blends at high starch content. Unmodified and organically modified montmorillonite clays, MMT and Cloisite 30B respectively, were added to blends of glycerol-plasticized starch and polypropylene, compatibilized using maleated polypropylene. TEM indicates that MMT is well dispersed in the PLS phase of the blends, while Cloisite 30B is located both within the PLS phase as well as at the interface between PLS and PP. At high PLS content, the addition of clay increased the tensile strength and tensile modulus by an order of magnitude, while reducing the ultimate elongation only slightly. Such improvements are attributable to both the addition of clay as a reinforcing component, as well as to the change in the two phase morphology due to addition of clay.     

Sustainability Assessment for Agriculture Scenarios in Europe’s Mountain Areas: Lessons from Six Study Areas

Sustainability assessment (SA) is a holistic and long-range strategic instrument capable of assisting policy-making in electing, and deciding upon, future development priorities. The outcomes of an SA process become more relevant and strengthened when conducted with multi-stakeholder engagement, which provides for multiple dialogues and perspectives. This was the object of research of the SA team in the context of BioScene (Scenarios for Reconciling Biodiversity Conservation with Declining Agriculture Use in Mountain Areas in Europe), a three-year project (2002–2005) funded by the European Union 5th Framework Program, which aimed to investigate the implications of agricultural restructuring and decline for biodiversity conservation in the mountain areas of Europe, using three distinct methodological streams: the ecological, the socio-economic, and the SA approaches. The SA approach drew on the previous two to assess the importance for biodiversity management of different scenarios of agri-environmental change and rural policy in six countries (France, Greece, Norway, Slovakia, Switzerland, and the United Kingdom), develop causal chains, include stakeholder views, and identify potential contributions for, or conflicts with, sustainability. This article tells how SA was used, what sustainability meant in each study area through different objectives of sustainability considered, discusses the methods used in SA, and the benefits arising. The SA was conducted by a team independent of any study area, who developed and oversaw the application of the SA methodology, assisting national teams, and developing a cross-country understanding of the sustainability of proposed scenarios in the different geographical and social contexts, and their implications for policy-making. Finally, it reflects on the persistent challenges of interdisciplinary research, compounded by multi-cultural teams, and concludes on the BioScene’s lessons for the further development and application of SA.

库里提巴市的可持续性与规划程序

可持续性是一个关于人与自然或社会与环境平衡的概念。根据自身历史、地理或社会文化背景的不同,每个人或社会对这一概念的理解也不相同。虽然在理论上缺乏一致性,但是可持续发展概念一直存在于社会的自然与人为空间适应和变化过程中,以及以生存和发展为目的的生产过程中。当涉及到城市或城市空间时,这些过程反映了一个社会认可、支配和确定保证满足基本需求范围的方式,同时确保城市随着时间的发展而生存下来。     

Assessment of trace metal air pollution in Paris using slurry-TXRF analysis on cemetery mosses

Mosses are useful, ubiquitous accumulation biomonitors and as such can be used for biomonitoring surveys. However, the biomonitoring of atmospheric pollution can be compromised in urban contexts if the targeted biomonitors are regularly disturbed, irregularly distributed, or are difficult to access. Here, we test the hypothesis that cemeteries are appropriate moss sampling sites for the evaluation of air pollution in urban areas. We sampled mosses growing on gravestones in 21 urban and peri-urban cemeteries in the Paris metropolitan area. We focused on Grimmia pulvinata (Hedwig) Smith, a species abundantly found in all studied cemeteries and very common in Europe. The concentration of Al, As, Br, Ca, Ce, Cl, Cr, Cu, Fe, K, Mn, Ni, V, P, Pb, Rb, S, Sr, Ti, and Zn was determined by a total reflection X-ray fluorescence technique coupled with a slurry sampling method (slurry-TXRF). This method avoids a digestion step, reduces the risk of sample contamination, and works even at low sample quantities. Elemental markers of road traffic indicated that the highest polluted cemeteries were located near the highly frequented Parisian ring road and under the influence of prevailing winds. The sites with the lowest pollution were found not only in the peri-urban cemeteries, adjoining forest or farming landscapes, but also in the large and relatively wooded cemeteries located in the center of Paris. Our results suggest that (1) slurry-TXRF might be successfully used with moss material, (2) G. pulvinata might be a good biomonitor of trace metals air pollution in urban context, and (3) cemetery moss sampling could be a useful complement for monitoring urban areas.

Open image in new window

Graphical abstract We tested the hypothesis that cemeteries are appropriate moss sampling sites for the evaluation of air pollution in urban areas. We sampled 110 moss cushions (Grimmia pulvinata) growing on gravestones in 21 urban and peri-urban cemeteries in the Paris metropolitan area. The concentration of 20 elements in mosses was determined by a total reflection X-ray fluorescence technique coupled with a slurry sampling method. Statistical analysis revealed that: - Urbanized Parisian areas crossed by traffic roads have the highest polluted cemeteries with a strong influence of main wind direction on the distribution of air pollutants - As expected, small cemeteries with low tree density were heavily polluted - Less obvious, large green spaces such as large cemeteries (Père Lachaise, Montmartre, Montparnasse) in the center of a dense metropolis like Paris present the same level of atmospheric trace metal pollution as cemeteries in less urbanized areas or nearing a very large forest. This suggests that even in densely urbanized areas, there is more spatial variability in pollution distribution than usually assumed and that large urban areas with low traffic and green filters such as trees are likely to intercept air pollutants

     

Facile fabrication of hybrid titanium(IV) isopropoxide/pozzolan nanosheets (TnS-Pz) of high photocatalytic activity: characterization and application for Cr(VI) reduction in an aqueous solution

Environmental Science and Pollution Research - This paper presents the synthesis of a hybrid material through the use of natural pozzolan and titanium(IV) isopropoxide using the sol-gel method and...     

Pigeon navigation: Charcoal filter removes relevant information from environmental air

Summary Homing pigeons were displaced and kept until they were released in airtight containers ventilated with environmental air that could be passed through: (a) a filter made of fiberglass paper retaining large portions of the solid and liquid aerosol particles, (b) an additional filter consisting of activated charcoal, or (c) no filter (controls). Before its release, each bird was taken out of the container, and its olfactory epithelium was immediately anesthetized by lidocaine (Xylocaine). Thus, neither experimentals nor controls were able to smell while their initial orientation behavior was being observed.The controls' initial bearings were better homeward-oriented than those of pigeons ventilated with charcoal-filtered air in 14 of 17 releases conducted in Italy and Germany, at distances of 24–155 km. In the final analysis, the bearings of the charcoal-filter birds did not show any relation to the direction toward home, whereas those of the controls did. Pigeons ventilated with air that had passed through only the paper filter did not behave noticeably differently from control pigeons.It is concluded that the material bases of olfactory navigation in pigeons are substances dispersed in the atmosphere, most probably in a molecular state.     

Effects of Amazonian flying rivers on frog biodiversity and populations in the Atlantic rainforest

Given the speed at which humans are changing the climate, species with high degrees of endemism may not have time to avoid extinction through adaptation. We investigated through teleconnection analysis the origin of rainfall that determines the phylogenetic diversity of rainforest frogs and the effects of microclimate differences in shaping the morphological traits of isolated populations (which contribute to greater phylogenetic diversity and speciation). We also investigated through teleconnection analysis how deforestation in Amazonia can affect ecosystem services that are fundamental to maintaining the climate of the Atlantic rainforest biodiversity hotspot. Seasonal winds known as flying rivers carry water vapor from Amazonia to the Atlantic Forest, and the breaking of this ecosystem service could lead Atlantic Forest species to population decline and extinction in the short term. Our results suggest that the selection of morphological traits that shape Atlantic Forest frog diversity and their population dynamics are influenced by the Amazonian flying rivers. Our results also suggest that the increases of temperature anomalies in the Atlantic Ocean due to global warming and in the Amazon forest due to deforestation are already breaking this cycle and threaten the biodiversity of the Atlantic Forest hotspot.