An introduction to critical loads

The critical loads approach to emission controls of gaseous pollutants is a concept with a short but eventful history. Despite difficulties with definitions and agreed values, its acceptance within the UN-ECE Convention on Long Range Transboundary Air Pollution has provided the impetus for developing methods to put critical loads to a practical use-the revision of the UNECE emission protocols for sulphur and nitrogen. Methodologies first focus upon quantifying a pollutant threshold at which harmful effects occur on particular sensitive receptors (usually biological species). This threshold is known as the critical load for deposited pollutants, and as the critical level for gaseous pollutants acting on receptors. To calculate a critical load, biological effects are usually 'translated' to critical chemical values, e.g. harmful effects on fish 'translate' to alkalinity or aluminium concentrations in water; thus, critical load calculations may be based upon the chemistry of a system. Such calculations may be performed using simple, steady-state models, whilst the use of more complex, dynamic models provides an insight into the past and future trends. Maps of critical loads can be drawn using calculated values, and maps of pollutant deposition data will then show geographical areas where critical loads are exceeded. Spatial emission-deposition models can identify sources contributing to areas of excess loads and quantify necessary emission reductions. Optimization procedures applied to such models can derive abatement strategies related to economic costs and critical load effects. The critical load calculations may also be used to underpin the setting of target loads; these are pollutant loads, determined by political agreement, which take account of social, economic and political considerations.     

Application of tracer ratio and inverse dispersion methods with boat-based plume measurements to estimate ammonia emissions from seabird colonies

Ammonia emissions from two contrasting seabird colonies in Scotland were measured, based on the determination of atmospheric concentrations downwind of the colonies. Atmospheric concentrations of ammonia (NH₃) across the downwind plume were compared with the inverse application of a Gaussian dispersion model (ID) to calculate the modelled NH₃ emission that would generate the measured cross-wind-integrated plume concentration. In parallel, a tracer gas (sulphur hexafluoride, SF₆) was released from the colonies with air samples taken to allow determination of SF₆ concentrations. On the basis of the known emission rate of SF₆, the magnitude of ammonia emissions was estimated by the cross-wind-integrated tracer ratio (TR) of NH₃/SF₆ concentrations. Coupled with data on annual bird attendance, the measurements indicate annual emissions from the Isle of May and the Bass Rock of 18 and 132 tonnes NH₃-N year^–1, respectively. The measured NH₃ emissions were compared with estimates of seabird nitrogen excretion to estimate the proportion of excreted N that is volatilised as NH₃ (F_Nr). The emission estimates of the two methods compared favourably, giving 4 and 6 kg NH₃-N h^–1 (F_Nr = 15%) for the Isle of May for the ID and TR methods, respectively, and 21 and 25 kg NH₃-N h^–1 (F_Nr = 50%) for the Bass Rock for the ID and TR methods, respectively. The results provide the first measurement-based estimates to allow regional up scaling of ammonia emissions from seabirds.     

Framework for integrating sustainability into remediation projects

The US Sustainable Remediation Forum (SURF) created this Framework to enable sustainability parameters to be integrated and balanced throughout the remediation project life cycle, while ensuring long‐term protection of human health and the environment and achieving public and regulatory acceptance. Parameters are considerations, impacts, or stressors of environmental, social, and economic importance. Because remediation project phases are not stand‐alone entities but interconnected components of the wider remediation system, the Framework provides a systematic, process‐based approach in which sustainability is integrated holistically and iteratively within the wider remediation system. By focusing stakeholders on the preferred end use or future use of a site at the beginning of a remediation project, the Framework helps stakeholders form a disciplined planning strategy. Specifically, the Framework is designed to help remediation practitioners (1) perform a tiered sustainability evaluation, (2) update the conceptual site model based on the results of the sustainability evaluation, (3) identify and implement sustainability impact measures, and (4) balance sustainability and other considerations during the remediation decision‐making process. The result is a process that encourages communication among different stakeholders and allows remediation practitioners to achieve regulatory goals and maximize the integration of sustainability parameters during the remediation process. © 2011 Wiley Periodicals, Inc.     

The importance of context for effective public engagement: learning from the governance of waste

This paper takes a new look at the importance of context – institutional and political – in effective public engagement processes. It does so through a rare comparative opportunity to examine the effectiveness of processes of public engagement in two UK waste authorities, where the same waste company was involved as both the primary contractor for the delivery of the waste management service (including new energy-from-waste facilities) and, furthermore, the same staff delivered the public engagement. Interrogating these cases affords the opportunity to place flesh on the bones of the sometimes ‘abstract’ skeleton of context. While engagement processes support effective local governance in an era of partnerships and deliberative democracy, the paper identifies that the methods adopted cannot be played out devoid of detailed understanding and response to local context, including the strength of partnership working between the public and private sector, the degree of political support for engagement, and the extent to which a traditional institutional paternalism still dominates.     

The habitat saturation hypothesis and sociality in an allodapine bee: cooperative nesting is not “making the best of a bad situation”

Several factors thought to be important for the evolution of cooperative breeding in vertebrates have received little attention in facultatively social insects. One of these, the “habitat saturation hypothesis” of Selander (1964), predicts that colony sizes will be greater in breeding units where dispersal opportunities are limited, suggesting that group living is a secondary option to independent reproduction. The Australian allodapine bee Exoneura bicolor exhibits a number of traits that occur in cooperatively breeding bird species, including long life-span, repeated opportunities for reproduction, and vulnerability to brood predation and parasitism. We experimentally examined the effect of a potentially limiting environmental factor, nesting substrate availability, as an agent influencing sociality in E. bicolor. We manipulated nesting substrate availability in two separate locations during a time when foundress dispersal is common. No significant difference was found between colony sizes in cases where dispersal options were abundant and cases where dispersal options were limited. An increase in opportunities for dispersal did not lead to higher rates of independent nesting, suggesting that cooperative nesting is a preferred strategy regardless of distance-related costs of dispersal. Reproductivity per female and brood survival were examined as factors selecting for group living. Low survival of brood in single-female nests has the potential to select for cooperative nesting in this bee. Received: 29 September 1995/Accepted after revision: 24 June 1996     

Size-related selection of two intertidal gastropods by the reef crab Ozius truncatus

Reef crabs, Ozius truncatus H. Milne-Edwards 1834, and gastropods, Bembicium nanum (Lamarck, 1882) and Nerita atramentosa Reeve, 1855, were collected from a South Australian rocky intertidal platform in April 1981. Laboratory experiments were conducted to determine (1) the size of prey chosen, and (2) the energy gained by the reef crabs feeding on B. nanum and N. atramentosa. The time taken to break open and consume prey increased exponentially with prey shell height. Crabs with larger master claws had shorter handling times for a given prey size. When offered a range of prey sizes, crabs selected prey of a certain size, well below the maximum prey size that they could handle. The mean prey size selected by crabs did not concide with the size predicted to yield the maximum rate of energy gain. For example, one reef crab preferred B. nanum 5 to 8 mm in size, but the size class predicted to yield the greatest energy gain was 4 to 4.9 mm. The results of the laboratory prey-choice experiments are discussed in relation to the shore-level size gradients of B. nanum and N. atramentosa.     

Minimizing the cost of translocation failure with decision‐tree models that predict species’ behavioral response in translocation sites

The high number of failures is one reason why translocation is often not recommended. Considering how behavior changes during translocations may improve translocation success. To derive decision‐tree models for species’ translocation, we used data on the short‐term responses of an endangered Australian skink in 5 simulated translocations with different release conditions. We used 4 different decision‐tree algorithms (decision tree, decision‐tree parallel, decision stump, and random forest) with 4 different criteria (gain ratio, information gain, gini index, and accuracy) to investigate how environmental and behavioral parameters may affect the success of a translocation. We assumed behavioral changes that increased dispersal away from a release site would reduce translocation success. The trees became more complex when we included all behavioral parameters as attributes, but these trees yielded more detailed information about why and how dispersal occurred. According to these complex trees, there were positive associations between some behavioral parameters, such as fight and dispersal, that showed there was a higher chance, for example, of dispersal among lizards that fought than among those that did not fight. Decision trees based on parameters related to release conditions were easier to understand and could be used by managers to make translocation decisions under different circumstances. Minimizar el Costo del Fracaso de la Reubicación con Modelos de Árboles de Decisión que Predigan la Respuesta Conductual de la Especie en los Sitios de Reubicación     

Effect of surfactants on Fenton's reagent-mediated degradation of Kraft black liquor

One of the limitations of the biodegradation of hydrophobic chemical compounds, like lignins, is their low solubility in the aqueous solution where this process takes place. To resolve this problem, surfactants have been used to improve the solubility of these hydrophobic compounds. In this investigation, we studied the effect of surfactants (anionic, cationic, and non-ionic) on the treatment of Kraft black liquor with Fenton's reagent. In the Fenton reaction, H2O2 (two different concentrations, 10 mM and 20 mM), FeCl2 (1 mM) and surfactant solution (10%) were used. Black liquor degradation was determined by UV/Visible spectrophotometry and by measuring phenolic groups. In the presence of Fenton's reagent, the optimum conditions for the oxidative degradation of black liquor were 10 mM H2O2, 1 microL of 10% solution of anionic surfactant (SDS). The importance of the use of surfactants for preparing black liquor for subsequent Fenton's reagent-mediated degradation was discussed.     

The sensitivity of surface waters of Great Britain to acidification predicted from catchment characteristics

Using a combination of soil, land use and geological information, a map of Great Britain has been derived which indicates the sensitivity of surface waters to acidification. For the geological information, a slightly modified version of an available map was used which indicated the sensitivity of groundwaters to acidification. For soils, 1-km databases of soil information for England and Wales and for Scotland were employed to map the soil sensitivity as determined by buffering capacity. The derived soils map was modified to take account of agricultural liming in arable and managed grassland areas using the ITE Land Classification. The final map of surface water sensitivity was obtained by using a geographic information system overlay procedure which enabled each combination of soil and geology sensitivity to be uniquely defined. The final sensitivity classification was based upon expert knowledge and the experience of a similar sensitivity mapping exercise for Wales.