FACTORS THAT AFFECT ACTIVATED SLUDGE PHOSPHATE RELEASE1

The activated sludge process can remove significant amounts of phosphorus from sewage, but the removal efficiency is usually significantly reduced by the release of phosphate back to solution during subsequent treatment steps. This research presents a study of soluble phosphate release from activated sludge with emphasis on defining the factors that affect such release and the actual release mechanisms. Laboratory units were used for experimental purposes. The experiments were designed to study the relationship between soluble phosphate release and various environmental factors such as redox potential (ORP), dissolved oxygen (DO), pH, solids concentration, solids destruction, and sulfate salt addition. The effect of substrate utilization on phosphate uptake and the relationship between uptake characteristics and subsequent phosphate release were also studied. The results show that some phosphate storage occurs during aerobic substrate utilization. Following substrate utilization, activated sludge phosphate release is directly related to the amount of biological stress the organisms are subjected to, and the mechanism of release is primarily cell lysis. The phosphate released per unit sludge under anoxic conditions is relatively constant. Under normal environmental conditions, neither ORP or pH change have a significant affect on phosphate release.     

POLLUTIONAL ASPECTS OF PESTICIDES IN NATURAL STREAMS

The extensive use of synthetic organic pesticides in this country during the past twenty-five years has resulted in widespread pollution of our water resources. An obvious detrimental effect of such pollution has been observed in the numerous fish kills that have occurred. The most widely used pesticides, and the ones that have been implicated in the vast majority of the pollutional episodes, are the chlorinated hydrocarbon insecticides. These compounds, generally speaking, have almost no solubility in water, are subject to very slow microbial degradation if any at all, and are so resistent to natural degradation forces they can persist almost indefinitely in aqueous environments; characteristics that are all detrimental from a stream pollution standpoint. In addition, studies have shown that, as a group, the chlorinated hydrocarbons are more toxic to higher forms of aquatic life than other chemicals widely used for pest control. Because of these undesirable characteristics, present trends are to discontinue using these highly toxic, persistent compounds for pest control in outdoor areas. Legislation banning the sale of DDT has been introduced. Similar legislation controlling the use of several of the chlorinated hydrocarbon pesticides is probably the most effective way to reduce pollution.     

Effects of glyphosate and foliar amendments on activity of microorganisms in the soybean rhizosphere

A field study was conducted to determine the effects of glyphosate on microbial activity in the rhizosphere of glyphosate-resistant (GR) soybean and to evaluate interactions with foliar amendments. Glyphosate at 0.84 kg ae ha^{? 1} was applied GR soybean at the V4–V5 development stages. Check treatments included a conventional herbicide tank mix (2003 study only) and no herbicides (hand-weeded). Ten days after herbicide application, a commercially available biostimulant and a urea solution (21.0% N) were applied to soybean foliage at 33.5 mL ha^{? 1} and 9.2 kg ha^{? 1}, respectively. Soil and plant samples were taken 0, 5, 10, 15, 20 and 25 days after herbicide application then assayed for enzyme and respiration activities. Soil respiration and enzyme activity increased with glyphosate and foliar amendment applications during the 2002 growing season; however, similar increases were not observed in 2003. Contrasting cumulative rainfall between 2002 and 2003 likely accounted for differences in soil microbial activities. Increases in soil microbial activity in 2002 suggest that adequate soil water and glyphosate application acted together to increase microbial activity. Our study suggests that general soil microbial properties including those involving C and N transformations are not sensitive enough to detect effects of glyphosate on rhizosphere microbial activity. Measurements of soil-plant-microbe relationships including specific microbial groups (i.e., root-associated Fusarium spp.) are likely better indicators of impacts of glyphosate on soil microbial ecology.     

Dairy washwater treatment using a horizontal flow biofilm system

In Ireland, dairy farmyard washwater commonly comprises farmyard run-off and dairy parlour washings. Land-spreading is the most widely used method for treating this wastewater. However, this method can be labour intensive and can cause, in some cases, the degradation of surface and ground waters, mainly due to nitrogen contamination. In this study, a horizontal flow biofilm reactor (HFBR) with step-feed was constructed and tested in the laboratory, to remove organic carbon and nitrogen from a agricultural strength synthetic washwater (SWW). The HFBR had an average top plan surface area (TPSA) of 0.1002 m(2) and consisted of a stack of 45 polystyrene horizontal sheets--15 sheets embedded with 25 mm deep frustums above 30 sheets with 10 mm deep frustums. The frustums acted as miniature reservoirs. The sheets were alternately offset to allow the wastewater to flow horizontally along each sheet and vertically from sheet to sheet down through the reactor. Biofilms developed on the sheets and treated the wastewater. During the 212-d study, the total hydraulic loading rate based on the TPSA of the sheets was 35 l m(-2) d(-1). SWW was pumped for 10 min each hour, in a step feed arrangement at a rate of 23.33 l m(-2) d(-1) on to the top sheet during Phases 1 and 2, and 11.67 l m(-2) d(-1) onto Sheet 16 during Phase 1 (days 1-92) and onto Sheet 30 during Phase 2 (days 93-212). The substrate loading rate during Phases 1 and 2 was 94.8 g total chemical oxygen demand (COD) m(-2) d(-1) and 10.5 g total nitrogen (TN) m(-2) d(-1), based on the TPSA. At steady state in Phase 2, the unit achieved excellent carbon removal of 99.7% 5-day biochemical oxygen demand (BOD(5)) and 96.7% total COD, equivalent to TPSA removal rates of 67.5 g BOD(5)m(-2)d(-1) and 91.7 g COD m(-2) d(-1). The nitrogen removal percentages were 98.3% total ammonium-nitrogen (NH(4)-N(t)) and 72.8% TN, which equated to TPSA removal rates of 4.8 g NH(4)-N(t) m(-2) d(-1) and 7.6g TN m(-2) d(-1). No sloughing of solids or clogging of media occurred during the study. The unit was simple to construct and operate, with little maintenance.     

Welfare and Environmental Implications of Farmed Sea Turtles

Various captivity-related health problems have been described as arising in the farming of sea turtles at the Cayman Turtle Farm (CTF). Our study included a desktop review of turtle farming, direct onsite inspection at the CTF, assessment of visual materials and reports provided by investigators from the World Society for the Protection of Animals (WSPA), and a limited analysis of water quality for potential pathogens. In particular, we assessed physical and behavioural condition of animals for signs of stress, injury and disease. During the onsite inspection we identified three distinct signs of physical injury and disease, six distinct signs of abnormal and problematic arousal- and discomfort-related behaviour; and three distinct signs of normal quiescence- and comfort-related behaviour. On evaluation of evidence provided by the WSPA we identified ten distinct signs of physical injury and disease, and management- or genetic-related conditions; six distinct signs of abnormal and problematic arousal- and discomfort-related behaviour; and three distinct signs of normal quiescence- and comfort-related behaviour. We conclude that sea turtles at the CTF manifested important physical and behavioural signs that are indicative of problematic management and captivity-related stress, and the limitations of sea turtle adaptive plasticity in captivity. The problematic physical and behavioural signs, in our view, related to the inherent nature of intensive turtle propagation which in particular involves overt- and crypto-overcrowding and understimulating environments, and an associated failure to meet all the physical, biological and innate behavioural needs of sea turtles.     

A method for determining the analytical form of a radionuclide depth distribution using multiple gamma spectrometry measurements

When characterizing environmental radioactivity, whether in the soil or within concrete building structures undergoing remediation or decommissioning, it is highly desirable to know the radionuclide depth distribution. This is typically modeled using continuous analytical expressions, whose forms are believed to best represent the true source distributions. In situ gamma ray spectroscopic measurements are combined with these models to fully describe the source. Currently, the choice of analytical expressions is based upon prior experimental core sampling results at similar locations, any known site history, or radionuclide transport models. This paper presents a method, employing multiple in situ measurements at a single site, for determining the analytical form that best represents the true depth distribution present. The measurements can be made using a variety of geometries, each of which has a different sensitivity variation with source spatial distribution. Using non-linear least squares numerical optimization methods, the results can be fit to a collection of analytical models and the parameters of each model determined. The analytical expression that results in the fit with the lowest residual is selected as the most accurate representation. A cursory examination is made of the effects of measurement errors on the method.     

Improved computational model (AQUIFAS) for activated sludge, integrated fixed-film activated sludge, and moving-bed biofilm reactor systems, Part I: Semi-empirical model development

Research was undertaken to develop a model for activated sludge, integrated fixed-film activated sludge (IFAS), and moving-bed biofilm reactor (MBBR) systems. The model can operate with up to 12 cells (reactors) in series, with biofilm media incorporated to one or more cells, except the anaerobic cells. The process configuration can be any combination of anaerobic, anoxic, aerobic, post-anoxic with or without supplemental carbon, and reaeration; it can also include any combination of step feed and recycles, including recycles for mixed liquor, return activated sludge, nitrates, and membrane bioreactors. This paper presents the structure of the model. The model embeds a biofilm model into a multicell activated sludge model. The biofilm flux rates for organics, nutrients, and biomass can be computed by two methods--a semi-empirical model of the biofilm that is relatively simpler, or a diffusional model that is computationally intensive. The values of the kinetic parameters for the model were measured using pilot-scale activated sludge, IFAS, and MBBR systems. For the semiempirical version, a series of Monod equations were developed for chemical oxygen demand, ammonium-nitrogen, and oxidized-nitrogen fluxes to the biofilm. Within the equations, a second Monod expression is used to simulate the effect of changes in biofilm thickness and fraction nitrifiers in the biofilm. The biofilm flux model is then linked to the activated sludge model. The diffusional model and the verification of the models are presented in subsequent papers (Sen and Randall, 2008a, 2008b). The model can be used to quantify the amount of media and surface area required to achieve nitrification, identify the best locations for the media, and optimize the dissolved oxygen levels and nitrate recycle rates. Some of the advanced features include the ability to apply different media types and fill fractions in cells; quantify nitrification, denitrification, and biomass production in the biofilm and mixed liquor suspended solids; and perform dynamic simulations.     

Self-reported job burnout among female human service professionals

A sample of 135 female human service professionals completed the Maslach Burnout Inventory (MBI) and the Staff Burnout Scale for Health Professionals (SBS), along with measures of job satisfaction, role stress, self-esteem, alienation, and locus of control. Principal components factor analysis of this battery indicates considerable covariation of self-reported burnout with job dissatisfaction and perceived role stress, and moderate overlap with more general feelings of alienation and low self-esteem. Item factor analysis of the 22 MBI items resulted in two independent factors, one defined by the Emotional Exhaustion and Depersonalization items, the other by the Personal Accomplishment items. Item factoring of the SBS produced one large factor which was highly correlated with the MBI exhaustion-depersonalization factor. Implications of these findings for the construct validity of the MBI and SBS are discussed.