Hydrocarbon emission fingerprints from contemporary vehicle/engine technologies with conventional and new fuels

The present paper presents results from the analysis of 29 individual C₂–C₉ hydrocarbons (HCs) specified in the European Commission Ozone Directive. The 29 HCs are measured in exhaust from common, contemporary vehicle/engine/fuel technologies for which very little or no data is available in the literature. The obtained HC emission fingerprints are compared with fingerprints deriving from technologies that are being phased out in Europe. Based on the total of 138 emission tests, thirteen type-specific fingerprints are extracted (Mean ± SD percentage contributions from individual HCs to the total mass of the 29 HCs), essential for receptor modelling source apportionment. The different types represent exhaust from Euro3 and Euro4 light-duty (LD) diesel and petrol-vehicles, Euro3 heavy-duty (HD) diesel exhaust, and exhaust from 2-stroke preEuro, Euro1 and Euro2 mopeds. The fuels comprise liquefied petroleum gas, petrol/ethanol blends (0–85% ethanol), and mineral diesel in various blends (0–100%) with fatty acid methyl esters, rapeseed methyl esters palm oil methyl esters, soybean oil methyl or sunflower oil methyl esters. Type-specific tracer compounds (markers) are identified for the various vehicle/engine/fuel technologies.An important finding is an insignificant effect on the HC fingerprints of varying the test driving cycle, indicating that combining HC fingerprints from different emission studies for receptor modelling purposes would be a robust approach.The obtained results are discussed in the context of atmospheric ozone formation and health implications from emissions (mg km^?1 for LD and mopeds and mg kW h^?1 for HD, all normalised to fuel consumption: mg dm^?3 fuel) of the harmful HCs, benzene and 1,3-butadiene.Another important finding is a strong linear correlation of the regulated “total” hydrocarbon emissions (tot-HC) with the ozone formation potential of the 29 HCs (ΣPO₃ = (1.66 ± 0.04) × tot-RH; r² = 0.93). Tot-HC is routinely monitored in emission control laboratories, whereas C₂–C₉ are not. The revealed strong correlations broadens the usability of data from vehicle emission control laboratories and facilitates the comparison of the ozone formation potential of HCs in exhaust from of old and new vehicle/engine/fuel technologies.     

Size and spatial structure in deep versus shallow populations of the Mediterranean gorgonian <Emphasis Type="Italic">Eunicella singularis</Emphasis> (Cap de Creus,northwestern Mediterranean Sea)

In the Western Mediterranean Sea, the gorgonian Eunicella singularis (Esper, 1794) is found at high densities on sublittoral bottoms at depths from 10 to 70 m. Shallow colonies have symbiotic zooxanthellae that deeper colonies lack. While knowledge of the ecology of the shallow populations has increased during the last decades, there is almost no information on the ecology of the deep sublittoral populations. In October and November 2004 at Cap de Creus (42°19′12″ N; 03°19′34″ E), an analysis of video transects made by a remotely operated vehicle showed that shallow populations (10–25 m depth) were dominated by small, non-reproductive colonies, while deep sublittoral populations (50–67 m depth) were dominated by medium-sized colonies. Average and maximum colony heights were greater in the deeper populations, with these deeper populations also forming larger patch sizes and more extensive regions of continuous substrate coverage. These results suggest that shallow habitats are suitable for E. singularis, as shown by the high recruitment rate, but perturbations may limit or delay the development of these populations into a mature stage. This contrasts with the deep sublittoral habitats where higher environmental stability may allow the development of mature populations dominated by larger, sexually mature colonies.     

Survey of deep-dwelling red coral (<Emphasis Type="Italic">Corallium rubrum</Emphasis>) populations at Cap de Creus (NW Mediterranean)

The distribution and population structure of the eurybathic gorgonian Corallium rubrum were studied off Cap de Creus (Costa Brava, Northwestern Mediterranean Sea). Red coral is endemic to the Mediterranean Sea and the adjacent NE Atlantic coast, where it has been over exploited for centuries. This study presents, the first quantitative data on the spatial distribution and structure of a population extending between 50 (common SCUBA limits) and 230 m depth, and compared it with shallow populations previously studied in the same area. Different remotely operated vehicles (ROV) and two methodological approaches were employed during four cruises between 2002 and 2006: 1-Extensive surveys: sea to coast transects in which red coral density and patch frequency were recorded; 2-Intensive surveys, in which parameters describing colony morphology were recorded. Most of the hard substrate between 50 and 85 m depth was inhabited by red coral colonies, showing a patch frequency of 8.3 ± 7.9 SD patches per 100 m-transect (total transect area: 34 m²), and within-patch colony densities of 16–376 colonies m⁻² (mean of 43 ± 53 colonies m⁻²). Below 120 m depth red coral was less abundant, and rather than forming dense patches as in shallow water, isolated colonies were more common. The population structure differed between sites that are easily accessible to red coral fishermen, and remote ones (both at similar depth, 60–80 m), as colonies in easily accessible locations were smaller in height and diameter, and showed a less developed branching pattern. At shallower locations (10–50 m depth) the population structure was significantly different from those at deeper locations, due to the heavy harvesting pressure they are exposed to in the shallows. Twenty-five to forty-six percentage of the deeper colonies were taller than 6 cm, while only 7–16% of the shallow water colonies exceeded 6 cm colony height. Forty-six to seventy-nine percentage of the colonies in deeper waters were large enough to be legally harvested, while only 9–20% of the shallow water colonies met the 7 mm legal basal diameter to be collected. The branching pattern was also better developed in deeper colonies, as up to 16% of the colonies showed fourth order branches, compared to less than 1% of the shallow water colonies (of which 96% consisted of only one single branch). The results thus confirm that C. rubrum populations above 50 m depth are exposed to a higher harvesting intensity than deeper populations in the same area.     

Polychlorinated biphenyls in two mollusc species from the coast of Tenerife (Canary Islands, Spain)

Levels of PCBs were determined in two marine organisms, limpets (Patella ullisiponensis aspera) and winkles (Ossilinus atratus), sampled in three stations in the south east coast of Tenerife during 1993. Winkles and limpets exhibited different PCB patterns. Principal Component Analysis (PCA) was used to study the patterns and the relationships among PCBs.     

Influence of the operation conditions on CO2 capture by CaO-derived sorbents prepared from synthetic CaCO3

In this work, a statistical experimental design is performed in order to prepare CaCO₃ materials for use as CaO-based CO₂ sorbent precursors. The influence of different operational parameters such as synthesis temperature (ST), stirring rate (SR) and surfactant percent (SP) on CO₂ capture is studied by applying Response Surface Methodology (RSM). The samples were characterized using different analytical techniques including X-ray diffraction, N₂ adsorption isotherm analysis and Scanning Electron Microscopy–X-ray Energy Dispersive Spectroscopy (SEM-EDX). CO₂ capture capacity was determined by means of a thermogravimetric analyzer which recorded the mass uptake of the samples when these were exposed to a gas stream containing diluted (15%) CO₂. The statistical approach used in this work provides a rapid way of predicting and optimizing the main preparation variables of CaO-derived sorbents for CO₂ sorption. The results obtained clearly indicate that four parameters statistically influence CO₂ uptake: SR, the square of SR, its interaction with SP and the square of SP.     

Remote sensing as a tool for monitoring water quality parameters for Mediterranean Lakes of European Union water framework directive (WFD) and as a system of surveillance of cyanobacterial harmful algae blooms (SCyanoHABs)

Remote sensing has been used from the 1980s to study inland water quality. However, it was not until the beginning of the twenty-first century that CHRIS (an experimental multi-angle sensor with good spectral and spatial resolutions) and MERIS (with good temporal and spectral resolutions) started to acquire imagery with very good resolutions, which allowed to develop a reliable imagery acquisition system so as to consider remote sensing as an inland water management tool. This paper presents the methodology developed, from the field data acquisition with which to build a freshwater spectral library and the study of different atmospheric correction systems for CHRIS mode 2 and MERIS images, to the development of algorithms to determine chlorophyll-a and phycocyanin concentrations and bloom sites. All these algorithms allow determining water eutrophic and ecological states, apart from generating surveillance maps of toxic cyanobacteria with the main objective of Assessment of the Water Quality as it was used for Monitoring Ecological Water Quality in smallest Mediterranean Reservoirs integrated in the Intercalibration Exercise of European Union Water Framework Directive (WFD). We keep on using it to monitor the Ecological Quality Ratio (EQR) in Spain inland water.