NUTRIENT LOAD CHARACTERIZATION FROM INTEGRATED SOURCE DATA FOR THE LOWER MISSISSIPPI RWER1

ABSTRACT: Nutrient data from all available sources for the lower Mississippi River were examined for potential differences among sampling agencies and geographic locations for the period between 1960 and 1998. Monthly means grouped by parameter, sampling location and agency, were calculated and compared as paired sets, excluding those months where data were not available for both sets. Some significant differences were found between various agencies collecting nutrient data on the river, as well as between various stretches of river, especially in the case of phosphorus nutrient data. Results were used to synthesize data sets from which a history of nutrient loading in the Mississippi River was determined. General trends in nitrate+nitrite, total Kjeldahl nitrogen, orthophosphate, total phosphorus and silica loads, as well as changes in nutrient proportions and the specific limiting nutrient (by month) are reported. This study provides a useful summary of contemporary and historical nutrient data that may assist in the evaluation of Mississippi River water quality and its potential effect on the Gulf of Mexico.     

Evaluation of lime requirement tests for minesoils

Evaluation of twelve minesoils collected from restored or abandoned surface mines in eastern Kentucky with six standard lime requirement procedures showed that one of the procedures accurately forecasted long term lime requirements. The minesoils were then evaluated for potassium choloride-extractable aluminum using the Yang exchangeable acidity procedure. When the extractable A1³⁺ was multiplied by a factor of 2.24 it was found to also be an accurate measure for longterm limestone requirements. To bring the minesoil to pH 5.5 the results obtained using the modified Yuan procedure indicate that for each MEQ Al³⁺ extracted per 100 grams of minesoil 2.24 Mg of calcium carbonate (CaCO₃) equivalent lime per hectare be applied. Application of lime based on this procedure and one of the standard lime procedures resulted in pH stability of the minesoils for forty months.     

Variations in speciated emissions from spark-ignition and compression-ignition motor vehicles in California's south coast air basin

The U.S. Department of Energy Gasoline/Diesel PM Split Study examined the sources of uncertainties in using an organic compound-based chemical mass balance receptor model to quantify the contributions of spark-ignition (SI) and compression-ignition (CI) engine exhaust to ambient fine particulate matter (PM2.5). This paper presents the chemical composition profiles of SI and CI engine exhaust from the vehicle-testing portion of the study. Chemical analysis of source samples consisted of gravimetric mass, elements, ions, organic carbon (OC), and elemental carbon (EC) by the Interagency Monitoring of Protected Visual Environments (IMPROVE) and Speciation Trends Network (STN) thermal/optical methods, polycyclic aromatic hydrocarbons (PAHs), hopanes, steranes, alkanes, and polar organic compounds. More than half of the mass of carbonaceous particles emitted by heavy-duty diesel trucks was EC (IMPROVE) and emissions from SI vehicles contained predominantly OC. Although total carbon (TC) by the IMPROVE and STN protocols agreed well for all of the samples, the STN/IMPROVE ratios for EC from SI exhaust decreased with decreasing sample loading. SI vehicles, whether low or high emitters, emitted greater amounts of high-molecular-weight particulate PAHs (benzo[ghi]perylene, indeno[1,2,3-cd]pyrene, and coronene) than did CI vehicles. Diesel emissions contained higher abundances of two- to four-ring semivolatile PAHs. Diacids were emitted by CI vehicles but are also prevalent in secondary organic aerosols, so they cannot be considered unique tracers. Hopanes and steranes were present in lubricating oil with similar composition for both gasoline and diesel vehicles and were negligible in gasoline or diesel fuels. CI vehicles emitted greater total amounts of hopanes and steranes on a mass per mile basis, but abundances were comparable to SI exhaust normalized to TC emissions within measurement uncertainty. The combustion-produced high-molecular-weight PAHs were found in used gasoline motor oil but not in fresh oil and are negligible in used diesel engine oil. The contributions of lubrication oils to abundances of these PAHs in the exhaust were large in some cases and were variable with the age and consumption rate of the oil. These factors contributed to the observed variations in their abundances to total carbon or PM2.5 among the SI composition profiles.     

Benzene accumulation in horticultural crops

In this study apple, blackberry and cucumber crops were exposed to elevated levels of benzene under controlled conditions. Benzene was retained in fruits of all crops, but only accumulated in leaves of blackberries and apples. The retention by cucumber fruits is suggested to result from the longer pathway for the desorption of benzene as a consequence of their increased tissue depth compared to leaves. The process of accumulation in blackberry and apple leaves is unknown. The ingestion of benzene via the food-chain pathway on the basis of this study is concluded not to be significant.     

Constraints on temperature-dependent sex determination in the leopard gecko (<Emphasis Type="Italic">Eublepharis macularius</Emphasis>): response to Kratochvil et al.

Kratochvil et al. (Naturwissenschaften 95:209–215, 2008) reported recently that in the leopard gecko (Eublepharis macularius) of the family Eublepharidae with temperature-dependent sex determination (TSD), clutches in which eggs were incubated at the same temperature produce only same-sex siblings. Interpreting this result in light of studies of sex steroid hormone involvement in sex determination, they suggested that maternally derived yolk steroid hormones could constrain sex-determining mechanisms in TSD reptiles. We have worked extensively with this species and have routinely incubated clutches at constant temperatures. To test the consistency of high frequency same-sex clutches across different incubation temperatures, we examined our records of clutches at the University of Texas at Austin from 1992 to 2001. We observed that clutches in which eggs were incubated at the same incubation temperature produced mixed-sex clutches as well as same-sex clutches. Furthermore, cases in which eggs within a clutch were separated and incubated at different temperatures produced the expected number of mixed-sex clutches. These results suggest that maternal influences on sex determination are secondary relative to incubation temperature effects.     

Speciation studies on simulated gastro‐intestinal digests of foodstuffs†

The factors affecting the solubilisation of metals during digestion of food have been examined in a two‐stage model system comprising simulated gastric and intestinal juices. The solubilisation of iron, copper and zinc was examined in digests of white and wholemeal bread. Zinc solubility was principally governed by pH and the simulated digestion had little additional effect. In contrast both iron and copper solubility were markedly affected by digestion of the bread. In the case of copper the enzymolysis increased solubility appreciably at neutral pH. All of the cadmium in a simulated gastric digest of canned crab meat was associated with soluble low molecular weight species of less than 1000 daltons. Cadmium solubility resulted from the acidic conditions of the digest rather than enzymatic solubilisation of binding proteins. Ninety percent of the cadmium in the digest became rebound to the insoluble fraction on adjustment to pH7.0. Subsequent simulated intestinal digestion increased the level of soluble cadmium to 20%; 1.0–1.5% was associated with soluble species in the range 26,000–37,000 daltons and 15.0–20.0% with soluble species of less than 3,000 daltons.     

Bromine and iodine in 1997 UK total diet study samples

Concentrations of bromine and iodine were analysed in samples from the 1997 UK Total Diet Study (TDS) using ICP-MS. The data has been used to estimate dietary exposures of UK consumers to these elements from the typical UK diet. Samples for the 20 TDS food groups were obtained from 20 towns in the UK in 1997 and analysed in 1998/99 for total bromine and total iodine concentrations. These samples were also analysed for 12 other elements. The UK regulatory authority had considered iodine recently, but had not considered bromine before. This survey provides up-to-data baseline data for those two elements. Iodine concentrations are similar to those found in recent surveys. Levels of bromine were consistent with previous data where available. Dietary exposures to bromine and iodine were calculated to see if there were any risks to health from the levels of these elements found in the UK diet. The estimated population average exposure to iodine was 0.25 mg d-1, which is within the range of previous estimates (1995, 0.21 mg d-1; 1991, 0.17 mg d-1; 1985, 0.28 mg d-1). The estimated population average exposure to bromine was 3.6 mg d-1.