Determinants of Individual Attitudes Toward Animal Welfare-Friendly Food Products

Animal welfare involves societal and human values, ethical concerns and moral considerations since it incorporates the belief of what is right or what is wrong in animal treatment and care. This paper aims to ascertain whether the different dimensions of individual attitudes toward animal welfare in food choices may be characterized by general human values, as identified by Schwartz. For this purpose, an EU-wide survey was carried out, covering almost 2500 nationally representative individuals from five European countries. Compared with the previous literature this study shows a twofold novelty: (1) it develops a general framework to link individual enduring beliefs and attitudes toward animal welfare attributes in food choices; (2) the framework is analyzed within a broad-based cross-country study. Our empirical results prove that human values related to self-transcendence are strongly associated to overall animal welfare attitudes and especially to those explicitly related to food choices, while values related to the spheres of self-enhancement and conservatism are significantly associated to less sensitive attitudes to animal welfare. Moreover, our results appear to indicate that a determinant of animal welfarism in food choices is potentially associated to individual concerns regarding food safety issues.     

A Wind Tunnel Study of Gaseous Pollutants in City Street Canyons

Steady state mean concentrations of tracer gas were measured in a 400:1 scale model of an idealized city with variable geometry placed within a wind tunnel at various orientations to the mean flow for a free stream velocity of 6.8 ft/sec. The tracer gas was released from two parallel line sources to simulate lanes of traffic in an effort to quantify the persistence of pollution as well as the mean values realized at street levels. An aerodynamically rough turbulent boundary layer of neutral thermal stratification was employed to simulate the atmosphere. Values of concentration measured in the model city were converted to prototype concentrations in ppm and compared to National Ambient Air Quality Standards. It was shown that single isolated structures may cause favorable mixing of pollution downwind but very high concentrations exist in the immediate leeward vicinity of the building. Two favorable geometries for city blocks tested were found to reduce pedestrian exposure to pollution both near heavy traffic congestion and downwind. It was concluded that the pollutant dilution was controlled by the mean flow rather than by turbulent diffusion and that the lateral spread of the plume was slight as one proceeded downwind of the line source. The combination of favorable geometry and higher dilution velocities may bring pollution levels down to existing Air Quality Standards. The body of information presented in this paper should interest city planners and air quality monitoring personnel, as well as those researchers attempting to study and model flow in city street canyons. It provides order of magnitude estimates on pedestrian and office worker exposure to pollutants under a wide range of conditions.     

Epidemiology of occupational acute traumatic hand injuries: a literature review

The purpose of this review was to summarize the literature on occupational, acute, traumatic hand injury and suggest directions for future research. In 1996, the leading occupational injury treated in United States' hospital emergency departments was an acute hand injury (e.g. laceration, crush or fracture). These injuries affected 30% of an estimated 3.3 million injured workers (990,000). Cuts and lacerations of the fingers ranked third after back and leg strains in the number of lost workday cases in the USA in 1994. The incidence rate of hand injuries studied in seven manufacturing environments around the world ranged from 4 to 11 per 100 workers per year. Workers aged 24 years or less had the highest risk of hand injury. Men had higher rates of severe hand injury than women.Despite the high frequency and significant amount of lost work time associated with these injuries, they are poorly understood from an etiological perspective. There is only one case-control study of occupational hand injury in the literature. That study suggested an important role for both fixed (age) and transient risk factors (doing an unusual task) at the time of the injury. More analytic epidemiological research is needed to identify potentially modifiable risk or protective factors (e.g. glove use) for acute hand injuries. In this regard, the case-crossover design, a relatively new epidemiological approach using cases as their own controls, could prove an efficient method for determining transient, modifiable risk factors for acute, occupational hand injury.     

Trace metal levels in Prochilodus lineatus collected from the La Plata River, Argentina

Most of the industrial, urban and sewage discharges are released into the La Plata River, Argentina without any previous treatment. However, few works have investigated the extent of metal contamination. The aim of this study was to assess the levels of cadmium, copper, lead and zinc in liver and gills of adults Prochilodus lineatus collected from three sampling stations along the coast of the La Plata River: Berazategui, Berisso and Atalaya (from north to south). Samplings were performed during 2002 and 2004. Berazategui and Berisso were located nearby the main ducts that discharge the urban and domestic waste disposal from the cities of Buenos Aires and La Plata, respectively. The third station, Atalaya, was free of sewage discharges. Levels of cadmium and copper in liver were always higher than those found in gills. Instead, for lead and zinc, high levels were observed either in liver or gills, depending on the sampling station and the sampling period. In both tissues, the concentrations of metals did not differ significantly between male and female fish. In liver samples, the concentrations of cadmium, copper and zinc tended to increase from north to south. Instead, the levels of lead followed an opposite pattern. No clear tendencies were observed in gill samples. The data may be useful as reference levels of metal contaminants in P. lineatus, the most important fish species in the La Plata River system.     

Nitrogen oxides from waste incineration: control by selective non-catalytic reduction

An experimental study of the selective non-catalytic reduction (SNCR) process was carried out to determine the efficiency of NOx removal and NH3 mass balance, the NOx reducing reagent used. Experimental tests were conducted on a full-scale SNCR system installed in a hospital waste incineration plant. Anhydrous NH3 was injected at the boiler entrance for NOx removal. Ammonia was analyzed after each flue-gas treatment unit in order to establish its mass balance and NH3 slip in the stack gas was monitored as well. The effective fraction of NH3 for the thermal NOx reduction was calculated from measured values of injected and residual NH3. Results show that a NOx reduction efficiency in the range of 46.7-76.7% is possible at a NH3/NO molar ratio of 0.9-1.5. The fraction of NH3 used in NOx removal was found to decrease with rising NH3/NO molar ratio. The NH3 slip in the stack gas was very low, below permitted limits, even at the higher NH3 dosages used. No direct correlation was found between the NH3/NO molar ratio and the NH3 slip in the stack gas since the major part of the residual NH3 was converted into ammonium salts in the dry scrubbing reactor and subsequently collected in the fabric filter. Moreover, another fraction of NH3 was dissolved in the scrubbing liquor.     

Analysis of energy recovery potential using innovative technologies of waste gasification

In this paper, two alternative thermo-chemical processes for waste treatment were analysed: high temperature gasification and gasification associated to plasma process. The two processes were analysed from the thermodynamic point of view, trying to reconstruct two simplified models, using appropriate simulation tools and some support data from existing/planned plants, able to predict the energy recovery performances by process application. In order to carry out a comparative analysis, the same waste stream input was considered as input to the two models and the generated results were compared. The performances were compared with those that can be obtained from conventional combustion with energy recovery process by means of steam turbine cycle. Results are reported in terms of energy recovery performance indicators as overall energy efficiency, specific energy production per unit of mass of entering waste, primary energy source savings, specific carbon dioxide production.     

Technical and economical assessment of a multipurpose electric vehicle for farmers

The RAMseS project, under the European Commission's 6th Framework Program, is dedicated to the construction and test of low-power operations based on photovoltaic power and a multipurpose electric vehicle. In the present study, the life-cycle costs and economical indices for the vehicle during its life span were assessed, compared to those of a standard internal combustion engine vehicle (ICEV). The results indicated that the life-cycle costs for the RAMseS vehicle and the ICEV are the same for a fuel unit price of 1.8 €/L. Also, the levelized cost of energy (LCE) for the RAMseS vehicle, was found to be 2.13 €/kWh, while RAMseS LCE, without EV taken into account, was shown to be 0.62 €/kWh. The RAMseS payback period (PBP) without EV taken into account was calculated to be 9 years if the value of the produced energy becomes at least 0.35 €/kWh. Vehicles that use PV systems as their power source, such as RAMseS, will be economically effective for fuel costs higher than 1.8 €/L, but considering the environmental benefits that are provided in terms of external costs, they can be considered profitable even at lower fuel costs.     

Characterisation of major component leaching and buffering capacity of RDF incineration and gasification bottom ash in relation to reuse or disposal scenarios

Thermal treatment of refuse derived fuel (RDF) in waste-to-energy (WtE) plants is considered a promising solution to reduce waste volumes for disposal, while improving material and energy recovery from waste. Incineration is commonly applied for the energetic valorisation of RDF, although RDF gasification has also gained acceptance in recent years. In this study we focused on the environmental properties of bottom ash (BA) from an RDF incineration (RDF-I, operating temperature 850-1000 °C) and a RDF gasification plant (RDF-G, operating temperature 1200-1400 °C), by evaluating the total composition, mineralogy, buffering capacity, leaching behaviour (both at the material’s own pH and as a function of pH) of both types of slag. In addition, buffering capacity results and pH-dependence leaching concentrations of major components obtained for both types of BA were analysed by geochemical modelling. Experimental results showed that the total content of major components for the two types of BA was fairly similar and possibly related to the characteristics of the RDF feedstock. However, significant differences in the contents of trace metals and salts were observed for the two BA samples as a result of the different operating conditions (i.e. temperature) adopted by the two RDF thermal treatment plants. Mineralogy analysis showed in fact that the RDF-I slag consisted of an assemblage of several crystalline phases while the RDF-G slag was mainly made up by amorphous glassy phases. The leached concentrations of major components (e.g. Ca, Si) at the natural pH of each type of slag did not reflect their total contents as a result of the partial solubility of the minerals in which these components were chemically bound. In addition, comparison of total contents with leached concentrations of minor elements (e.g. Pb, Cu) showed no obvious relationship for the two types of BA. According to the compliance leaching test results, the RDF-G BA would meet the limits of the Italian legislation for reuse and the European acceptance criteria for inert waste landfilling. RDF-I BA instead would meet the European acceptance criteria for non hazardous waste landfilling. A new geochemical modelling approach was followed in order to predict the leaching behaviour of major components and the pH buffering capacity of the two types of slags on the basis of independent mineralogical information obtained by XRD analysis and the bulk composition of the slag. It was found that the combined use of data regarding the mineralogical characterization and the buffering capacity of the slag material can provide an independent estimate of both the identity and the amount of minerals that contribute to the leaching process. This new modelling approach suggests that only a limited amount of the mineral phases that control the pH, buffering capacity and major component leaching from the solid samples is available for leaching, at least on the time scale of the applied standard leaching tests. As such, the presented approach can contribute to gain insights for the identification of the types and amounts of minerals that control the leaching properties and pH buffering capacity of solid residues such as RDF incineration and gasification bottom ash.