Distribution of DDT and benzo[a]pyrene between water and dissolved organic matter in natural humic water

DDT and benzo[a]pyrene (BaP) were added both separately and as a mixture to filtered (0.22 μm) humic surface water samples. Following a contact time of 1 d, the fraction bound to dissolved organic matter and the freely dissolved part were separated by using reversed-phase octadecyl silica cartridges. The enriched solutes were analysed by gas chromatography-mass spectrometry in the selective ion monitoring (GC-MS/SIM) mode. Partition coefficients to dissolved organic matter, calculated on the basis of the recovery data, varied between 2.0 × 10⁴ and 6.6 × 10⁴ mL/g for BaP depending on the experimental conditions, whereas the corresponding values for DDT (0.6 × 10⁴ mL/g) showed no significant variation.     

Effects of aquatic humic substances on a hydrophobic ultrafiltration membrane

Natural humic surface water (pH 5.9), ion exchanged samples of the same water (pH 5.5), and aqueous solutions of isolated humic substances at pH 4.5, 5.5 and 6.5, respectively, were ultrafiltered (15°C, 0.5 bar) using hydrophobic polysulfone membranes (GR51) in a cross-flow flat sheet module. The used membrane did not completely retain natural organic matter from the surface water and the addition of complexing metals did not affect the retention any further. The changes which were induced in the membranes during each filtration run were studied by simultaneous streaming potential and flux measurements in 0.01 M KCl solutions. Zeta potentials were calculated based on the streaming potentials and the results showed changes towards more negative values for all the samples due to adsorption of organic matter onto the surface of the membrane pores. Humic acid affected the membrane charges more than fulvic acid. High ionic strength and low pH enhanced flux reduction and fouling. Filtration of natural waters caused more pore plugging and flux reduction than filtration of solutions of the isolated humic substances.