Content and bioconcentration factors of mercury by Parasol Mushroom Macrolepiota procera

The carpophores of Parasol Mushroom and underlying soil substrate collected from several unpolluted and spatially distant sites across Poland were examined to know content and bioconcentration potential of mercury by this species. The total mercury content of the caps of Parasol Mushroom for the particular sites ranged from 1.1 +/- 1.0 to 8.4 +/- 7.4 microg/g dry matter (total range from 0.05 to 22 microg/g dm), while in the stalks were from 0.53 +/- 0.27 to 6.8 +/- 7.1 microg/g dm (total range from 0.078 to 20 microg/g dm). A top soil layer (0-10 cm) showed baseline mercury concentration from 0.022 +/- 0.011 to 0.36 +/- 0.16 microg/g dm (total range from 0.010 to 0.54 microg/g dm). Parasol Mushroom is an effective mercury accumulator in the carpophores and bioconcentration factor (BCF) values of this element in the caps and depending on the sampling site ranged from 16 +/- 6 to 220 +/- 110 (total range from 0.52 to 470), while for the stalks were from 7.6 +/- 2.6 to 130 +/- 96 (total range from 0.52 to 340). It seems reasonable to state that tolerance (maximum allowable concentration) of the total mercury in a single cap of Parasol Mushroom at unpolluted areas should not exceed 25 microg/g dm. A value greater then 25 mu g/g dm will imply an elevated content due to site pollution problems. Nevertheless, knowledge on highly toxic methylmercury content and its fraction in the total mercury content of Parasol Mushroom is lacking.     

Determination of selected quaternary ammonium compounds by liquid chromatography with mass spectrometry. Part I. Application to surface, waste and indirect discharge water samples in Austria

A method for simultaneous quantitative determination of alkyl benzyl, dialkyl and trialkyl quaternary ammonium compounds (QACs) has been developed, validated and subsequently applied to real water samples in Austria. The method employs liquid-liquid extraction (LLE) followed by liquid chromatography/tandem mass spectrometry (LC-MS/MS), using electrospray ionization (ESI) in positive mode. The overall method quantification limits range from 4 to 19ng/L for the enrichment of 500mL water samples and analyte recoveries are between 80 and 99%. The method was applied to 62 of the respective water samples without filtration to avoid the loss of the analytes due to the high adsorption capacity of these compounds. Maxima in the mg/L range, especially in the wastewater of hospitals and laundries, could be detected for the selected target compounds.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Assessment of Metal Contamination in Doñana National Park (Spain) using Crayfish (Procamburus Clarkii)

Water quality assessment in the Aznalcollar area was attempted using multivariate methods based on heavy metal concentrations in red swamp crayfish (Procamburus clarkii). Trace levels of four heavy metals, copper (Cu), zinc (Zn), cadmium (Cd) and lead (Pb), were detected in crayfish from eleven different stations. Principal component analysis (PCA) highlighted a gradient of contamination between the sampling stations. Cluster analysis (CA) distinguished three groups of stations. Discriminant analysis also differentiated three groups. The group centroids of the first discriminant function were used to devise an index that varies according to the source of the crayfish. These standardized values are proposed for use as a water quality index. The ability of this index to successfully predict environmental quality was proved with random samples.     

The monitoring of cadmium,zinc and copper in the kidneys and liver of humans deceased in the region of Cracow (Poland)

Cadmium, zinc and copper levels were determined in the renal cortex and liver of 60 inhabitants of Cracow, Poland. Cadmium levels in the renal cortex were contained in broad limits of 5–176 g/g, mean 50.6 g/g (wet weight). Maximum levels were found in the age group of about 50–60 years. The levels were slightly higher in men (53 g/g) than in women (45 g/g), with no effect of location within the region. The levels in smokers (62 g/g) were much higher than in non-smokers (32 g/g). The above relations were less pronounced for cadmium levels in the liver. Whole body retention of cadmium followed the pattern of cadmium in renal cortex. The level of zinc in renal cortex reflected those of cadmium. A significant proportion of the population (54% in smokers, 9% in non-smokers) showed cadmium levels in renal cortex exceeding the reference level of 50 g/g recently accepted for general population. In the view of the authors the exposure to cadmium of the population of Cracow is excessive and calls for attention.The study was performed under a KBN grant No 40106 91 01.     

Environmental assessment of supercritical water oxidation of sewage sludge

Environmental aspects of using supercritical water oxidation (SCWO) to treat sewage sludge were studied using a life cycle assessment (LCA) methodology. The system studied is the first commercial scale SCWO plant for sewage sludge in the world, treating sludge from the municipal wastewater treatment facility in Harlingen, TX, USA. The environmental impacts were evaluated using three specific environmental attributes: global warming potential (GWP), photo-oxidant creation potential (POCP) and resource depletion; as well as two single point indicators: EPS2000 and EcoIndicator99. The LCA results show that for the described process, gas-fired preheating of the sludge is the major contributor to environmental impacts, and emissions from generating electricity for pumping and for oxygen production are also important. Overall, SCWO processing of undigested sewage sludge is an environmentally attractive technology, particularly when heat is recovered from the process. Energy-conserving measures and recovery of excess oxygen from the SCWO process should be considered for improving the sustainability potential.     

Assessment of aluminum bioavailability in alum sludge for agricultural utilization

Inorganic aluminum ions, [Al(H₂O)₆]³⁺, [Al(OH)(H₂O)₅]²⁺, and [Al(OH)₂(H₂O)₄]⁺, are toxic to a number of crops. The aim of this study was to estimate the danger of soil contamination of bioavailable aluminum and heavy metals forms because of alum sludge which was a by-product of water, and wastewater treatment technology using aluminum coagulant is introduced into the soil. Aluminum and selected heavy metal fractionation was carried out in the post-coagulation sludge collected at a water treatment plant (where aluminum was used as a coagulant), fermented sewage sludge at a municipal wastewater treatment plant (which did not apply aluminum coagulant), and soil from water treatment plant as well as the mixtures of sludge and soil. It has been found that post-coagulation sludge used as natural fertilizer is a secondary source of bioavailable aluminum, especially when aluminum coagulants are used during water and wastewater treatment. The evaluation of applicability of the sludge to very weak acidic and acidic agricultural soils was carried out. The authors shall debate the question whether, in this case, the Regulation of EU and Polish Government on sewage sludge should also take the bioavailable aluminum into account and add to the list of the elements whose allowable contents are limited.     

Socio-cultural valuation of ecosystem services in a transhumance social-ecological network

The ecosystem services framework is receiving increasing attention in the fields of policy and research. The assessment of human attitudes and perceptions regarding ecosystem services has been proposed as a promising tool for addressing complex problems associated with environmental change, particularly in the context of cultural landscapes. Transhumance is not only a farming practice responsible for shaping cultural landscapes but also an adaptive strategy based on mobility that may represent a useful approach to overcoming the growing challenges posed by accelerated environmental change. A socio-cultural valuation of ecosystem services associated with the Conquense Drove Road, one of the major transhumant networks still in use in Mediterranean Spain, was conducted via the distribution of questionnaires to 416 local residents and visitors to capture their perceptions regarding the importance of 34 ecosystem services (10 provisioning, 12 regulating, and 12 cultural) for both social and personal well-being. Overall, the ecosystem services considered to be the most important for social well-being were fire prevention, air purification and livestock. Most of the ecosystem services in question were perceived as declining, with the exception of those associated with recreation, scientific knowledge and environmental education. This study revealed that perceptions regarding the value of ecosystem services differed among respondents, depending on their age, place of origin and gender. Several methodological issues, as well as the implications of socio-cultural valuation for policy making, are also discussed here.     

The application of regenerable sorbents for mercury capture in gas phase

Mercury is a well-known toxic element, and flue gas streams emitted from coal-fired utilities are one of the largest anthropogenic sources of this element. This study briefly reviews the proposed technologies for reducing mercury emissions from coal combustion, focusing on an emerging process which involves the use of regenerable sorbents and especially those loaded with noble metals. Among the mercury species formed during coal combustion, elemental mercury is the most difficult to remove from the flue gases due to its low reactivity and insolubility in water. The widespread interest in using regenerable sorbents with metals is due to their ability to retain elemental mercury. With this technology, not only can efficiencies of 100 % be reached in the retention of elemental mercury but also a way to avoid the generation of new wastes loaded with mercury. This study considers the main aspects that must be taken into account when developing effective regenerable sorbents for mercury capture, with special attention to sorbents containing noble metals. The characteristics of this process are compared with those of other processes in a more advanced state of development.