Effect of different design aspects of pipe for earth air tunnel heat exchanger system: A state of art

Earth air tunnel heat exchanger (EATHE) is a promising passive technique to provide thermal comfort condition in buildings. EATHE system uses undisturbed temperature of the ground for heating/cooling of air. Despite the several advantages, this technique has not become much popular owing to its high capital cost (mainly pipe cost and trench excavation cost) and large land area requirements. The primary objective of this study is to present a comprehensive review of different EATHE pipe layouts, pipe properties and positioning of the pipe with their advantages and limitations. It is observed that the ring pipe layout is the most cost-effective pipe-layout for small size EATHE system because it saves excavation cost by using a trench of the existing foundation of the building. However, Grid pipe-layout is an ideal layout for a large size EATHE system. Multi-layer pipe layouts should be used to reduce the land area requirement significantly. Moreover, EATHE system can be installed beneath the building (under building foot-print) to eliminate extra land area requirement for the installation of EATHE system. This review article shows that the Initial capital cost and land area requirement for the EATHE system can be substantially reduced by using appropriate pipe layout. It can be concluded that if EATHE system is installed with proper design strategies, it will be a clean and cost-effective method for building heating/cooling with significant power savings.     

Pet Waste Management by Chemical Recycling: A Review

The paper reviews the problem due to the use and disposal of synthetic polymers to the environment and its solutions; in particular poly (ethylene terphthalate). Wide spread application and non-biodegradability of the PET creates huge amounts of waste and disposal, tend to a serious problem. The most important cause for recycling and reprocessing the waste PET has arisen from the awareness and concern for environmental pollution. To manage this various methods of polymer recycling has been proposed. Among them chemical recycling, i.e. hydrolysis, methanolysis, glycolysis and aminolysis are reviewed in detail. Appropriate technology and waste disposal procedures based on the socio-economic aspect to solve this problem are suggested.     

Phytoremedial assessment of flora tolerant to heavy metals in the contaminated soils of an abandoned Pb mine in Central Portugal

Significant accumulation of heavy metals in soils and flora exists around the abandoned Barbadalhos Pb mine in Central Portugal. Soil and plant samples [49 species] were collected from two line transects, LT 1 and LT 2, in the mineralized and non-mineralized area, respectively to gain a comprehensive picture of heavy metals in soils and flora to assess its potential for phytoremediation. Phytosociological inventories of the vegetation were made using the Braun-Blanquet cover-abundance scale. Metal concentrations in soil ranged from (in mg kg^?1): 98–9330 [Pb], 110–517 [Zn], 7.1–50 [Co], 69–123 [Cr], 31–193 [Cu], 33 400–98 500 [Fe], 7.7–51 [Ni], 0.95–13 [Ag], 2.8–208 [As], and 71–2220 [Mn] along LT 1; and 24–93 [Pb], 30–162 [Zn], 3.7–34 [Co], 61–196 [Cr], 21–46 [Cu], 24 100–59 400 [Fe], 17–87 [Ni], 0.71–1.9 [Ag], 4.3–12 [As], and 44–1800 [Mn] along LT 2. Plant metal content ranged from (in mg kg^?1): 1.11–548 [Pb], 7.06–1020 [Zn], 0.08–2.09 [Co], 0.09–2.03 [Cr], 2.63–38.5 [Cu], 10.4–4450 [Fe], 0.38–8.9 [Ni], and 0.03–1.9 [Ag] along LT 1; and 0.94–11.58 [Pb], 2.83–96.5 [Zn], 0.12–1.44 [Co], 0.21–1.49 [Cr], 1.61–22.7 [Cu], 4.6–2050 [Fe], 0.51–4.81 [Ni], and 0.02–0.31 [Ag] along LT 2. Plants with highest uptake of metals were: Cistus salvifolius (548 mg Pb kg^?1), Digitalis purpurea (1017 mg Zn kg^?1 and 4450 mg Fe kg^?1). Mentha suavolens and Ruscus ulmifolius were seen to hyperaccumulate Ag (1.9 and 1 mg Ag kg^?1, respectively). More metals and higher concentrations were traced in plants from LT 1, especially for Pb and Zn.     

Predicting the distributional range shifts of Rhizocarpon geographicum (L.) DC. in Indian Himalayan Region under future climate scenarios

Environmental Science and Pollution Research - Himalaya, the highest mountain system in the world and house of important biodiversity hotspot, is sensitive to projected warming by climate change....     

Organochlorine pesticide contamination of ground water in the city of Hyderabad

Organochlorine pesticides are ubiquitous and persistent organic pollutants used widely throughout the world. Due to the extensive use in agriculture, organic environmental contaminants such as HCH, DDT along with other organochlorine pesticides are distributed globally by transport through air and water. The main aim of present study is to determine contamination levels of organochlorine pesticides in the ground water of Hyderabad City. Water samples were collected from 28 domestic well supplies of the city. For this study, random sampling technique was applied, all the samples were collected in high purity glass bottles and refrigerated at 4 degrees C until analysis. Solid Phase Extraction (SPE) is used for the extraction of organochlorine pesticide residues in water sample. The collected water samples were pre-filtered through a 0.45 microg glass fiber filter (Wattman GF/F) to remove particulate matter and were acidified with hydrochloric acid (6N) to pH 2.5. Methanol modifier (BDH, for pesticide residue analysis, 10 mL) was added to water sample for better extraction. SPE using pre-packed reversed phase octadecyl (C-18 bonded silica) contained in cartridges was used for sample preparation. Prior to the extraction, the C-18 bonded phase, which contains 500 mg of bonded phase, was washed with 20 mL methanol. The sample was mixed well and allowed to percolate through the cartridges with flow rate of 10-15 mL/min under vacuum. After sample extraction, suction continued for 15 min to dry the packing material and pesticides trapped in the C-18 bonded phases were eluted by passing 10 mL hexane and fraction was evaporated in a gentle steam of Nitrogen. In all samples pesticide residues were analyzed by GC (Chemito-8510) with Ni63 ECD detector. Helium was used as carrier gas and nitrogen was used as make up gas. The injection technique was split/split less. All the samples analyzed were found to be contaminated with four pesticides i.e. DDT, beta-Endosulfan, alpha-Endosulfan and Lindane. DDT was found to range between 0.15 and 0.19 microg L(-1), beta-Endosulfan ranges between 0.21 and 0.87 microg L(-1), alpha-Endosulfan ranges between 1.34 and 2.14 microg L(-1) and Lindane ranges between 0.68 and 1.38 microg L(-1) respectively. These concentrations of pesticides in the water samples were found to be above their respective Acceptable Daily Intake (ADI) values for Humans.     

Monitoring of Organochlorine Pesticide Residues in Summer and Winter Vegetables from Agra, India – A case study

Analysis of summer and winter vegetable samples during 2002–2003 for pesticidal contamination was carried out on Gas Chromatograph-Electron Capture Detector with capillary columns. The contamination levels of winter vegetables (average concentration of 4.57, 6.80 and 5.47 ppb respectively for Lindane, Endosulphan and DDT) were found to be slightly higher than the summer vegetables (average concentration of 4.47, 3.14 and 2.82 ppb respectively for Lindane, Endosulphan and DDT). The concentration of these organochlorine pesticides in summer and winter vegetables were well below the established tolerances but continuous consumption of such vegetables even with moderate contamination level can accumulate in the receptor's body and may lead to chronic effects that could be fatal.     

Metal contamination of soils and plants associated with the glass industry in North Central India: prospects of phytoremediation

Introduction  

The effect of the glass industry on urban soil metal characterization was assessed in the area of Firozabad, India. A comprehensive profile of metal contamination was obtained in five zones each containing five specific sites.     

Bioassay as monitoring system for lead phytoremediation through Crinum asiaticum L.

Toxicity of lead in soil is well documented and established. Phytoremediation has gained attention as a cheap, easily applicable, and eco-friendly clean-up technology. Chemical methods are used to assess exact levels and type of pollutants but heavy metal content in soil can also be evaluated indirectly by estimation of phytotoxicity levels using bioassays. Plant bioassays through fast germinating cereals can indicate not only the level of pollution and its effects on growth and survival but also the progress of phytoremediation process. The performance of barley Hordeum vulgare L. seedlings as bioassay for assessment of changes in the levels of lead (Pb) at three concentrations, i.e., 300 (T₁), 600 (T₂), and 1,200 ppm (T₃) in the soil was evaluated while testing the efficiency of Crinum asiaticum L. as a phytoremedial tool. At the first assessment, i.e., 30 DAT (days after treatment) shoot and root lengths of seedlings decreased with increasing concentrations of Pb. As the study progressed, a decrease in levels of Pb was accompanied by better germinability and growth of barley. At 120 DAT seedling growth in all the treatments were comparable to control. In T₁, T₂, and T₃ soils, 74.5%, 83.7%, and 91.2% reduction in lead content was observed at 120 DAT. Highly significant correlations between decreasing pollutant (Pb) content in the soil, seed germination, and seedling growth of barley H. vulgare were found. The differences in root and shoot length as well as overall growth pattern are indicative of the suitability of barley as a bio-monitoring tool.     

Contamination of vegetables of different seasons with organophosphorous pesticides and related health risk assessment in northern India

India is an agrarian country. The use of pesticides, herbicides and fungicides were introduced in India during the mid-sixties, which are now being used on a large scale and is a common feature of Indian agriculture. The main intention of the introduction of pesticides was to prevent and control insects, pests and diseases in the field crops. Initially the use of pesticides reduced pest attack and paved way for increasing the crop yield as expected. Simultaneously, increased use of chemical pesticides has resulted in contamination of environment and also caused many long-term affect on the society. In the present study an effort has been made to evaluate the residual concentration of selected organophosphorous pesticides (methyl parathion, chlorpyriphos and malathion) in vegetables grown in different seasons (summer, rainy and winter). Data obtained was then used for estimating the potential health risk associated with the exposure to these pesticides. The pesticides residue concentrations in vegetables of different season shows that the winter vegetables are the most contaminated followed by summer and rainy vegetables. The concentration of the various pesticides were well below the established tolerances but continuous consumption of such vegetables even with moderate contamination level can accumulate in the receptor's body and may prove fatal for human population in the long term. The analysis of health risk estimates indicated that chlorpyriphos and malathion did not poses a direct hazard, however, exposure to methyl parathion has been found to pose some risk to human health.