Heterogeneous photocatalytic degradation of pesticides using decatungstate intercalated macroporous layered double hydroxides

Decatungstate W₁₀O₃₂ ^4? was efficiently intercalated between the layers of three-dimensionally ordered macroporous Mg₂Al-layered double hydroxide. The structural and textural properties of as-prepared intercalated compound were characterized using different solid-state characterization techniques such as X-ray powder diffraction, FTIR and Raman spectroscopies and electronic microscopy. The photocatalytic properties of immobilized W₁₀O₃₂ ^4? within Mg₂Al structure were investigated using 2-(1-naphthyl) acetamide (NAD) as a model of pesticide. The influence of different parameters such as amount of catalyst, pH and oxygen concentration were investigated. An optimal NAD degradation was obtained for a photocatalyst concentration of 60 mg l^?1. Under our experimental conditions, this heterogeneous photocatalyst induces photodegradation of 60 % of NAD after 17 h of irradiation at 365 nm and at pH 6.6. Interestingly, pesticide photodegradation leads to the mineralization of substrates to H₂O and CO₂ and the photocatalyst can be recycled and reused without any loss of activity over four cycles.     

Removal and degradation of aromatic compounds from a highly polluted site by coupling soil washing with photocatalysis

The possible application of two environmental remediation technologies - soil washing and photocatalysis - to remove and decompose various aromatic pollutants present in excavated soils of a contaminated industrial site has been investigated. Aqueous solutions containing the non-ionic surfactant Brij 35 were used to extract the contaminants from the soil samples. The photocatalytic treatment of the obtained washing wastes, performed in the presence of TiO(2) suspensions irradiated with simulated sunlight, showed a slow abatement of the toxic compounds due to the relevant concentrations of organics in the waste. A neat improvement of the process performances, obtained by operating in the presence of added potassium peroxydisulfate, suggests a feasible treatment route.     

Vacuum-ultraviolet (VUV) photolysis of water: Mineralization of atrazine

The versatility and efficiency of the VUV photolysis of water as an “Advanced Oxidation Procedure” for the light-induced oxidative degradation of atrazine as a pollutant of surface and ground waters is evaluated. The oxidation of atrazine using TiO₂ as a photocatalyst has been reported to produce almost stoichiometric amounts of cyanuric acid. Mineralization to CO₂, water and inorganic nitrogen containing ions occurred to a very low extent implying that cyanuric acid is resistant to further degradation under the chosen experimental conditions. Our present results show that in oxygen saturated solutions 50% of the initial atrazine is converted to cyanuric acid, whereas only 10% of the initial atrazine is isolated as cyanuric acid in argon saturated solutions. The results indicate that mineralization is more efficient in not strictly oxidative reaction media.     

Photocatalytic degradation of bentazone in soil washing wastes containing alkylpolyoxyethylene surfactants

Three alkylpolyoxyethylene surfactants bearing the same hydrophobic chain and a different number of oxyethylene groups were investigated as suitable candidates for the soil washing treatment of contaminated soil samples containing bentazone. Comparable good recoveries of the pesticide were obtained working with these surfactants. The photocatalytic treatment of the collected washing wastes, performed in the presence of suspended TiO₂ particles under irradiation with simulated sunlight, leads to the effective degradation of bentazone residues after a time depending on the nature and concentration of the chosen amphiphile. Brij 35 was found to be the best surfactant candidate, giving the faster abatement of the pesticide in the collected wastes. The overall treatment time depends on the bentazone mineralization kinetics, markedly slow in the presence of surfactants. Useful information about the photocatalytic degradation route was obtained from the HPLC-MS analysis of transient intermediates formed in water.     

Why air quality in the Alps remains a matter of concern. The impact of organic pollutants in the alpine area

In the middle of Europe, the Alps form a geographical and meteorological trap for atmospheric pollutants including volatile and semi-volatile organic compounds emitted in the surrounding lowlands. This is due to their barrier effects, high precipitation rates, and low ambient temperatures. Also the pollutants emitted in the cities inside the Alps spread in the region depending on orographic and meteorological conditions. Although a number of studies on the distribution and effect of pollutants in the Alps has been published, comprehensive information on potential hazards, and ways to improve this sensible environment are lacking. This opinion paper is the result of a discussion during the Winterseminar of the AlpsBioCluster project in Munich. It summarizes the current literature and presents some case studies on local pollution sources in the Alps, and the possibility of using biomonitoring techniques to assess critical pollution loads and distributions.     

Intermediate distributions and primary yields of phenolic products in nitrobenzene degradation by Fenton's reagent

Nitrobenzene thermal degradation was investigated using the Fenton reagent in different experimental conditions. Reaction products were analyzed by HPLC, GC-MS, LC-MS and IC. The products obtained at different nitrobenzene conversion degrees show that degradation mainly involves successive hydroxylation steps of the aromatic ring and its subsequent opening followed by oxidation of corresponding aliphatic compounds. Our results show as primary reaction products: 4-nitrophenol, 3-nitrophenol, 2-nitrophenol, phenol and 1,3-dinitrobenzene, indicating that both hydroxylation and nitration reactions are involved. The formation of phenolic products can be explained by postulating an initial step of HO() addition to nitrobenzene ring. The mechanisms of primary reaction pathways are discussed and a detailed kinetic analysis to obtain the true primary yields of phenolic products is proposed. The relative yields observed for nitrophenol isomers do not follow the expected orientation according to deactivating characteristics of the nitro group but significantly depend on Fe(+2), Fe(+3), H(2)O(2) and O(2) concentrations. The understanding of the effect of reaction conditions on the relative product distribution benefits the application of Fenton and Fenton-like systems to waste water treatment.     

Removal of alkylphenols from polluted sites using surfactant-assisted soil washing and photocatalysis

Background and purpose  

Surfactant-assisted soil washing and photocatalysis are well-known remediation processes of environmental concern. The application of photocatalysis to treat soil washing extracts containing 4-methylphenol, 4-ethylphenol and 4–tert-butylphenol in the presence of nonionic (C₁₂E₈ and C₁₂E₂₃) and anionic (SDS) surfactants and some of their binary mixtures was investigated in this work by studying the pollutants degradation in the presence of TiO₂ dispersions irradiated with simulated solar light.     

Photocatalytic degradation of chlorophenols in soil washing wastes containing Brij 35. Correlation between the degradation kinetics and the pollutants–micelle binding

The photocatalytic degradations of 4-chlorophenol (CP), 4-chloro-2-methylphenol (CMP), 4-chloro-3,5-dimethylphenol (CDMP) and 4-chloro-2-isopropyl-5-methylphenol (CIMP) were investigated in water and in simulated soil washing wastes containing Brij 35 (polyoxyethylene(23)dodecyl ether) in the presence of TiO₂ dispersions. A neat inhibition of substrate decomposition proportional to their growing hydrophobicity was observed in the washing wastes for CP, CMP and CDMP, whereas CIMP showed a different behaviour. The mineralization of the organic chlorine of CP and CIMP was relatively fast and complete, whereas it was much slower for CMP and CDMP. Micellar solubilization and substrate adsorption onto the semiconductor play opposite roles on the degradation kinetics, and a breakpoint between the corresponding induced effects was evidenced when the pollutants become completely bound to the micellar aggregates.     

Photocatalytic behavior of nanosized TiO2 immobilized on layered double hydroxides by delamination/restacking process

Introduction

Efficient immobilization of TiO₂ nanoparticles on the surface of Mg₂Al-LDH nanosheets was performed by delamination/restacking process.

Experimental part

The structural and textural properties of as-prepared nanocomposite were deeply analyzed using different solid-state characterization techniques such as: X-ray powder diffraction, Fourier transform infrared spectroscopy, and Raman spectroscopies, chemical analysis, X-ray photoelecton spectroscopy, N₂ adsorption?Cdesorption, and electronic microscopy.

Results and discussion

The photocatalytic properties of immobilized TiO₂ nanoparticles on Mg₂Al were investigated using the photodegradation of two model pollutants: Orange II and 4-chlorophenol, and compared with pure colloidal TiO₂ solution.

Conclusion

It appears that Orange II photodegradation was systematically faster and more efficient than 4-chlorophenol photodegradation regardless of the medium pH. Moreover under slightly basic conditions, even if the TiO₂ photocatalytic efficiency decreases, photodegradation performed in presence of easily recovered TiO₂/Mg₂Al_1.5 nanocomposite gives rise to comparable or better results than pure TiO₂.