ASM1耦合曝气模型对污水处理厂的模拟研究

为了更好地模拟污水处理厂实际的曝气方式及溶解氧浓度,采用更加精确的曝气模型对某污水处理厂进行了模拟研究.该模型考虑了污泥浓度、堵塞及温度等因素对氧传质的影响,并将该曝气模型与ASM1相耦合.首先,通过灵敏度分析确定了对该污水处理厂出水指标影响较大的参数,分别为异养菌产率系数YH、异养菌最大比增长速率μH、自养菌最大比增长速率μA及自养菌氧利用半饱和系数KOA.然后,测定部分灵敏度较高的参数并使用测量结果对模型进行校正,校正结果使用希尔系数表征.最后,使用另一批数据对校正参数进行验证.模拟的COD、氨氮、总氮和好氧池末端溶解氧的希尔不等系数分别是0.13、0.23、0.20和0.15,而通过控制溶解氧浓度或理论氧转移效率模型模拟则出现氨氮、溶解氧、总氮及COD的希尔不等系数不同程度上升的结果.校验后的ASM1/曝气耦合模型参数可以很好地应用于污水处理厂的模拟当中,对于优化污水厂曝气控制具有重要意义.     

土霉素对SBR系统细菌的抑制效应与机制研究

基于SBR系统,从脱氮过程、化学需氧量(COD)的去除过程、胞外聚合物(EPS)的总量变化过程、比呼吸速率(SOUR)的变化过程及微生物群落的变化等多个角度出发,较系统地研究了不同浓度土霉素对SBR系统的冲击作用.结果表明,由于土霉素(OTC)的作用,系统氨氮去除率从空白对照组的99.0%分别下降至77.2%(OTC 1 mg·L~(-1))、47.4%(OTC 5 mg·L~(-1))及10.0%(OTC 10 mg·L~(-1)).此外,高浓度土霉素(10mg·L~(-1))引起EPS分泌量和异养菌SOUR分别下降至空白组的44.3%和41.2%.由高通量分析可得,由于高浓度土霉素(5 mg·L~(-1)以上)的作用,活性污泥中微生物的多样性显著下降,且微生物的群落结构也发生显著变化.属层面的分析可得,高浓度土霉素(5 mg·L~(-1)以上)反应器中的部分氨氧化菌,如Nitrospira和Nitrosomonas均受到了抑制.     

氧化-混凝法处理碱性高砷废水的实验研究

对碱性高砷废水的处理进行了研究 ,针对常规混凝法除砷的缺点提出了氧化 混凝工艺。结果表明 ,用氧化 混凝工艺除砷效果显著 ,废水经处理后砷含量低于 0 5mg/L ,符合国家排放标准。氧化 混凝除砷的最佳工艺条件为 :pH值为 6— 7,H2 O2 用量为 2 5 % ,氧化时间为 10min ,Fe2 (SO4) 3 用量为 2 5g/L ,PAM用量为 11 2 5mg/L。     

全耦合活性污泥模型(FCASM3)Ⅰ:建模机理及数学表征

在充分分析活性污泥系统中生物反应机理的基础上,建立了活性污泥系统生物去除营养物质的细观机理模型--全耦合活性污泥模型(Fully Coupled Activated Sludge Model No.3,简称FCASM3).FCASM3将系统中微生物划分为8类菌群,包含31种组分、72个子过程;该模型的主要特点是将活性污泥系统中的微生物进一步细化,充分考虑了系统中微生物间的相互作用.FCASM3引入了硝化-反硝化过程中的中间产物亚硝酸盐.实现了对两步硝化-反硝化过程的模拟;FCASM3不仅包含聚糖菌的有关生物反应过程,而且还考虑了聚磷菌(非反硝化聚磷菌和反硝化聚磷菌)以及聚糖菌的厌氧维持过程,为直接体现温度对生物反应的影响,FCASM3将温度作为一个变量直接耦合到生物反应速率方程中.     

全耦合活性污泥模型(FCASM3)Ⅱ:模型校验

以采用AAO污水处理工艺的德清县狮山污水处理厂作为全耦合活性污泥模型(FCASM3)校验的现场试验基地,分别进行了常规水质指标测定和进水水质特征分析等试验研究,依据现场试验结果,完成了对活性污泥系统生物去除营养物质细观机理模型FCASM3的校验工作,动态校验结果表明,FCASM3模型可以对AAO连续流工艺系统实现较准确的细观模拟,营养物质生物去除过程的动态数值模拟结果与实测结果相一致.     

Diphenylarsinic acid sorption mechanisms in soils using batch experiments and EXAFS spectroscopy

• DPAA sorption data was found to fit the Freundlich equation. • K_f was significantly positive correlated with oxalate-extractable Fe₂O₃. • Ligand exchange was the main mechanism for DPAA sorption on soils. • Bidentate binuclear and monodentate mononuclear DPAA bonds were identified. Diphenylarsinic acid (DPAA) is a phenyl arsenic compound derived from chemical warfare weapons. Macroscopic and microscopic work on DPAA sorption will provide useful information in predicting the partitioning and mobility of DPAA in the soil-water environment. Here, batch experiments and extended X-ray absorption fine structure (EXAFS) spectroscopy were used to investigate the sorption mechanisms of DPAA. The DPAA sorption data from 11 soil types was found to fit the Freundlich equation, and the sorption capacity, K_f, was significantly and positively correlated with oxalate-extractable Fe₂O₃. The K_f values of eight of the 11 untreated soils (1.51–113.04) significantly decreased upon removal of amorphous metal (hydr)oxides (0.51–13.37). When both amorphous and crystalline metal (hydr)oxides were removed from the untreated soils, the K_f values either decreased or slightly increased (0.65–3.09). Subsequent removal of soil organic matter from these amorphous and crystalline metal (hydr)oxide-depleted samples led to further decreases in K_f to 0.02–1.38, with only one exception (Sulfic Aquic-Orthic Halosols). These findings strongly suggest that ligand exchange reactions with amorphous metal (hydr)oxides contribute most to DPAA sorption on soils. EXAFS data provide further evidence that DPAA primarily formed bidentate binuclear (²C) and monodentate mononuclear (¹V) coring-sharing complexes with As-Fe distances of 3.34 and 3.66 Å, respectively, on Fe (hydr)oxides. Comparison of these results with earlier studies suggests that ²C and ¹V complexes of DPAA may be favored under low and high surface coverages, respectively, with the formation of ¹V bonds possibly conserving the sorption sites or decreasing the steric hindrance derived from phenyl substituents.     

偶氮染料酸性橙7脱色菌的分离、鉴定及其脱色性能研究

从活性污泥中筛选得到一株对偶氮染料酸性橙7(Acid Orange 7)具有高效脱色功能的菌株,根据16S rRNA基因序列分析鉴定,该菌属于嗜水气单胞菌属,将其命名为Aeromonas hydrophila strain JL-1.同时,研究了该菌株对偶氮染料酸性橙7的最佳脱色条件,结果表明,菌株JL-1在缺氧振荡培养条件下能对偶氮染料酸性橙7进行有效脱色;培养基、初始染料浓度、接种量、pH和NaCl浓度等环境条件对菌株JL-1脱色性能及其生长有明显影响.pH为5.0、盐度为10%、温度为30℃、转速为150 r·min~(-1)的LB(Luria-Bertani medium)培养基为菌株JL-1最佳的脱色及生长环境;在此最佳环境条件下,菌株JL-1对100 mg·L~(-1)的偶氮染料AO7在8 h的脱色率高达95%.另外,该菌株耐盐性良好,能在高达30%盐度下依然可以进行有效的生物脱色.     

Effect of copper tolerant Elsholtzia splendens on bacterial community associated with Commelina communis on a copper mine spoil

Facilitation, or positive plant–plant interaction, has received increasing concern from ecologists over the last two decades. Facilitation may occur through direct mitigation of severe environments or indirect mediation by a third participant from the same or different trophic levels. The copper(Cu) tolerant species Elsholtzia splendens facilitates the establishment and growth of co-occurring Commelina communis through indirect enrichment of microbial activity. However, whether and how E. splendens impacts the microbial community that is associated with C. communis is less known. We characterized the soil bacterial community in the rhizosphere of C. communis in the absence and presence of E.splendens using PCR-DGGE(polymerase chain reaction-denaturing gradient gel electrophoresis) and sequencing. The result showed that the richness of the bacterial community increased, but diversity and evenness remained similar, in the presence of E. splendens.Chloroflexi, Acidobacteria and Proteobacteria were the most dominant bacteria. The relative abundance of dominant and minor bacterial groups showed distinctly different responses to E. splendens. Principal component analysis and redundancy analysis indicated that variation of the bacterial community was determined by multiple factors and might be driven by the tested soil parameters collectively, or alternatively changed through plant root exudates or other microorganisms. Our results enhance the understanding of how the bacterial community associated with a beneficiary plant responds to a benefactor plant and suggests that the changes of bacterial community composition may have far-reaching influence on plant–soil feedback and the aboveground plant community in the long run.     

不锈钢冷轧重金属污泥的处理与利用对策

不锈钢冷轧重金属污泥成分复杂、产量大、危害严重,已成为不锈钢企业环保治理的难点,目前国内外尚无妥善安全、经济实用的大宗利用途径。针对不锈钢冷轧酸洗废水的来源和特点,提出了一条污泥源头减量、废水两段处理、污泥分段回收的技术路线,由此得到的前段重金属污泥,利用途径可参考含铁尘泥,用作转炉造渣剂、烧结原料、球团矿、生产直接还原铁或其他高附加值产品;后段含以CaSO4,CaF2为主的钙盐污泥,利用途径可参考氟石膏,用作水泥矿化剂、建材原料或冶金辅料。     

钢铁工业含铁尘泥的资源化利用现状与发展方向

含铁尘泥是钢铁生产过程中从不同工艺流程的除尘系统中排出的含铁粉尘。这些尘泥回收后利用不当，不仅会造成环境污染，也是对含铁资源的巨大浪费。本文概述了钢铁工业含铁尘泥的综合利用现状，对瓦斯泥、转炉污泥、轧钢污泥、高锌含铁污泥、电炉粉尘等几类重点尘泥，提出了未来高附加值利用的方向。