Thermal treatment and decontamination of mercury-contaminated waste: Recent developments and comparative evaluation

The land disposal restriction regulations have necessitated development of technologies for the treatment of wastes and soils containing mercury. Of all the treatment methods, thermal technologies are the most advanced and proven for a variety of mercury-contaminated waste materials. During the past few years, a number of thermal treatment processes have been developed both for listed and characteristic waste. A review of the technologies identified six that are in either commercial or pilot plant stages. The biggest volumes of waste currently occur in the gas processing and caustic-chlorine industries, so most of the technologies being used appear to have been developed around the characteristics of these two wastes. This article discusses the characteristics of each of the six available thermal treatment processes, and describes the types of mercury-contaminated wastes these technologies have been designed to handle.     

Conventional pyrolysis of Plastic waste for Product recovery and utilization of pyrolytic gases for carbon nanotubes production

Environmental Science and Pollution Research - Inevitably increase in plastic demand has resulted in an overgrowing production on a global scale. The utilization of plastics has been applied to a...     

Two-dimensional modeling of torrefaction of a large biomass particle

A two-dimensional (2-D) model is developed to predict the torrefaction behavior of a large wet biomass particle. Although one-dimensional (1-D) model is found to be adequate for L/D ≥ 6, the necessity of using 2-D model at lower L/D ratios and higher torrefaction temperature is established. Errors up to 18% are observed in predicted mass fractions between 1-D and 2-D models. The center temperatures differed more, up to 96%, between z = 0 and z = L/2 in 2-D model which is not captured by the 1-D model. The model predictions agree well with the experimental results of the present authors and others. The evolution of the temperature profile is found to govern the mass fraction profile. At higher reactor temperature, three distinct zones are visible in the contour plots: peripheral fully torrefied zone, intermediate torrefying zone, and core with unreacted virgin biomass zone. Simulation studies show the formation of two symmetric annular hot spots at the ends, which move inward axially and subsequently merge at the center, the rate being faster for smaller L/D ratio. However, 1-D model does not provide such insight. The effects of reactor temperature, particle size, the residence time, and the initial moisture content on the torrefaction behavior are investigated.     

Mercury and organomercurial resistance in bacteria isolated from freshwater fish of wetland fisheries around Calcutta

Mercury-resistant bacteria belonging to the genera Bacillus, Escherichia, Klebsiella, Micrococcus, Pseudomonas, Salmonella, Sarcina, Shigella, Staphylococcus and Streptococcus were isolated from gills and guts of fresh water fish collected from wetland fisheries around Calcutta, India, contaminated with mercury compounds. The total number of bacteria, as well as Hg-resistant bacteria, were always higher in guts than gills. Bottom-dwelling fish contained higher number of bacteria, including Hg-resistant bacteria, than surface and middle water dwelling fish. They belonged either to narrow-spectrum or to broad-spectrum Hg-resistant groups and they also possessed other heavy metal and antibiotic resistant properties. In the presence of toxic levels of HgCl(2), phenylmercuric acetate (PMA) and methylmercuric chloride (MMC), the lag in growth of the bacterial strains gradually increased with increasing concentration of Hg-compounds. Narrow-spectrum Hg-resistant bacterial strains volatilized only HgCl(2) from the liquid medium in the range of 64-89%, whereas the broad-spectrum group exhibited a high level of HgCl(2) (80-94%), PMA (72-84%) and MMC (64-80%) volatilizing capacity with inducible mercuric reductase and organomercurial lyase enzyme activities in their cell-free extracts. Cell-free extracts prepared from narrow-spectrum Hg-resistant bacterial strains induced by HgCl(2) exhibited Hg(+2)-dependent NADPH oxidation, indicating the presence of only mercuric reductase enzyme.     

Predictability by Box-Behnken model for carbaryl adsorption by soils of Indian origin

This study was undertaken to investigate the adsorption capacity of carbaryl on four Indian soils with different physiochemical properties. A batch adsorption study was carried out in order to evaluate the maximum adsorption capacity of carbaryl using a Response Surface Methodology (RSM). The effects of operating parameter such as initial carbaryl concentration (1–20 mgL^?1), adsorbent dosage (0.5–6 g) and contact time (10–180 min) were examined. The proposed quadratic model for Box-Behnken design fits very well to the experimental data because it may be used to navigate design space according to ANOVA results. The regression co-efficient (R²) of the models developed and the results of validation experiments conducted at optimal conditions strongly suggests that the predicted values are in good agreement with experimental results. Contour and response surface plots are used to determine the interactions effects of main factors and optimal conditions of the process. The experiment can be utilized as a guideline for better understanding of carbaryl adsorption onto soil under different operating conditions. The results show that the forest soil is most efficient in binding carbaryl (Sevin) than the other types of soil tested.