Chemical composition and mass closure of ambient PM10 at urban sites

The chemical composition of PM10 was studied during summer and winter sampling campaigns conducted at two different urban sites in the city of Thessaloniki, Greece (urban-traffic, UT and urban-industrial, UI). PM10 samples were chemically analysed for minerals (Si, Al, Ca, Mg, Fe, Ti, K), trace elements (Cd, Cr, Cu, Mn, Pb, V, Zn, Te, Co, Ni, Se, Sr, As, and Sb), water-soluble ions (Cl^?, NO₃^?, SO₄^2?, Na⁺, K⁺, NH₄⁺, Ca²⁺, Mg²⁺) and carbonaceous compounds (OC, EC). Spatial variations of atmospheric concentrations showed significantly higher levels of minerals, some trace metals and TC at the UI site, while at the UT site significantly higher levels of elements like Cd, Ba, Sn, Sb and Te were observed. Crustal elements, excepting Ca at the UI site, did not exhibit significant seasonal variations at any site pointing to constant emissions throughout the year. In order to reconstruct the particle mass, the determined components were classified into six classes as follows: mineral matter (MIN), trace elements (TE), organic matter (OM), elemental carbon (EC), sea salt (SS) and secondary inorganic aerosol (SIA). Good correlations with slopes close to 1 were found between chemically determined and gravimetrically measured PM10 masses for both sites. According to the chemical mass closure obtained, the major components of PM10 at both sites were MIN (soil-derived compounds), followed by OM and SIA. The fraction unaccounted for by chemical analysis comprised on average 8% during winter and 15% during summer at the urban-industrial site, while at the urban-traffic site the percentages were 21.5% in winter and 4.8% in summer.     

Profile analysis of organic micropollutants in the environment of a coal burning area, NW Greece

The concentrations and profiles of dibenzo-p-dioxins, dibenzofurans, polychlorinated biphenyls and polynuclear aromatic compounds in various environmental matrices are presented in this study. The examined environmental matrices are total suspended particles, fly ash and soil collected in NW Greece, an area characterized by intensive coal burning for electrical power generation. Moreover, the occurrence of organic micropollutants in soot after an accidental fire was examined and the possible impact on the outdoor environment was evaluated. Results were statistically treated to obtain information on representative PCDD/F profiles in each matrix and to compare these profiles with the compositional patterns of possible sources from literature. Coal combustion, fly ash and vehicle exhausts appeared to be the most possible sources in local atmosphere.     

Distribution of persistent organic pollutants, polycyclic aromatic hydrocarbons and trace elements in soil and vegetation following a large scale landfill fire in northern Greece

Polycyclic aromatic hydrocarbons (PAHs), polychlorinated biphenyls (PCBs), organochlorine pesticides (OCPs), including hexaclorocyclohexanes (HCHs) and DDTs, as well as trace elements were determined in soil and vegetation samples collected from the surrounding area of the landfill "Tagarades", the biggest in northern Greece, following a large scale fire involving approximately 50,000 tons of municipal waste. High concentrations of total PAHs, PCBs and heavy metals were found inside the landfill (1475 microg kg(-1) dw, 399 microg kg(-1) dw and 29.8 mg kg(-1) dw, respectively), whereas concentrations in the surrounding soils were by far lower ranging between 11.2-28.1 microg kg(-1) dw for PAHs, 4.02-11.2 microg kg(-1) dw for PCBs and 575-1207 mg kg(-1) dw for heavy metals. The distribution of HCHs and DDTs were quite different since certain soils exhibited equal or higher concentrations than the landfill. In vegetation, the concentrations of PAHs, PCBs, HCHs and DDTs ranged from 14.1-34.7, 3.64-25.9, 1.41-32.1 and 0.61-4.03 microg kg(-1) dw, respectively, while those of heavy metals from 81 to 159 mg kg(-1) dw. The results of the study indicated soil and vegetation pollution levels in the surroundings of the landfill comparable to those reported for other Greek locations. The impact from the landfill fire was not evident partially due to the presence of recent and past inputs from other activities (agriculture, vehicular transport, earlier landfill fires).     

Evaluation of PCDD/F pollution in surface sediments of Izmit Bay

This study evaluates PCDD/F pollution in the surface sediments of Izmit Bay (Turkey) and assesses the possible sources of PCDD/F inputs to the bay. The results showed that concentrations of toxic PCDD/F congeners in the sediments varied between 0.45 and 255 ng WHO₂₀₀₅-TEQ/kg dry weight. Pollution mapping shows that PCDD/F levels in the central section of Izmit Bay are much higher than those in the eastern and the western sections. Sediments collected from the northern part of the central section showed very high PCDD/F concentrations. The samples reveal three different congener profiles dominated by OCDF, 1,2,3,4,6,7,8-HpCDF, and OCDD respectively. The dominance of OCDF in the sediment samples taken from the central section was attributed to the former production of vinyl chloride monomer in the area, while that of 1,2,3,4,6,7,8-HpCDF was attributed to the (previously unknown) use of a chlorophenol-based fungicide in the region. The OCDD dominated group was explained by the use of pentachlorophenol. The results indicate that historic industrial discharges are the main contributor to the PCDD/F pollution in the sediments.     

Prioritisation of organic contaminants in a river basin using chemical analyses and bioassays

Region-specific contaminant prioritisation is an important prerequisite for sustainable and cost-effective monitoring due to the high number of different contaminants that may be present. Surface water and sediment samples from the Sava River, Croatia, were collected at four locations covering a 150-km-long river section characterised by well-defined pollution gradients. Analysis of contaminant profiles along the pollution gradients was performed by combining toxicity screening using a battery of small-scale or in vitro bioassays, which covered different modes of action, with detailed chemical characterisation based on gas chromatography/mass spectrometry (GC/MS) and liquid chromatography/quadrupole time-of-flight mass spectrometry (LC-QTOF-MS). A large number of contaminants, belonging to different toxicant classes, were identified in both analysed matrices. Analyses of water samples showed that contaminants having polar character occurred in the highest concentrations, while in sediments, contributions from both non-polar and amphiphilic contaminants should be taken into account. Estimated contributions of individual contaminant classes to the overall toxicity indicated that, besides the classical pollutants, a number of emerging contaminants, including surfactants, pharmaceuticals, personal care products and plasticizers, should be taken into consideration in future monitoring activities. This work demonstrates the importance of the integrated chemical and bioanalytical approach for a systematic region-specific pollutant prioritisation. Finally, the results presented in this study confirm that hazard assessment in complex environmental matrices should be directed towards identification of key pollutants, rather than focusing on a priori selected contaminants alone.     

Chemical indicators of anthropogenic impacts in sediments of the pristine karst lakes

The anthropogenic impact on the pristine karst lakes was investigated using combination of specific parameters, including multielemental analysis of major inorganic constituents (Al, K, Fe) and trace metals (Li, Ag, Cd, Sn, Pb, Bi, Cr, Co, Ni, Cu, Zn and Sb), polycyclic aromatic hydrocarbons (PAHs) and anionic surfactants of linear alkylbenzene sulfonate (LAS) type. The study was performed in the Plitvice Lakes National Park, situated in a sparsely populated area of the northwestern Dinarides, central Croatia. Dated cores of recent sediments from the two biggest lakes, Lake Prosce and Lake Kozjak, were analysed for the selected contaminants using highly specific methods, involving inductively coupled plasma mass spectrometry (ICP/MS), gas chromatography/mass spectrometry (GC/MS) and liquid chromatography/tandem mass spectrometry (LC/MS/MS). The concentration of inorganic constituents reflected primarily the geological background of the area as well as geomorphological and geochemical characteristics of the Plitvice Lakes. Due to the higher terrigenous input, the concentration of all elements was significantly higher in the Lake Prosce. The concentration of toxic metals was relatively low in both lakes, except for Cd (>1 mg kg⁻¹) and Pb (up to 40 mg kg⁻¹). The vertical profiles of these metals suggested that elevated concentrations of Cd were of natural origin, derived from the erosion of the Jurassic dolomite bedrock, while Pb was predominately of recent anthropogenic origin. A similar distribution pattern, suggesting the same prevailing mechanism of input, was observed for pyrolytic PAHs. The characteristic diagnostic PAH ratios revealed that higher PAHs prevailingly originated from the combustion of biomass and fossil fuels. LAS, which represent highly specific indicators of untreated wastewaters, were found in rather high concentrations in the recent sediment layers (up to 4.7 mg kg⁻¹), suggesting that contaminated household and hotel wastewaters reach the Lakes, very probably by leaking through the porous karst rocks.     

On the use of PAH molecular diagnostic ratios in sewage sludge for the understanding of the PAH sources. Is this use appropriate?

The concentrations ratios of specific pairs of polycyclic aromatic hydrocarbons (PAHs) are widely used for the qualitative determination of the PAHs sources. These ratios are called PAHs molecular diagnostic ratios and are commonly used for PAHs concentrations in air, soils and sediments. Some scientists have extended the use of these ratios also for sewage sludges, suggesting that calculation of these ratios by individual PAHs concentrations can be as effective as in soils or sediments. This paper describes the reason why the PAH molecular ratios calculated from sewage sludge concentrations should not be used for the understanding of the PAH sources.     

A comparative study on the recovery of polycyclic aromatic hydrocarbons from fly ash and lignite coal

The recovery of polycyclic aromatic hydrocarbons (PAHs) from lignite coal burnt in Greek power stations and the fly ash produced is examined comparatively using Soxhlet, ultrasonic and accelerated solvent extraction procedures with various organic solvents. Soxhlet using toluene/methanol mixture and accelerated solvent extraction/toluene were found to be the most efficient methods for fly ash PAHs, yielding average recoveries of about 80%. The accelerated solvent extraction/toluene procedure was superior for lignite PAHs, yielding 96% average recovery, whereas ultrasonic and Soxhlet extraction yielded relatively lower recoveries (75% and 67%, respectively).