Co-injection of air and steam for the prevention of the downward migration of DNAPLs during steam enhanced extraction: an experimental evaluation of optimum injection ratio predictions

When steam is injected into soil containing a dense volatile non-aqueous phase liquid contaminant, the DNAPL vaporized within the heated soil region condenses and accumulates ahead of the steam condensation front. If enough DNAPL accumulates, gravitational forces can overcome trapping forces allowing the liquid contaminant to flow downward. By injecting air with steam, a portion of the DNAPL vapor remains suspended in equilibrium with the air, decreasing liquid contaminant accumulation ahead of the steam condensation front, and thus reducing the possibility of downward migration. In a previous work, a theoretical model was developed to predict the optimum injection ratio of air to steam that would eliminate accumulation of DNAPL ahead of the temperature front and thus minimize the potential for downward migration. In this work, the theoretical model is summarized, and an experiment is presented in order to evaluate the optimum injection ratio prediction. In the experiment, a two-dimensional water saturated sand pack is contaminated with a known mass of TCE (DNAPL). The system is then remediated by co-injecting air and steam at the predicted optimum injection ratio, calculated based on the average contaminant soil concentration in the sand pack. Results for the co-injection of air and steam are compared to results for the injection of pure steam or pure air. Injection at the predicted optimum injection ratio for a volumetric average NAPL saturation, reduced accumulation of the contaminant ahead of the condensation front by over 90%, as compared to steam injection alone. This indicates that the optimum injection ratio prediction is a valuable tool for limiting the spreading of DNAPL during steam-enhanced extraction. Injection at the optimum injection ratio resulted in earlier recovery of contaminant than for steam injection alone. Co-injection of steam and air is also shown to result in much higher recovery rates than air injection alone.     

A theoretical model of air and steam co-injection to prevent the downward migration of DNAPLs during steam-enhanced extraction

When steam is injected into soil containing a dense volatile non-aqueous phase liquid contaminant the DNAPL vaporized within the heated soil region condenses and accumulates ahead of the steam condensation front. If enough DNAPL accumulates, gravitational forces can overcome trapping forces allowing the liquid contaminant to flow downward. By injecting air with steam, a portion of the DNAPL vapor remains suspended in equilibrium with the air, decreasing liquid contaminant accumulation ahead of the steam condensation front, and thus reducing the possibility of downward migration. In this work, a one-dimensional theoretical model is developed to predict the injection ratio of air to steam that will prevent the accumulation of volatile DNAPLs. The contaminated region is modeled as a one-dimensional homogeneous porous medium with an initially uniform distribution of a single component contaminant. Mass and energy balances are combined to determine the injection ratio of air to steam that eliminates accumulation of the contaminant ahead of the steam condensation front, and hence reduces the possibility of downward migration. The minimum injection ratio that eliminates accumulation is defined as the optimum injection ratio. Example calculations are presented for three DNAPLs, carbon tetrachloride (CCl4), trichloroethylene (TCE), and perchloroethylene (PCE). The optimum injection ratio of air to steam is shown to depend on the initial saturation and the volatility of the liquid contaminant. Numerical simulation results are presented to validate the model, and to illustrate downward migration for ratios less than optimum. Optimum injection ratios determined from numerical simulations are shown to be in good agreement with the theoretical model.     

Anaerobic dechlorination and redox activities after full-scale Electrical Resistance Heating (ERH) of a TCE-contaminated aquifer

The effects of Electrical Resistance Heating (ERH) on dechlorination of TCE and redox conditions were investigated in this study. Aquifer and groundwater samples were collected prior to and after ERH treatment, where sediments were heated to approximately 100 degrees C. Sediment samples were collected from three locations and examined in microcosms for 250 to 400 days of incubation. Redox activities, in terms of consumed electron acceptors, were low in unamended microcosms with field-heated sediments, although they increased upon lactate-amendment. TCE was not dechlorinated or stalled at cDCE with field-heated sediments, which was similar or lower compared to the degree of dechlorination in unheated microcosms. However, in microcosms which were bioaugmented with a mixed anaerobic dechlorinating culture (KB-1) and lactate, dechlorination past cDCE to ethene was observed in field-heated sediments. Dechlorination and redox activities in microcosms with field-heated sediments were furthermore compared with controlled laboratory-heated microcosms, which were heated to 100 degrees C for 10 days and then slowly cooled to 10 degrees C. In laboratory-heated microcosms, TCE was not dechlorinated and redox activities remained low in unamended and lactate-amended sediments, although organic carbon was released to the aqueous phase. In contrast, in field-heated sediments, high aqueous concentrations of organic carbon were not observed in unamended microcosms, and TCE was dechlorinated to cDCE upon lactate amendment. This suggests that dechlorinating microorganisms survived the ERH or that groundwater flow through field-heated sediments carried microorganisms into the treated area and transported dissolved organic carbon downstream.     

Dechlorination after thermal treatment of a TCE-contaminated aquifer: laboratory experiments

A microcosm study was conducted to evaluate dechlorination of trichloroethene (TCE) to ethene and survival of dechlorinating bacteria after a thermal treatment in order to explore the potential for post-thermal bioremediation. Unamended microcosms containing groundwater and aquifer material from a contaminated site dechlorinated TCE to cis-1,2-dichloroethene (cDCE), while lactate-amended microcosms dechlorinated TCE to cDCE or ethene. A thermal treatment was simulated by heating a sub-set of microcosms to 100 degrees C for 10d followed by cooling to 10 degrees C over 150 d. The heated microcosms demonstrated no dechlorination when unamended. However, when amended with lactate, cDCE was produced in 2 out of 6 microcosms within 300 d after heating. Dechlorination of TCE to cDCE thus occurred in fewer heated (2 out of 12) than unheated (10 out of 12) microcosms. In unheated microcosms, the presence of dechlorinating microorganisms, including Dehalococcoides, was confirmed using nested PCR of 16S rRNA genes. Dechlorinating microorganisms were detected in fewer microcosms after heating, and Dehalococcoides were not detected in any microcosms after heating. Dechlorination may therefore be limited after a thermal treatment in areas that have been heated to 100 degrees C. Thus, inflow of groundwater containing dechlorinating microorganisms and/or bioaugmention may be needed for anaerobic dechlorination to occur after a thermal treatment.