Simulation of wind-driven dispersion of fire pollutants in a street canyon using FDS

Air quality in urban areas attracts great attention due to increasing pollutant emissions and their negative effects on human health and environment. Numerous studies, such as those by Mouilleau and Champassith (J Loss Prevent Proc 22(3): 316–323, 2009), Xie et al. (J Hydrodyn 21(1): 108–117, 2009), and Yassin (Environ Sci Pollut Res 20(6): 3975–3988, 2013) focus on the air pollutant dispersion with no buoyancy effect or weak buoyancy effect. A few studies, such as those by Hu et al. (J Hazard Mater 166(1): 394–406, 2009; J Hazard Mater 192(3): 940–948, 2011; J Civ Eng Manag (2013)) focus on the fire-induced dispersion of pollutants with heat buoyancy release rate in the range from 0.5 to 20 MW. However, the air pollution source might very often be concentrated and intensive, as a consequence of the hazardous materials fire. Namely, transportation of fuel through urban areas occurs regularly, because it is often impossible to find alternative supply routes. It is accompanied with the risk of fire accident occurrences. Accident prevention strategies require analysis of the worst scenarios in which fire products jeopardize the exposed population and environment. The aim of this article is to analyze the impact of wind flow on air pollution and human vulnerability to fire products in a street canyon. For simulation of the gasoline tanker truck fire as a result of a multivehicle accident, computational fluid dynamics large eddy simulation method has been used. Numerical results show that the fire products flow vertically upward, without touching the walls of the buildings in the absence of wind. However, when the wind velocity reaches the critical value, the products touch the walls of the buildings on both sides of the street canyon. The concentrations of carbon monoxide and soot decrease, whereas carbon dioxide concentration increases with the rise of height above the street canyon ground level. The longitudinal concentration of the pollutants inside the street increases with the rise of the wind velocity at the roof level of the street canyon.     

Developing an automated risk management tool to minimize bird and bat mortality at wind facilities

A scarcity of baseline data is a significant barrier to understanding and mitigating potential impacts of offshore development on birds and bats. Difficult and sometimes unpredictable conditions coupled with high expense make gathering such data a challenge. The Acoustic and Thermographic Offshore Monitoring (ATOM) system combines thermal imaging with acoustic and ultrasound sensors to continuously monitor bird and bat abundance, flight height, direction, and speed. ATOM’s development and potential capabilities are discussed, and illustrated using onshore and offshore test data obtained over 16 months in the eastern USA. Offshore deployment demonstrated birds tending to fly into winds and activity declining sharply in winds >10 km h^?1. Passerines showed distinct seasonal changes in flight bearing and flew higher than non-passerines. ATOM data could be used to automatically shut down wind turbines to minimize collision mortality while simultaneously providing information for modeling activity in relation to weather and season.     

ASsessment Of Alcohol Ethoxylate Surfactants And Fatty Alcohols Mixtures In River Sediments And Prospective Risk Assessment

A feasible and relatively readily available analytical method was adapted for the assessment of alcohol ethoxylates (AE) and fatty alcohols (FA) in sediments. This study illustrates the simultaneous measurement of 38 of 114 possible alcohol ethoxylate ethoxymers (AE) and fatty alcohols (FA) found in commercially important AE products. We predicted toxicity for all identified fractions, as well as the total mixture toxicity, relative to three exposure scenarios via sewage treatment plants (STP) for these widely used chemicals in consumer products and hence generate a preliminary environmental risk screening for AE and FA in sediments. The method is based on derivatization of solvent or solid-phase extracts with 2-fluoro-N-methylpyridinium p-toluenesulfonate (Pyr+). The derivatized extracts were analyzed with liquid chromatography/mass spectrometry (LC/MS) operating in the positive ion electrospray mode. The extraction efficiency of AE and FA in three different sediments of varying composition was evaluated with spike-recovery studies, ranging from 64% to 80%. The detection limits for individual ethoxymers typically ranged from 1 to 5ngg⁻¹on a dry weight basis. The mean limit of detection (LOD) was 6ngg⁻¹and the median LOD was 3ngg⁻¹. AE and FA in sediments were found to be stable for two weeks if preserved with 3% (v/v) formalin and stored at 4–6^∘C. Based on equilibrium partitioning, background concentrations of AE and FA were predicted to be below concentrations known to elicit chronically toxic effects. Total worst case mixture toxicities for all AE ethoxymers combined with FA were predicted to result in a risk quotient less than 0.6. Activated sludge treatment (STP) significantly reduced the release of total AE and FA by four-fold, suggesting that the total mixture risk quotient would be < 0.15 for sediment dependent organisms.