Fate and efficacy of polyacrylamide applied in furrow irrigation: full-advance and continuous treatments

Polyacrylamide (PAM) is applied to 400000 irrigated hectares annually in the USA to control irrigation-induced erosion, yet the fate of dissolved PAM applied in irrigation water is not well documented. We determined the fate of PAM added to furrow streams under two treatments: Initial-10, 10 mg L(-1) PAM product applied only during the initial hours of the irrigation, and Cont-1, 1.0 mg L(-1) PAM product applied continuously during the entire irrigation. The study measured PAM concentrations in 167-m-long PAM-treated furrow streams and along a 530-m tail ditch that received this runoff. Soil was Portneuf silt loam (coarse-silty, mixed, superactive, mesic Durinodic Xeric Haplocalcid) with 1.5% slope. Samples were taken at three times during the irrigations, both during and after PAM application. Polyacrylamide was adsorbed to soil and removed from solution as the streams traversed the soil-lined channels. The removal rate increased with stream sediment concentration. Stream sediment concentrations were higher when PAM concentrations were <2 mg L(-1) a.i., for early irrigations, and when untreated tributary flows combined with the stream. In these cases, PAM concentration decreased to undetectable levels over the flow lengths used in this study. When inflows contained >6 mg L(-1) PAM a.i., stream sediment concentrations were minimal and PAM concentrations did not change down the furrow, though they decreased to undetectable levels within 0.5 h after application ceased. One percent of applied PAM was lost in tail-ditch runoff. This loss could have been eliminated by treating only the furrow advance or not treating the last two irrigations.     

Efficacy of Vegetated Buffers in Preventing Transport of Fecal Coliform Bacteria from Pasturelands

An experimental study was conducted in Tillamook, Oregon, USA, to quantify the effectiveness of edge-of-field vegetated buffers for reducing transport of fecal coliform bacteria (FCB) from agricultural fields amended with dairy cow manure. Installation of vegetated buffers on loamy soils dramatically reduced the bacterial contamination of runoff water from manure-treated pasturelands, but the size of the vegetated buffer was not an important determinant of bacterial removal efficiency. Only 10% of the runoff samples collected from treatment cells having vegetated buffers exhibited FCB concentrations >200 colony forming units (cfu)/100 mL (a common water quality standard value), and the median concentration for all cells containing vegetated buffers was only 6 cfu/100 mL. The presence of a vegetated buffer of any size, from 1 to 25 m, generally reduced the median FCB concentration in runoff by more than 99%. Results for FCB load calculations were similar. Our results suggest that where substantial FCB contamination of runoff occurs from manure-treated pasturelands, it might be disproportionately associated with specific field or management conditions, such as the presence of soils that exhibit low water infiltration and generate larger volumes of runoff or the absence of a vegetated buffer. Buffer size regulations that do not consider such differences might not be efficient or effective in reducing bacterial contamination of runoff.     

Attribution theory: An introduction to the special issue

This special issue of the Journal of Organizational Behavior was developed to further extend attribution theory and its application to the field of organizational behavior. In this introduction, we provide a brief overview of the motivation for this special issue, a concise summary of the papers included in it, a discussion about progress toward the field's goals, and suggestions for how future research can move the field forward. In doing so, we describe how applying attribution theory to studies that utilize a broad range of study designs, research contexts, and focal topics results in insights that enhance our understanding of how attributional processes predict and explain individuals' emotions and behaviors. We also provide suggestions for how to further develop attribution theory so we can more clearly describe the generalizability of relationships across a wide variety of organizational contexts.     

Status and drivers of food insecurity and adaptation responses under a changing climate among smallholder farmers households in Bagmati Province,Nepal

Environment, Development and Sustainability - Like other low-income countries in Asia and Africa, Nepal still suffers from food insecurity with a large proportion of food-insecure households being...     

Concentrations and spatial distribution of trace metals in mangrove sediments from the Brisbane River, Australia

Fifty surface sediment samples were collected from 12 transects through a mangrove woodland near the mouth of the Brisbane River, Australia. Samples were analyzed for 10 trace metals; measured concentrations (microg g(-1)) were: Cu 3.1-34.1; Pb 7.7-84.7; Zn 40.8-144.0; Ag nd-2.8; Cr 7.6-116.8; V 16.4-57.9; Mo 7.6-82.6; Ni 2.4-57.6; As nd-13.0; and Cd nd-2.0. Coefficients of variation ranged from 22-153%. Sediments were moderately contaminated, with Mo being enriched by up to thirty times background levels. Spatial variation was considerable, and canonical trend analysis showed concentrations of all metals but Ag and Cr tended to increase downshore, suggesting tidal deposition was important in determining metal concentrations. Silver and Cr concentrations appeared to be a consequence of contamination from landward point sources. An investigation of different random sampling intensities showed the spatial variation required that many samples be taken for a satisfactory assessment of metal burdens. Even so, mean values were not a good indication of the possible environmental effects of the metal contamination. Since metal concentrations increase downshore in inter-tidal environments, a more appropriate sampling strategy would be to take a downshore series of samples normal to the shoreline.     

Simulation of wind-driven dispersion of fire pollutants in a street canyon using FDS

Air quality in urban areas attracts great attention due to increasing pollutant emissions and their negative effects on human health and environment. Numerous studies, such as those by Mouilleau and Champassith (J Loss Prevent Proc 22(3): 316–323, 2009), Xie et al. (J Hydrodyn 21(1): 108–117, 2009), and Yassin (Environ Sci Pollut Res 20(6): 3975–3988, 2013) focus on the air pollutant dispersion with no buoyancy effect or weak buoyancy effect. A few studies, such as those by Hu et al. (J Hazard Mater 166(1): 394–406, 2009; J Hazard Mater 192(3): 940–948, 2011; J Civ Eng Manag (2013)) focus on the fire-induced dispersion of pollutants with heat buoyancy release rate in the range from 0.5 to 20 MW. However, the air pollution source might very often be concentrated and intensive, as a consequence of the hazardous materials fire. Namely, transportation of fuel through urban areas occurs regularly, because it is often impossible to find alternative supply routes. It is accompanied with the risk of fire accident occurrences. Accident prevention strategies require analysis of the worst scenarios in which fire products jeopardize the exposed population and environment. The aim of this article is to analyze the impact of wind flow on air pollution and human vulnerability to fire products in a street canyon. For simulation of the gasoline tanker truck fire as a result of a multivehicle accident, computational fluid dynamics large eddy simulation method has been used. Numerical results show that the fire products flow vertically upward, without touching the walls of the buildings in the absence of wind. However, when the wind velocity reaches the critical value, the products touch the walls of the buildings on both sides of the street canyon. The concentrations of carbon monoxide and soot decrease, whereas carbon dioxide concentration increases with the rise of height above the street canyon ground level. The longitudinal concentration of the pollutants inside the street increases with the rise of the wind velocity at the roof level of the street canyon.     

Opportunities for Improved Risk Assessments of Exotic Species in Canada Using Bioclimatic Modeling

This paper briefly reviews the process of exotic pest risk assessments and presents some examples of emerging opportunities for spatial bioclimatic modeling of exotic species in Canada. This type of analysis can support risk assessments but does not replace the need for on-going high quality field-based observations to validate and update models. Bioclimatic analysis of several exotic pests is provided to illustrate both opportunities and limits. A link is demonstrated to the National Forest Inventory to characterize timber volumes at risk for one exotic species. Challenges' are both scientific and administrative. More accessible and current field survey data are required to improve models. Our experience is that for many exotic species, historical, and even current, data are not always digital or quality controlled for taxonomic identity and accurate geo-referencing. This inhibits their use for integrated spatial modeling applications.     

Picophytoplankton responses to changing nutrient and light regimes during a bloom

The spring bloom in seasonally stratified seas is often characterized by a rapid increase in photosynthetic biomass. To clarify how the combined effects of nutrient and light availability influence phytoplankton composition in the oligotrophic Gulf of Aqaba, Red Sea, phytoplankton growth and acclimation responses to various nutrient and light regimes were recorded in three independent bioassays and during a naturally-occurring bloom. We show that picoeukaryotes and Synechococcus maintained a “bloomer” growth strategy, which allowed them to grow quickly when nutrient and light limitation were reversed. During the bloom picoeukaryotes and Synechococcus appeared to have higher P requirements relative to N, and were responsible for the majority of photosynthetic biomass accumulation. Following stratification events, populations limited by light showed rapid photoacclimation (based on analysis of cellular fluorescence levels and photosystem II photosynthetic efficiency) and community composition shifts without substantial changes in photosynthetic biomass. The traditional interpretation of “bloom” dynamics (i.e., as an increase in photosynthetic biomass) may therefore be confined to the upper euphotic zone where light is not limiting, while other acclimation processes are more ecologically relevant at depth. Characterizing acclimation processes and growth strategies is important if we are to clarify mechanisms that underlie productivity in oligotrophic regions, which account for approximately half of the global primary production in the ocean. This information is also important for predicting how phytoplankton may respond to global warming-induced oligotrophic ocean expansion.     

Comparison of Cadmium Adsorption from Water Using Same Source Chitosan and Nanochitosan: Is It Worthwhile to Go Nano?

Journal of Polymers and the Environment - Industrial effluents and stormwater runoff pose a significant threat to the environment and public health. Consequently, the water quality guidelines set...