Radon gas distribution in natural gas processing facilities and workplace air environment

Evaluation was made of the distribution of radon gas and radiation exposure rates in the four main natural gas treatment facilities in Syria. The results showed that radiation exposure rates at contact of all equipment were within the natural levels (0.09-0.1 microSvh(-1)) except for the reflex pumps where a dose rate value of 3 microSvh(-1) was recorded. Radon concentrations in Syrian natural gas varied between 15.4 Bq m(-3) and 1141 Bq m(-3); natural gas associated with oil production was found to contain higher concentrations than the non-associated natural gas. In addition, radon concentrations were higher in the central processing facilities than the wellheads; these high levels are due to pressurizing and concentrating processes that enhance radon gas and its decay products. Moreover, the lowest 222Rn concentration was in the natural gas fraction used for producing sulfur; a value of 80 Bq m(-3) was observed. On the other hand, maximum radon gas and its decay product concentrations in workplace air environments were found to be relatively high in the gas analysis laboratories; a value of 458 Bq m(-3) was observed. However, all reported levels in the workplaces in the four main stations were below the action level set by IAEA for chronic exposure situations involving radon, which is 1000 Bq m(-3).     

Vertical distribution and inventories of 137Cs in the Syrian soils of the eastern Mediterranean region

Vertical distribution and inventories of (137)Cs have been determined using radiocesium distributions in presumably undistributed soil profiles, collected from 36 sites distributed all over Syria (eastern Mediterranean region). Vertical distributions of (137)Cs in the collected profiles were found to be strongly correlated with soil type and five groups were identified. Based on these profiles, total (137)Cs inventory (bomb test and Chernobyl) varied between 320 Bq m(-2) and 9,647 Bq m(-2). Geographical mapping of (137)Cs inventories showed that the highest values were found in the coastal, middle and north-east regions of Syria indicating that Chernobyl atmospheric contribution to the total (137)Cs deposition in the region is predominant. In contrast, the lowest values were found in the south-east region (Syrian Badia), where a relatively uniform distribution was observed, which may only be attributed to the past global nuclear bomb test. The measured inventories were also compared with a mathematical model for estimating bomb derived (137)Cs reference inventories.     

Speciation of 210Po and 210Pb in air particulates determined by sequential extraction

Speciation of (210)Po and (210)Pb in air particulates of two Syrian phosphate sites with different climate conditions has been studied. The sites are the mines and Tartous port at the Mediterranean Sea. Air filters were collected during September 2000 until February 2002 and extracted chemically using different selective fluids in an attempt to identify the different forms of these two radionuclides. The results have shown that the inorganic and insoluble (210)Po and (210)Pb (attached to silica and soluble in mineral acids) portion was found to be high in both sites and reached a maximum value of 94% and 77% in the mine site and Tartous port site, respectively. In addition, only 24% of (210)Pb in air particulates was found to be associated with organic materials probably produced from the incomplete burning of fuel vehicle and similar activities. Moreover, the (210)Po/(210)Pb activity ratio in air particulates was higher than that in all samples at both sites and varied between 3.85 in November 2000 at Tartous port site and 20 in April 2001 at the mine area. These activity ratios were also higher than the natural levels. The (210)Po/(210)Pb activity ratio was also determined in each portion resulting from the selective extraction and found to be higher than that in most samples. The sources of (210)Po excess in these portions are discussed. Soil suspension, which is common in the dry climate dominant in the area, sea water spray and heating of phosphate ores were considered; polonium is more volatile than the lead compounds at even moderate temperature. Furthermore, variations in the chemical forms of (210)Po and (210)Pb during the year were also investigated. However, the results of this study can also be utilized for dose assessment to phosphate industry workers.     

The hardrock minerals industry and the landscape architect

The landscape architecture profession is a source of creative thinking and planning which is relatively untapped within the mining industry in the United States of America. The landscape architect has been active in European operations for years as indicated by the four examples presented. The landscape architect can provide an important interface with mine design and engineering and environmental affairs. To initiate this interface within the United States, and increase its effectiveness, six objectives are presented and discussed.     

The impact of phosphate loading activities on near marine environment: the Syrian coast.

The impact of loading cargoes of phosphate ore into ships on the near marine environment at the Syrian coast has been evaluated. Results have shown a significant enhancement of 210Po, 210Pb and other natural radionuclides in sediment and surface water inside the port area. The highest 210Po and 210Pb concentrations observed in sediment were found to be 170 and 64 Bq kg(-1) respectively, while 210Pb and 210Po concentrations in surface water ranged from 5 to 20 mBq l(-1) and 0.93 to 3.23 mBq l(-1). In addition, comparable values of 210Po and 210Pb for all marine organisms (algae, crab and fish) suggest that their use as indicators for phosphate pollution is not recommended. However, the effect of loading cargoes on the port marine environment of Tartous was found to be mainly related to wind direction where radioactive air particulate are either being dispersed to land or sea.     

Chorionic villus sampling utilization following reports of a possible association with fetal limb defects

Prenatal diagnosis choices were reviewed in 473 women who presented for genetic counselling prior to 11 weeks' gestation for the indication of advanced maternal age. Group A consisted of 336 patients who were unaware of a possible association between chorionic villus sampling (CVS) and limb defects. Group B consisted of 137 patients who were provided this information. Fifty-one per cent of patients in group A and 45 per cent of patients in group B chose CVS. This difference was not significant by χ² analysis (P = 0·7). Patterns of prenatal diagnosis procedure utilization from 1987 to 1992 revealed a significant reduction in CVS utilization accompanied by a corresponding increase in amniocentesis after the association between CVS and limb defects was publicized. Referrals for CVS counselling also significantly declined. However, acceptance rates did not change for those patients who received genetic counselling. First-trimester genetic counselling, including a discussion regarding a possible association between CVS and limb defects, helps patients make informed decisions concerning prenatal diagnosis options, and, in our population, resulted in no change in CVS acceptance rates.     

Socio-economic impact management: programme design and implementation considerations

While larger mineral resource development projects offer new jobs and provide a stimulus to the economy of the area where they are sited, they may also pose problems in rural areas associated with rapid population growth. The purpose of an impact management programme is to anticipate and alleviate project effects that are generally perceived as undesirable and to enhance effects that are beneficial to site area communities. While the effective management of project effects is the end towards which all impact assessment efforts are directed, an integrated approach to impact management has been notably lacking. This paper suggests a systems framework for meeting this need by: (1) reviewing the need for impact management efforts; (2) discussing the objectives of, and considerations in, designing impact management programmes; (3) presenting a conceptual framework for, and key components of, such a programme; and (4) suggesting an approach for implementing such a system as an integral part of the project development process.     

Transfer of (40)K, (238)U, (210)Pb, and (210)Po from soil to plant in various locations in south of Syria

Transfer factors of (40)K, (238)U, (210)Pb, and (210)Po from soil to some agriculture crops in various locations in south of Syria (Dara'a and Assuwaydaa districts) have been determined. Soil and vegetable crops (green pepper, cucumber, tomato, and eggplant), legumes crops (lentil, chickpea, and broad bean), fruit trees (apple, grape, and olives) and cereals (barley and wheat) were collected and analyzed for (238)U, (210)Pb, and (210)Po. The results have shown that higher transfer factors (calculated as Bqkg(-1) dry wt. plant material per Bqkg(-1) dry wt. soil) for (210)Po, (210)Pb and (238)U were observed in vegetable leaves than fruits and cereals leaves; the highest values of transfer factor (TF) for (238)U were found to be 0.1 for straw of chickpea. Transfer factors for (210)Po varied between 2.8x10(-2) and 2 in fruits of eggplant and grain of barley, respectively. In addition, several parameters affecting transfer factors of the radionuclides were evaluated. The results can be considered as base values for TF of natural radionuclides in the region.     

White-tailed deer movement and distribution about surface coal mines in West Virginia,USA

Deer movements around surface coal mines were investigated in Preston Country, West Virginia, USA. Seventy-two deer crossings were counted on 29 surface mines with only 8% found on highwalls with more than 20% rock or stone. Thus, although slope was important, the percentage of dirt on the highwall determined use as a crossing location for deer. The average distance between all deer crossing was 209.7 m but the distance between the end of the highwall and the nearest highwall crossing was 248.7 m indicating reluctance of deer to cross mines when they could walk around them. Winter snow track counts showed fewer deer within 90 m of the top edge of the highwall. Four land bridges traversed the highwall and were heavily utilized by deer, especially in March, April, May, October and November. The surface mine bench was used as a fawn bedding area, but little feeding occurred on this portion of the mine.