Research progress and hot spots of hydrothermal liquefaction for bio-oil production based on bibliometric analysis

Environmental Science and Pollution Research - Hydrothermal liquefaction (HTL) of biomass used HTL reaction under high temperature and pressure to produce bio-oil. This technology is considered as...     

金属加工过程中应力状态的分析方法

分析简单地拉伸、压缩和扭转的情况时,应力状态能容易地被确定.但是,实际上在金属加工过程中材料是承受复杂的应力状态,在模具——工件接触面上增加有摩擦力.而且,这些应力和摩擦力一般地沿着接触面变化.准确的计算或预测载荷、力、应力和温度,不但对设计适宜的设备是重要的,而且对研究工艺期间材料的变化过程也是重要的.本文将讨论材料变形过程中所运用的主要分析方法及其优缺点.     

Distribution of antifouling biocides in California marinas

Antifouling biocides are used to prevent the settlement and growth of organisms on submerged surfaces. Irgarol 1051 is currently among the most widely used organic booster biocides worldwide. This study reports Irgarol 1051, its major metabolite M1 (aka GS26575), and diuron concentrations found in selected California marinas. Seasonal water samples (n = 46) were collected during the summer and fall of 2006 from eleven marinas throughout Southern and Northern California. The samples were extracted using solid phase extraction and analysed utilizing liquid chromatography tandem mass spectrometry (LC-MS-MS) with electrospray ionization. All three compounds were detected in all samples, representing a 100% frequency of occurrence and indicating widespread use around the sampled marinas. Irgarol concentrations ranged from 12 to 712 ng L(-1) (average 102 ng L(-1)), M1 concentrations were 1-217 ng L(-1) (average 31 ng L(-1)), and diuron concentrations were 5-27 ng L(-1) (average 13 ng L(-1)). In general, concentrations of both Irgarol (15-712 ng L(-1)) and M1 (1-217 ng L(-1)) were greater in samples collected during the summer, corresponding to the peak of the boating season. The detected diuron concentrations in most cases were greater for fall samples (7-27 ng L(-1)), and probably represented a combination of non-agricultural (rights of way) and agricultural applications of diuron in California. The maximum Irgarol concentration detected in California marinas in summer 2006 (712 ng L(-1)) was five times greater than the Irgarol concentration suggested as the plant toxicity benchmark (136 ng L(-1)). Twenty three percent of samples from California marinas in this study exceeded this benchmark, suggesting that detected Irgarol concentrations may be high enough to cause changes in phytoplankton communities in the sampled marinas.     

青岛工业与资源灰色关联分析

本文应用灰色关联分析方法研究了青岛地区主导工业对资源的依赖状态及不同工业行业之产出对各类资源投入的反应程度,以灰关联树反映工业经济与资源复合系统之整体及不同层次子系统的耦合关系,定量揭示工业经济效益主导变量与各类资源变量的动态联系,从资源高效利用的角度探讨了青岛工业产业结构调整和优化的方向及区域经济与环境效益相协调的可能途径。     

Study on the regional atomized dust suppression technological system based on the measured law of dust concentration distribution in longwall fully mechanized mining faces

Environment, Development and Sustainability - In order to reveal the distribution and migration law of downwind and upwind coal cutting, total dust (TD) and respirable dust (RD) concentration...     

基于两种再分析资料的一次四川盆地大气污染过程气象要素数值模拟研究

利用ECMWF-ERA5和NCEP-FNL再分析资料作为中尺度气象模式WRF（The Weather Research and Forecasting）初始场,对四川盆地2018年1月一次大气污染过程气象要素进行了模拟,对比分析了气温、风速、风向、相对湿度、边界层高度、温廓线的模拟效果,并结合大气超级站观测数据对模拟结果进行评估.结果表明：两种资料均能较好地模拟出气象要素的变化情况,但由于两套资料时空分辨率、采用的模式、同化方案、数据来源和质量控制方案存在一定区别,导致各要素模拟效果并不一致.与NCEP-FNL相比,ECMWF-ERA5模拟的平均相对湿度（59.23%）与观测值差异更小,且均方根误差、偏差较小,分别为9.83%和-0.83%,但NCEP-FNL模拟的平均气温（8.99℃）更接近观测值,且偏差值较小,为-0.04℃.两组模拟结果均显示盆地内部为模拟区域的低风速区,相对湿度模拟值在60%以上,气温高于西部山地地区.NCEP-FNL模拟的盆地内部气温、相对湿度、风速小于ECMWF-ERA5模拟值,但边界层高度模拟值较大.ECMWF-ERA5模拟的逆温强度相比较小,且温度露点差较小.此次污染过程PM_2.5和PM₁₀日均浓度最大值分别为190.1 μg·m^-3和261.0 μg·m^-3,相对湿度增大引发的颗粒物吸湿增长是导致PM_2.5和PM₁₀质量浓度突增的主要原因.     

富营养化巢湖沉积物溶解性有机质光谱时空分布特征及其环境意义

通过紫外吸收光谱（UV-vis）和三维荧光光谱（3D-EEMs）,研究典型富营养化湖泊巢湖沉积物溶解性有机质（DOM）光谱时空分布特征.结果表明,巢湖表层沉积物DOM的a（254）含量为13.1~101.7 m^-1,平均值为（32.2±16.2）m^-1.其中,夏季沉积物a（254）的含量（（46.6±25.6）m^-1）要显著高于其它季节,且湖心区a（254）平均值和变异性均小于湖滨区.表层沉积物DOM的S_275~295值从春季到冬季上随时间呈明显上升趋势.沉积物DOM荧光强度在夏季最高,在垂直剖面上总体呈下降趋势.DOM组分以酪氨酸类蛋白质和溶解性微生物产物为主,各组分在空间分布上无明显差异.巢湖沉积物DOM荧光指数（FI）为2.56~4.89,腐殖化指数（HIX）为0.57~6.78,生物源指数（BIX）为0.31~1.54.巢湖沉积物DOM主要来自于生物源,藻的生长循环会显著影响富营养化湖泊沉积物DOM的来源和性质.     

稻壳与聚氯乙烯共热解的特性及动力学

在热重分析仪中进行了稻壳和聚氯乙烯（PVC）的共热解实验,结果显示:在共热解时稻壳开始剧烈热解的温度相比单独热解时大幅度降低,由350℃降至300℃,表明掺入PVC降低了稻壳的热解温度。在升温速率为20℃/min,稻壳和PVC比例为2∶1（质量比）时,混合热解协同效应最明显。3种动力学分析方法均证明共热解现象的存在。利用Coats-Redfern法进行动力学分析,发现共热解活化能普遍较单独热解时低,表明PVC与稻壳共热解有明显的相互作用。利用Ozawa法进行分析,发现转化率为20%~60%阶段下共热解平均活化能值为37.60 kJ/mol,低于稻壳单独热解的平均活化能41.45 kJ/mol。Friedman法分析结果显示对应转化率下共热解活化能均低于稻壳单独热解活化能。稻壳和PVC共热解倾向于反应动力学控制。     

对低影响开发与海绵城市的再认识

海绵城市建设是在继承我国古代先贤智慧和参考国外经验,系统总结我国雨洪管理领域长期研究和实践经验的基础上,结合我国城市水系统实际问题提出的城市发展方式,其核心是构建基于绿灰结合的现代城市雨洪控制系统,通过"渗、滞、蓄、净、用、排"综合措施,实现"治涝"与"治黑"等多重目标。低影响开发是海绵城市建设的重要指导思想,也是海绵城市核心技术体系的重要组成部分。正确认识低影响开发与海绵城市的内涵与联系,对于进一步在全国范围内落实低影响开发建设模式,科学推进海绵城市建设具有重要意义。