Partitioning and removal of perfluorooctanoate during rain events: the importance of physical-chemical properties

The potential for airborne emissions to undergo long-range transport or to be removed from the atmosphere is influenced by their physical-chemical properties. When perfluorooctanate (PFO) enters the environment, its physical-chemical properties can vary significantly, depending on whether it exists as an acid, a salt, or a dissociated ion. A summary of the physical-chemical properties of the three most likely environmental states: ammonium perfluorooctanoate (APFO), perfluorooctanoic acid (PFOA) and the dissociated perfluorooctanoate anion (PFO(-)) is presented to illustrate the distinct environmental properties of each. The most volatile species, PFOA, is shown to have a pH-dependent air-water partitioning coefficient (K(aw)). The variability of K(aw) with pH influences the potential for vapor formation from aqueous environments, including rain events. Using the pH-dependent K(aw) and measured rain and air concentrations, it is shown that vapor-phase PFOA is not likely to be present above measurable levels of 0.2 ng m(-3) (12 parts per quadrillion v/v) during a rain event. Because rain concentrations determined in this work are comparable to measurements in other parts of North America, it is unlikely that rain events are a significant source of vapor-phase PFOA for the general North American region. It is shown that PFOA exists primarily in the particle phase in ambient air near direct sources of emissions and is efficiently scavenged by rain droplets, making wet deposition an important removal mechanism for emissions originating as either PFOA or APFO. Washout ratios of particle-associated PFO were determined to range between 1 x 10(5) and 5 x 10(5), in the same range as other semi-volatile compounds for which wet deposition is an important mechanism for atmospheric removal and deposition onto soils and water bodies.     

A comparison of speciated atmospheric mercury at an urban center and an upwind rural location

Gaseous elemental mercury (GEM), particulate mercury (PHg) and reactive gaseous mercury (RGM) were measured every other hour at a rural location in south central Wisconsin (Devil's Lake State Park, WI, USA) between April 2003 and March 2004, and at a predominantly downwind urban site in southeastern Wisconsin (Milwaukee, WI, USA) between June 2004 and May 2005. Annual averages of GEM, PHg, and RGM at the urban site were statistically higher than those measured at the rural site. Pollution roses of GEM and reactive mercury (RM; sum of PHg and RGM) at the rural and urban sites revealed the influences of point source emissions in surrounding counties that were consistent with the US EPA 1999 National Emission Inventory and the 2003-2005 US EPA Toxics Release Inventory. Source-receptor relationships at both sites were studied by quantifying the impacts of point sources on mercury concentrations. Time series of GEM, PHg, and RGM concentrations were sorted into two categories; time periods dominated by impacts from point sources, and time periods dominated by mercury from non-point sources. The analysis revealed average point source contributions to GEM, PHg, and RGM concentration measurements to be significant over the year long studies. At the rural site, contributions to annual average concentrations were: GEM (2%; 0.04 ng m(-3)); and, RM (48%; 5.7 pg m(-3)). At the urban site, contributions to annual average concentrations were: GEM (33%; 0.81 ng m(-3)); and, RM (64%; 13.8 pg m(-3)).     

Unionists/researchers writing a book in co-operation: Importance in training/research dynamics

This text describes two different experiences of co-operation between unionists and researchers that resulted in writing of a book. We emphasize their similarities and differences and discuss the importance of these experiences in the dynamics of research and training in Ergonomics.     

High frequency monitoring of the coastal marine environment using the MAREL buoy

The MAREL Iroise data buoy provides physico-chemical measurements acquired in surface marine water in continuous and autonomous mode. The water is pumped 1.5 m from below the surface through a sampling pipe and flows through the measuring cell located in the floating structure. Technological innovations implemented inside the measuring cell atop the buoy allow a continuous cleaning of the sensor, while injection of chloride ions into the circuit prevents biological fouling. Specific sensors for temperature, salinity, oxygen and fluorescence investigated in this paper have been evaluated to guarantee measurement precision over a 3 month period. A bi-directional link under Internet TCP-IP protocols is used for data, alarms and remote-control transmissions with the land-based data centre. Herein, we present a 29 month record for 4 parameters measured using a MAREL buoy moored in a coastal environment (Iroise Sea, Brest, France). The accuracy of the data provided by the buoy is assessed by comparison with measurements of sea water weekly sampled at the same site as part of SOMLIT (Service d'Observation du Milieu LIToral), the French network for monitoring of the coastal environment. Some particular events (impact of intensive fresh water discharges, dynamics of a fast phytoplankton bloom) are also presented, demonstrating the worth of monitoring a highly variable environment with a high frequency continuous reliable system.     

Sulphate, Nitrogen and Base Cation Budgets at 21 Forested Catchments in Canada, the United States and Europe

To assess the concern over declining base cation levels in forest soils caused by acid deposition, input-output budgets (1990s average) for sulphate (SO₄), inorganic nitrogen (NO₃-N; NH₄-N), calcium (Ca), magnesium (Mg) and potassium (K) were synthesised for 21 forested catchments from 17 regions in Canada, the United States and Europe. Trend analysis was conducted on monthly ion concentrations in deposition and runoff when more than 9 years of data were available (14 regions, 17 sites). Annual average SO₄ deposition during the 1990s ranged between 7.3 and 28.4 kg ha⁻¹ per year, and inorganic nitrogen (N) deposition was between 2.8 and 13.8 kg ha⁻¹ per year, of which 41–67% was nitrate (NO₃-N). Over the period of record, SO₄ concentration in deposition decreased in 13/14 (13 out of 14 total) regions and SO₄ in runoff decreased at 14/17 catchments. In contrast, NO₃-N concentrations in deposition decreased in only 1/14 regions, while NH₄-N concentration patterns varied; increasing at 3/14 regions and decreasing at 2/14 regions. Nitrate concentrations in runoff decreased at 4/17 catchments and increased at only 1 site, whereas runoff levels of NH₄-N increased at 5/17 catchments. Decreasing trends in deposition were also recorded for Ca, Mg, and K at many of the catchments and on an equivalent basis, accounted for up to 131% (median 22%) of the decrease in acid anion deposition. Base cation concentrations in streams generally declined over time, with significant decreases in Ca, Mg and K occurring at 8, 9 and 7 of 17 sites respectively, which accounted for up to 133% (median 48%) of the decrease in acid anion concentration. Sulphate export exceeded input at 18/21 catchments, likely due to dry deposition and/or internal sources. The majority of N in deposition (31–100%; median 94%) was retained in the catchments, although there was a tendency for greater NO₃-N leaching at sites receiving higher (<7 kg ha^-1 per year) bulk inorganic N deposition. Mass balance calculations show that export of Ca and Mg in runoff exceeds input at all 21 catchments, but K export only exceeds input at 16/21 sites. Estimates of base cation weathering were available for 18 sites. When included in the mass balance calculation, Ca, Mg and K exports exceeded inputs at 14, 10 and 2 sites respectively. Annual Ca and Mg losses represent appreciable proportions of the current exchangeable soil Ca and Mg pools, although losses at some of the sites likely occur from weathering reactions beneath the rooting zone and there is considerable uncertainty associated with mineral weathering estimates. Critical loads for sulphur (S) and N, using a critical base cation to aluminium ratio of 10 in soil solution, are currently exceeded at 7 of the 18 sites with base cation weathering estimates. Despite reductions in SO₄ and H⁺ deposition, mass balance estimates indicate that acid deposition continues to acidify soils in many regions with losses of Ca and Mg of primary concern. The U.S. Government's right to retain a non-exclusive, royalty free licence in and to any copyright is acknowledged. The Canadian Crown reserves the right to retain a non-exclusive, royalty free licence in and to any copyright.     

Examples of the role of analytical chemistry in environmental risk management research

Analytical chemistry is an important tier of environmental protection and has been traditionally linked to compliance and/or exposure monitoring activities for environmental contaminants. The adoption of the risk management paradigm has led to special challenges for analytical chemistry applied to environmental risk analysis. Namely, methods developed for regulated contaminants may not be appropriate and/or applicable to risk management scenarios. This paper contains examples of analytical chemistry applied to risk management challenges broken down by the analytical approach and analyte for some selected work in our laboratory. Specific techniques discussed include stable association complex electrospray mass spectrometry (cESI-MS), gas chromatography-mass spectrometry (GC-MS), split-flow thin cell (SPLITT) fractionation and matrix-assisted laser desorption time of flight mass spectrometry (MALDI-ToF-MS). Specific analytes include haloacetic acids (HAA9), perchlorate, bromate, triazine degradation products, metal-contaminated colloids and Cryptosporidium parvum oocysts.     

The Impact of Landsat Satellite Monitoring on Conservation Biology

Landsat 7s recent malfunctioning will result in significant gaps in long-term satellite monitoring of Earth, affecting not only the research of the Earth science community but also conservation users of these data. To determine whether or how important Landsat monitoring is for conservation and natural resource management, we reviewed the Landsat programs history with special emphasis on the development of user groups. We also conducted a bibliographic search to determine the extent to which conservation research has been based on Landsat data. Conservation biologists were not an early user group of Landsat data because a) biologists lacked technical capacity – computers and software – to analyze these data; b) Landsats 1980s commercialization rendered images too costly for biologists budgets; and c) the broad-scale disciplines of conservation biology and landscape ecology did not develop until the mid-to-late 1980s. All these conditions had changed by the 1990s and Landsat imagery became an important tool for conservation biology. Satellite monitoring and Landsat continuity are mandated by the Land Remote Sensing Act of 1992. This legislation leaves open commercial options. However, past experiments with commercial operations were neither viable nor economical, and severely reduced the quality of monitoring, archiving and data access for academia and the public. Future satellite monitoring programs are essential for conservation and natural resource management, must provide continuity with Landsat, and should be government operated.     

Planning Tools for Developing Comprehensive Regional Monitoring Programs

We present a planning framework that structures thelarge amount of interrelated information involved indeveloping regional monitoring programs. By regionalwe mean programs that recognize the importance ofprocesses that occur on larger geographic scales andthat cut across more than one ecosystem component. Theframework helps visualize functional relationshipsamong qualitative ingredients such as public concernsand more concrete details such as individual dataelements. It portrays the flow of information amongthe components of a regional program and ties eachaspect of the program to management decision-makingneeds. This makes it easier, during the planningprocess, to ensure that monitoring will actuallyproduce useful information. Further, the frameworksnovel, graphically oriented, and readily accessibleformat makes key information equally available to thewide range of participants (regulators, scientists,managers, public) whose input and support arenecessary for program success.