京津冀地区一次污染过程的星载地基激光雷达联合观测分析

针对2018年3月9—15日京津冀地区的一次空气重污染过程,进行了基于地基颗粒物激光雷达组网的星载-地基联合观测分析。颗粒物激光雷达观测到污染前期为局地污染累积过程,中期有明显的污染物区域传输过程,北京受太行山沿线城市污染输送影响较大。风廓线激光雷达观测结果表明:此次污染过程近地面主要为偏南风且风力较弱,冷空气到来时风向转为较强东北风,导致污染消散。微波辐射计观测到保定在污染过程中出现持续6 d的逆温层,同时在污染过程中近地面相对湿度较高,逆温层被打破后污染开始消散。在污染过程的各个阶段中,污染团的空间分布与变化特征均被很好地反映出来,可见地天联合观测对污染物的累积与输送研究有较大的意义,能对京津冀及周边地区的大气污染联防联控提供有力支持。     

Seasonal and Inter-Annual Variations in Methyl Mercury Concentrations in Zooplankton from Boreal Lakes Impacted by Deforestation or Natural Forest Fires

We compared the effects of natural and anthropogenic watershed disturbances on methyl mercury (MeHg) concentration in bulk zooplankton from boreal Shield lakes. MeHg in zooplankton was monitored for three years in nine lakes impacted by deforestation, in nine lakes impacted by wildfire, and in twenty lakes with undisturbed catchments. Lakes were sampled during spring, mid- and late summer. MeHg in zooplankton showed a seasonal trend: concentrations were the lowest in spring, then peaked in mid-summer and decreased in late summer. Over the three study years, MeHg concentrations observed in mid-summer in zooplankton from forest harvested lakes were significantly higher than in reference and fire-impacted lakes, whereas differences between these two groups of lakes were not significant. The pattern of distribution of MeHg in zooplankton during the different seasons paralleled that of dissolved organic carbon (DOC), which is known as a vector of Hg from watershed soils to lake water. Besides DOC, MeHg in zooplankton also showed a positive significant correlation with epilimnetic temperature and sulfate concentrations. An inter-annual decreasing trend in MeHg was observed in zooplankton from reference and fire-impacted lakes. In forest harvested lakes, however, MeHg concentrations remained higher and nearly constant over three years following the impact. Overall these results indicate that the MeHg pulse observed in zooplankton following deforestation by harvesting is relatively long-lived, and may have repercussions to the accumulation of MeHg along the food chain. Therefore, potential effects of deforestation on the Hg contamination of fish should be taken into account in forest management practices.     

Effects of bed materials on the performance of an anaerobic sequencing batch biofilm reactor treating domestic sewage

The objective of this study was to determine the best performance of an anaerobic sequencing batch biofilm reactor (AnSBBR) based on the use of four different bed materials as support for biomass immobilization. The bed materials utilized were polyurethane foam (PU), vegetal carbon (VC), synthetic pumice (SP), and recycled low-density polyethylene (PE). The AnSBBR, with a total volume of 7.2L, was operated in 8-h batch cycles over 10 months, and fed with domestic sewage with an average influent chemical oxygen demand (COD) of 358+/-110mg/L. The average effluent COD values were 121+/-31, 208+/-54, 233+/-52, and 227+/-51mg/L, for PU, VC, SP, and PE, respectively. A modified first-order kinetic model was adjusted to temporal profiles of COD during a batch cycle, and the apparent kinetic constants were 0.52+/-0.05, 0.37+/-0.05, 0.80+/-0.04, and 0.30+/-0.02h(-1) for PU, VC, SP, and PE, respectively. Specific substrate utilization rates of 1.08, 0.11, and 0.86mg COD/mgVS day were obtained for PU, VC, and PE, respectively. Although SP yielded the highest kinetic coefficient, PU was considered the best support, since SP presented loss of chemical constituents during the reactor's operational phase. In addition, findings on the microbial community were associated with the reactor's performance data. Although PE did not show a satisfactory performance, an interesting microbial diversity was found on its surface. Based on the morphology and denaturing gradient gel electrophoresis (DGGE) results, PE showed the best capacity for promoting the attachment of methanogenic organisms, and is therefore a material that merits further analysis. PU was considered the most suitable material showing the best performance in terms of efficiency of solids and COD removal.     

区域水资源最优配置的研究：以汉中盆地为例

本文通过对水资源优化系统的分析，指出了该系统一些易被人们忽视的特征：①水资源优化系统只是整个资源优化大系统的一个子系统，它具有大型性、整体最优性、等级层次性、相对独立性等诸多特征，因此我们必须将其置于资源优化系统中去考察。②该系统也是一个复杂的动态系统，所以必须应用动态规划法去处理它。③水资源优化系统中的多目标间存在各种冲突，显然协调冲突在水资源优化配置研究中是至关重要的，文中提出三种冲突－协调方     

Mineralogical characterization of the Tournemire argillite after in situ interaction with concretes

This study aims to investigate, through mineralogical characterization (SEM, XRD) and mass-balance calculations, the effects of contact time, concrete types and presence of free water on the Tournemire argillite under in situ conditions. Three sampling zones from Excavation Disturbed Zone (EDZ) areas have been chosen: (1) dry contacts, collected at the tunnel masonry/argillite interface (contact time - 125 years), (2) wet contacts, taken close to drained areas below the tunnel roadbed in contact with the canal draining the Cernon fault water (contact time - 15 and 7 years) and at the tunnel masonry/argillite interface over 70 m from the Cernon fault (contact time - 125 years). This study shows that: in the absence of water, no significant modification of argillite is observed after 125 years, except for pyrite dissolution and gypsum precipitation; in the presence of water, precipitation of gypsum, recrystallization of mixed-layer clays, neoformation of zeolites and K-feldspars overgrowths are observed. At the concrete/argillite interface near the Cernon fault, important dolomite neoformation and leaching of chlorite and kaolinite occur. These processes are enhanced with contact time, low flow rate and the nature of the concrete (compound cement Portland CEM II 32.5). Evidence for oxidation processes linked to the EDZ (pyrite oxidation, Fe-oxy-hydroxide and gypsum precipitation) is observed.     

Gas chromatographic methods for monitoring of wastewater chlorophenol degradation in anaerobic reactors

Wastewater samples from an anaerobic reactor were extracted with hexane and derivatized with diazomethane (method 1) and with acetic anidride (method 2). Gas chromatography with electron-capture detection (ECD) was employed for separating the parent compound and intermediates trichlorophenols (TCP) and dichlorophenols (DCP) which originated from the penta chlorophenol (PCP) degradation process. The relations between concentrations of PCP, TCP and DCP areas were linear in the range of concentrations of 0.2 to 8 mg/L and 0.025 mg/L to 5 mg/L for methods 1 and 2, respectively. The repeatability of the extraction methods was satisfactory, with variation coefficients lower than 11%. For method 1, at the fortification level of 0.2 mg/L, recovery of PCP, TCP, and DCP was 112%, 74% and 45%, respectively. For method 2, the corresponding recovery values at the fortification level of 0.1 mg/L were 91%, 93% and 103%, respectively. Storage of the frozen samples did not alter their PCP determination properties. The chromatographic methods adapted for chlorophenol determination in wastewater were suitable with relatively simple manipulation techniques. The obtained results were reproducible and allowed identification of intermediates formed during the PCP degradation process.     

Comparison between the accumulation capacity of four lichen species transplanted to a urban site

The capacity to accumulate trace elements from the atmosphere of the lichens Hypogymnia physodes, Parmelia sulcata, Pseudevernia furfuracea and Usnea gr. hirta transplanted to an urban site of N Italy was compared. Twenty-nine elements (Al, As, Br, Ca, Cd, Ce, Cl, Co, Cr, Cs, Cu, Fe, Hg, I, K, La, Mg, Mn, Ni, Pb, Rb, Sb, Sc, Se, Sm, Th, Ti, V, Zn) were analyzed by Instrumental Neutron Activation Analysis (INAA) and Electro-Thermal Atomic Absorption Spectroscopy (ET-AAS). The ratio between the concentrations of each element in exposed samples to that of control samples (exposed-to-control ratio and EC ratio) was used to investigate the accumulation rates of lichen thalli. The results showed that in general elements did not exhibit well defined trends, but rather showed fluctuations, and indicated that H. physodes, P. furfuracea and U. gr. hirta have a similar accumulation capacity, while that of P. sulcata is lower.     

Distribution of antifouling biocides in California marinas

Antifouling biocides are used to prevent the settlement and growth of organisms on submerged surfaces. Irgarol 1051 is currently among the most widely used organic booster biocides worldwide. This study reports Irgarol 1051, its major metabolite M1 (aka GS26575), and diuron concentrations found in selected California marinas. Seasonal water samples (n = 46) were collected during the summer and fall of 2006 from eleven marinas throughout Southern and Northern California. The samples were extracted using solid phase extraction and analysed utilizing liquid chromatography tandem mass spectrometry (LC-MS-MS) with electrospray ionization. All three compounds were detected in all samples, representing a 100% frequency of occurrence and indicating widespread use around the sampled marinas. Irgarol concentrations ranged from 12 to 712 ng L(-1) (average 102 ng L(-1)), M1 concentrations were 1-217 ng L(-1) (average 31 ng L(-1)), and diuron concentrations were 5-27 ng L(-1) (average 13 ng L(-1)). In general, concentrations of both Irgarol (15-712 ng L(-1)) and M1 (1-217 ng L(-1)) were greater in samples collected during the summer, corresponding to the peak of the boating season. The detected diuron concentrations in most cases were greater for fall samples (7-27 ng L(-1)), and probably represented a combination of non-agricultural (rights of way) and agricultural applications of diuron in California. The maximum Irgarol concentration detected in California marinas in summer 2006 (712 ng L(-1)) was five times greater than the Irgarol concentration suggested as the plant toxicity benchmark (136 ng L(-1)). Twenty three percent of samples from California marinas in this study exceeded this benchmark, suggesting that detected Irgarol concentrations may be high enough to cause changes in phytoplankton communities in the sampled marinas.     

Vanadium recovery from oil fly ash by leaching, precipitation and solvent extraction processes

In order to reduce the environmental impact due to land disposal of oil fly ash from power plants and to valorize this waste material, the removal of vanadium was investigated using leaching processes (acidic and alkaline treatments), followed by a second step of metal recovery from leachates involving either solvent extraction or selective precipitation. Despite a lower leaching efficiency (compared to sulfuric acid), sodium hydroxide was selected for vanadium leaching since it is more selective for vanadium (versus other transition metals). Precipitation was preferred to solvent extraction for the second step in the treatment since: (a) it is more selective; enabling complete recovery of vanadate from the leachate in the form of pure ammonium vanadate; and (b) stripping of the loaded organic phase (in the solvent extraction process) was not efficient. Precipitation was performed in a two-step procedure: (a) aluminum was first precipitated at pH 8; (b) then ammonium chloride was added at pH 5 to bring about vanadium precipitation.