Depth-dependence and monthly variability of charophyte biomass production: consequences for the precipitation of calcium carbonate in a shallow <Emphasis Type="Italic">Chara</Emphasis>-lake

The month-to-month variability of biomass and CaCO₃ precipitation by dense charophyte beds was studied in a shallow Chara-lake at two depths, 1 and 3 m. Charophyte dry weights (d.w.), the percentage contribution of calcium carbonate to the dry weight and the precipitation of CaCO₃ per 1 m² were analysed from May to October 2011. Physical-chemical parameters of water were also measured for the same sample locations. The mean dry weight and calcium carbonate precipitation were significantly higher at 1 m than at 3 m. The highest measured charophyte dry weight (exceeding 2000 g m^?2) was noted at 1 m depth in September, and the highest CaCO₃ content in the d.w. (exceeding 80 % of d.w.) was observed at 3 m depth in August. The highest CaCO₃ precipitation per 1 m² exceeded 1695 g at 1 m depth in August. Significant differences in photosynthetically active radiation (PAR) were found between 1 and 3 m depths; there were no significant differences between depths for other water properties. At both sampling depths, there were distinct correlations between the d.w., CaCO₃ content and precipitation and water properties. In addition to PAR, the water temperature and magnesium and calcium ion concentrations were among the most significant determinants of CaCO₃ content and d.w. The results show that light availability seems to be the major factor in determining charophyte biomass in a typical, undisturbed Chara-lake. The study results are discussed in light of the role of charophyte vegetation in whole ecosystem functioning, with a particular focus on sedimentary processes and the biogeochemical cycle within the littoral zone.     

The evaluation of energy consumption in transportation and processing of municipal waste for recovery in a waste-to-energy plant: a case study of Poland

Environmental Science and Pollution Research - Refuse-derived fuel (RDF) can be produced from combustible materials contained in municipal waste. This article investigates energy and material flow...     

Brominated flame retardants and organochlorines in the European environment using great tit eggs as a biomonitoring tool

Large-scale studies are essential to assess the emission patterns and spatial distribution of organohalogenated pollutants (OHPs) in the environment. Bird eggs have several advantages compared to other environmental media which have previously been used to map the distribution of OHPs. In this study, large-scale geographical variation in the occurrence of OHPs, such as polychlorinated biphenyls (PCBs), polybrominated diphenyl ethers (PBDEs) and organochlorine pesticides (OCPs), was investigated throughout Europe using eggs of a terrestrial residential passerine species, the great tit (Parus major). Great tit eggs from 22 sampling sites, involving urban, rural and remote areas, in 14 European countries were collected and analysed (5-8 eggs per sampling site). The environmentally most important congeners/compounds of the analysed pollutants were detectable in all sampling locations. For PCBs, PBDEs and OCPs, no clear geographical contamination pattern was found. Sum PCB levels ranged from 143 ng/g lipid weight (lw) to 3660 ng/g lw. As expected, PCB concentrations were significantly higher in the sampled urban compared to the remote locations. However, the urban locations did not show significantly higher concentrations compared to the rural locations. Sum PBDEs ranged from 4.0 ng/g lw to 136 ng/g lw. PBDEs were significantly higher in the urbanized sampling locations compared to the other locations. The significant, positive correlation between PCB and PBDE concentrations suggests similar spatial exposure and/or mechanisms of accumulation. Significantly higher levels of OCPs (sum OCPs ranging from 191 ng/g lw to 7830 ng/g lw) were detected in rural sampling locations. Contamination profiles of PCBs, PBDEs and OCPs differed also among the sampling locations, which may be due to local usage and contamination sources. The higher variance among sampling locations for the PCBs and OCPs, suggests that local contamination sources are more important for the PCBs and OCPs compared to the PBDEs. To our knowledge, this is the first study in which bird eggs were used as a monitoring tool for OHPs on such a large geographical scale.     

Sex-specific effects of parasites on telomere dynamics in a short-lived passerine—the blue tit

The pollination syndrome concept implies that flowers evolved with particular sets of characteristics, such as colors, shapes, orientations, and rewards, as a means of attracting pollinators. However, these traits may have also evolved to deter unwanted visitors. The North American genus Penstemon exhibits a great floral diversity that is mainly associated with bumblebee and hummingbird pollination. Evolutionary shifts from insect pollination to hummingbird pollination have occurred in Penstemon repeatedly, but some species maintain mixed-pollination systems and intermediate floral traits between bee- and hummingbird-pollination modes. The apparently intermediate floral traits of species with mixed-pollination systems might be potentially acting to deter bumblebee foragers. Then, bird-flower traits might be selected with increased hummingbird visitation over evolutionary time might, resulting in specialization to and the evolution of floral traits present in hummingbird-pollinated species. Here, we modified bee-pollination floral traits in Penstemon gentianoides with a mixed pollination system, to resemble hummingbird-pollination traits, and measured the effects of trait modification on bumblebee foraging behavior and plant female reproductive fitness. Our results showed that reduction in the width of the corolla tube and the absence of the corolla lip negatively affects bumblebee visitation and their efficiency as pollinators, and that the synergistic interaction of both traits enhanced the “anti-bee” effect. We conclude that acquisition of floral traits that resemble those of hummingbird-pollination enables Penstemon plant species to deter bumblebee visits.

     

S–O–C isotopic picture of sulphate–methane–carbonate system in freshwater lakes from Poland. A review

Microbial oxidation of organic compounds (including methane), in freshwater sediments, may result in precipitation of carbonates, which may become an important geochemical archive of paleoenvironmental variations. Most probably low δ¹³C value in calcite in eutrophic systems results from an advanced oxidation of organic compounds in turbulent or/and sulphate-rich conditions. Likewise, high δ¹³C value in calcite from organic-rich sediments may evidence low redox potential of the freshwater system. Oxidation of methane and organic matter results in significant isotope effects in sulphates dissolved in water. Therefore, to better understand the origin of carbon isotope signal in carbonates, concentration and stable isotope measurements in dissolved sulphate (water column), bubble methane and calcite (freshwater sediments) have been carried out in 24 lakes, 2 ponds and 4 rivers in Poland. The highest concentration of sulphate has been detected in rivers (85.47 SO₄ ²⁻ mg/l) and an artificial lake (70.30 SO₄ ²⁻ mg/l) located in the extremely SO₄ ²⁻-polluted region called the “Black Triangle”. The lowest concentration of sulphate is found in dystrophic and mountain lakes (from 0.5 SO₄ ²⁻ to about 3 mg/l). The lowest δ³⁴S(SO₄ ²⁻) and δ¹⁸O(SO₄ ²⁻) values occur in unpolluted lakes in eastern Poland (−0.94 and 1.38‰, respectively). The highest S and O isotopic ratios are found in a polluted lake in western Poland (δ¹⁴S(SO₄ ²)=12.95‰) and in a dystrophic lake in eastern Poland (δ¹⁸O(SO₄ ²) = 16.15‰) respectively. It is proposed that δ³⁴SO₄ ²⁻ and (¹⁸O(SO₄ ²⁻) values in lakes represent a good tool to assess and quantify anthropogenic impact by acid precipitation and to monitor variations in the trophic state and redox processes controlled by biodegradation of organic compounds in sediments and water column. In general, increasing depth (up to 12 m) of the water column is associated with decreasing trend the δ¹³C(CH₄) value from about –35 to about –78‰. However, δ¹³C value in sedimentary calcite (δ¹³C vary from –10 to 0.5‰) shows opposite trends as compared to the corresponding methane. This is probably due to redox processes and distribution of heavy isotopes between methane and calcite. Likewise, turbulent water (river) show high δ¹³C value in methane and low δ¹³C value in calcite—this is probably due to an enhanced oxidation of methane producing ¹³C-depleted CO₂. In contrast to clean lakes, it is observed that an increase of the δ¹³C(CH₄) value occurs with increasing depth of the water column in a strongly SO₄ ²⁻-contaminated lake. This is probably due to a loss of biological buffering potential of the lake accompanied by an active oxidation of methane precursors.     

<Emphasis Type="Italic">Fusarium</Emphasis> head blight incidence and mycotoxin accumulation in three durum wheat cultivars in relation to sowing date and density

Durum wheat (Triticum turgidum var. durum) is an important crop in Europe, particularly in the Mediterranean countries. Fusarium head blight (FHB) is considered as one of the most damaging diseases, resulting in yield and quality reduction as well as contamination of grain with mycotoxins. Three winter durum wheat cultivars originating from Austria, Slovakia, and Poland were analyzed during 2012–2014 seasons for FHB incidence and Fusarium mycotoxin accumulation in harvested grain. Moreover, the effects of sowing density and delayed sowing date were evaluated in the climatic conditions of Southern Poland. Low disease severity was observed in 2011/2012 in all durum wheat cultivars analyzed, and high FHB occurrence was recorded in 2012/2013 and 2013/2014 seasons. Fusarium graminearum was the most abundant pathogen, followed by Fusarium avenaceum. Through all three seasons, cultivar Komnata was the most susceptible to FHB and to mycotoxin accumulation, while cultivars Auradur and IS Pentadur showed less symptoms. High susceptibility of cv. Komnata was reflected by the number of Fusarium isolates and elevated mycotoxin (deoxynivalenol, zearalenone, and moniliformin) content in the grain of this cultivar across all three seasons. Nivalenol was identified in the samples of cv. Komnata only. Genotype-dependent differences in FHB susceptibility were observed for the plants sown at optimal date but not at delayed sowing date. It can be hypothesized that cultivars bred in Austria and Slovakia show less susceptibility towards FHB than the cultivar from Poland because of the environmental conditions allowing for more efficient selection of breeding materials.     

Determination of PCDDs,PCDFs, PCBs and HCB emissions from the metallurgical sector in Poland

Background The aim of the project was to measure the actual emissions of PCDD/F, PCBs and HCB from 20 selected metallurgical installations in Poland, in order to update the national inventory of dioxin emission from metallurgical industry for developing a strategy for dioxins and furans emission abatement from the subject facilities (UNEP 2005). Methods Sampling methodology used in this work was developed at the Cracow University of Technology because of the complexity of simultaneous sampling and determining PCDFs, PCDDs, PCB and HCB. For the determination a GC-MS/MS system was used. Results and Discussion Results from the work indicate that the highest dioxins and PCB concentrations were recorded for iron ore sintering plants at 1.10–1.32 ng total¹ TEQ/Nm³ followed by aluminium scrap melting at 0.03–0.66 ng total TEQ/Nm³. The highest HCB concentrations at 613–1491 ng/Nm³ were also recorded for iron ore sintering plants, whereas at aluminium plants the HCB concentrations were in the range of only 10.1–22.7 ng/Nm³. Conclusions The above investigations indicate that secondary aluminium production is the most significant dioxins source, if calculated as emission factor values. However, iron ore sintering plants are operating at much higher production capacity, causing this process to become the major source of dioxins, PCB and HCB pollution to the atmosphere in Poland. Recommendations and Perspectives Based on the performed tests and the environmental reviews of selected plants several recommendations were formulated for the reduction of generation or of emission of these pollutants from iron ore sintering plants, electric arc furnace steel production processes, hot-blast furnace operations, secondary aluminium smelting and primary zinc production from zinc cathodes.     

Integration studies on a two-stage fermentation process for the production of biohydrogen

Fermentation of biomass residues and second generation biomasses is potentially a way to enable a sustainable production of hydrogen. Simulation models which calculate mass and energy balances, developed with Aspen Plus^®, are used to integrate the process steps necessary to produce pure hydrogen from biomass in a 2-stage fermentation process. Process and heat integration are introduced to reduce the high water and heat demand of the process, connected to the low substrate concentrations in the involved process streams. The results show that the recirculation of process effluents, together with the use of properly designed heat exchangers, can reduce the water and heat demand up to 90% from a non-integrated process, but is also subject to restrictions due to an increase in osmolality in the system.     

Survey of dioxin sources in the Baltic Region (extended summary)

The present paper summarises the results of the project: 'Survey of Anthropogenic Sources of Dioxins and Furans in the Baltic Region'. As a part of the project, inventories have been carried out in Estonia, Latvia, Lithuania and Poland by applying the toolkit for quantification of dioxin and furan releases developed by UNEP Chemicals. The main route of direct releases to the environment is emission to air. Total emission to air from Poland was estimated at 490 (88-1,300) g I-TEQ/year, whereas the emissions from Estonia, Latvia and Lithuania were estimated as being 14 (2.4-54), 23 (2.6-63) and 17 (2.6-38) g I-TEQ, respectively. In general, the uncertainty on the estimates is very high, and recommendations regarding further development of the inventories have been made, and measures for reducing the releases have been provided.