The effect of greenhouse vegetation coverage and area on the performance of an earth-to-air heat exchanger for heating and cooling modes

The underground temperature at a depth of about 3–4 m is almost constant all the year round. In summer, the underground temperature is lower than the ambient temperature, but in winter it is vice versa. This potentiality is considered for greenhouse cooling and heating by using an earth-to-air heat exchanger (EAHE). This paper considers the effects of two parameters as independent variables including the area of greenhouse and the percentage of vegetation coverage inside the greenhouse on the performance of an EAHE system during both cooling and heating modes. The inside temperature, the thermal energy exchange and the coefficient of performance (COP) of the system were considered as dependent variables. The results showed that both greenhouse area and the percentage of vegetation coverage inside the greenhouse had significant effects on the performance of the EAHE system during both cooling and heating modes. However, the COP of the EAHE system was higher in the cooling mode (4.32) than during the heating mode (1.01). The percentage of vegetation coverage negatively affected the performance of the EAHE system in the cooling mode. However, the performance of the EAHE system improved with the increase in the percentage of vegetation coverage during the heating mode.     

Objective approach for analysis of noise source characteristics and acoustic conditions in noisy computerized embroidery workrooms

It is highly important to analyze the acoustic properties of workrooms in order to identify best noise control measures from the standpoint of noise exposure limits. Due to the fact that sound pressure is dependent upon environments, it cannot be a suitable parameter for determining the share of workroom acoustic characteristics in producing noise pollution. This paper aims to empirically analyze noise source characteristics and acoustic properties of noisy embroidery workrooms based on special parameters. In this regard, reverberation time as the special room acoustic parameter in 30 workrooms was measured based on ISO 3382-2. Sound power quantity of embroidery machines was also determined based on ISO 9614-3. Multiple linear regression was employed for predicting reverberation time based on acoustic features of the workrooms using MATLAB software. The results showed that the measured reverberation times in most of the workrooms were approximately within the ranges recommended by ISO 11690-1. Similarity between reverberation time values calculated by the Sabine formula and measured values was relatively poor (R ²?=?0.39). This can be due to the inaccurate estimation of the acoustic influence of furniture and formula preconditions. Therefore, this value cannot be considered representative of an actual acoustic room. However, the prediction performance of the regression method with root mean square error (RMSE)?=?0.23 s and R ²?=?0.69 is relatively acceptable. Because the sound power of the embroidery machines was relatively high, these sources get the highest priority when it comes to applying noise controls. Finally, an objective approach for the determination of the share of workroom acoustic characteristics in producing noise could facilitate the identification of cost-effective noise controls.     

Biodegradation of low-density polyethylene (LDPE) by isolated fungi in solid waste medium

In this study, biodegradation of low-density polyethylene (LDPE) by isolated landfill-source fungi was evaluated in a controlled solid waste medium. The fungi, including Aspergillus fumigatus, Aspergillus terreus and Fusarium solani, were isolated from samples taken from an aerobic aged municipal landfill in Tehran. These fungi could degrade LDPE via the formation of a biofilm in a submerged medium. In the sterilized solid waste medium, LPDE films were buried for 100 days in a 1-L flask containing 400 g sterile solid waste raw materials at 28 °C. Each fungus was added to a separate flask. The moisture content and pH of the media were maintained at the optimal levels for each fungus. Photo-oxidation (25 days under UV-irradiation) was used as a pretreatment of the LDPE samples. The progress of the process was monitored by measurement of total organic carbon (TOC), pH, temperature and moisture. The results obtained from monitoring the process using isolated fungi under sterile conditions indicate that these fungi are able to grow in solid waste medium. The results of FT-IR and SEM analyses show that A. terreus and A. fumigatus, despite the availability of other organic carbon of materials, could utilize LDPE as carbon source. While there has been much research in the field of LDPE biodegradation under solid conditions, this is the first report of degradation of LDPE by A. fumigatus.     

Prevalence of Norovirus Infection in Children and Adults with Acute Gastroenteritis,Tehran, Iran, 2008–2009

Noroviruses are one of important agents that cause acute viral gastroenteritis worldwide. These viruses are belonging to Caliciviridae family and are genetically diverse. To date, there is no valuable data about prevalence of norovirus infection and the dominant genogroup/genotype among Iranian population. The objective of this study was to determine the frequency of norovirus infection in Iranian patients with gastroenteritis referred to three hospitals of Tehran and to specify the dominant genogroup/genotype of this virus among our study population. A total of 293 patients with acute gastroenteritis were included in the study. Detection of norovirus was performed using RT-PCR method and confirmed by direct sequencing with specific designed primers for capsid region of norovirus genome. Phylogenetic analysis was performed using the neighbor-joining method. Norovirus strains identified in our study were subsequently categorized according to previously defined genogroup/genotypes. Of these, norovirus GII was dominant genogroup. Sixty-five percent (17 of 26) of positive samples were determined as GII and 35% (9 of 26) were determined as GI, respectively, in 2008–2009. And among 8 sequenced strains of genogroup II the most frequent genotype was GII.3. The results of this study indicated that norovirus must be considered as one of the infectious causes of acute gastroenteritis among Iranian population. We also found that GII.3 is more prevalent in our study population. To the best of our knowledge there is limited data about the role of noroviruses in children and adults’ acute gastroenteritis among Iranian patients and this prevalence and genotyping report of norovirus infection could be remarkable for further studies.     

Groundwater geochemistry in the Alisadr, Hamadan, western Iran

The chemical composition of 59 well water samples throughout the Alisadr area, Hamadan, western Iran was determined in order to describe the background ion concentration and to identify the major hydrogeochemical processes that control the observed groundwater chemistry. The hydrochemical types, Ca–HCO₃, Ca–SO₄, dominate the largest part of the groundwater followed by water types Ca–Cl and Mg–HCO₃. Total hardness indicated that 30% of groundwater samples fell in the very hard water category. Ninety-seven percent of the water samples showed nitrate ( ${\rm NO}_{3}^{-})$ concentrations above the human affected value (13 mg l^???1 ${\rm NO}_{3}^{-})$ , while 15% exceeded the maximum acceptable level (50 mg l^???1 ${\rm NO}_{3}^{-})$ according to WHO regulations. With respect to sodium adsorption ratio, the groundwater can be used for irrigation on almost all soils with little danger of the developing harmful levels of exchangeable Na^?+?. But with respect to electrical conductivity, the water quality for irrigation was low to medium, providing the necessary drainage to avoid the buildup of toxic salt concentrations. Geochemical modeling using PHREEQC enabled prediction of the saturation state of minerals and indicated the dissolution and precipitation reactions occurring in the groundwater. Groundwaters were undersaturated with respect to amorphous silica. Stability diagram indicated that the dominant cluster of groundwater samples fell into the K-feldspar field.     

Phosphorus sorption–desorption behaviour of river bed sediments in the Abshineh river, Hamedan, Iran, related to their composition

Phosphorus (P) sorption by sediments may play a vital role in buffering P concentration in the overlying water column. To characterize P sorption–desorption in the river bed sediments, 17 bed sediment samples collected from Abshineh river, in a semi arid region, Hamedan, western Iran were studied through a batch experiment and related to sediment composition. The sorbed fraction ranged from 4.4% to 5.4% and from 38.5% to 86.0% of sorption maxima when 20 and 1,500 mg P kg^?1, respectively, was added to the sediment samples. Phosphorus sorption curves were well fitted to the Langmuir model. Zero equilibrium P concentration ranged from 0.10 to 0.51 mg P l^?1 and varied with sediment characteristics. Phosphorus desorption differed strongly among the studied bed sediments and ranged from 10.8% to 80.2% when 1,500 mg P kg^?1 was added. The results of the geochemical modelling indicated that even under low P addition (2 mg l^?1), the solutions are mainly saturated with respect to hydroxyapatite and ß-tricalcium phosphate minerals and undersaturated with respect to other Ca and Mg minerals, whereas under higher P addition (150 mg l^?1), most Ca–P solid phases, except the most soluble mineral (brushite), will likely precipitate. A Langmuir sorption maximum was positively correlated with carbonate calcium. Estimated P retention capacity of the bed sediments are generally lower and zero equilibrium P concentration values higher in upstream sites than at the downstream sites, suggesting that sediments in upstream and downstream may act as source and sink of P, respectively.     

Coral assemblages in Tonga: spatial patterns, replenishment capacities, and implications for conservation strategies

Coral reefs in Tonga have been confronted by multiple threats of various origins, including large-scale disturbances and human-induced stressors. These reef communities have been poorly studied, and efficient conservation actions are urgently needed. The aim of this study was to: (1) examine the spatial distribution of coral assemblages in the lagoon of Tongatapu; (2) determine the degree to which spatial heterogeneity of adult corals is influenced by recruitment processes; and (3) examine the implications of these results in terms of conservation actions. We recorded a total of 37 adult and 28 juvenile coral genera, a mean density of 11.6 adult and 5.5 juvenile colonies m^?2, and a dominance of Montipora, Acropora, and Porites. For seven of the 10 dominant genera, spatial patterns of adults were linked to the short-term recruitment pattern history. Despite a reduced diversity and abundance of adult corals in some areas, the lagoon of Tongatapu retains the potential for replenishment through recruitment of young corals. Consequently, we suggest that conservation actions should focus on reducing factors causing coral mortality and maintain suitable conditions for the establishment and growth of juvenile corals, thus increasing the probability that they will reach maturity and participate to the maintenance of local populations. Rather than establishing a large marine protected area, which will almost certainly suffer from a lack of control and poor enforcement, alternative conservation measures could be successfully implemented through the establishment of several small village-based marine reserves, as has been undertaken in other South Pacific islands with promising results.     

Preparation and Properties of Starch/Nanosilicate Layer/Polycaprolactone Composites

Starch nanocomposites have been prepared using mineral clay. Montmorillonite, kaolin and a surface-modified montmorillonite by dimethyl (hydrogenated tallow alkyl) ammonium cation were used. Starch-g-PCL nanocomposites have been prepared with graft polymerization through in situ ring-opening polymerization of ε-caprolactone in the presence of starch, Sn(Oct)₂ (Tin(II) 2-ethyl hexanoate) as an initiator/catalyst and silicate layers. In fact, the related composites were prepared in solution method, bulk polymerization and in situ polymerization methods with introducing the mineral clay. The effect of kind of clay on d-spacing of silicate layers was investigated and the obtained nanocomposites were analyzed using X-ray diffraction. The obtained compounds were characterized by Fourier transform infrared (FT-IR). Morphology of the prepared nanocomposites was investigated using scanning electron microscopy and DSC enhanced the study of thermal behaviour of the prepared composite compounds.