Environmental monitoring of Micro Prespa Lake basin (Western Macedonia,Greece): hydrogeochemical characteristics of water resources and quality trends

The Micro Prespa basin is a trilateral catchment area of significant importance with a unique ecosystem closely related to the homonymous lake. In this frame, a fully operational monitoring project was carried out including continuous real-time measurements in Micro Prespa Lake with the use of a multi-sensor probe, as well as periodical sampling and analyses of all available water systems for an extended set of 85 parameters. Four main interacting water systems were identified, including alluvial and karstic aquifers, Micro Prespa Lake and adjacent drainage network. The results outlined that general environmental conditions are satisfying in respect to the relative legislation and the hydrogeochemical signatures. However, trends of environmental pressures were ascertained as a result of natural (geogenic) factors, embracing seasonal peaks for Ni, Pb, and NH₄ mainly in groundwater systems. Based on chlorophyll a records, Micro Prespa is classified as oligotrophic to slightly mesotrophic, subjected to seasonal variations. Heavy metal concentrations are low, except Ni which appears to have elevated values during the dry hydrological period. Finally, the hydrogeochemistry of drainage network is primarily influenced by surface runoff of the surrounding mountainous areas, hence elevated phosphorus values of the Aghios Germanos stream are possibly linked with the leaching of the granitic formations on the east.     

Effects of low concentration biodiesel blend application on modern passenger cars. Part 1: Feedstock impact on regulated pollutants, fuel consumption and particle emissions

Five biodiesels from different feedstocks (rapeseed, soy, sunflower, palm, and used fried oils) blended with diesel at 10% vol. ratio (B10), were tested on a Euro 3 common-rail passenger car. Limited effects (−2% to +4%) were observed on CO₂ emissions. CO and HC emissions increased between 10% and 25% on average, except at high speed - high power where emissions were too low to draw conclusions. NOx emissions increased by up to 20% for two out of the five blends, decreased by up to 15% for two other blends, and remained unchanged for one blend. Particulate matter (PM) was reduced for all blends by up to 25% and the reductions were positively correlated with the extent of biodiesel saturation. PM reductions are associated with consistent reductions in non-volatile particle number. A variable behaviour in particle number is observed when volatile particles are also accounted.     

Potential effects of particulate matter from combustion during services on human health and on works of art in medieval churches in Cyprus

Indoor and outdoor particulate matter (PM_0.3-10) number concentrations were established in two medieval churches in Cyprus. In both churches incense was burnt occasionally during Mass. The highest indoor PM_0.5-1 concentrations compared with outdoors (10.7 times higher) were observed in the church that burning of candles indoors was allowed. Peak indoor black carbon concentration was 6.8 μg m⁻³ in the instances that incense was burning and 13.4 μg m⁻³ in the instances that the candles were burning (outdoor levels ranged between 0.6 and 1.3 μg m⁻³). From the water soluble inorganic components determined in PM₁₀, calcium prevailed in all samples indoors or outdoors, whilst high potassium concentration indoors were a clear marker of combustion. Indoor sources of PM were clearly identified and their emission strengths were estimated via modeling of the results. Indoor estimated PM_0.3-10 mass concentrations exceeded air quality standards for human health protection and for the preservation of works of art.     

Metal concentrations and metallothionein levels in Mytilus galloprovincialis from Elefsis bay (Saronikos gulf, Greece)

Spatial and temporal variability of Cd, Cu, Cr, Ni, Zn, Fe and Mn and metallothionein (MT) concentrations were determined in mussels Mytilus galloprovincialis from Elefsis bay (Saronikos gulf, Greece). Higher concentrations of both metal concentrations and MTs were recorded in mussels inhabiting industrial locations (steelworks and shipyard), indicating a markedly higher metal bioavailability. However at these sites, located at the eastern part of the bay, mussel metal concentrations were not always correlated with both seawater metal concentrations and MTs possibly due to different time scales of integration of the metal sources into mussels and/or the participation of other metal regulatory mechanisms except MT induction. The pattern of the temporal variation of mussel metal concentrations and the MT levels was similar among stations with higher values during the winter–spring season and lower during the summer–autumn period. The inverse relationship of flesh condition index with mussel metal concentrations was attributed to the influence of mussel annual reproductive cycle.     

Assessing the quality of marine coastal environments: comparison of scope for growth and Microtox bioassay results of pollution gradient areas in eastern Mediterranean (Greece)

Methods for assessing the quality of marine coastal environments are numerous and rapidly evolving. The integration of physiological parameters termed as Scope for Growth (SfG) and the luminescent bioassay Microtox were applied in several sites of Saronikos and Amvrakikos Gulfs (Greece) to assess the environmental quality and compare the results of the two methods. Each site in the two areas undergoes different types and levels of pollution. Both methods could identify a pollution gradient reflecting the quality of each site. A very good linear correlation was noticed between the two methods (r = 0.98). The stress order, which was similar in both methods, exhibited the expected pollution gradient according to the pressure that each site undergoes. Results suggest that for screening and fast isolation of polluted sites before further analysis, the rapid and simple Microtox assay could operate as an alternative to the more complex SfG method.     

Dispersion of volatile hydrocarbons in urban street canyons

Volatile hydrocarbons (VHCs) were monitored in two urban street canyons for 16 days. Measurements of 15 selected VHCs were performed simultaneously at three different sampling heights: at street level (2 m), at 8 m, and at the rooftop (25 m above the ground). The aim of the study was to investigate the factors responsible for the horizontal and vertical changes in VHC concentrations. Physical parameters controlling the concentration gradients (wind flow and speed) were enabled. It was concluded that dilution and dispersion decrease the concentrations of HCs emitted at street level by approximately a factor of 6 between rooftop and street levels. Low winds and winds parallel to the street axis were identified as the worst dispersion conditions. The correlation between the measured VHC concentrations gave an insight into their fate. An empirical relationship between CO and benzene was established. These results may have important implications in planning monitoring studies to support research on population exposure in urban areas.     

Effects of diesel/biodiesel blends on regulated and unregulated pollutants from a passenger vehicle operated over the European and the Athens driving cycles

This paper presents the regulated and unregulated exhaust emissions of a diesel passenger vehicle, operated with low sulphur automotive diesel and soy methyl ester blends. Emission and fuel consumption measurements were conducted under real driving conditions (Athens Driving Cycle, ADC) and compared with those of a modified New European Driving Cycle (NEDC) using a chassis dynamometer. A Euro II compliant diesel vehicle was used in this study, equipped with an indirect injection diesel engine, fuelled with diesel fuel and biodiesel blends at proportions of 5, 10, and 20% respectively. Unregulated emissions of 11 polycyclic aromatic hydrocarbons (PAHs), 5 nitro-PAHs, 13 carbonyl compounds (CBCs) and the soluble organic fraction (SOF) of the particulate matter were measured. Qualitative hydrocarbon analysis was also performed on the SOF. Regulated emissions of NO_x, CO, HC, CO₂, and PM were also measured over the two test cycles. It was established that some of the emissions measured over the (hot-start) NEDC differed from the real-world cycle. Significant differences were also observed in the vehicle's fuel consumption between the two test cycles. The addition of biodiesel reduced the regulated emissions of CO, HC and PM, while an increase in NO_x was observed over the ADC. Carbonyl emissions, PAHs and nitro-PAHs were reduced with the addition of biodiesel over both driving cycles.     

Characterization of atmospheric particulates, particle-bound transition metals and polycyclic aromatic hydrocarbons of urban air in the centre of Athens (Greece)

The concentrations of trace metals and polycyclic aromatic hydrocarbons (PAHs) adsorbed to total suspended particulate (TSP) and finer fractions of airborne particulate matter (PM) were determined from a site in the centre of Athens (Greece), which is characterized by heavy local traffic and is densely populated, during the winter and summer periods in 2003-2004. Also, we collected and analyzed samples of diesel and gasoline exhaust particles from local vehicles (buses, taxis and private cars) and from chimney exhaust of residential central heating appliances. A seasonal effect was observed for the size distribution of aerosol mass, with a shift to larger fine fractions in winter. The most commonly detected trace metals in the TSP and PM fractions were Fe, Pb, Zn, Cu, Cr, V, Ni and Cd and their concentrations were similar to levels observed in heavily polluted urban areas from local traffic and other anthropogenic emissions. Analysis of 16 PAHs bound to PM showed that they are mostly traffic related. In general, the fine particulate PAHs concentrations were higher than coarse particles. The most common PAHs in PM(10.2) and PM(2.1) were pyrene, phenanthrene, acenapthylene and fluoranthene, which are associated with diesel and gasoline exhaust particles. The results of this study underlined the importance of local emission sources, especially vehicular traffic, central heating and other local anthropogenic emissions. Compared with other big cities, Athens has much higher levels of airborne particles, especially of the finer fractions PM(10) and PM(2.5), correlated with traffic-related air pollution.     

Air quality in cabin environment of different passenger cars: effect of car usage,fuel type and ventilation/infiltration conditions

Environmental Science and Pollution Research - Despite that commuters spend only 5.5% of their time in cabin vehicles, their exposure to harmful air pollutants, originated from the vehicle itself,...     

Evaluation of potential dermal exposure of pesticide spray operators in greenhouses by use of visible tracers

In the present study, the potential dermal and inhalation exposure of the operator was measured, following simulation of insecticide application with the dye tracer Sunset Yellow in greenhouse cucumbers and tomatoes. For the monitoring of operator exposure, the whole body technique was used. The potential inhalation exposure was measured with a personal air sampler equipped with a glass fiber filter. The potential dermal operator exposure ranged from 84.4 to 526.7 ml of spray solution (s.s.)/h for the whole body and from 18.5 to 62.5 ml s.s./h for hands in the case of greenhouse cucumbers. The respective inhalation exposure was between 0.17 and 1.0 ml s.s./h. For greenhouse tomatoes, the potential body exposure was in the range of 22.4 to 62.1 ml s.s./h. The hand exposure varied from 5.5 to 6.1 ml s.s./h. The potential inhalation exposure was in the range of 0.33 to 0.43 ml s.s./h. The potential dermal operator exposure is a highly variable parameter, with a variation factor higher than 100% in many cases. One of the most critical factors for the determination of both potential dermal and inhalation exposure is the application pressure. Other field and operational conditions, including unpredictable factors, are also important for the determination of operator exposure levels. The measured potential dermal operator exposure values were above the levels of exposure estimated with mathematical models.