Investigation the effect of adding graphene oxide into diesel/higher alcohols blends on a diesel engine performance

ABSTRACT

This article aims to study the influence of the addition of graphene oxide nanoparticles (GO) to diesel/higher alcohols blends on the combustion, emission, and exergy parameters of a CI engine under various engine loads. The higher alcohols mainly n-butanol, n-heptanol, and n-octanol are blended with diesel at a volume fraction of 50%. Then, the 25 and 50 mg/L concentrations of GO are dispersed into diesel/higher alcohols blends using an ultrasonicator. The GO structures are examined using TEM, TGA, XRD and FTIR. The findings show that there is a reduction in p_max. and HRR when adding higher alcohols with diesel fuel. Regarding engine emission, there is a significant improvement in emissions formation with adding higher alcohols. The addition of GO into diesel/higher alcohols blends improves the brake thermal efficiency by 15%. Moreover, the p_max. and HRR are both enhanced by 4%. The CO, UHC and smoke formation are reduced considerably by 40%, 50 and 20%, respectively, while NO_x level is increased by 30% with adding GO. Finally, adding high percentages of n-butanol, n-heptanol, and n-octanol with diesel fuel with the presence of GO has the potential to achieve ultra-low CO, UHC, and smoke formation meanwhile keeping high thermal efficiency level.     

Bioremediation of kerosene I: A case study in liquid media

The ability of different local isolates in addition to some isolates from Germany to degrade kerosene in liquid medium was studied. The results showed that the percent of kerosene degradation varied among the different organisms and that 59–94% of kerosene was degraded after 21 d. Two local isolates (Pseudomonas sp. AP and Pseudomonas sp. CK) and one German isolate (Gordonia sp. DM) were selected for this study. The addition of wheat bran, as co-substrate, stimulated the kerosene degradation by the two local strains, while glucose inhibited the degradation rate using the three organisms with different rates. Ammonium nitrate and urea was the best nitrogen sources. The use of superphosphate (as phosphorus source) in the presence of urea stimulates the degradation rate. It was also observed that the addition of 1% surfactants, like Triton X-100, Igepal, Tergitol, or Tween 20 and 80 enhanced the kerosene degradation. The degradation percent lied between 94% and 98%. The ability of the tested organisms to degrade kerosene concentration from 2% to 8% was evaluated. It was found that the three organisms degraded about 65–85% from 8% kerosene after 21 d. The use of rice straw-immobilized cells reduced the time of degradation and enhanced the degradation ability of the organisms. The sodium dodecyl sulphate-polyacrylamide gel electrophoresis revealed the presence of a common protein band when the tested organisms were grown on kerosene.     

Biodesulfurization of refractory sulfur compounds in petro-diesel by a novel hydrocarbon tolerable strain Paenibacillus glucanolyticus HN4

Environmental Science and Pollution Research - One of the main precursors of air pollution and acid rains is the presence of the recalcitrant thiophenic compounds, for example dibenzothiophene...     

Modeling and simulation of biogas-fueled power system

The main objective of this paper is to develop a complete model that fully simulate a biogas-fueled power plant which can be used to supply a rural farm with sufficient electricity. The reactor is fed with animal manure of the farm. The proposed model consists of three main parts; a biogas reactor, a microturbine (MT) coupled to a permanent magnet synchronous generator, and a storage system. The model describes the dynamics of an MT and it is suitable for both steady state and transient simulation and analysis. The volume of biogas output delivered from the Anaerobic Digester depends on the reactor volume, reactor temperature, and animal manure type. The storage system is used to store the excess value of biogas if any. It is composed of two parts: a comparator and a storage tank. The comparator compares the volume of biogas produced by the reactor with that needed to supply the load. An adaptive controller is developed to withstand the system against any transient condition such as suddenly load increase/decrease. The proposed model is implemented for chemical and physical behaviors of the biogas production process, as well as for different variables of MT-generator operations. The model is implemented in Matlab/Simulink environment and tested under different operating conditions in both steady state and transient status to study the impacts of different variables on the system output. The output results prove its applicability and effectiveness under different operating conditions.     

Do female roe deer in good condition produce more sons than daughters

In polygynous roe deer Capreolus capreolus, males are only slightly heavier than females and the overall sex ratio at birth is close to unity. We studied offspring sex ratio and litter size (range 1–4, n = 74) of culled females, in utero, which provided an opportunity to examine responses of sex ratio to maternal condition. Male embryos were heavier than their sisters, and male fawns (9 months old) heavier than female fawns, suggesting a higher growth rate in males. There was no evidence for differential mortality between the sexes from birth to 9 months old. Heavier adult females produced larger embryos than lighter, or primiparous females. The overall sex ratio of embryos did not differ from unity, but adult does had more male embryos (55%) than primiparous does (32%), and the proportion of male embryos in a litter increased with the mother's body mass. Litter size also tended to increase with maternal age and body mass. We argue that this pattern reflects adaptive variation in offspring sex ratio.     

Potential of windrow food and green waste composting in Tunisia

Environmental Science and Pollution Research - Solid waste management and disposal is one of the most significant challenges facing urban communities around the world. There is a wide range of...     

Natural radioactivity in farm soil and phosphate fertilizer and its environmental implications in Qena governorate, Upper Egypt

Samples of phosphate fertilizers and farm soils, taken to a depth of up to 30 cm in cultivated land, were collected over the Qena governorate, Upper Egypt. Activity concentration of background radionuclides such as (226)Ra, (232)Th and (40)K of these samples were determined by gamma-ray spectrometry. The results show that these radionuclides were present in concentrations of 366+/-10.5, 66.7+/-7.3 and 4+/-2.6 Bq/kg for phosphate fertilizers. For farm soil and Nile island's soil the corresponding values were 13.7+/-7, 12.3+/-4.6, 1233+/-646 and 11.9+/-6.7, 10.5+/-6.1, 1636+/-417 Bq/kg, respectively. The radium equivalent activity (Ra(eq)), the representative level index, I(gamma r), and absorbed dose in air for all samples were calculated. The data were discussed and compared with those given in the literature.     

Measurement of natural radioactivity in building materials in Qena city, Upper Egypt

Building materials cause direct radiation exposure because of their radium, thorium and potassium content. In this paper, samples of commonly used building materials (bricks, cement, gypsum, ceramics, marble, limestone and granite) in Qena city, Upper Egypt have been collected randomly over the city. The samples were tested for their radioactivity contents by using gamma spectroscopic measurements. The results show that the highest mean value of (226)Ra activity is 205+/-83 Bqkg(-1) measured in marble. The corresponding value of (232)Th is 118+/-14 Bqkg(-1) measured in granite. For (40)K this value is (8.7+/-3.9)x10(2) Bqkg(-1) measured in marble. The average concentrations of the three radionuclides in the different building materials are 116+/-54, 64+/-34 and (4.8+/-2.2)x10(2) Bqkg(-1) for (226)Ra, (232)Th and (40)K, respectively. Radium equivalent activities and various hazard indices were also calculated to assess the radiation hazard. The maximum mean of radium equivalent activity Ra(eq) is 436+/-199 Bqkg(-1) calculated in marble. The highest radioactivity level and dose rate in air from these materials were calculated in marble.