Optimization of the O3/H2O2 process with response surface methodology for pretreatment of mother liquor of gas field wastewater

• Real ML-GFW with high salinity and high organics was degraded by O₃/H₂O₂ process. • Successful optimization of operation conditions was attained using RSM based on CCD. • Single-factor experiments in advance ensured optimal experimental conditions. • The satisfactory removal efficiency of TOC was achieved in spite of high salinity. • The initial pH plays the most significant role in the degradation of ML-GFW. The present study reports the use of the O₃/H₂O₂ process in the pretreatment of the mother liquor of gas field wastewater (ML-GFW), obtained from the multi-effect distillation treatment of the gas field wastewater. The range of optimal operation conditions was obtained by single-factor experiments. Response surface methodology (RSM) based on the central composite design (CCD) was used for the optimization procedure. A regression model with Total organic carbon (TOC) removal efficiency as the response value was established (R² = 0.9865). The three key factors were arranged according to their significance as: pH>H₂O₂ dosage>ozone flow rate. The model predicted that the best operation conditions could be obtained at a pH of 10.9, an ozone flow rate of 0.8 L/min, and H₂O₂ dosage of 6.2 mL. The dosing ratio of ozone was calculated to be 9.84 mg O₃/mg TOC. The maximum removal efficiency predicted was 75.9%, while the measured value was 72.3%. The relative deviation was found to be in an acceptable range. The ozone utilization and free radical quenching experiments showed that the addition of H₂O₂ promoted the decomposition of ozone to produce hydroxyl radicals (·OH). This also improved the ozone utilization efficiency. Gas chromatography-mass spectrometry (GC-MS) analysis showed that most of the organic matters in ML-GFW were degraded, while some residuals needed further treatment. This study provided the data and the necessary technical supports for further research on the treatment of ML-GFW.     

南京市典型地区大气多环芳烃污染特征及健康风险评价

采用气相色谱-质谱法,于2016年9月和12月对南京市2个典型地区大气中16种多环芳烃(PAHs)的质量浓度进行分析,并开展了PAHs组成特征、来源解析及人体健康风险评价研究。结果表明,工业区(六合区)和生活区(江宁区)大气(气态和可吸入颗粒态)中16种PAHs的质量浓度分别为914.82和712.27 ng/m~3,苯并[a]芘毒性等效浓度分别为274.1和309.84 ng/m~3,且呈现冬季高、秋季低的特征。比值法源解析结果表明,燃煤污染是六合区PAHs污染主要来源,而江宁区主要表现为交通污染。人体健康风险评价结果表明,六合区和江宁区人群通过大气吸入PAHs的超额致癌风险分别为5.17×10~(-5)和5.85×10~(-5),均略高于可接受水平10~(-6)。     

液液萃取-气相色谱/串联质谱法测定水中五氯酚及其钠盐

采用液液萃取处理水样,用气相色谱-串联质谱法测定样品中五氯酚及其钠盐,通过优化测定条件,使方法在1.00μg/L~500μg/L范围内线性良好。检出限和定量限分别为1.00μg/L和5.00μg/L,空白水样五氯酚钠3个质量浓度水平的加标回收率为89.8%~98.4%,5次平行试验测定结果的RSD为5.5%~10.7%。     

秦巴山区降雨侵蚀力时空变化特征

降雨侵蚀力时空变化特征的研究对区域土壤侵蚀风险评估及水土保持规划具有重要的意义。利用秦巴山区及周边地区共63个气象站1961~2016年的逐日降雨量数据计算各站的降雨侵蚀力，借助Kriging空间插值法、Mann-Kendall趋势检验、Pettitt突变检验等方法分析了秦巴山区降雨侵蚀力的时空变化特征。结果表明：秦巴山区年均降雨侵蚀力为3 696 MJ·mm/(hm²·h·a)，年内变化呈单峰型，7月最大，占全年的26.6%；四季中，夏季最大，冬季最小。代际间，20世纪80年代的降雨侵蚀力最大，90年代最小。年际间，年降雨侵蚀力存在明显的阶段性，但未表现出显著的趋势性和突变性特征。秦巴山区多年平均降雨侵蚀力呈南高北低的分布格局，不同地区年均降雨侵蚀力变化于787~8 858 MJ·mm/(hm²·h·a)之间；整体而言，年降雨侵蚀力随纬度增加而减小，随海拔升高而减小。     

Enhanced arsenate removal from aqueous solution by Mn-doped MgAl-layered double hydroxides

Environmental Science and Pollution Research - In this study, Mn-doped MgAl-layered double hydroxides (LDHs) were successfully synthesized for efficient removal arsenate from aqueous solution. The...     

资阳市大气污染源排放清单研究

采用实地调研、资料收集等方式获得了2017年资阳市典型污染源的活动水平数据,参照城市大气污染物排放清单编制技术手册建立了基于排放因子法和物料衡算法的资阳市大气污染源排放清单,分析了主要污染物的行业排放特征和空间分布特征。结果表明,2017年资阳市SO₂、NO_X、CO、PM₁₀、PM_2.5、VOCs、NH₃总排放量分别为3.58kt、13.91kt、94.91kt、25.51kt、8.67kt、23.84kt和46.44kt。SO₂排放主要来自工业源;NOX排放主要来自移动源;CO排放主要来自工业过程及移动源;PM₁₀和PM_2.5、排放来自扬尘源和露天秸秆焚烧;VOCs主要来自溶剂使用源;NH₃主要来自农业活动。资阳市主要污染物排放分布在工业点源较为集中的雁江区和安岳县,乐至县污染物排放量相对较小。     

Characteristic and mechanism of sorption and desorption of benzene on humic acid

Environmental Science and Pollution Research - The sorption/desorption behaviors of benzene, toluene, ethylbenzene, and xylene (BTEX) on soil organic matter (SOM) have a significant influence on...     

神农架大九湖移民搬迁居民能源替代探讨

自2013年开始,神农架大九湖湿地启动生态移民工程.为了解大九湖生态搬迁后居民用火用电情况以及资源消耗情况变化,采用样地调查和走访调查的方法,对搬迁户、未搬迁户的能源消耗情况进行收集和分析.结果 表明:除了人口和牲畜数量,海拔也是家庭影响能源消耗的重要因素,薪柴量和用电量相差84％和62.1％,因此搬迁工作可以优先考虑高海拔地区;搬迁前后,居民做饭消耗从基本完全依赖薪柴转变为燃气和电混用,取暖消耗由薪柴转变为燃煤,搬迁后,居民实现了薪柴的零消耗和森林零砍伐,用电量大幅增加,相比搬迁前生活成本增加了折合3450元左右;搬迁后居民居住条件、生活条件、交通设施、创收机会均有所改善;搬迁的431户居民相当于每年保护森林47.08 hm2,对于封山育林和生态恢复工作起到了积极作用.     

微波强化CWPO工艺CuO_x-CeO_2/GAC催化剂的制备及其对二甲亚砜的降解

以颗粒活性炭(GAC)为载体、铜为活性组分、铈为助剂组分、草酸钠为沉淀剂,采用浸渍焙烧法制得CuO_x-CeO_2/GAC催化剂。以H_2O_2为氧化剂,微波强化催化湿式过氧化氢氧化(CWPO)处理二甲亚砜(DMSO)初始质量浓度为1 000 mg/L的废水,处理3 min后DMSO去除率达93.8%。催化剂第7次使用时DMSO去除率仍保持在75%以上。初始废水pH在3~9范围内,DMSO去除率均在85%以上。助剂Ce的加入提高了催化剂表面活性组分的分散性和稳定性,使催化剂的活性稳定性和使用寿命显著提高。     

网状季胺基阴离子吸附剂制备及吸附性能

以丝瓜络为原料,采用醚化-接枝技术制备出季胺基阴离子交换吸附剂。采用电镜扫描、傅里叶红外光谱、比表面积孔径分布测定仪和元素分析仪等仪器对其进行分析和结构表征,并考察了温度、p H和硝酸盐初始浓度等因素对NO-3去除率的影响。实验结果表明,在20℃,p H值为3~10时,NO-3的吸附率可达90%左右;在不同温度下该吸附过程用Langmuir等温线模型和Freundich等温线模型描述均可;与伪一级动力学方程相比,伪二级动力学方程能更好地描述其吸附动力学方程。