Comparison of different sequential extraction procedures for mercury fractionation in polluted soils

Environmental Science and Pollution Research - Three sequential extraction procedures (SEPs), modified Tessier, modified BCR, and CIEMAT, were compared for mercury fractionation in polluted soils....     

Low digestibility of phytate phosphorus,their impacts on the environment,and phytase opportunity in the poultry industry

Environmental Science and Pollution Research - Phosphorus is an essential macro-mineral nutrient for poultry, needed for the body growth, development of bones, genomic function, good...     

Correction to: Preparation of GO/MIL-101(Fe,cu) composite and its adsorption mechanisms for phosphate in aqueous solution

Environmental Science and Pollution Research - A Correction to this paper has been published: https://doi.org/10.1007/s11356-021-15526-6     

Comprehensive utilization of residues of Magnolia officinalis based on fiber characteristics

Journal of Material Cycles and Waste Management - The traditional Chinese medicinal plant Magnolia officinalis has a wide range of applications; including more than 200 kinds of patented Chinese...     

Estimating sampling frequency in pollen exposure assessment over time

A time series model was fitted to the pollen concentration data collected in the Greater Cincinnati area for the Cincinnati Childhood Allergy and Air Pollution Study (CCAAPS). A traditional time series analysis and temporal variogram approach were applied to the regularly spaced databases (collected in 2003) and irregularly spaced ones (collected in 2002), respectively. The aim was to evaluate the effect of the sampling frequency on the sampling precision in terms of inverse of standard error of the overall level of mean value across time. The presence of high autocorrelation in the data was confirmed and indicated some degree of temporal redundancy in the pollen concentration data. Therefore, it was suggested that sampling frequency could be reduced from once a day to once every several days without a major loss of sampling precision of the overall mean over time. Considering the trade-offs between sampling frequency and the possibility of sampling bias increasing with larger sampling interval, we recommend that the sampling interval should take values from 3 to 5 days for the pollen monitoring program, if the goal is to track the long-term average.     

亲水性多孔载体在流化床中的生物膜形成过程分析

采用实验制备的一种新型亲水性多孔聚合物作为流化床反应器中生物膜附着生长的载体,实现流态化水力条件下的生物挂膜过程.在3个结构尺寸相同的流化床反应器中考察了接种污泥浓度、进水有机负荷及载体粒径对亲水性多孔载体生物挂膜量的影响,试验结果表明,接种污泥浓度为30 g VSS/L、进水TOC值为350 mg/L、载体粒径为5～8 mm时载体表面的附着生物量最大,反应器运行12 d的载体附着生物量达到4.45 g VSS/L,膜结构稳定,表现出较活性污泥法更高的活性.在进水TOC、氨氮浓度分别为350 ms/L、50 mg/L,HRT为6 h的情况下,两者的去除率分别达到了97.1%和64.3%,表明载体上的生物膜对污水中TOC及氨氮的去除表现出高效率.挂膜后载体表面上的微生物以丝状菌为主,孔壁上的微生物以球菌和杆菌为主要生物相,证明载体内外表面皆适宜微生物的生长,并且形成合理的生物相分布.     

地震救灾过渡安置点避雷针的布设选点及安装要求

"5.12"汶川8级大地震波及范围很大,给陕西省部分地方造成了不小的损失.灾后,汉中、宝鸡的地震救灾过渡安置点由于缺乏防雷电保护,打雷时有遭受雷电灾害的可能,亟需要对其采取防雷电保护措施.对救灾过渡安置点采用独立避雷针进行防护,该措施安全可靠、简便易行,就成为首选,其布设选点要科学、规范,可使其效益最大化,避雷针的制作和安装应符合技术标准要求,做到牢固可靠,在施工中要因地制宜.综合考虑,始终把安全和牢靠放在首位.     

计算机模拟研究UO2+2在人体细胞液的形态分布

建立了由多种金属离子和小分子配体组成的多相细胞液热力学平衡模型.模拟研究了UO2 2在组织液和细胞液的形态分布及CO2-3、氨三乙酸（NTA）和乙二胺四乙酸（EDTA）浓度对细胞液中UO2 2形态分布的影响.在组织液中,正常生理pH下,当各形态UO2 2总摩尔浓度 [U]= 1.0×10-6 mol/L 或[U]=1.0×10-3 mol/L时,UO2 2均主要以[UO2(CO3)3]4-和[UO2(CO3)2]2-形态存在.在细胞液中,当[U]=1.0×10-6 mol/L时,UO2 2主要以[UO2(CO3)3]4-和[UO2(CO3)2]2-存在；当[U]=1.0×10-3 mol/L,pH为6.0～6.8时,细胞液中存在大量的固相(UO2)3(PO4)2·4H2O,当pH为6.8～7.4时,UO2 2主要以[UO2(CO3)3]4-、[UO2(CO3)2]2-和[(UO2)2CO3(OH)3]-存在.细胞液中(UO2)3(PO4)2·4H2O含量随[U]升高而增加.通过调节细胞液pH和增加细胞液CO2-3浓度均能降低其固相UO2 2配合物含量.在细胞液中增加NTA会增加(UO2)3(PO4)2·4H2O含量,当添加EDTA时会显著降低(UO2)3(PO4)2·4H2O含量.     

蚯蚓生态滤池处理农村生活污水现场试验研究

对蚯蚓生态滤池处理太湖流域农村生活污水进行现场试验研究.通过对蚯蚓同化容量与污染负荷进行单因素分析,得出蚯蚓生态滤池处理农村生活污水的运行参数与运行方式,并据此进行连续运行试验.结果表明,在表面水力负荷1 m3/(m2*d)、湿干比(布水时间和落干时间之比)1∶3、蚯蚓负荷(以单位体积填料中蚯蚓的质量计)12.5 g/L的条件下,蚯蚓生态滤池处理农村生活污水具有可行性与高效性,单级系统的COD、总氮、氨氮和总磷的去除率分别在81%、66%、82%和89%左右.改进蚯蚓床填料、设计通风结构和采取适宜运行方式,是蚯蚓生态滤池成功应用于农村生活污水处理的三大重要因素.     

Fast and efficient aqueous arsenic removal by functionalized MIL-100(Fe)/rGO/δ-MnO2 ternary composites: Adsorption performance and mechanism

Because of its significant toxicological effects on the environment and human health,arsenic(As) is a major global issue.In this study,an Fe-based metal-organic framework(MOF)(Materials of Institut Lavoisier:MIL-100(Fe)) which was impregnated with reduced graphene oxide(rGO) by using a simple hydrothermal method and coated with birnessitetype manganese oxide(δ-MnO_2) using the one-pot reaction process(MIL-100(Fe)/rGO/δ-MnO_2 nanocomposites) was synthesized and applied successfully in As removal.The removal efficiency was rapid,the equilibrium was achieved in 40 min and 120 min for As(Ⅲ) and As(Ⅴ),respectively,at a level of 5 mg/L.The maximum adsorption capacities of As(Ⅲ) and As(Ⅴ) at pH 2 were 192.67 mg/g and 162.07 mg/g,respectively.The adsorbent revealed high stability in pH range 2-9 and saturated adsorbent can be fully regenerated at least five runs.The adsorption process can be described by the pseudo-second-order kinetic model and Langmuir monolayer adsorption.The adsorption mechanisms consisted of electrostatic interaction,oxidation and inner sphere surface complexation.