Current status and research on E-waste issues in Asia

Rapid economic growth in Asia and the increasing transboundary movement of secondary resources will increasingly require both 3R endeavors (reduce, reuse, recycle) in each country and appropriate control of international material cycles. Recently, managing electrical and electronic waste (E-waste) has become an important target for domestic and international material cycles from the viewpoints of environmental preservation and resource utilization efficiency. To understand the current status of E-waste issues in the context of international material cycles and to discuss the future tasks related to achieving 3R in the region, we organized the National Institute for Environmental Studies (NIES) E-waste Workshop in December 2004. This article reviews past studies on E-waste and briefly describes the topics presented and discussions held at the workshop. The topics at the workshop included E-waste generation, recycling systems, international trade, and environmental impacts. In addition, we discussed various issues such as terminology, current environmental concerns, and possible solutions. Transboundary shipments of E-waste should be conducted taking into consideration the concept of sustainable development. The direction of future research and possible collaborations are also discussed.     

Comparison of end-of-life vehicle material flows for reuse,material recycling,and energy recovery between Japan and the European Union

Journal of Material Cycles and Waste Management - Japan and the European Union (EU) both have well-established End-of-Life Vehicle (ELV) policies and management systems. However, due to the...     

Measurement of Fine Particles in Diesel Emissions Using a Real-Time Aerosol Monitor

Abstract

A real-time monitoring methodology to determine diesel fine particles in diesel emissions has been evaluated. The range of particle size captured by the monitor was ～0.1 μm to 1 μm. DustTrak real-time monitors were connected to the dilution tunnel of the vehicle exhaust to measure the emissions during the vehicle tests under both dynamic and steady-state driving conditions, and concentration data were recorded every 5 sec. Test variation of the real-time monitoring among different test days was similar to that measured by traditional filter-based gravi-metric method, whereas the repeatability of the monitor data within the same-day tests was better than that of gravimetric method. Correlations between the two methods were established for different fuels tested on a single light duty vehicle. When the emissions from the reference fuel was used to convert the monitor’s response to diesel fuels, the levels determined by the real-time monitor were consistent with those measured by gravimetric method among different fuels tested. Use of the real-time monitor could provide information on the levels of fine particles that is more relevant to the public health than the total particles.     

Japan’s waste management policies for dioxins and polychlorinated biphenyls

We summarize the measures taken by the Japanese government to prevent the emission of dioxins and polychlorinated biphenyls (PCBs) into the environment. Because incineration is the main method of waste management in Japan, reducing the amount of dioxins emitted from waste incinerators is an essential aspect of proper waste treatment. Intensive measures to prevent the formation of dioxins at the source have been implemented, with a focus on waste treatment methods and improving comprehensive management. The efforts have been very successful, with a 95% reduction in the amount of dioxins emitted between 1997 and 2003. The toxicity of PCBs has been monitored with keen interest since the Yusho incident. Unfortunately, treatment facilities for PCB wastes were not built until long after PCBs had been removed from use, and PCB wastes remained in storage in an untreated state. The Japanese government has promoted the construction of facilities for treating PCB wastes, and five such facilities have commenced operations. To more completely eradicate dioxins, a future challenge will be to reduce the amount of PCB-derived dioxins, which are persistent in the environment and have a long exposure pathway from the environment media to the organism and the human body.     

Material cycles in Asia: especially the recycling loop between Japan and China

In this article, we clarify the current status of Japanese exports and Chinese imports of secondary resources. A total of around 10 million metric tons (t) of secondary resources are exported annually from Japan to China, Hong Kong, and Korea. Hong Kong plays the role of a transshipment point, especially regarding the trade in plastic waste, and China imports much from the USA and Japan, often through Hong Kong. The secondary resources exported from Japan include both byproducts from manufacturing processes and end-of-life products or materials. The great demand in China, and the difference in prices between countries, drive this transboundary shipment, although Japan has enacted various recycling laws that were implicitly intended to promote domestic recycling. In China, the imported secondary resources are recycled, usually by means of primitive and low-cost hand labor. The greatest concern is whether there are still improper (illegal or polluting) recycling activities in China. International material cycles should prevent environmental pollution and ensure efficient resource utilization. To that end, the following measures are needed: cooperative control of the trade of secondary resources between countries, the alignment of domestic laws with the regulations in other countries based on the actual trade activities, and the realization of sound practices for global resources management.     

Development of a database of landfills and dump sites in Asian countries

This article briefly summarizes the limited landfill/dump information available for developing Asian countries, and introduces a database that aims to close the information gap through collecting and sharing data. Developing nations usually try to adapt the systems and technologies of developed countries. However, this approach may not be appropriate because of differences in socioeconomic, cultural, and political backgrounds. Many waste management projects fail after operations are transferred to local authorities owing to a lack of funds to cover the high operational expenses. Some successful projects have been adapted to local conditions, although the information on these successes is not often available for others. Nevertheless, only a few developing countries even have a national inventory of their dumps/landfills, and decision-makers have little awareness of the dumps and their impacts. The database introduced here will gather landfill/dump information from each country and organize it in a comparable format, and it will then be published on the Internet.     

Photodegradation of tetraphenyltin contained in polychlorinated biphenyl-based transformer oil simulants in alkaline 2-propanol solution

The photodegradation of tetraphenyltin (TePT) contained in polychlorinated biphenyl (PCB)-based transformer oil simulants by ultraviolet (UV) irradiation in alkaline 2-propanol solutions was examined. In the absence of PCBs, the TePT level fell to below 1% of the initial concentration within 30 min. In the absence of both PCBs and an alkali, the concentrations of tri-, di-, and monophenyltins initially increased to a few milligrams per liter, and then reduced to below the detection limits within 90 min. The addition of an alkali to the reaction solution slightly accelerated the photodecomposition of TePT. The decomposition of other phenyltins (PTs) was also accelerated. When PCBs with concentrations of approximately 80 times the initial TePT concentration were added, only a small fraction of the TePT decomposed within 100 min. Moreover, the levels of PTs did not change during irradiation. TePT and other PTs did decompose when the level of PCBs was reduced to the same concentration as that of TePT; however, the decomposition rates were slower than those in the absence of PCBs. In the actual treatment process, TePT and other PTs in PCB-based transformer oil are decomposed by catalytic reduction, which is used after UV irradiation. Therefore, in the actual treatment of PCB-based transformer oil wastes, pollution due to PTs can be prevented.     

Municipal solid waste composition and food loss reduction in Kyoto City

For 35 years, Kyoto City has conducted detailed household waste composition surveys under the guidance of Kyoto University by dividing household waste into approximately 400 categories. In addition, the city has conducted detailed composition surveys of commercial waste generated by businesses. These surveys show that food loss accounts for approximately 40% of total waste, of which leftovers and untouched food account for about 40% in both households and business facilities. Consequently, the annual generation of household and commercial food loss is estimated at about 30,000 tons. Various efforts have been made to reduce waste, including food loss, but further reduction in environmental burden is needed. Thus, Kyoto City revised the ordinance for waste reduction, and in March 2015, formulated a new municipal waste management plan. The plan not only includes the 2Rs (reduce, reuse), but also, for the first time in Japan, sets quantitative targets for reducing food loss. Kyoto City must ensure that the necessary waste reduction measures are clearly explained to the residents and business operators. To ensure that this plan is successful, it is important to clarify concrete actions that residents and business operators should implement, along with their effects.     

Levels of polychlorinated dibenzo-p-dioxins and dibenzofurans in China and chemometric analysis of potential emission sources

Aimed to give a preliminary image of dioxin pollution in China, chemometric analysis was performed to determine background dioxin levels during the period 1994-2002 and potential emission sources. Using principal components analysis (PCA), the congener profiles of 71 sediment samples from rivers, lakes, and sea bays around China were compared with the congener profiles of various known or suspected industrial, residential, and municipal dioxin sources to determine whether the dioxin residues typically found in a broad range of potential environmental sources could explain the presence of these chemicals in China. It was found that the background dioxin levels of China were similar to those of lightly polluted samples from other countries during the period 1994-2002. Primary ferrous ore sintering and secondary lead and aluminum smelters were the major sources of dioxin emission in China. Chloranil and wastewater from chemical plants, sodium pentachlorophenate, and pulp bleaching were also important sources of dioxin emission. Open burning of e-waste as well as diesel-fueled and leaded gas-fueled vehicles were additional possible sources of dioxin. In contrast to other countries, in China, flue gases from incineration of municipal waste, hazardous waste, and medical waste might be minor sources of dioxin emission.