Assessing groundwater quality and its sustainability in Joypurhat district of Bangladesh using GIS and multivariate statistical approaches

Sustainable groundwater quality is a key global concern and has become a major issue of disquiets in most parts of the world including Bangladesh. Hence, the assessment of groundwater quality is an important study to ensure its sustainability for various uses. In this study, a combination of multivariate statistics, geographical information system (GIS) and geochemical approaches was employed to evaluate the groundwater quality and its sustainability in Joypurhat district of Bangladesh. The results showed that the groundwater samples are mainly Ca–Mg–HCO₃ type. Principal component analysis (PCA) results revealed that geogenic sources (rock weathering and cation exchange) followed by anthropogenic activities (domestic sewage and agro-chemicals) were the major factors governing the groundwater quality of the study area. Furthermore, the results of PCA are validated using the cluster analysis and correlation matrix analysis. Based on the groundwater quality index (GWQI), it is found that all the groundwater samples belong to excellent to good water quality domains for human consumption, although iron, fluoride and iodide contaminated to the groundwater, which do not pose any significant health hazard according to World Health Organization’s and Bangladesh’s guideline values. The results of irrigation water quality index including sodium adsorption ratio (SAR), permeability index and sodium percentage (Na %) suggested that most of the groundwater samples are good quality water for agricultural uses. The spatial distribution of the measured values of GWQI, SAR, Fe (iron), EC (electrical conductivity) and TH (total hardness) were spatially mapped using the GIS tool in the study area.     

Improvement of sand filter and constructed wetland design using an environmental decision support system

With the aim of improving effluent quality of waste stabilization ponds, different designs of vertical flow constructed wetlands and intermittent sand filters were tested on an experimental full-scale plant within the framework of a European project. The information extracted from this study was completed and updated with heuristic and bibliographic knowledge. The data and knowledge acquired were difficult to integrate into mathematical models because they involve qualitative information and expert reasoning. Therefore, it was decided to develop an environmental decision support system (EDSS-Filter-Design) as a tool to integrate mathematical models and knowledge-based techniques. This paper describes the development of this support tool, emphasizing the collection of data and knowledge and representation of this information by means of mathematical equations and a rule-based system. The developed support tool provides the main design characteristics of filters: (i) required surface, (ii) media type, and (iii) media depth. These design recommendations are based on wastewater characteristics, applied load, and required treatment level data provided by the user. The results of the EDSS-Filter-Design provide appropriate and useful information and guidelines on how to design filters, according to the expert criteria. The encapsulation of the information into a decision support system reduces the design period and provides a feasible, reasoned, and positively evaluated proposal.     

A directional passive air sampler for monitoring polycyclic aromatic hydrocarbons (PAHs) in air mass

A passive air sampler was developed for collecting polycyclic aromatic hydrocarbons (PAHs) in air mass from various directions. The airflow velocity within the sampler was assessed for its responses to ambient wind speed and direction. The sampler was examined for trapped particles, evaluated quantitatively for influence of airflow velocity and temperature on PAH uptake, examined for PAH uptake kinetics, calibrated against active sampling, and finally tested in the field. The airflow volume passing the sampler was linearly proportional to ambient wind speed and sensitive to wind direction. The uptake rate for an individual PAH was a function of airflow velocity, temperature and the octanol-air partitioning coefficient of the PAH. For all PAHs with more than two rings, the passive sampler operated in a linear uptake phase for three weeks. Different PAH concentrations were obtained in air masses from different directions in the field test.     

A Sensitivity Analysis of an Integrated Modelling Approach to Assess the Risk of Wind-borne Spread of Foot-and-mouth Disease Virus from Infected Premises

The sensitivity of an integrated model to assess the potential for wind-borne spread of foot-and-mouth disease (FMD) to variations in key parameters controlling different physical and biological processes was evaluated. The estimated number of farms at risk is sensitive to the virus strain used and the accompanying effective contact rate. The C Noville strain increased the estimated number of exposed farms ranked as high and medium risk of being infected by a factor of 5, compared to the baseline, based on the O UKG 2001 strain. The inclusion of a model for biological ageing of the virus can also have a significant effect on the concentration patterns arising from transport and dispersion of the virus. Its inclusion has the practical advantage of markedly reducing the time required for the calculations. The estimated number of farms affected by exposure to high and medium virus concentrations is not grossly sensitive to attenuation caused by temperature or relative humidity effects. Changes in susceptibility to infection, as determined by the parameter θ in the exposure-risk model, does not change the configuration of the virus plumes, but it does change the distribution of farms at risk by risk category. These findings suggest that a good understanding of characteristics (excretion rates from infected animals, susceptibility of different species to infection, virus survival, etc.) of the virus strain involved in an FMD outbreak is necessary to provide a reliable assessment of the risk of wind-borne spread. In the event of an incursion of FMD, provision for laboratory studies on the virus will be an essential component of the disease response and should be factored into contingency plans.

Design and validation of a practical index for trauma assessment

In the past 20 years a variety of indices have been suggested for measuring the severity of trauma, however none of them meets the requirement of being a simple and objective instrument that can be utilized efficiently by lay persons and providers of health services without previous experience in triaging. A new system has been proposed which meets this requirement and which has been validated with 197 injured persons at the emergency ward of the Valle University Hospital in Call, Colombia. The instrument showed a high level of concordance with the conventional triaging method and classifies victims into four categories: critical with recovery unlikely, critical but recoverable, moderately serious, and ambulatory. There is discussion on the reliability of this instrument and it is recommended that it be validated with victims from larger disasters. Regardless, it has the advantage of being specific and free of the subjectivity that characterizes other indices.     

Inorganic nitrogen metabolism inUlva rigida illuminated with blue light

Inorganic nitrogen metabolism in blue light was studied for the green algaUlva rigida C. Agardh collected in the south of Spain (Punta Carnero, Algeciras) in the winter of 1987. NH₄ ⁺ has been reported to inhibit NO₃ ^- uptake; however,U. rigida showed a net NO₃ ^- uptake even when the NH₄ ⁺ concentration of the external medium was three or four times greater than the concentration of NO₃ ^-. NO₃ ^- uptake rates were similar in both darkness and in blue light of various photon fluence rates (PFR) ranging from 17 to 160 mol m^-2 s^-1. Since NO₃ ^- uptake is an active mechanism involving the consumption of ATP, respiratory metabolism can provide enough ATP to maintain the energetic requirement of NO₃ ^- transport even in darkness. In contrast, NO₃ ^- reduction inU. rigida was highly dependent on the net photosynthetic rate. After 7 h in blue light, intracellular NO₃ ^- concentrations ([NO₃ ^-] _i ) were higher in specimens exposed to intensities below the light compensation point (LCP) than in those incubated at a PFR above the LCP. When PFR is below the light compensation point, NO₃ ^- reduction is low, probably because all the NADH produced by the cells is oxidized in the respiratory chain in order to produce ATP to maintain a steady NO₃ ^- transport rate. The total nitrogen (TN) and carbon (TC) contents decreased from darkness to 33 mol m^-2 s^-1 in blue light. In this range, catabolic processes prevailed over anabolic ones. In contrast, increases in TN and TC contents were observed above the light compensation point. The C : N ratio increased with light intensity, reaching a stable value of 17 at 78 mol m^-2 s^-1 in blue light. Intracellular NO₃ ^- concentration and NO₃ ^- reduction appear to be directly controlled by light intensity. This external control of [NO₃ ^-]_i and the small capacity ofU. rigida to retain incorporated NO₃ ^-, NO₂ ^- and NH₄ ⁺ ions may explain its nitrophilic character.     

海水入侵指标对比分析与评价—以珠江口地下水含水层为例

合理评价海水入侵对于地下水含水层管理和居民生活健康有着重要的意义。当前海水入侵评价应用较广泛的为包含单一因子和基于统计分析的多种水化学方法。本文综合阐述了海水入侵评价中所用的水化学指标、原理与方法,包括在国内评价体系中少见的一些方法,并以珠江口地下水含水层为例,对比了各种指标的有效性,评价了各类方法的优缺点以及在实际应用中可能产生的问题。结果显示,以Cl-和TDS作为简单直接的单因子可以快速评价海水入侵,尤其对于大范围的海水入侵评价十分有效。而和Ca2+,HCO₃-,SO₄2-等变化有关的指标具有地域性,在研究区对海水入侵的指示并不是十分敏感。在复杂评价因子中,与离子交换有关SAR,BEX以及GQI_SWI与Cl-相关性较高,可以较好的指示海水入侵及水岩相互作用。经过分析,受到地下含水层和地表水道双重介质入侵的影响,研究区海水入侵范围在过去几个年代有向北推进的趋势。本研究对于高速经济发展下的沿海地下水含水层管理和评价有重要的指导意义。     

Application of cryofocusing hydride generation and atomic fluorescence detection for dissolved mercury species determination in natural water samples

The concentration levels of mercury (Hg) species in natural water samples are usually low. Consequently, accurate analysis with low detection limits is still a major problem. In this work, a method was applied for the simultaneous direct determination of dissolved mercury species in water samples by on-line hydride generation (HG), cryogenic trapping (CT), gas chromatography (GC) and detection by atomic fluorescence spectrometry (AFS). The suitability of the method for real samples with different organic matter and chloride contents was evaluated by recovery experiments in synthetic and natural spiked water samples. The HG method was compared with other current available methods for mercury analysis with respect to the different fraction of mercury analysed, i.e. 'reactive', 'reducible' or total. HG derivatization and SnCl2 reduction (with and without previous oxidation with BrCl) were applied to synthetic and natural (spiked and non-spiked) water samples. The influence of chloride and dissolved organic matter concentrations was studied. The results suggest that the HG procedure is suitable for the simultaneous determination of Hg2+ and MeHg+ in surface water samples. Inorganic mercury analysed by HG (i.e. reducible) is close to the total inorganic mercury.     

Speciation of arsenic using solid phase extraction cartridges

Various solid phase extraction (SPE) cartridges were investigated for speciation of arsenite [As(III)], arsenate [As(v)], monomethylarsonic acid (MMA) and dimethylarsinic acid (DMA). Cartridges containing different types of sorbent materials were tested for arsenic retention and elution characteristics. Alumina cartridges were found to completely retain all the four target arsenic species, and are suitable for removal and preconcentration purposes. For speciation analysis, different arsenic species were separated on the basis of their selective retention on and elution from specific cartridges. DMA was retained on a resin-based strong cation exchange cartridge and eluted with 1.0 M HCl. MMA and As(v) were both retained on a silica-based strong anion exchange cartridge and sequentially eluted with 60 mM acetic acid (for MMA) and 1.0 M HCl [for As(v)]. As(III) was not retained on either cartridge and remained in solution. Arsenic species in solution and those eluted from the cartridges were subsequently quantified by using flow injection with hydride generation atomic fluorescence spectrometry (FI-HGAFS) and hydride generation atomic absorption spectrometry (FI-HGAAS). A detection limit of 0.05 microg L(-1) arsenic in water sample was achieved using HGAFS. An application of the method was demonstrated at a drinking water treatment facility. As(III) and As(v) species were determined in water at various stages of treatment. The method is suitable for routine determination of trace levels of arsenic in drinking water to comply with more stringent environmental regulations.     

Working backwards to move forwards: Graph-based connectivity metrics for reserve network selection

In this paper we apply graph theory in a reserve selection exercise to explore the tradeoffs between maintaining connectivity and minimizing the total area of a protected area network. Rather than focus on a single organism, we used a multi-species approach and looked at the tradeoff curves for organisms with varying dispersal abilities. We first generated the tradeoff curves using a graph-based metric to determine the importance of individual patches for maintaining connectivity. We then performed an analogous set of analyses using patch size as a surrogate measure of importance.