Transformation of hazardous lead into aluminosilicate ceramics: structure evolution and lead leaching

This study investigated crystallization mechanisms for the formation of lead aluminosilicate by sintering lead stabilization with kaolin-based precursors. PbAl2Si2O8 was found to be the only stable lead aluminosilicate in low-PbO system and demonstrates its highly intrinsic resistance to acid attack in leaching test. A three-stage PbAl2Si2O8 formation mechanism was supported by the results of the changing temperature in the system. Amorphization of sintered products was observed in both PbO/kaolinite and PbO/mullite systems at 600–700°C. When the temperature was increased to 750–900°C, the crystallochemical formation of lead aluminosilicates (i.e., Pb4Al4Si3O16, Pb6Al6Si2O21, and PbAl2Si2O8) was observed. Pb4Al4Si3O16 and Pb6Al6Si2O21 were found to be the intermediate phases at 700–900°C. Finally, PbAl2Si2O8 was found to be the only crystallite phase to host Pb at above 950°C. A maximum of 80% and 96.7% Pb can be incorporated into PbAl2Si2O8 in PbO/kaolinite and PbO/mullite systems, respectively, but the final products exhibited different microstructures. To reduce environmental hazard of lead, this strategy demonstrated a preferred mechanism of immobilizing lead into PbAl2Si2O8 structure via kaolin-based precursors.     

微电子远红外联动仪在胶带喷雾降尘系统中的应用

阐述了微电子远红外联动仪在胶带喷雾降尘系统中的流程、设备特性及运行效果。     

MBBR处理低浓度污水的工程应用

用 2座体积 12 0m3的移动床生物膜反应器处理抚顺乙烯有限公司厂区的低浓度 (CODCr6 0～ 80mg L)生活污水 ,停留时间 2 4h ,出水通过高效纤维球过滤罐 ,CODCr降至 2 0mg L ,BOD5降至 5mg L ,SS降至 5mg L ,氨氮降至 1mg L ,达到了循环冷却水的回用标准。进水浓度过低 ,对MBBR挂膜不利 ,工程中采用外加营养物质的措施后 ,3d内反应器成功挂膜启动。     

微氧膜生物反应器同时去除有机物和氮的研究

采用微氧颗粒污泥膜生物反应器处理生活污水,进行同时去除有机物和氮的研究。结果表明,膜出水COD不受水力停留时间变化的影响一直稳定在较低值,为15~35mg/L,去除率在94%以上。氮通过发生同时硝化反硝化反应而去除。在水力停留时间为16h以上时, 系统总氮去除率为65% ~92%,平均去除率为77%。     

高温与超高温UASB反应器的研究进展

本文介绍了国内外对上流式厌氧污泥床 (UASB)反应器应用于高温和超高温废水处理的研究进展现状 ,探讨了在高温和超高温下UASB反应器接种、启动及其处理效果的特点     

移动床生物膜反应器的研究及应用现状

移动床生物膜反应器是一种高效的污水处理系统 ,目前在国内外已有较多应用。本文就其特点及研究应用状况作简要介绍。     

The Aerosol Research and Inhalation Epidemiology Study (ARIES): PM2.5 mass and aerosol component concentrations and sampler intercomparisons

The Aerosol Research and Inhalation Epidemiology Study (ARIES) was designed to provide high-quality measurements of PM2.5, its components, and co-varying pollutants for an air pollution epidemiology study in Atlanta, GA. Air pollution epidemiology studies have typically relied on available data on particle mass often collected using filter-based methods. Filter-based PM2.5 sampling is susceptible to both positive and negative errors in the measurement of aerosol mass and particle-phase component concentrations in the undisturbed atmosphere. These biases are introduced by collection of gas-phase aerosol components on the filter media or by volatilization of particle phase components from collected particles. As part of the ARIES, we collected daily 24-hr PM2.5 mass and speciation samples and continuous PM2.5 data at a mixed residential-light industrial site in Atlanta. These data facilitate analysis of the effects of a wide variety of factors on sampler performance. We assess the relative importance of PM2.5 components and consider associations and potential mechanistic linkages of PM2.5 mass concentrations with several PM2.5 components. For the 12 months of validated data collected to date (August 1, 1998-July 31, 1999), the monthly average Federal Reference Method (FRM) PM2.5 mass always exceeded the proposed annual average standard (12-month average = 20.3 +/- 9.5 micrograms/m3). The particulate SO4(2-) fraction (as (NH4)2SO4) was largest in the summer and exceeded 50% of the FRM mass. The contribution of (NH4)2SO4 to FRM PM2.5 mass dropped to less than 30% in winter. Particulate NO3- collected on a denuded nylon filter averaged 1.1 +/- 0.9 micrograms/m3. Particle-phase organic compounds (as organic carbon x 1.4) measured on a denuded quartz filter sampler averaged 6.4 +/- 3.1 micrograms/m3 (32% of FRM PM2.5 mass) with less seasonal variability than SO4(2-).     

武汉地铁线地下工程有害气体勘察与防治技术研究

武汉地铁二号线汉口火车站—范湖站区间含有沼气层,沼气(瓦斯)在隧道中的释放与聚集将直接威胁盾构施工和日后地铁运营的安全,因此采用岩芯钻孔探测法和静力触探孔探测法对其进行瓦斯赋存状况勘察与安全检测评价十分必要,根据勘察与评价的结果可为施工单位提供指导性的安全施工建议。     

热电厂再生水回用工艺分析

介绍一套日处理量14 400 t的再生水回用工艺,该工艺应用预处理+反渗透工艺深度处理二级城市污水并将产水回用于热电厂的循环冷却水及锅炉补给水的源水,分析了该工艺关键单元的特点。运行结果表明:该工艺可行,产水各项指标满足该热电厂对回用水的要求。最后,对工艺运行过程中出现的问题提出解决办法和改进建议。     

分散填料曝气塔多相流态分析与传氧性能表征

针对分散填料曝气塔中多相流的流态与传氧过程,实验了布气方式以及海绵和陶粒2种填料对于体系的气含率εg、流态以及气-液传质性能的影响。在表观气速U范围(0.01～0.18 m/s)内观察到81孔布气板(Φ1 mm)体系出现3个明显相区,孔数过少(25孔),或者孔间距较小(225孔)均没有明显过渡区,在湍流区(U>0.118 m/s)3种布气板的气含率没有明显差别。海绵填料体积分数εs<25%时体系的气含率没有明显变化,35%时气含率下降且过渡区提前出现。在非均相区,海绵填料明显提高了体系的传质系数KLa。陶粒填料降低了气含率,固含率对εg的影响差别不明显,同时降低了多相流体系的KLa,且随着固含率的增加KLa降低。对比多种操作条件,单位体积空气传氧能力KLa/εg无明显差别,但在81孔布气板的过渡区KLa/εg出现一个明显的极小区间,说明过渡区传氧效率较低。在特定的实验操作条件下,KLa/εg较为稳定,这为深入理解两种气泡群体的共存体系在传氧性能方面各自的权重,提供了重要的量化参考。