Halopriming imparts tolerance to salt and PEG induced drought stress in sugarcane

Sugarcane, a glycophyte grown in the tropical and subtropical regions, is frequently subjected to soil salinity, affecting the yield and quality of the harvest. The ameliorative efficiency of salt priming on emergence and plantlet growth was examined in sugarcane cultivars which are known to vary in salt tolerance under field conditions. Salt priming with NaCl (100 mM) improved both the percent and rate of germination of the sets of the tolerant (Co 62175) and moderately tolerant (CoM 265) varieties compared to sensitive (CoC 671) and test variety (Co 86032). Salt priming during germination also improved the growth performance of two-month-old sugarcane plants in terms of shoot length, shoot and root fresh weight when subjected to 15 day iso-osmotic (−0.7 MPa) NaCl (150 mM) or polyethylene glycol (PEG 8000; 20%, w/v) stress. The primed plants exhibited lower salt- and dehydration-induced leaf senescence. The results suggest salt priming as an efficient approach for imparting abiotic stress tolerance in sugarcane.     

Guidance for performing footprint analyses and life‐cycle assessments for the remediation industry

The US Sustainable Remediation Forum (SURF) proposes a nine‐step process for conducting and documenting a footprint analysis and life‐cycle assessment (LCA) for remediation projects. This guidance is designed to assist remediation practitioners in evaluating the impacts resulting from potential remediation activities so that preventable impacts can be mitigated. Each of the nine steps is flexible and scalable to a full range of remediation projects and to the tools used by remediation practitioners for quantifying environmental metrics. Two fictional case studies are presented to demonstrate how the guidance can be implemented for a range of evaluations and tools. Case‐study findings show that greater insight into a study is achieved when the nine steps are followed and additional opportunities are provided to minimize remediation project footprints and create improved sustainable remediation solutions. This guidance promotes a consistent and repeatable process in which all pertinent information is provided in a transparent manner to allow stakeholders to comprehend the intricacies and tradeoffs inherent in a footprint analysis or LCA. For these reasons, SURF recommends that this guidance be used when a footprint analysis or LCA is completed for a remediation project. © 2011 Wiley Periodicals, Inc.     

Effects of Light Zenith Angle Variation on Spectral Responses of a Water Body’s Environmental Quality

The effect of light source zenith angle (θ_z) variation on the spectral reflectance measurement from sediment-laden water was studied in the laboratory using a spectroradiometer. Light source zenith angle in addition to sediment characteristics and concentration play a dominant role in affecting the reflectance characteristics of a suspension. With an increase in θ_z values, an increase in spectral reflectance is observed. The spectral reflectance characteristics of a water body also increase with the sediment concentration for all soil types and at all wavelengths. Empirical relationships between the spectral reflectance, suspended sediment concentration, and the light source zenith angle have been developed. Such a remote sensing technique for monitoring the concentration of the suspended sediment and their characteristics is a useful tool for economical estimation of a large water body’s quality related parameters vis-a-vis its environmental quality.Retd. Professor of Environmental Engineering & Pollution Control, Presently Residing at Makkhan Kutir, Bhargava Lane, Devpura, Haridwar-249401, India.Former Ph.D. student.     

Assessment of industrial effluent and its impact on soil and plants

The present study deals with the assessment of industrial water of an electronic component manufacturing unit with electroplating and its subsequent effects on soil and plants receiving the effluent. The physico-chemical parameters of the effluent samples showed higher value than that of ground water. The treated effluent was within the permissible limit. Microtox test was conducted and determined the degree of toxicity of untreated, treated effluents as well as the water sample collected at effluent discharge point of receiving river (confluence point). The physico- mechanical parameters of the soil samples were not changed due to irrigation of the treated effluent, but the concentration of metals were comparatively higher than the control soil. Higher accumulation of metals was found in the plant parts in naturally growing weeds and cultivated crop plant irrigated with treated effluent. Elevated accumulation of metals in Eichhornia crassipes and Marsilea sp. growing along the effluent channel has been identified as a potential source of biomonitoring of metals particularly for Cu and Ca and can be utilised for the removal of heavy metal from wastewater.     

A simplified model for the steady-state biofilm-activated sludge reactor

A simplified mathematical model is proposed to describe the steady-state completely mixed biofilm-activated sludge reactor (hybrid reactor). The model is derived based on Monod kinetic expressions and the Fickian diffusion law in biofilm. In addition, it considers all the essential concepts that describe the two types of growth (suspended and attached) and the competition between them for limiting substrate. Also the present study has been extended to investigate simple and accurate mathematical expressions for describing the substrate diffusion in biofilm (J). The expression for substrate flux has an explicit solution, which may be useful in the proposed model and many other applications. The application of the model for the hybrid system has been explained for a given set of data and verified by comparison with another solution. Also the model was applied to experimental results for a trace level of suspended biomass concentration (X). It was found that the biofilm flux (J) is the key factor in the model prediction, hence the accuracy of the model output is influenced by the accuracy of J. Compared with other solutions for such systems the model is simple, easy to use, and provides an accurate tool for describing such systems based on fundamental principles.     

Assessment of urban air pollution and it's probable health impact

The present study deals with the quantitative effect of vehicular emission on ambient air quality during May 2006 in urban area of Lucknow city. In this study SPM, RSPM, SO2, NOx and 7 trace metals associated with RSPM were estimated at 10 representative locations in urban area and one village area for control. Beside this, air quality index (AQI), health effects of different metals and mortality were assessed. The 24 hr average concentration of SPM, RSPM, SO2 and NOx was found to be 382.3, 171.5, 24.3 and 33.8 microg m(-3) respectively in urban area and these concentrations were found to be significantly (p < 0.01) higher by 94.8, 134.8, 107.4 and 129.6% than control site respectively The 24 hr mean of SPM and RSPM at each location of urban area were found to be higher than prescribed limit of National Ambient Air Quality Standard (NAAQS) except SPM for industrial area. The 24 hr mean concentration of metals associated with RSPM was found to be higher than the control site by 52.3, 271.8, 408.9, 75.81, 62.7, 487.54 and 189.5% for Fe, Cu, Pb, Zn, Ni, Mn and Cr respectively. The inter correlation of metals Pb with Mn, Fe and Cr; Zn with Ni and Cr; Ni with Cr; Mn with Fe and Cu with Cr showed significant positive relation either at p < 0.05 or p < 0.01 level. Metals Pb, Mn and Cr (p < 0.01) and Cu (p < 0.05) showed significant positive correlation with RSPM. These results indicate that ambient air quality in the urban area is affected adversely due to emission and accumulation of SPM, RSPM, SO2, NOx and trace metals. These pollutants may pose detrimental effect on human health, as exposure of these are associated with cardiovascular and respiratory diseases, neurological impairments, increased risk of preterm birth and even mortality and morbidity.     

Metals concentration associated with respirable particulate matter (PM10) in industrial area of Eastern U.P. India

The present study deals with the assessment of ambient air quality with respect to respirable suspended particulate matter (RSPM or PM10 < or = 10 microm) and trace metals (Fe, Zn, Cu, Cr Ni, Cd, Mn and Pb) concentrations in RSPM at five locations of Renukoot, an industrial area of Eastern Uttar Pradesh. The 24 hr mean concentrations of PM10 ranged between 69.3 to 118.9 microg m(-3), which is well within the permissible limit (150 microg m(-3)) of national ambient air quality standards (NAAQS) but found higher than the prescribed annual daily limit of US EPA (50 microg m(-3)). The ambient air was mostly dominated by the Fe and least by the Cd among the metal analysed. Murdhawa, a commercial place influenced by vehicular population, is found to be the most polluted area of Renukoot and Dongia nalla (forest area) the least. The ambient air of Murdhawa is rich in Cu and Ni, indicating contribution of mobile sources. The Rammandir a residential place near the industry, is rich in Cd and Cr suggesting contribution of point sources. The Ni concentration is found to be alarmingly high in the air at all the locations except Dongia nallah, when compared with the EC (European Commission) limit (20 ng m(-3)). The Cd concentration is found to be higher only at Rammandir as compared with the EC limit (5 ng m(-3)). Mean concentrations of Zn, Pb and Mn are found to be almost equal in the ambient air of all the locations, suggesting the significance of sources contributing to presence of these metals. Zn, Cu, Pb and Ni having a significant correlation with PM10 indicate the same source contributing these metals as well as PM10. The present study has focused on the quantitative variation in different metals in the PM10, which is extremely harmful due to their toxic and carcinogenic nature.     

Distribution of chlorophyll,carotenoids and phytoplankton in relation to certain environmental factors along the central west coast of India

Distribution of chlorophyll pigments, carotenoids and abundance of phytoplankton in relation to certain environmental factors of the nearshore waters off the central west coast of India (latitudes 15°30 to 18°30N) were studied monthly at 7 stations during 1970/1971. Changes in the hydrographical factors and the biological processes occurring in the region during different months appear to be influenced by the pattern of upwelling along the northern and southern parts of the west coast of India. The pigment concentration shows a marked decrease in October, but is followed by a slow but steady rise, which reaches its maximum in April/May. A slightly smaller maximum is noticed in December/January. The composition of various chlorophyll pigments and carotenoids indicated the physiological state of phytoplankton populations during different months in the region investigated. Abundance of specific phytoplanktonic elements, consisting mainly of diatoms, in space and time, characterises the waters of the central west coast of India, indicating a clear succession of species.     

Sludge age, stability, and safety factor for the biofilm-activated sludge process reactor

The average sludge age (theta(c)) of the activated sludge process (ASP)-biofilm were developed and verified experimentally. In addition, the stability and safety factor were investigated against theta(c). through a series of curves. These curves are important to explain, in concept, the function of the hybrid system under different values of theta(c). The proposed curves of this study are simple and can be modified for any specified wastewater. The definition of theta(c) of ASP was found to be applicable to the hybrid system after including the biofilm. A ratio ranging from 70 to 80% of the total mass of biofilm may be used in the definition of theta(c). to give close results with the experimental values. Furthermore, the minimum sludge age (theta(c)(M)) does not exist in the hybrid reactor because of the presence of biofilm; however, theta(c) should come down to a critical value under some specific conditions of the reactor.