Characterization of PM2.5 aerosols dominated by local pollution and Asian dust observed at an urban site in Korea during aerosol characterization experiments (ACE)--Asia Project

Daily fine particulate matter (PM2.5) samples were collected at Gwangju, Korea, during the Aerosol Characterization Experiments (ACE)-Asia Project to determine the chemical properties of PM2.5 originating from local pollution and Asian dust (AD) storms. During the study period, two significant events occurred on April 10-13 and 24-25, 2001, and a minor event occurred on April 19, 2001. Based on air mass transport pathways identified by back-trajectory calculation, the PM2.5 dataset was classified into three types of aerosol populations: local pollution and two AD aerosol types. The two AD types were transported along different pathways. One originated from Gobi desert area in Mongolia, passing through Hunshandake desert in Northern Inner Mongolia, urban and polluted regions of China (AD1), and the other originated in sandy deserts located in the Northeast Inner Mongolia Plateau and then flowed southward through the Korean peninsula (AD2). During the AD2 event, a smoke plume that originated in North Korea was transported to our study site. Mass balance closures show that crustal materials were the most significant species during both AD events, contributing -48% to the PM2.5 mass; sulfate aerosols (19.1%) and organic matter (OM; 24.6%) were the second greatest contributors during the AD1 and AD2 periods, respectively, indicating that aerosol properties were dependent on the transport pathway. The sulfate concentration constituted only 6.4% (4.5 microg/m3) of the AD2 PM2.5 mass. OM was the major chemical species in the local pollution-dominated PM2.5 aerosols, accounting for 28.7% of the measured PM2.5 mass, followed by sulfate (21.4%), nitrate (15%), ammonium (12.8%), elemental carbon (8.9%), and crustal material (6.5%). Together with substantial enhancement of the crustal elements (Mg, Al, K, Ca, Sc, Ti, Mn, Fe, Sr, Zr, Ba, and Ce), higher concentrations of pollution elements (S, V, Ni, Zn, As, Cd, and Pb) were observed during AD1 and AD2 than during the local pollution period, indicating that, in addition to crustal material, the AD dust storms also had a significant influence on anthropogenic elements.     

Effects of equipment loadings on geosynthetic-lined slope behaviour.

When combined in the lining and covering of waste-containment facilities, soil and geosynthetic components protect the environment by acting as a hydraulic barrier. Equipment loading may significantly increase the tensile stress induced in geosynthetic components, leading to a potential stability problem. Large equipment loadings may also result in a localized circular slip surface during construction operations. New analytical method based on discrete element modelling is proposed for estimating the distribution of tensile force developed in the individual geosynthetic components of the lining system and for evaluating the safety factor of slope failure due to equipment loading. The analytical results of an example are presented to demonstrate the applicability of the analytical method for the lining system of a waste landfill. The analyses of the example show that equipment loading provide a substantial increase in the tensile forces of the geosynthetic components of a lining system and that the possibility of shallow failure due to equipment loading increases as the slope becomes steeper. This method is a useful tool for analysing the lining system of waste landfills with complex lining components.     

Ecotoxicity evaluation of Cu- and Fe-CNT complexes based on the activity of bacterial bioluminescence and seed germination

The toxic effects of the composites of Fe~0 and Cu~0 with different percentages of CNTs were examined based on the activity of bacterial bioluminescence and seed germination. In terms of the EC_50 values, the toxic effects of Cu~0 on bacterial bioluminescence and seed germination were approximately 2 and 180 times greater than that of Fe~0, respectively. The toxicity increased with increasing CNT content in the Cu-CNT mixtures for both organisms,whereas opposite results were observed with Fe-CNT mixtures. The mean toxic effects of Cu-CNT(6%) were approximately 1.3–1.4 times greater than that of Cu-CNT(0%), whereas the toxic effects of Fe-CNT(6%) were approximately 2.1–2.5 times lower than that of Fe-CNT(0%) for both the bioluminescence activity and seed germination. The causes of this phenomenon are unclear at this point. More research will be needed to elucidate the mechanism of the toxicity of nano-mixture materials and the causes of the different patterns of toxicity with Cu-and Fe-CNT mixtures.     

日本企业的环境责任

上世纪90年代初期，日本的许多企业都未将环境管理、指标、社会责任等纳入企业成本、运营和规划中，他们认为这会给企业带来负担。也无必要，这种情形与现阶段的中国企业有着非常类似的“价值取向”，我们希望这篇文章能给中国的同行们带来一些思考和借鉴，从而使得我们的企业更绿，环境更清洁，社会更可持续。[编者按]     

Effect of soil solids concentration in batch tests on the partition coefficients of organic pollutants in landfill liner-soil materials

 The effect of the soil solids concentration in batch tests on the measured values of the partition coefficient (K _p) of organic pollutants in landfill liner-soil material was investigated. Since this study was based on the results of batch and column tests conducted independently, there were limitations to the conclusions derived. The organic compounds tested were benzene, methylene chloride, toluene, trichloroethylene, and p-xylene. The results of this study showed that as soil solids concentrations increased, the measured K _p values of these organic compounds strongly decreased. The observed values of K _p stabilized when the soil solids concentration was above a certain value. Typical K _p values obtained from batch tests conducted under high soil solids concentrations were close to those obtained from column tests. It was concluded that the K _p values of organic compounds measured under low soil solids concentrations, i.e., less than 100 g/l, may not correctly simulate the field situation. Consequently, the values of K _p obtained with low soil solids concentrations can result in an overestimation of the retardation factor of the landfill liner material. Received: March 14, 2002 / Accepted: August 25, 2002     

STREAM DISCHARGE PREDICTION VIA A GRID BASED SOIL WATER ROUTING WITH PADDY FIELDS1

ABSTRACT: A grid based daily hydrologic model for a watershed with paddy fields was developed to predict the stream discharge. ASCII formatted elevation, soil, and land use data supported by the GRASS Geographic Information System are used to generate distributed results such as surface runoff and subsurface flow, soil water content, and evapotranspiration. The model uses a single flow path algorithm and simulates a water balance at each grid element. A linear reservoir assumption was used to predict subsurface runoff components. The model was applied to a 75.6 km² watershed located in the middle of South Korea, and observed stream flow hydrographs from 1995 and 1996 were compared to model predictions. The stream flow predictions of 1995 and 1996 generally agreed with the observed flow, resulting in a Nash‐Sutcliffe efficiency R² of 0.60 and 0.62, respectively. The hydraulic conductivity for percolating water through the saturated layer affected baseflow generation. The levee height of the paddy influenced the time and magnitude of the surface runoff, depending on irrigation management. The model will be used for making low flow management decisions by evaluating the role of each land use to stream flow, especially in case of paddy decrease by gradual urbanization of a watershed.     

Analysis of Roadside Inhalable Particulate Matter (PM10) in Major Korean Cities

A data analysis of three major Korean cities was conducted to assess roadside inhalable particulate matter 10 μm or smaller in aerodynamic diameter (PM₁₀), including temporal and meteorological variations, over a recent period of 4 to 6 years. The yearly roadside PM₁₀ concentrations presented a well-defined increasing trend or no trend depending on the roadside monitoring station. Most mean values exceeded or approximated the Korean standard of 70 μg/m³ per year for PM₁₀. A representative roadside diurnal trend was characterized by a distinct morning maximum. In most cases, the Sunday roadside concentrations were similar to or somewhat lower than the weekday concentrations, and the PM₁₀ concentrations presented a well-defined seasonal variation, with the maximum concentration in March. The monthly maximum concentrations observed in March were most likely attributable to Asian dust storms. In two metropolitan cities (Seoul and Busan), the frequency of days with roadside PM₁₀ concentrations exceeding the standard of 150μg/m³ per 24 h was much lower for the roadside monitoring stations than for the residential monitoring station, whereas in the third city (Daegu), this result was reversed. Interestingly, the average maximum concentrations observed for the roadside sites in Seoul and Busan during March were higher than those for the residential sites, suggesting that the roadside concentrations responded more to the dust storms than the residential areas. The relationship between the pollutant concentrations and five important meteorological parameters (solar radiation, wind speed, air temperature, relative humidity, and precipitation) showed that the number and type of meteorological variables included in the equations varied according to the monitoring station or season. Finally, the current results confirmed that attention should be given to the PM₁₀ exposure of residents living near roadways.     

Assessment of Soil Erodibility Indices for Conservation Reserve Program Lands in Southwestern Kansas Using Satellite Imagery and GIS Techniques

The soil erodibility index (EI) of Conservation Reserve Program (CRP) lands, which was the major criterion for CRP enrollment, was assessed for six counties in southwestern Kansas using USGS seamless digital elevation model data and Geographical Informational System techniques. The proportion of land areas with EI values of 8 or lower was less than 1% of the entire study area and most of the land areas (72.5%) were concentrated on EI values between 8 and 24. Although land acreage with EI values of 24 or higher decreased dramatically, the proportion of CRP lands to the other land-use types did not change much from low to high EI levels. The soil EI and physical soil characteristics of the CRP lands were compared to those of other land-use types. In general, the mean EI values of the land-use types were strongly correlated with physical soil properties, including organic matter content, clay content, available water capacity, permeability, and texture. CRP lands were compared in detail with cropland in terms of their soil characteristics to infer the pivotal cause of the land transformation. Although there was no significant statistical difference in EI between cropland and CRP soils, soil texture, soil family, and permeability were statistically different between the two. Statistical analyses of these three variables showed that CRP soils had coarser texture and higher permeability on average than cropland soils, indicating that CRP lands in the study area are drier than cropland soils. Therefore, soil moisture characteristics, not necessarily soil erosion potential, might have been the key factor for CRP enrollment in the study area.