Electro-Fenton pretreatment for the improvement of tylosin biodegradability

The feasibility of an electro-Fenton process to treat tylosin (TYL), a non-biodegradable antibiotic, was examined in a discontinuous electrochemical cell with divided cathodic and anodic compartments. Only 15 min electrolysis was needed for total tylosin degradation using a carbon felt cathode and a platinum anode; while 6 h electrolysis was needed to achieve high oxidation and mineralization yields, 96 and 88 % respectively. Biodegradability improvement was shown since BOD₅/COD increased from 0 initially to 0.6 after 6 h electrolysis (for 100 mg L^?1 initial TYL). With the aim of combining electro-Fenton with a biological treatment, an oxidation time in the range 2 to 4 h has been however considered. Results of AOS (average oxidation state) and COD/TOC suggested that the pretreatment could be stopped after 2 h rather than 4 h; while in the same time, the increase of biodegradability between 2 and 4 h suggested that this latter duration seemed more appropriate. In order to conclude, biological cultures have been therefore carried out for various electrolysis times. TYL solutions electrolyzed during 2 and 4 h were then treated with activated sludge during 25 days, showing 57 and 67 % total organic carbon (TOC) removal, respectively, namely 77 and 88 % overall TOC removal if both processes were considered. Activated sludge cultures appeared, therefore, in agreement with the assessment made from the analysis of physico-chemical parameters (AOS and COD/TOC), since the gain in terms of mineralization expected from increasing electrolysis duration appeared too low to balance the additional energy consumption.     

Bages-Sigean and Canet-St Nazaire lagoons (France): physico-chemical characteristics and contaminant concentrations (Cu,Cd, PCBs and PBDEs) as environmental quality of water and sediment

Environmental characteristics in water and sediments of two contrasted coastal Mediterranean lagoons, Bages-Sigean and Canet-St Nazaire, were measured over a three season survey. The urban pollution (treatment plant discharges) is very important in Canet-St Nazaire lagoon reflecting untreated sewages, while in Bages-Sigean, the northern part appears more impacted due to larger anthropogenic inputs. Dissolved Cd concentrations are on the whole similar in both lagoons, whereas Cu concentrations are by far higher in lagoon Canet-St Nazaire. Cu concentrations appear to be highly dependent on dissolved organic carbon whereas salinity seems to control Cd variations. Concerning the sediments, the confined northern part of lagoon Bages-Sigean shows organic carbon and total nitrogen enrichment whereas lipid concentrations are much higher in the Canet-St Nazaire lagoon. Cu complexation seems to be strongly related to organic matter as evidenced by the two significant positive relationships, on one hand between Cu and organic carbon, and on the other hand, between Cu and lipids. On the contrary, Cd concentrations appear to be mainly controlled by carbonates. PCBs and PBDEs were detected only in sediments and show relatively low concentrations compared to similar lagoon environments. Regarding the sediment quality guidelines, Cd, Cu and PCBs in both lagoons did not exceed any Probable Effect Concentration (PEC).     

Speciation of arsenic in plants by HPLC-HG-AFS: extraction optimisation on CRM materials and application to cultivated samples

A recently developed method for the determination of arsenic species (arsenite, arsenate, monomethylarsonate, MMAA, and dimethylarsinate, DMAA) has been applied to the study of arsenic speciation in plants. This method uses ion-exchange liquid chromatography coupled on-line to atomic fluorescence spectrometry through continuous hydride generation. Various extraction procedures have been studied in detail using three plant certified reference materials. None of the procedures tested revealed fully satisfying results with all kinds of plant samples; microwave assisted extraction with 0.3 mol dm-3 orthophosphoric acid was found to be the most convenient for dealing with terrestrial plants. Species stability appears good. This method was applied to real world cultivated plant parts. Arsenate appears to predominate in soils, roots and leaves; unidentified species (probably arsenosugars) play an important role (60%) in rice fruits. Carrot was found to be the most contaminated edible plant part, containing 1 mg kg-1 essentially as arsenate species. MMAA was detected in all soils and some plant parts especially shallots at low levels, whereas DMAA was found only in one soil sample and in hot pepper leaves. Arsenite is a minor component of all soils; it is also present in some plant parts at low levels. However, no evident relationships were found between As speciation in the various plant parts and much more detailed studies will be necessary to elucidate As behaviour in plants.     

Arsenic in marine sediments from French Mediterranean ports: Geochemical partitioning,bioavailability and ecotoxicology

This work investigates arsenic mobility, bioavailability and toxicity in marine port sediments using chemical sequential extraction and laboratory toxicity tests. Sediment samples were collected from two different Mediterranean ports, one highly polluted with arsenic and other inorganic and organic pollutants (Estaque port (EST)), and the other one, less polluted, with a low arsenic content (Saint Mandrier port (SM)). Arsenic distribution in the solid phase was studied using a sequential extraction procedure specifically developed for appraising arsenic mobility in sediments. Toxicity assessment was performed on sediment elutriates, solid phases and aqueous arsenic species as single substance using the embryo-toxicity test on oyster larvae (Crassostrea gigas) and the Microtox test with Vibrio fischeri. Toxicity results showed that all sediment samples presented acute and sub-chronic toxic effects on oyster larvae and bacteria, respectively. The Microtox solid phase test allow to discriminate As-contaminated samples from the less contaminated ones, suggesting that toxicity of whole sediment samples is related to arsenic content. Toxicity of dissolved arsenic species as single substance showed that Vibrio fischeri and oyster larvae are most sensitive to As(V) than As(III). The distribution coefficient (Kd) of arsenic in sediment samples was estimated using results obtained in chemical sequential extractions. The Kd value is greater in SM (450 L kg^?1) than in EST (55 L kg^?1), indicating that arsenic availability is higher for the most toxic sediment sample (Estaque port). This study demonstrates that arsenic speciation play an important role on arsenic mobility and its bioavailability in marine port sediments.     

Ex situ remediation of contaminated sediments using mineral additives: assessment of pollutant bioavailability with the Microtox solid phase test

The aim of this work is to assess the potential ecotoxicological effects of contaminated sediments treated with mineral additives. The Microtox solid phase test was used to evaluate the effect of mineral additives on the toxicity of sediment suspensions. Four Mediterranean port sediments were studied after dredging and bioremediation: Sample A from navy harbor, sample B from commercial port and samples C and D from pleasure ports. Sediment samples were stabilized with three mineral additives: hematite, zero-valent iron and zeolite. Results show that all studied mineral additives can act as stabilizer agent in highly contaminated sediments (A and C) by decreasing dissolved metal concentrations and sediment toxicity level. On the contrary, for the less contaminated samples (B and D) hematite and zeolite can provoke toxic effect towards Vibrio fischeri since additive particles can favor bacteria retention and decrease bioluminescence emission.     

Alien plant invasions--incorporating emerging invaders in regional prioritization: a pragmatic approach for Southern Africa

Plant invasions are a serious threat to natural and semi-natural ecosystems worldwide. Most management-orientated research on invasions focuses on invaders that are already widespread and often have major impacts. This paper deals with "emerging" invaders-those alien species with the potential to become important problems without timely intervention. A climate matching procedure was developed to define areas of South Africa, Lesotho and Swaziland that could be invaded by 28 plant species that had previously been classified as emerging invaders. Information on the location of populations of these species in the study area was combined with information on their distributions (as native or alien) in parts of Australia and the United States of America. These two countries had the best available distribution data for this study. They also share many invasive alien plant species with South Africa. Climatic data obtained for weather stations near points of known occurrence in these countries were used to define the climatically suitable areas for each species in the study area. Almost 80% of the remaining natural environment in southern Africa was found to be vulnerable to invasion by at least one of these species, 50% by six or more and 24% by 16 or more species. The most vulnerable areas are the highveld grasslands and the eastern escarpment. The emerging invaders with the greatest potential range included Acacia podalyriifolia and Cortaderia selloana. The globally important invaders Ulex europaeus and Lythrum salicaria had a more limited invasion potential but could still become major invaders. There was no relationship between the extent of the climatically suitable areas for the different species and an expert ranking of their invasion potential, emphasising the uncertainties inherent in making expert assessments based on very little information. The methods used in this analysis establish a protocol for future modelling exercises to assess the invasion potential of other emerging invaders.