Nature and frequency of chromosomal abnormalities in pregnancies with abnormal ultrasound findings: An analysis of 117 cases with review of the literature

During a 7-year period, 117 fetal karyotypes were available from 131 genetic amniocenteses. These procedures were performed between 14 and 37 weeks' gestation for the following abnormal ultrasound findings: (1) intrauterine growth retardation (IUGR)—61 cases; (2) fetal malformation—71 cases; and (3) amniotic fluid volume (AFV) abnormality—60 cases. Chromosomal abnormalities were identified in 19 cases (16.2 per cent). Aneuploidy was 2.5 times as frequent in the presence of malformations than in their absence. No correlation was demonstrated between specific fetal malformations and specific chromosomal abnormalities. Aneuploidy was also twice as frequent in the presence of symmetrical IUGR than in its absence. No chromosomal abnormalities were found among eight cases of asymmetrical IUGR. Four cases of aneuploidy presented with isolated IUGR, three of these involving the X chromosome. The frequency of aneuploidy was the same with or without abnormalities of AFV (14.3 versus 16.4 per cent). No chromosomal abnormality was found associated with isolated AFV abnormalities.     

The value of virtual conferencing for ecology and conservation

The objectives of conservation science and dissemination of its research create a paradox: Conservation is about preserving the environment, yet scientists spread this message at conferences with heavy carbon footprints. Ecology and conservation science depend on global knowledge exchange—getting the best science to the places it is most needed. However, conference attendance from developed countries typically outweighs that from developing countries that are biodiversity and conservation hotspots. If any branch of science should be trying to maximize participation while minimizing carbon emissions, it is conservation. Virtual conferencing is common in other disciplines, such as education and humanities, but it is surprisingly underused in ecology and conservation. Adopting virtual conferencing entails a number of challenges, including logistics and unified acceptance, which we argue can be overcome through planning and technology. We examined 4 conference models: a pure‐virtual model and 3 hybrid hub‐and‐node models, where hubs stream content to local nodes. These models collectively aim to mitigate the logistical and administrative challenges of global knowledge transfer. Embracing virtual conferencing addresses 2 essential prerequisites of modern conferences: lowering carbon emissions and increasing accessibility for remote, time‐ and resource‐poor researchers, particularly those from developing countries.     

Impact on sward composition and stock performance of grazing Molinia-dominant grassland

A comparative experiment was conducted to test the extent to which grazing of rank Molinia caerulea-dominated grassland increases botanical diversity and improves animal performance. The study was carried out on an area of under-grazed Molinia-dominant pasture that had not been stocked for 20 years. Three treatments were compared from 2001 until 2008: (1) no grazing, (2) grazing by Welsh Mountain sheep and (3) grazing by Welsh Black heifers. Patterns of change in sward surface composition across the grazing season were consistent with greater consumption of Molinia by the cattle, but there was little evidence of management regime influencing changes in sward composition year-on-year. There was a significant effect of year on animal performance (P < 0.001). Although the growth rates of the heifers improved over the course of the first three years of the experiment, this performance was not sustained. In contrast, any weight changes for the sheep were positive. The results highlight the slow pace of change within upland swards, and the need to develop site-specific grazing guidelines.     

Estimating contaminant mass discharge: a field comparison of the multilevel point measurement and the integral pumping investigation approaches and their uncertainties

In this field study, two approaches to assess contaminant mass discharge were compared: the sampling of multilevel wells (MLS) and the integral groundwater investigation (or integral pumping test, IPT) that makes use of the concentration-time series obtained from pumping wells. The MLS approached used concentrations, hydraulic conductivity and gradient rather than direct chemical flux measurements, while the IPT made use of a simplified analytical inversion. The two approaches were applied at a control plane located approximately 40m downgradient of a gasoline source at Canadian Forces Base Borden, Ontario, Canada. The methods yielded similar estimates of the mass discharging across the control plane. The sources of uncertainties in the mass discharge in each approach were evaluated, including the uncertainties inherent in the underlying assumptions and procedures. The maximum uncertainty of the MLS method was about 67%, and about 28% for the IPT method in this specific field situation. For the MLS method, the largest relative uncertainty (62%) was attributed to the limited sampling density (0.63 points/m(2)), through a novel comparison with a denser sampling grid nearby. A five-fold increase of the sampling grid density would have been required to reduce the overall relative uncertainty for the MLS method to about the same level as that for the IPT method. Uncertainty in the complete coverage of the control plane provided the largest relative uncertainty (37%) in the IPT method. While MLS or IPT methods to assess contaminant mass discharge are attractive assessment tools, the large relative uncertainty in either method found for this reasonable well monitored and simple aquifer suggests that results in more complex plumes in more heterogeneous aquifers should be viewed with caution.     

Air pollutant concentrations near three Texas roadways,Part I: Ultrafine particles

Vehicular emitted air pollutant concentrations were studied near three types of roadways in Austin, Texas: (1) State Highway 71 (SH-71), a heavily traveled arterial highway dominated by passenger vehicles; (2) Interstate 35 (I-35), a limited access highway north of Austin in Georgetown; and (3) Farm to Market Road 973 (FM-973), a heavily traveled surface roadway dominated by truck traffic. Air pollutants examined include carbon monoxide (CO), oxides of nitrogen (NO_x), and carbonyl species in the gas-phase. In the particle phase, ultrafine particle (UFP) concentrations (diameter < 100 nm), fine particulate matter (PM_2.5, diameter < 2.5 μm) mass and carbon content and several particle-bound organics were examined. All roadways had an upwind stationary sampling location, one or two fixed downwind sample locations and a mobile monitoring platform that characterized pollutant concentrations fall-off with increased distance from the roadways. Data reported in this paper focus on UFP while other pollutants and near-roadway chemical processes are examined in a companion paper. Traffic volume, especially heavy-duty traffic, wind speed, and proximity to the road were found to be the most important factors determining UFP concentrations near the roadways. Since wind directions were not consistent during the sampling periods, distances along wind trajectories from the roadway to the sampling points were used to study the decay characteristics of UFPs. Under perpendicular wind conditions, for all studied roadway types, particle number concentrations increased dramatically moving from the upwind side to the downwind side. The elevated particle number concentrations decay exponentially with increasing distances from the roadway with sharp concentration gradients observed within 100–150 m, similar to previously reported studies. A single exponential decay curve was found to fit the data collected from all three roadways very well under perpendicular wind conditions. No consistent pattern was observed for UFPs under parallel wind conditions. However, regardless of wind conditions, particle concentrations returned to background levels within a few hundred meters of the roadway. Within measured UFP size ranges, smaller particles (6–25 nm) decayed faster than larger ones (100–300 nm). Similar decay rates were observed among UFP number, surface, and volume.     

Air pollutant concentrations near three Texas roadways, part II: Chemical characterization and transformation of pollutants

Spatial gradients of vehicular emitted air pollutants were measured in the vicinity of three roadways in the Austin, Texas area: (1) State Highway 71 (SH-71), a heavily traveled arterial highway dominated by passenger vehicles; (2) Interstate 35 (I-35), a limited access highway north of Austin in Georgetown; and (3) Farm to Market Road 973 (FM-973), a heavily traveled surface roadway with significant truck traffic. A mobile monitoring platform was used to characterize the gradients of CO and NO_x concentrations with increased distance from each roadway, while concentrations of carbonyls in the gas-phase and fine particulate matter mass and composition were measured at stationary sites upwind and at one (I-35 and FM-973) or two (SH-71) downwind sites. Regardless of roadway type or wind direction, concentrations of carbon monoxide (CO), nitric oxide (NO), and oxides of nitrogen (NO_x) returned to background levels within a few hundred meters of the roadway. Under perpendicular wind conditions, CO, NO and NO_x concentrations decreased exponentially with increasing distance perpendicular to the roadways. The decay rate for NO was more than a factor of two greater than for CO, and it comprised a larger fraction of NO_x closer to the roadways than further downwind suggesting the potential significance of near roadway chemical processing as well as atmospheric dilution. Concentrations of most carbonyl species decreased with distance downwind of SH-71. However, concentrations of acetaldehyde and acrolein increased farther downwind of SH-71, suggesting chemical generation from the oxidation of primary vehicular emissions. The behavior of particle-bound organic species was complex and further investigation of the size-segregated chemical composition of particulate matter (PM) at increasing downwind distances from roadways is warranted. Fine particulate matter (PM_2.5) mass concentrations, polycyclic aromatic hydrocarbons (PAHs), hopanes, and elemental carbon (EC) concentrations generally exhibited concentrations that decreased with distance downwind of SH-71. Concentrations of organic carbon (OC) increased from upwind concentrations immediately downwind of SH-71 and continued to increase further downwind from the roadway. This behavior may have primarily resulted from condensation of semi-volatile organic species emitted from vehicle sources with transport downwind of the roadway.     

Bottom up and top down: analysis of participatory processes for sustainability indicator identification as a pathway to community empowerment and sustainable environmental management

The modern environmental management literature stresses the need for community involvement to identify indicators to monitor progress towards sustainable development and environmental management goals. The purpose of this paper is to assess the impact of participatory processes on sustainability indicator identification and environmental management in three disparate case studies. The first is a process of developing partnerships between First Nations communities, environmental groups, and forestry companies to resolve conflicts over forest management in Western Canada. The second describes a situation in Botswana where local pastoral communities worked with development researchers to reduce desertification. The third case study details an on-going government led process of developing sustainability indicators in Guernsey, UK, that was designed to monitor the environmental, social, and economic impacts of changes in the economy. The comparative assessment between case studies allows us to draw three primary conclusions. (1) The identification and collection of sustainability indicators not only provide valuable databases for making management decisions, but the process of engaging people to select indicators also provides an opportunity for community empowerment that conventional development approaches have failed to provide. (2) Multi-stakeholder processes must formally feed into decision-making forums or they risk being viewed as irrelevant by policy-makers and stakeholders. (3) Since ecological boundaries rarely meet up with political jurisdictions, it is necessary to be flexible when choosing the scale at which monitoring and decision-making occurs. This requires an awareness of major environmental pathways that run through landscapes to understand how seemingly remote areas may be connected in ways that are not immediately apparent.     

Outline of an environmental information system

The development of an environmental information system necessitates a phased implementation approach. Phase 1 includes the elements that are traditionally viewed as comprising monitoring and assessment activities. Analysis tools for interpretive work are identified including statistics, modelling, and GIS. Phase 2 follows the information flow beyond project reporting to examine the process of decision making. The inclusion of other forms of knowledge beyond the strictly scientific is necessary where the development of multi-sectoral decisions must be made. Phase 3 extends the decision-making process to the policy development and implementation field. This is accomplished by the inclusion of expert systems as advanced decision support systems which enable the manager to test various hypotheses and policy options prior to commitment. In addressing water resource issues, the importance of setting achievable and enforceable sectoral criteria and standards for industrial, agricultural, and drinking water supplies is discussed with reference to both usage and effluent criteria. Quality assurance and control is an area which must be critically addressed in any water resource project. The implementation of quality control programs must extend from the field sampling procedures and laboratory standard methods to both inter- and intra-laboratory tests and the development and maintenance of databases.