Complexing capacity of natural waters carrying a great amount of suspended matter

The cadmium binding properties of waters of the superior section of the Rio de la Plata estuarine were determined over a three-year period. Samples were collected at different hydrodynamic conditions. The complexing capacity was determined by square wave anodic stripping voltammetry (SWASV). Titration curve data were analyzed using a multivariable regression. Suspended particulate matter (SPM) was identified by XR diffraction and FTIR. These analyses showed that SPM principal components are clays (illite, montmorillonite and chlorite). The study was applied to the untreated, filtered and centrifuged fractions of each sample at the pH of the natural waters and at pH 1. The results show that the contribution of dissolved organic matter to the complexing capacity is negligible when compared with SPM. At natural pH, the complexing capacity of filtered and untreated fractions can be described by considering two kinds of binding sites. The associated conditional binding constants are independent of the concentration of suspended matter. Their average logarithms are ca. 6.5 and ca. 4.4. The total concentration of binding sites (S(T)) is in microM range, which is about three orders of magnitude higher than that reported for most of the studied estuaries. This difference is explained on the basis of the great amount of SPM. Hydrodynamic conditions produce variations in the concentration and composition of the SPM. At pH 1 samples still exhibit an important complexing capacity with only one binding site with log K(cond) ca. 5.4. These differences could be attributed to superficial modifications that take place at very low pH.     

Vulnerability assessment of sea-level rise in Viti Levu, Fiji Islands

Fiji is expected to come under increasing pressure and risk from various threats resulting from climate change and sea-level rise (SLR). Fiji consists of 332 islands and thus has a predominant and large coastline. Viti Levu is the largest and most important of the islands, harboring Fiji’s capital city and most of the major towns concentrated around its coast. The objectives of this study were to evaluate the extent of possible sea-level rise using GIS, and to identify high-risk locations. Potential sea level rise was shown graphically as an output to determine where inundation or flooding would take place. This analysis allowed important areas facing risk to be highlighted for future action. Flooding/inundation can be classified into two kinds: ‘permanent inundation’, which is the result of sea-level rise with tide; and ‘temporary flooding’, also including occasional storm surge events. The inundated area was displayed under different projections and quantified. The results produced output maps showing the distribution of inundation/flooding around the island of Viti Levu as well as the extent of flooding. Six scenarios for sea-level rise were used (0.09, 0.18, 0.48, 0.50, 0.59, 0.88 m). Six scenarios for storm surge were used with return intervals of 1, 2, 5, 10, 25, 50 years. High risk and priority locations are identified as Fiji’s capital Suva, the major tourist center and arrival port of Nadi, and Fiji’s second city Lautoka. Future action, adaptation and response strategies in these identified locations must occur to reduce risk from climate change.     

Establishing a standard Sonoran Reference Plant and its application in monitoring industrial and urban pollution throughout the Sonoran Desert

Using analyses from honey mesquite (Prosopis glandulosa) leaves from nearly pristine locations in Arizona, an inorganic plant concentration standard is proposed for use as a Sonoran Reference Plant (SRP). Such a standard can be used as a monitoring device for different anthropogenic pollution sources throughout the Sonoran Desert. To test the application of the SRP, honey mesquite leaves were collected at different sites in southern Arizona and their chemical fingerprints compared to SRP. Sources of element origin were identified through factor analysis and correlation matrices. A terrestrial factor was found in leaves from all sites. Anthropogenic factors varied for different sites. Mesquite leaves accumulated significant amounts of elements originating from copper smelters (As, Sb) and urban pollution (La, Sm, Ce, V). These pollutants are small-sized and have been linked to human lung diseases. Mesquite is a deciduous tree; the yearly comparison of mesquite leaf element concentration spectra to the SRP standard can be used to determine seasonal improvement or deterioration of environmental quality in a particular area.     

The role of the rural settlements in the Brazilian savanna deforesting process

Although the drivers of deforestation in Brazil are relatively well known, there is still limited understanding of the role of family farm-based rural settlements in land cover changes, particularly in the Brazilian savanna. This research aims to identify land use patterns within rural settlements and examine how they are influenced by regional dynamics. The study is based on GIS techniques and satellite image classification (Landsat 5-TM and RapidEye imagery), combined with geo-referenced fieldwork data in three different regions of the State of Goiás. The results reveal that the deforestation arrangement within the studied rural settlements is very similar to the deforestation found in the surrounding regions. As a positive outcome, the rural settlements have a higher share of remnant vegetation when compared to the surrounding areas, but this is still concentrated within legal reserves. We conclude that the changing patterns of rural settlement land cover are highly influenced by regional dynamics.     

Anti-oviposition activities of used sock media against a dengue vector: prospects of eco-friendly control and solutions to pollution

Yearly, huge amounts of sock refuse are discarded into the environment. Socks contain many molecules, and worn ones, which are rich in smell-causing bacteria, have a strong influence on animals’ behaviors. But the impacts of sock odor on the oviposition behavior of dengue vectors are unknown. We assessed whether Aedes albopictus changes its oviposition activity in response to the presence of used socks extract (USEx) in potential breeding grounds, using choice and no-choice bioassays (NCB). When furnished even chances to oviposit in two sites holding USEx and two others containing water (control), Ae. albopictus deposited significantly less eggs in USEx than in water sites. A similar pattern of oviposition preference was also observed when there were more oviposition options in water. When there were greater oviposition opportunities in USEx sites, Ae. albopictus oviposited preferentially in water. Females laid significantly more eggs during the NCB involving water than USEx. Also, significantly more mature eggs were retained by females in the NCB with USEx than in that with water. These observations strongly suggest the presence of molecules with either repellent or deterrent activities against Ae. albopictus females and provide an impetus to advocate the integration of used socks in dengue control programs. Such applications could be a realistic end-of-life recourse to reroute this waste from landfills.

     

Assessing demineralization treatments for PVC effluent reuse in the resin polymerization step

To reduce fresh water consumption in a polyvinyl chloride (PVC) plant, the effluent from a biological treatment must be demineralized to be re-used in the resin polymerization process. Demineralization is a critical process, since the quality and the stability of the PVC resins are highly influenced by the water quality used in the process. The main target values for water parameters are the following: conductivity <10 μScm^?1, TOC < 10 mg L^?1, and Al < 0.1 mg L^?1. To achieve this quality, several reverse osmosis membranes from different materials and suppliers were tested and compared in the demineralization treatment. Polyamide membranes showed higher salt rejection compared to cellulose acetate membranes yielding both types similar flux and permeability. Two-pass reverse osmosis treatment was necessary to reach conductivities lower than 10 μS cm^?1. On the other hand, a good quality effluent for reuse was obtained by combining RO and ionic exchange resins. Results showed that good quality PVC resins in terms of color, granulometry, porosity, and bulk density were obtained when demineralized water from two-pass reverse osmosis was used as fresh water, proving the feasibility of the effluent reuse in the PVC industry.     

Electrooxidation of industrial wastewater containing 1,4-dioxane in the presence of different salts

The treatment of 1,4-dioxane solution by electrochemical oxidation on boron-doped diamond was studied using a central composite design and the response surface methodology to investigate the use of SO₄ ^2? and HCO₃ ^? as supporting electrolytes considering the applied electric current, initial chemical oxygen demand (COD) value, and treatment time. Two industrial effluents containing bicarbonate alkalinity, one just carrying 1,4-dioxane (S1), and another one including 1,4-dioxane and 2-methyl-1,3-dioxolane (S2), were treated under optimized conditions and subsequently subjected to biodegradability assays with a Pseudomonas putida culture. Electrooxidation was compared with ozone oxidation (O₃) and its combination with hydrogen peroxide (O₃/H₂O₂). Regarding the experimental design, the optimal compromise for maximum COD removal at minimum energy consumption was shown at the maximum tested concentrations of SO₄ ^2? and HCO₃ ^? (41.6 and 32.8 mEq L^?1, respectively) and the maximum selected initial COD (750 mg L^?1), applying a current density of 11.9 mA cm^?2 for 3.8 h. Up to 98 % of the COD was removed in the electrooxidation treatment of S1 effluent using 114 kWh per kg of removed COD and about 91 % of the COD from S2 wastewater applying 49 kWh per kg of removed COD. The optimal biodegradability enhancement was achieved after 1 h of electrooxidation treatment. In comparison with O₃ and O₃/H₂O₂ alternatives, electrochemical oxidation achieved the fastest degradation rate per oxidant consumption unit, and it also resulted to be the most economical treatment in terms of energy consumption and price per unit of removed COD.     

Hydrological Controls and Freshening in Meromictic Soap Lake,Washington, 1939-20021

Kallis, Jahn, Leo Bodensteiner, and Anthony Gabriel, 2010. Hydrological Controls and Freshening in Meromictic Soap Lake, Washington, 1939-2002. Journal of the American Water Resources Association (JAWRA) 46(4): 744-756. DOI: 10.1111/j.1752-1688.2010.00446.x Abstract: The chemically stratified layer of naturally formed meromictic lakes exhibits unusual and often extreme physical and chemical conditions that have resulted in the evolution of uniquely adapted species. The Columbia Basin Irrigation Project appears to have had a marked effect on the hydrology of Soap Lake, a meromictic lake in the Grand Coulee of central Washington. The relation of hydrology to salinity was assessed by analyzing water budgets before and after the introduction of the irrigation project. Before irrigation, water gains were balanced by losses; after irrigation began groundwater gains approximately doubled. To manage lake levels and reduce groundwater influx, wells were installed to intercept groundwater. Although the hydrological cycle has been restored to pre-irrigation conditions, the meromictic character of the lake continues to change. Interception wells remove 10 to 16 Mm³ of groundwater annually, but influx continues based on change in the monimolimnion. From 1958 to 2003 the chemocline descended 1.1 m and the volume of the monimolimnion from 698,000 m³ to 114,000 m³. Annual loss of volume is occurring at a rate of 1.9% since 1958. Although groundwater interception wells are maintaining the volume of the entire lake, the recession of the chemocline indicates that conditions that have maintained meromixis at Soap Lake are currently not in equilibrium.     

A Generic Bio-Economic Farm Model for Environmental and Economic Assessment of Agricultural Systems

Bio-economic farm models are tools to evaluate ex-post or to assess ex-ante the impact of policy and technology change on agriculture, economics and environment. Recently, various BEFMs have been developed, often for one purpose or location, but hardly any of these models are re-used later for other purposes or locations. The Farm System Simulator (FSSIM) provides a generic framework enabling the application of BEFMs under various situations and for different purposes (generating supply response functions and detailed regional or farm type assessments). FSSIM is set up as a component-based framework with components representing farmer objectives, risk, calibration, policies, current activities, alternative activities and different types of activities (e.g., annual and perennial cropping and livestock). The generic nature of FSSIM is evaluated using five criteria by examining its applications. FSSIM has been applied for different climate zones and soil types (criterion 1) and to a range of different farm types (criterion 2) with different specializations, intensities and sizes. In most applications FSSIM has been used to assess the effects of policy changes and in two applications to assess the impact of technological innovations (criterion 3). In the various applications, different data sources, level of detail (e.g., criterion 4) and model configurations have been used. FSSIM has been linked to an economic and several biophysical models (criterion 5). The model is available for applications to other conditions and research issues, and it is open to be further tested and to be extended with new components, indicators or linkages to other models.