穿层爆破中控制孔对裂隙扩展作用机理试验研究

为研究控制孔在穿层爆破中对裂隙扩展的作用机理，在实验室内进行穿层爆破相似模拟试验。研究表明:煤岩体试块上表面产生了贯穿炮孔和控制孔的裂隙，侧面生成了多条不规则的裂隙，试块内部出现了包括沿控制孔方向发展的多个断裂面；炮孔和控制孔连线上产生了较高拉应力，炮孔和控制孔连线方向上拉应变峰值是炮孔45°方向上的拉应变峰值的1.12倍；爆破产生的压缩应力波P和在控制孔处反射生成的反射横波Sr、反射纵波Pr在控制孔附近的煤岩体上产生应力叠加，造成煤岩体损伤，最终形成贯穿裂隙。穿层爆破中控制孔对爆生裂隙的扩展起到导向作用，但由于穿层爆破中煤岩交界面的存在，使得应力波出现复杂的反射、透射、叠加效应，造成煤层内裂隙无序发育，工程现场应予以重视。     

In-situ synthesis of TiO2 rutile/anatase heterostructure by DC magnetron sputtering at room temperature and thickness effect of outermost rutile layer on photocatalysis

TiO_2 rutile/anatase heterostructure thin films with varying rutile thickness have been in-situ synthesized via DC magnetron sputtering with Ar gas at room temperature. The crystal texture, surface morphology, energy gap and optical properties of the films have been investigated by X-ray diffraction meter, grazing incidence X-ray diffraction meter, Raman spectroscopy, scanning electron microscopy, and UV–visible spectrophotometer, which indicates that the rutile/anatase heterostructure films are successfully fabricated. The further degradation experiments display that the photocatalytic activity can be dramatically affected by the thickness of the outmost rutile layer and the 100 nm thickness exhibits the best performance in all of the TiO_2 thin films. With the increase of the outmost rutile layer, the optical band gap of TiO_2 film displays a systematic decrease slightly. However,the change in photocatalytic activity does not coincide with that in the band gap. The photoresponse and electrochemical properties of the thin films have been characterized to understand the mechanism of the varied photocatalytic activity.     

Manganese concentrations in maternal–infant blood and birth weight

Manganese (Mn) is an essential mineral nutrient in mammals. The physiological role of Mn in animal models is well documented, but little is known about the adverse effects of Mn deficiency or overexposure in humans, including pregnancy outcomes such as birth weight. We examined the relationship of the maternal and cord blood Mn levels with birth weight in a cohort of 172 mother–infant pairs born in Shanghai, China. Non-linear spline and quadratic regression models were used to test the hypothesis of an inverted U-shaped association between the Mn levels and birth weight. The median (range) levels of Mn in the maternal and cord blood were 5.38 (2.34–30.37) μg/dL and 7.66 (2.57–34.23) μg/dL, respectively. An inverted U-shaped relationship was observed between maternal Mn and birth weight after adjusting for potential confounders. The birth weight increased with Mn levels up to 4.18 μg/dL, and a slight reduction in weight was observed at higher levels. The cord blood Mn levels were not found to be associated with birth weight. Both lower and higher Mn exposures are associated with lower birth weight, which may influence important developmental parameters; the association of higher Mn levels with lower weight was weak and imprecise.     

浸提分离法提取皂素清洁工艺研究

提出一种通过溶剂提取将游离皂苷与淀粉、纤维等成分分离，从源头上减少用水量、耗酸量和污染物排放量的皂素清洁生产工艺。首先对溶剂提取条件进行优化，得出最佳工艺条件为：90%（体积比）乙醇溶液，料液比1∶7，沸腾回流提取3 h，重复提取3次。然后通过气质联用（GC/MS）分析了皂素废水的有机物组成。研究结果表明，清洁工艺皂素产率为1.51%（降低3.82%），用酸量比传统工艺减少了71%，头道液COD浓度降低了46%，每100 g原料排放的COD总量下降了84%；皂素废水的有机物污染物主要为糠醛及其衍生物，清洁工艺废水的有机物含量更低，更易降解。     

沿海城市风暴潮灾害风险评估研究述评

对风暴潮灾害形成机理、风暴潮灾害风险评估方法、灾害风险区划与等级评估、灾害损失评估等方面进行了梳理和分析,认为:①风暴潮灾害风险评估指标体系目前多为主要社会因子和经济损失因子,而忽视主要气象水文指标(最大增水、中心风速等)对风暴潮灾害的影响,研究发现,最大增水和风暴潮灾害呈正相关关系;可通过主成分分析等相关数学模型提取指标因子,避免指标选取主观随意性,又能够客观的确定指标因子的权重;②应建立统一的风暴潮灾害风险评估综合指标;提出建立灾害熵综合风险评估方法,定量的反映所研究区域灾害损失整体水平,灾害熵值也可作为划分灾害等级的分级量度。     

强化水旋澄清池技术处理黄河高浊度水的试验研究

由于兰州段夏季黄河水的浊度较高,直接影响了自来水厂的正常运行,而目前水厂所用工艺无法满足高浊度水的处理要求,因此,采用自主研究开发的具有特殊结构的水旋澄清池对黄河高浊度水进行了强化处理的试验研究。研究结果表明：在多点投药混合方式下,强化水旋澄清池可提高浊度的处理效果;若在投加无机絮凝剂PAC后,再投加有机絮凝剂PAM进行复配作用,不仅可降低无机絮凝剂的用量,节约制水成本,而且提高了自来水厂的出水水质;结果也表明该水旋澄清池技术能够推广应用于黄河高浊度水的强化处理工艺中。     

浅谈石化企业体系审核策划的增值

从审核方案策划和审核实施策划两个方面就审核策划的增值方案制订、实施方式和途径进行了探讨。     

应用氧化锌改性沸石的城市污水重金属离子去除技术研究

天然沸石具有离子交换能力,但其中含有很多杂质,离子结合性强弱不一,导致交换性能较低,可以通过化学改性来提升沸石的交换性能。对应用氧化锌改性沸石的城市污水重金属离子去除技术进行研究。测试过程中,使用自来水对沸石填料进行反向冲洗,废水经过水泵提升之后,分别进至3个交换柱中,流过沸石填料,流量通过水阀门进行控制,试验每隔0.5 h~1 h进行取样1次,并分别取进水与出水的水样,读取测压管,对水头损失进行计算。