Transvaginal chorionic villus sampling

Chorionic villus sampling (CVS) with either transcervical catheters or transabdominal needles is a widely-accepted method for prenatal diagnosis. However, there exists a small subset of patients in whom sampling is difficult or impossible with either route because of individual anatomic variations. A new method of chorionic villus biopsy has been developed to circumvent these problems, utilizing transvaginal chorionic needle aspiration guided by an intravaginal ultrasound probe. This technique was performed successfully in 15 patients in whom villi could not be obtained by either of the conventional methods. This method now makes CVS possible in essentially all women regardless of their uterine anatomy or placental placement; it may also prove useful for very early chorionic sampling.     

Is maternal alpha-fetoprotein screening still of value in a low-risk area for neural tube defects?

Estimation of maternal serum alpha-fetoprotein (AFP) was used as a screening method for the detection of neural tube defects (NTDs) in 6344 women over three years. Of 88 (1.4 per cent) who had one or more serum AFP levels equal to, or greater than, 2.5 multiples of the median (MoM) for the relevant gestational age, 43 (0.68 per cent) underwent amniocentesis. There were eight NTDs. Four of these were screened by serum AFP, and all cases of spina bifida had serum AFP levels greater than 3.0 MoM, including one small open defect which was not seen on ultrasound. The other four cases of NTD, which were not screened, were identified by ultrasound. Of 64 singleton pregnancies 32 (50 per cent) had serum AFP levels between 2.5 and 3.0 MoM, and low birthweight (⪕2500 g) occurred in 29 per cent. Because of improvements in ultrasound techniques and the apparent falling incidence of NTD, the role of serum AFP as the primary screening procedure should be regularly reviewed. Effective screening is dependent on mothers booking early.     

CFD Investigation of Particle Deposition in a Horizontal Looped Turbulent Pipe Flow

This paper presents comprehensive 3D numerical investigations on depositions of particles flowing through a horizontal pipe loop consisting of four bends. The multiphase mixture model available in FLUENT 6.2 was used in this study. In this numerical simulation, five different particle sizes have been used as secondary phases to calculate real multiphase effect in which inter-particle interaction has been considered. The deposition of particles along the periphery of the pipe wall was investigated as a function of particle size and fluid velocity. The simulations showed that near the upstream of the bends, maximum particle concentration occurred at the bottom of the pipe. However, downstream the bends, the maximum particle concentration occurred at an angle of 60° from the bottom. The larger particles clearly showed deposition near the bottom wall except downstream. As expected, the smaller particles showed less tendency of deposition and lesser at higher velocity. This numerical investigation showed qualitative agreement with the experiments conducted by Commonwealth Scientific and Industrial Research Organisation, Melbourne team for similar conditions.     

Scale-up of electrochemical oxidation system for treatment of produced water generated by Brazilian petrochemical industry

Scale-up of anodic oxidation system is critical to the practical application of electrochemical treatment in bio-refractory organic wastewater treatment. In this study, the scale-up of electrochemical flow system was investigated by treating petrochemical wastewater using platinized titanium (Ti/Pt) and boron-doped diamond (BDD) anodes. It was demonstrated that flow cell was successfully scaled-up because when it was compared with batch mode (Rocha et al. 2012b), higher performances on organic matter removal were achieved. Under the suitable operating conditions and better anode material, the chemical oxygen demand (COD) of petrochemical wastewater was reduced from 2,746 to 200 mg L^?1 within 5 h with an energy consumption of only 56.2 kWh m^?3 in the scaled-up BDD anode system. These results demonstrate that anode flow system is very promising in practical bio-refractory organic wastewater treatment.     

Extended Analytical Turbulent Diffusion Model for Particle Dispersion and Deposition in a Horizontal Pipe: Comparison with CFD Simulation

A 2D analytical turbulent diffusion model for particle dispersion and deposition at different heights along the pipe flow and circumferential deposition has been developed. This liquid–solid turbulent diffusion model presented in this paper has emanated from an existing gas–liquid turbulent diffusion model. This model can be used as a handy tool for quick estimation one and two-dimensional deposition fluxes of particles in water distribution networks. A comprehensive 3D numerical investigation has been carried out using multiphase mixture model available in “Fluent 6.2” to verify the above analytical model. Different particles sizes and densities were used for 3D numerical investigations. The deposition was studied as a function of particle diameter, density, and fluid velocity. The deposition of particles, along the periphery of the pipe wall and at different depths, was investigated. Both the models findings matched with qualitative phenomena such as deposition of heavier particles at the bottom of the pipe wall were higher at lower velocities and lower at higher velocities. The lighter particles were found mostly suspended with homogeneous distribution. Smaller particles were also suspended with marginal higher concentration near the bottom of the pipe wall. This marginal higher concentration of the smaller particles was found to be slightly pronounced for lower velocity. These analogies of particles are well discussed with the ratio between free-flight velocity and the gravitational settling velocity. Extended analytical model results were compared with the 3D computational fluid dynamics simulation results. Discrepancies in the model results were discussed.     

Sample storage and extraction efficiencies in determination of polycyclic and nitro musks in sewage sludge

Analytical technology is continuously improving, developing better methods for isolating and concentrating trace compounds in environmental samples. Polycyclic and nitro musks (PNMs) are one group of emerging trace compounds detected in municipal wastewater. Differences in sample storage, preparation, and extraction methods for their measurement have led to variability in results. We analyzed 11 PNMs by GC/MS and compared the results of different storage times and extraction methods (supercritical fluid (SFE) or microwave-assisted (MAE)) for 202 samples of primary sludge, waste activated sludge (WAS), raw sludge, and aerobically/anaerobically digested biosolids collected from Canadian municipal wastewater treatment plants. Sixty-three air-dried samples were extracted by SFE, and 139 air-dried, centrifuged, or filtered samples were extracted by MAE. The mean surrogate recoveries were 89% (standard deviation (SD)=11%) for d(10)-anthracene by SFE and 88% (SD=14%) for d(10)-phenanthrene by MAE. Storage study results showed that PNM concentrations changed by a mean of 7% and 9% for primary sludge and WAS respectively after four weeks and decreased up to 25% after 13.5 months of storage in amber glass containers at -18 degrees C. Air-drying of sludge at room temperature caused losses of about 50% of PNM concentrations compared to centrifugation. The proportions of PNMs present in the liquid phase of sludge samples were less than 5% compared to proportions in the sludge solids. The most complete liquid-solid separation was achieved by filtration of frozen/thawed sludge samples, producing a liquid phase that contained less than 1% of the total musk content of the sample.     

活性污泥合成聚羟基烷酸酯代谢机制研究进展

聚羟基烷酸酯(PHAs)是生物制备型环境友好塑料,具有广阔的应用前景.活性污泥合成PHAs可降低生产成本,实现废水处理厂剩余污泥的减量化和资源化.研究微生物合成PHAs的代谢机制,有利于优化PHAs的工业化生产,目前其代谢研究多集中在以纯菌种合成PHAs,而以活性污泥合成PHAs的研究尚不成熟.资料表明,DO变化对活性污泥合成PHAs的代谢途径有显著影响,进而改变其PHAs产物的产量和单体组成.综述了活性污泥合成PHAs在厌氧/好氧工艺、微氧/好氧工艺、缺氧/好氧工艺、好氧动态底物投加工艺条件下的代谢机制,分析了现有PHAs合成代谢模型中存在的问题,展望了PHAs合成代谢机制研究的发展方向.     

An enzyme-linked immunosorbent assay for the determination of dioxins in contaminated sediment and soil samples

A 96-microwell enzyme-linked immunosorbent assay (ELISA) method was evaluated to determine PCDDs/PCDFs in sediment and soil samples from an EPA Superfund site. Samples were prepared and analyzed by both the ELISA and a gas chromatography/high resolution mass spectrometry (GC/HRMS) method. Comparable method precision, accuracy, and detection level (8 ng kg(-1)) were achieved by the ELISA method with respect to GC/HRMS. However, the extraction and cleanup method developed for the ELISA requires refinement for the soil type that yielded a waxy residue after sample processing. Four types of statistical analyses (Pearson correlation coefficient, paired t-test, nonparametric tests, and McNemar's test of association) were performed to determine whether the two methods produced statistically different results. The log-transformed ELISA-derived 2,3,7,8-tetrachlorodibenzo-p-dioxin values and log-transformed GC/HRMS-derived TEQ values were significantly correlated (r=0.79) at the 0.05 level. The median difference in values between ELISA and GC/HRMS was not significant at the 0.05 level. Low false negative and false positive rates (<10%) were observed for the ELISA when compared to the GC/HRMS at 1,000 ng TEQ kg(-1). The findings suggest that immunochemical technology could be a complementary monitoring tool for determining concentrations at the 1,000 ng TEQ kg(-1) action level for contaminated sediment and soil. The ELISA could also be used in an analytical triage approach to screen and rank samples prior to instrumental analysis.