Special issue on contamination,remediation and health for pollutants in natural aquatic,soil, sediments and atmospheric environments

Environmental Geochemistry and Health -     

Development of a Local-Scale Spatially Refined Multimedia Fate Model (LSRMFM) for Urban-Scale Risk Assessment: Model Formulation, GIS-Based Preprocessing, and Case Study

A local-scale spatially refined multimedia fate model (LSRMFM) was developed to evaluate in detail the multimedia transport of organic compounds at a spatial level. The model was derived using a combination of an advection?Cdispersion?Creaction partial differential equation, a steady-state multimedia fugacity model, and a geographical information system. The model was applied to predicting four major volatile organic compounds that are produced as emissions (benzene, toluene, xylene, and styrene) in an urban and industrial area (the 50?×?50-km area was divided into 0.5?×?0.5-km segments) in Korea. To test the accuracy of the model, the LSRMFM was used to predict the extent of dispersion and the data compared with actual measured concentrations and the results of a generic multimedia fate model (GMFM). The results indicated that the method developed herein is appropriate for predicting long-term multimedia pollution. However, the comparison study also illustrated that the developed model has some limitations (e.g., steady-state assumption) in terms of explaining all the observed concentrations, and additional verification and study (e.g., validation using a large observed data set, integration with a more accurate runoff model) would be desirable. In comparing LSRMFM and GMFM, discrepancies between the LSRMFM and GMFM outputs were found, as the result of geographical effects, even though the environmental parameters were identical. The geographical variation for LSRMFM output indicated the existence of considerable local human and ecological risks, whereas the GMFM output indicated less average risk. These results demonstrate that the model has the potential for improving the management of pollutant levels under these refined spatial conditions.     

Occurrence of perchlorate in rice from different areas in the Republic of Korea

Perchlorate concentrations in rice samples from many different provinces, and correlation with surface water contamination, were investigated in the Republic of Korea. Perchlorate levels in the 51 rice samples purchased from local markets ranged from below the detection limit to 1.79?±?0.39 μg/kg with a mean level of 0.21 μg/kg and 7 samples collected from the Nakdong River watershed ranged from 0.38?±?0.1 to 3.23?±?0.47 μg/kg with a mean level of 0.9 μg/kg. The correlation coefficient between perchlorate levels in rice samples from the Nakdong river watershed and the levels in surface water was estimated to be approximately 0.904 in the 95 % confidence interval. These results show that surface water contamination was highly related to the perchlorate pollution of rice in the Republic of Korea.     

Measurement and Analysis of the Relationship between Ammonia,Acid Gases,and Fine Particles in Eastern North Carolina

Abstract

An annular denuder system, which consisted of a cyclone separator; two diffusion denuders coated with sodium carbonate and citric acid, respectively; and a filter pack consisting of Teflon and nylon filters in series, was used to measure acid gases, ammonia (NH₃), and fine particles in the atmosphere from April 1998 to March 1999 in eastern North Carolina (i.e., an NH₃?rich environment). The sodium carbonate denuders yielded average acid gas concentrations of 0.23 μg/m³ hydrochloric acid (standard deviation [SD] ± 0.2 μg/m³); 1.14 μg/m³ nitric acid (SD ± 0.81 μg/m³), and 1.61 μg/m³ sulfuric acid (SD ± 1.58 μg/m³). The citric acid denuders yielded an average concentration of 17.89 μg/m³ NH₃ (SD ± 15.03 μg/m³). The filters yielded average fine aerosol concentrations of 1.64 μg/m³ ammonium (NH₄ ⁺;SD ± 1.26 μg/m³); 0.26 μg/m³ chloride (SD ± 0.69 μg/m³), 1.92 μg/m³ nitrate (SD ± 1.09 μg/m³), and 3.18 μg/m³ sulfate (SO₄ ^2?; SD ± 3.12 μg/m³). From seasonal variation, the measured particulates (NH₄ ⁺,SO₄ ^2?, and nitrate) showed larger peak concentrations during summer, suggesting that the gas-to-particle conversion was efficient during summer. The aerosol fraction in this study area indicated the domination of ammonium sulfate particles because of the local abundance of NH₃, and the long-range transport of SO₄ ^2? based on back trajectory analysis. Relative humidity effects on gas-to-particle conversion processes were analyzed by particulate NH₄ ⁺ concentration originally formed from the neutralization processes with the secondary pollutants in the atmosphere.     

Atmospheric bulk deposition of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in the vicinity of an iron and steel making plant

An IRA-743 resin bulk sampler was validated to monitor long-term bulk deposition of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). Six consecutive sampling campaigns (2008-2009) were conducted at four sites around steel complexes in Pohang, South Korea to investigate spatial and seasonal variations of PCDD/F bulk deposition. The bulk deposition within the steel complex showed the highest ∑_4-8PCDD/F (Tetra-Octa) fluxes, ranging from 204 to 608 (mean: 352) pg m⁻² d⁻¹, indicating steel complexes were major sources of PCDD/Fs. The homologue profiles were dominated with lower chlorinated PCDFs. Furthermore, the prevailing winds were confirmed to influence the spatial distribution of PCDD/F deposition. There were apparent seasonal variations of the bulk deposition at each site, and seasonal homologue patterns of PCDD/Fs were clearly observed. According to the passive air sampling, however, no significant seasonal change of ambient air concentrations of PCDD/Fs was observed. Therefore, it was concluded that the seasonal variations of deposition fluxes of PCDD/Fs probably resulted from temperature-dependent gas/particle partitioning.     

Selective recovery of Cu, Zn, and Ni from acid mine drainage

In Korea, the heavy metal pollution from about 1,000 abandoned mines has been a serious environmental issue. Especially, the surface waters, groundwaters, and soils around mines have been contaminated by heavy metals originating from acid mine drainage (AMD) and mine tailings. So far, AMD was considered as a waste stream to be treated to prevent environmental pollutions; however, the stream contains mainly Fe and Al and valuable metals such as Ni, Zn, and Cu. In this study, Visual MINTEQ simulation was carried out to investigate the speciation of heavy metals as functions of pH and neutralizing agents. Based on the simulation, selective pH values were determined to form hydroxide or carbonate precipitates of Cu, Zn, and Ni. Experiments based on the simulation results show that the recovery yield of Zn and Cu were 91 and 94 %, respectively, in a binary mixture of Cu and Zn, while 95 % of Cu and 94 % of Ni were recovered in a binary mixture of Cu and Ni. However, the recovery yield and purity of Zn and Ni were very low because of similar characteristics of Zn and Ni. Therefore, the mixture of Cu and Zn or Cu and Ni could be recovered by selective precipitation via pH adjustment; however, it is impossible to recover selectively Zn and Ni in the mixture of them.     

Field application of electrokinetic remediation for multi-metal contaminated paddy soil using two-dimensional electrode configuration

In this study, we evaluated the feasibility of in situ electrokinetic remediation for arsenic (As)-, copper (Cu)-, and lead (Pb)-contaminated soil, in a pilot-scale field application with two-dimensional electrode configurations. Square and hexagonal configurations with different electrode spacing, 1 m and 2?m, were investigated under a constant 100 V. A square configuration with electrode spacing of 2 m removed 61.5 % of As, 11.4 % of Cu, and 0.9 % of Pb, respectively, and a hexagonal configuration with the same spacing showed a higher removal efficiency in top (59 % of As, 0–0.5 m) and middle (53 % of As, 0.5–1.0 m) layers, but much lower removal efficiency in the bottom layer (1–1.5 m), which was thought to be due to groundwater flow through periodic rise and fall of tides. Fractionation analysis showed that As bound to Fe–Mn oxyhydroxide was the main form of As removed by the electrokinetic process. The two-dimensional configuration wasted less electrical energy by Joule heating, and required fewer electrode installations, compared to the one-dimensional electrode configuration.     

Aging estimation of reactor pressure vessel in the field using magnetic properties

Many researchers have been interested in the nondestructive measurement methods for estimating components damage in order to assure the safe service of steel structures. It is recognized that the evaluating techniques based on magnetic measurement can offer a great potential because of high susceptibility to the change of several metallurgical factors. Magnetic property such as coercive force was measured. The coercive force at room temperature monotonously increased with the increase of frequency. The correlation between the magnetic properties of used material and that of un-used material was studied. The coercive force gradient at room temperature increased with the increase of aging. Hence the estimating method using magnetic properties allows one to evaluate the extent of material aging for reactor pressure vessel.     

Environmental assessment on a soil washing process of a Pb-contaminated shooting range site: a case study

In this study, an environmental assessment on a soil washing process for the remediation of a Pb-contaminated shooting range site was conducted, using a green and sustainable remediation tool, i.e., SiteWise ver. 2, based on data relating specifically to the actual remediation project. The entire soil washing process was classified into four major stages, consisting of soil excavation (stage I), physical separation (stage II), acid-based (0.2 N HCl) chemical extraction (stage III), and wastewater treatment (stage IV). Environmental footprints, including greenhouse gas (GHG) emissions, energy consumption, water consumption, and critical air pollutant productions such as PM₁₀, NO _x , and SO _x , were calculated, and the relative contribution of each stage was analyzed in the environmental assessment. In stage I, the relative contribution of the PM₁₀ emissions was 55.3 % because the soil excavation emitted the fine particles. In stage II, the relative contribution of NO _x and SO _x emissions was 42.5 and 52.5 %, respectively, which resulted from electricity consumption for the operation of the separator. Stage III was the main contributing factor to 63.1 % of the GHG emissions, 67.5 % of total energy used, and 37.4 % of water consumptions. The relatively high contribution of stage III comes from use of consumable chemicals such as HCl and water-based extraction processes. In stage IV, the relative contributions of GHG emissions, total energy used, and NO _x and SO _x emissions were 23.2, 19.4, 19.5, and 25.3 %, respectively, which were caused by chemical and electricity demands for system operation. In conclusion, consumable chemicals such as HCl and NaOH, electric energy consumption for system operation, and equipment use for soil excavation were determined to be the major sources of environmental pollution to occur during the soil washing process. Especially, the acid-based chemical extraction process should be avoided in order to improve the sustainability of soil washing processes.