Development of a Local-Scale Spatially Refined Multimedia Fate Model (LSRMFM) for Urban-Scale Risk Assessment: Model Formulation, GIS-Based Preprocessing, and Case Study

A local-scale spatially refined multimedia fate model (LSRMFM) was developed to evaluate in detail the multimedia transport of organic compounds at a spatial level. The model was derived using a combination of an advection?Cdispersion?Creaction partial differential equation, a steady-state multimedia fugacity model, and a geographical information system. The model was applied to predicting four major volatile organic compounds that are produced as emissions (benzene, toluene, xylene, and styrene) in an urban and industrial area (the 50?×?50-km area was divided into 0.5?×?0.5-km segments) in Korea. To test the accuracy of the model, the LSRMFM was used to predict the extent of dispersion and the data compared with actual measured concentrations and the results of a generic multimedia fate model (GMFM). The results indicated that the method developed herein is appropriate for predicting long-term multimedia pollution. However, the comparison study also illustrated that the developed model has some limitations (e.g., steady-state assumption) in terms of explaining all the observed concentrations, and additional verification and study (e.g., validation using a large observed data set, integration with a more accurate runoff model) would be desirable. In comparing LSRMFM and GMFM, discrepancies between the LSRMFM and GMFM outputs were found, as the result of geographical effects, even though the environmental parameters were identical. The geographical variation for LSRMFM output indicated the existence of considerable local human and ecological risks, whereas the GMFM output indicated less average risk. These results demonstrate that the model has the potential for improving the management of pollutant levels under these refined spatial conditions.     

Toxicity of atrazine and its bioaccumulation and biodegradation in a green microalga,Chlamydomonas mexicana

This study evaluated the toxicity of herbicide atrazine, along with its bioaccumulation and biodegradation in the green microalga Chlamydomonas mexicana. At low concentration (10 μg L^?1), atrazine had no profound effect on the microalga, while higher concentrations (25, 50, and 100 μg L^?1) imposed toxicity, leading to inhibition of cell growth and chlorophyll a accumulation by 22 %, 33 %, and 36 %, and 13 %, 24 %, and 27 %, respectively. Atrazine 96-h EC50 for C. mexicana was estimated to be 33 μg L^?1. Microalga showed a capability to accumulate atrazine in the cell and to biodegrade the cell-accumulated atrazine resulting in 14–36 % atrazine degradation at 10–100 μg L^?1. Increasing atrazine concentration decreased the total fatty acids (from 102 to 75 mg g^?1) and increased the unsaturated fatty acid content in the microalga. Carbohydrate content increased gradually with the increase in atrazine concentration up to 15 %. This study shows that C. mexicana has the capability to degrade atrazine and can be employed for the remediation of atrazine-contaminated streams.     

A comparison study on high-temperature water–gas shift reaction over Fe/Al/Cu and Fe/Al/Ni catalysts using simulated waste-derived synthesis gas

A comparative study on Fe/Al, Fe/Al/Cu, and Fe/Al/Ni catalysts in high-temperature water–gas shift reaction (HT–WGS) using simulated waste-derived synthesis gas has been carried out. The metal oxide (Cu and Ni) and aluminum incorporated Fe catalysts were designed to get highly active HT–WGS catalysts. Despite the high CO concentration in the simulated waste-derived synthesis gas, Fe/Al/Cu catalyst exhibited the highest CO conversion (84 %) and 100 % selectivity to CO₂ at a very high gas hourly space velocity (GHSV) of 40,057 h^?1. The outstanding catalytic performance is mainly due to easier reducibility, the synergy effect of Cu and Al, and the stability of the magnetite.     

Risk of serious injury of occupants involved in frontal crashes of cab-over-type trucks

Objectives: Truck vehicles (TVs) have a different structure and stiffness than non-TVs and are used commercially for transporting goods. This study aimed to analyze whether truck occupants have a greater risk of serious injury than those of other types of vehicles.

Methods: Crash data were obtained from the Korean In-Depth Data Analysis Study (KIDAS) for calendar years 2011–2016. Vehicles involved in frontal crash were included and classified into TVs and non-TVs (passenger cars and sports utility vehicles). We compared the demographic characteristics and serious injuries by body region between the 2 groups and analyzed factors that contributed to the serious injury severity from frontal crashes.

Results: The analysis was based on 884 occupants; 177 (20.0%) were in TVs and 707 (80.0%) were in non-TVs. Non-TVs had more frontal airbags deployments than TVs (50.9% vs. 3.4%, P <.01). TV occupants were 4.8 times more likely to have a serious lower extremity (LE) injury (adjusted odds ratio [AOR] = 4.820; 95% confidence interval [CI], 2.407–9.653) and 2.5 times to have a serious abdominal injury (AOR = 2.465; 95% CI, 1.108–5.487) compared to non-TV occupants.

Conclusions: Truck occupants had more serious LE and abdominal injuries than those of other types of vehicles in frontal crashes. Structural improvement and legislative efforts to develop safety systems are necessary to improve the safety of truck occupants.     

Effects of salinity and organic matter on the partitioning of perfluoroalkyl acid (PFAs) to clay particles

The influence of salinity and organic matter on the distribution coefficient (K(d)) for perfluorooctane sulfonic acid (PFOS) and perfluorooctanoic acid (PFOA) in a brackish water-clay system was studied. The distribution coefficients (K(d)) for PFAs onto inorganic clay surfaces increased with salinity, providing evidence for electrostatic interaction for the sorption of PFAs, whereas the relationship between K(d) and organic carbon content (f(oc)) suggested that hydrophobic interaction is the primary driving force for the sorption of PFAs onto organic matter. The organic carbon normalized adsorption coefficient (K(oc)) of PFAs can be slightly overestimated due to the electrostatic interaction within uncoated inorganic surfaces. In addition, the dissolved organic matter released from coated clay particles seemed to solvate PFA molecules in solution, which contributed to a decrease in K(d). A positive relationship between K(d) and salinity was apparent, but an empirical relationship for the 'salting-out' effect was not evident. The K(d) values of PFAs are relatively small compared with those reported for persistent organic pollutants. Thus, sorption may not be a significant route of mass transfer of PFAs from water columns in estuarine environments. However, enhancement of sorption of PFAs to particulate matter at high salinity values could evoke potential risks to benthic organisms in estuarine areas.     

Effect of fertilizer application on ammonia emission and concentration levels of ammonium, nitrate, and nitrite ions in a rice field

The concentrations of ammonium NH4+, nitrate NO3-, and nitrite NO2- ions were recorded along with ammonia (NH(3)) emission from a fertilized rice field located in the Kwangju province in South Korea over a period of 4 months (June to October 2006). The highest magnitude of NH(3) flux was 20,754 microg m(-2) h(-1), while the average flux value over the entire sampling period was 2,395 microg m(-2) h(-1). The highest ionic concentrations were 1.67, 0.44, and 0.71 ppm for NH4+, NO3-, and NO2- ions, respectively. Possible effects of soil pH on NH(3) fluxes were detected, as they concurrently exhibited a gradual and periodic change during the sampling period. Positive correlations existed between concentrations of NH4+ and NO2- ions and the soil pH. Positive correlations also existed between NH(3) emission flux and ambient (and water) temperatures. Results indicated that fertilizer application to rice can lead to significant emission of NH(3) along with NH4+ and NO3- ions.     

Development of a country-specific CO2 emission factor for domestic anthracite in Korea, 2007�C2009

Introduction

Korea has been making efforts to reduce greenhouse gas (GHG) emissions, including a voluntary commitment to the target of a 30% reduction, based on business-as-usual of the total GHG emission volume, by 2020; 2006 IPCC Guidelines provided default values, applying country-specific emission factors was recommended when estimating national greenhouse gas emissions.

Results and discussion

This study focused on anthracite produced in Korea in order to provide basic data for developing country-specific emission factor. This study has estimated CO₂ emission factors to use worksheet of which five steps consisted according to the fuel analysis method.

Conclusion

As a result, the average of net colorific value for 3 years (2007??2009) was 4,519 kcal/kg, and the CO₂ emission factor was calculated to be 111,446 kg/TJ, which is about 11.8% lower than the 2006 IPCC guidelines default value, and about 7.9% higher than the US EPA emission factor.