基于尾涡强度的无人机与民机纵向安全间隔评估研究

为了解决无人机频频入侵机场净空，与民航客机发生危险接近的问题，以碰撞风险为量化指标，对无人机与民机需要保持的纵向安全间隔进行评估研究。分析民机尾涡流场对无人机运行的影响，利用Crow近场涡强度消散理论，得到实际尾迹影响区改进Reich碰撞模板，据此建立CNS/GPS性能环境下的纵向间隔评估模型，通过Matlab进行间隔值求解。研究结果表明:模型可以较为准确地反映民机起飞初始爬升阶段无人机尾随运行时导航性能和尾涡迹对所需最小间隔值的影响，并得到给定安全目标水平的计算结果。     

呼吸效应对矿井封闭火区氧浓度的影响分析

为避免因火区封闭导致重大安全事故发生，通过采集某矿井1 d内3个不同监测点的大气压力变化情况，建立大气压力波动模型并分析计算，同时建立火区内外压差100，750 Pa情形下的氧浓度模型进而获得火区内侧氧气浓度因呼吸效应，在不同压差、体积大小火区、风阻、瓦斯涌出量、封闭时刻等多因素耦合影响下随时间的变化规律，以评估火区危险性。研究结果表明:井下大气随地面大气周期波动，封闭火区内、外侧之间的气压差因外界大气波动呈现16 h的余弦波动和8 h的线性波动周期变化；密闭质量好的火区具有更好地抗干扰性，内侧氧浓度的降低主要依靠瓦斯稀释；密闭质量差的火区，内侧氧浓度易受到火区涌出瓦斯、外界涌入大气双重影响；火区氧浓度在2%~12%之间波动，以至火区存在发生瓦斯爆炸的可能性；火区内外压差较大时，氧浓度波动变化幅度更大，危险作用持续时间更长。结合火区氧浓度波动模型，可有效地对矿井火区采取安全的防范措施，避免瓦斯爆炸事故发生。     

Pseudomonas sp.fz胞外分离物降解四溴双酚A

四溴双酚A(TBBPA)是全球消耗量最大的溴系阻燃剂。通过活性物质的定位、分离和TBBPA产物的分析等步骤,对Pseudomonas sp.fz胞外分离物降解TBBPA进行了研究。结果表明,存在于胞外的活性物质通过异丙基断裂和脱溴两条途径降解TBBPA。通过超滤,Sephadex G-10分离纯化得到了具有降解活性的小分子物质,分子量约为376~456 Da,初步鉴定为短肽类物质。这种小分子物质具有很好的热稳定性(30~80℃),在弱酸性条件下(2.0~5.0)活性较高,其活性还受金属离子、氧气和抑制剂(Na N3)的影响。此外,部分纯化的小分子物质在一定条件下能够产生羟基自由基(·OH)。     

水泥窑共处置过程中水泥生料对砷的吸附/冷凝特性

针对水泥生料开展了氮吸附与SEM测试分析,研究了水泥生料的比表面积,孔径结构和微观表面积。同时,利用管式回转炉和控温立式炉联用装置研究了砷元素在水泥生料上的吸附冷凝特性。结果表明,水泥生料的比表面积很小,微观表面结构致密无孔,砷元素主要是冷凝在生料表面上。进入吸附冷凝炉的重金属可以分为3部分,第1部分冷凝在管壁上,占80%左右;第2部分吸附/冷凝在生料上,占10%左右;第3部分随烟气释放到空气中,不到10%。水泥生料对砷的吸附冷凝量随时间的增加而增加,随温度的升高而降低。水泥生料对砷的吸附冷凝特性可用双常数速率方程拟合,拟合效果较好,计算得表观活化能在6~7 kJ/mol之间。此外,砷的初始浓度对水泥生料的吸附冷凝特性影响很小。     

Pollution characteristics and ecological risk assessment of heavy metals in three land-use types on the southern Loess Plateau,China

The accumulation of heavy metals in agricultural soils has been the subject of great concern because these metals have the potential to be transferred to soil solutions and subsequently accumulate in the food chain. To study the persistence of trace metals in crop and orchard soils, representative surface soil samples were collected from terrace farmland that had been cultivated for various numbers of years (3, 8, 12, 15, and >20 years), terrace orchard land that had been cultivated for various numbers of years (4, 7, 10, 12, 15, 18, 25, and >30 years), and slope farmland with various gradients (3°, 5°, 8°, 12°, 15°, and 25°) and analyzed for heavy metals (As, Cr, Cu, Hg, Ni, and Zn). These samples were collected from Nihegou catchment of Chunhua county in the southern Loess Plateau of China. The six heavy metals demonstrated different trends with time or gradient in the three land-use types. The Cu and Zn contents of the soil were higher than the referee background values of the loessal soil, and the contents of Cr and Ni, and especially those of As and Hg, were lower. Cu was the only heavy metal that just met the Grade III Environmental Quality Standard for Soils of China, while the others reached grade I. Cu and Hg were considered contaminant factors and Hg was a moderate potential ecological risk factor in the catchment. Of the sites investigated, 89.5% fell into the category with a low degree of contamination (C _d ) and rest were moderate, while all three land-use types had low potential ecological risk (RI). Changes of C _d and RI were consistent with the cultivated time in the terrace farmland and terrace orchard land. Values of RI increased while C _d decreased with the increasing of slope gradient in the slope farmland. Evaluating the ecological risk posed by heavy metals using more soil samples in a larger study area is necessary on the Loess Plateau of China.     

Mechanism of the intermittent motion of two-phase debris flows

A typical two-phase debris flow exhibits a high and steep flow head consisting of rolling boulders and cobbles with intermittent or fluctuating velocity. The relative motion between the solid phase and the liquid phase is obvious. The motion of a two-phase debris flow depends not only on the rheological properties of the flow, but also on the energy transmission between the solid and liquid phases. Several models have been developed to study two-phase debris flows. An essential shortcoming of most of these models is the omission of the interaction between the two phases and identification of the different roles of the different materials in two-phase debris flows. The tracer particles were used for the velocity of solid phase and the velocity of liquid phase was calculated by the water velocity on the surface of the debris flow in the experiments. This paper analyzed the intermittent feature of two-phase debris flows based on videos of debris flows in the field and flume experiments. The experiments showed that the height of the head of the two-phase debris flow increased gradually in the initiation stage and reached equilibrium at a certain distance from the start of the debris flow. The height growth and the velocity of the flow head showed fluctuating characteristics. Model equations were established and the analyses proved that the average velocity of the two-phase debris flow head was proportional to the flood discharge and inversely proportional to the volume of the debris flow head.     

Screening of indicator pharmaceuticals and personal care products in landfill leachates: a case study in Shanghai,China

● A systematic framework was developed to identify i-PPCPs for landfill leachate. ● The wide-scope target analysis offered a basis for comprehensive i-PPCP screening. ● Source-specificity and representativeness analysis helped to refine i-PPCPs. ● Erythromycin, gemfibrozil and albendazole were identified as i-PPCPs for leachate. Identifying potential sources of pharmaceuticals and personal care products (PPCPs) in the environment is critical for the effective control of PPCP contamination. Landfill leachate is an important source of PPCPs in water; however, it has barely been involved in source apportionment due to the lack of indicator-PPCPs (i-PPCPs) in landfill leachates. This study provides the first systematic framework for identifying i-PPCPs for landfill leachates based on the wide-scope target monitoring of PPCPs. The number of target PPCPs increased from < 20 in previous studies to 68 in the present study. Fifty-nine PPCPs were detected, with median concentrations in leachate samples ranging from below the method quantification limit (MQL) to 41 μg/L, and 19 of them were rarely reported previously. A total of 29 target compounds were determined to be PPCPs of high concern by principal component analysis according to multiple criteria, including occurrence, exposure potential, and ecological effect. Coupled with source-specificity and representativeness analysis, erythromycin, gemfibrozil, and albendazole showed a significant difference in their occurrence in leachate compared to other potential sources (untreated and treated municipal wastewater and livestock wastewater) and correlated with total PPCP concentrations; these were recommended as i-PPCPs for leachates. Indicator screening procedure can be used to develop a sophisticated source apportionment method to identify sources of PPCPs from adjacent landfills.     

Heterogeneous UV/Fenton degradation of bisphenol A catalyzed by synergistic effects of FeCo2O4/TiO2/GO

A new method for bisphenol A (BPA) degradation in aqueous solution was developed. The characteristics of BPA degradation in a heterogeneous ultraviolet (UV)/Fenton reaction catalyzed by FeCo₂O₄/TiO₂/graphite oxide (GO) were studied. The properties of the synthesized catalysts were characterized using scanning electron microscopy, X-ray diffraction, and vibrating sample magnetometry. FeCo₂O₄ and TiO₂ were grown as spherical shape, rough surface, and relatively uniform on the surface of GO (FeCo₂O₄/TiO₂/GO). Batch tests were conducted to evaluate the effects of the initial pH, FeCo₂O₄/TiO₂/GO dosage, and H₂O₂ concentration on BPA degradation. In a system with 0.5 g L⁻¹ of FeCo₂O₄/TiO₂/GO and 10 mmol L⁻¹ of H₂O₂, approximately 90 % of BPA (20 mg L⁻¹) was degraded within 240 min of UV irradiation at pH 6.0. The reused FeCo₂O₄/TiO₂/GO catalyst retained its activity after three cycles, which indicates that it is stable and reusable. The heterogeneous UV/Fenton reaction catalyzed by FeCo₂O₄/TiO₂/GO is a promising advanced oxidation technology for treating wastewater that contains BPA.

     

UV/Fenton技术处理某工厂高浓度乳化油废水

研究了UV/Fenton技术对高浓度金属清洗乳化油废水的处理效果,考察了亚铁与双氧水浓度、pH、反应时间和搅拌对COD去除效果的影响。实验结果表明,UV/Fenton技术对高浓度乳化油废水(COD平均浓度为35 000 mg/L)具有较高的去除效果,最佳工艺条件为:亚铁与双氧水浓度分别为2 400 mg/L和6 000 mg/L,pH为3,经过2 h反应,COD可降低至1 050 mg/L,去除率为97%。搅拌会降低COD的去除率。研究表明,UV/Fenton技术对高浓度乳化油废水具有很好的降解效果,且药品消耗较低,为目前此类高浓度有机废水的处理提供了技术参考。     

碱液预处理玉米秸秆的条件优化及添加剂的选择

利用稀NaOH溶液预处理玉米秸秆,以去除木质素,减少半纤维素、纤维素的损失为目的,采用响应曲面法对预处理条件进行优化,得到的最佳预处理条件为:NaOH溶液浓度0.77%(w/w),预处理时间16 h,温度45.6℃。并且,进一步研究了不同添加剂(聚乙二醇、吐温-80和尿素)与NaOH溶液协同作用下秸秆中木质素的去除效果,结果表明尿素与NaOH的混合溶液对木质素去除效果最显著。秸秆在45.6℃,0.77%NaOH和0.2%尿素混合溶液中浸泡16 h后,纤维素回收率为86.33%,半纤维素回收率为69.89%,木质素去除率为64.93%;与原秸秆相比,纤维素含量提高了31.70%,半纤维素含量提高了6.62%,木质素含量减少了46.48%。