A hybrid model for human factor analysis in process accidents: FBN-HFACS

Human factors are the largest contributing factors to unsafe operation of the chemical process systems. Conventional methods of human factor assessment are often static, unable to deal with data and model uncertainty, and to consider independencies among failure modes. To overcome the above limitations, this paper presents a hybrid dynamic human factor model considering Human Factor Analysis and Classification System (HFACS), intuitionistic fuzzy set theory, and Bayesian network. The model is tested on accident scenarios which have occurred in a hot tapping operation of a natural gas pipeline. The results demonstrate that poor occupational safety training, failure to implement risk management principles, and ignoring reporting unsafe conditions were the factors that contributed most failures causing accident. The potential risk-based safety measures for preventing similar accidents are discussed. The application of the model confirms its robustness in estimating impact rate (degree) of human factor induced failures, consideration of the conditional dependency, and a dynamic and flexible modelling structure.     

Density functional theory (DFT) studies of vanadium-titanium based selective catalytic reduction (SCR) catalysts

Based on density functional theory (DFT) and basic structure models, the chemical reactions on the surface of vanadium-titanium based selective catalytic reduction (SCR) denitrification catalysts were summarized. Reasonable structural models (non-periodic and periodic structural models) are the basis of density functional calculations. A periodic structure model was more appropriate to represent the catalyst surface, and its theoretical calculation results were more comparable with the experimental results than a non-periodic model. It is generally believed that the SCR mechanism where NH₃ and NO react to produce N₂ and H₂O follows an Eley-Rideal type mechanism. NH₂NO was found to be an important intermediate in the SCR reaction, with multiple production routes. Simultaneously, the effects of H₂O, SO₂ and metal on SCR catalysts were also summarized.     

清洁生产工艺在造纸工业中的应用

介绍了清洁生产这个新概念,清洁生产工艺在造纸工业中的应用,实例表明:造纸废水再循环,不准能节约水资源,节约能源,防止环境污染,而且可以取得良好的经济效益和社会效益,为造纸废水在2000 年前达到国家排准排放奠定了良好基础     

SBR工艺处理城市垃圾渗滤液的可行性分析

在参考国内外垃圾渗滤液的处理方案后，选择厌氧预处理 SBR工艺作为处理方案，通过实验对该废水处理的情况来看，该工艺较好地适应了垃圾渗滤液的处理特点，能达到比较良好的效果。     

防止井下作业污染环境的工艺技术应用

分析了井下作业施工对环境造成污染的因素，介绍江苏油田在井下作业过程中进行污染防治的措施及其相关配套新工艺、新技术的应用和效果。     

金陵石化炼油厂第二污水处理场改造工程介绍

金陵石化炼油厂第二污水处理场改造工程中对原有处理设施进行了工艺调整和优化，采用了均质，二级好氧生物处理及后浮选工艺，工程运行结果表明所采用的技术、设备是合理有效的。     

活性污泥外循环SBR系统循环污泥释磷能力研究

本试验以HAc作为厌氧释磷的碳源有机物，以SBR系统外循环污泥作为研究对象，探索外循环活性污泥的厌氧释磷能力和获取高浓度富磷污水的途径，试验表明：厌氧过程中聚磷菌吸收HAc和释放PO4^3 的分子比为1：1。即吸收2．06mgHAc-COD将诱导1mgP释放，单位时段比污泥的平均释磷速率Vp=6.54.t^0.76，理想的厌氧时间为60－180min，减少循环污泥释磷系统的反应容积可以提高富磷污水磷酸盐的浓度。     

水解酸化—SBR法处理乳品废水的工程应用

介绍了应用SBR法处理乳品废水的工程实例。利用SBR工艺处理乳品废水的特点是工艺简单、占地面积小、运转费用低、管理方便、出水稳定。当进水CODCr2 0 0 0～ 2 5 0 0mg/L之间 ,出水可以达到国家《污水综合排放标准》(GB8978- 1996 )中的一级标准 ,CODCr≤ 10 0mg/L。     

餐饮泔水油及废动植物油下脚料深加工利用大有可为：介绍《国家级科技成果重点推广计划》高效益环保项目“利用餐饮泔水油及废动植物油生产油酸、甘油、硬脂酸”新工艺

综述了我国的餐饮泔水油及废油脂资源浪费、破坏环境现状，对比介绍了新工艺显著的经济及环保效益。     

Upgrading of organic waste: production of the copolymer poly-3-hydroxybutyrate-co-valerate by Ralstonia eutrophus with organic waste as sole carbon source

Two types of fermented organic waste (trade and industry waste and fruit and vegetable waste) were successfully used as a sole carbon source to produce poly-3-hydroxybutyrate-co-valerate (PHBV) by Ralstonia eutrophus (formerly Alcaligenes eutrophus) via oxygen limitation.The production of PHBV could be optimized by optimizing the oxygen transfer through the fermentor. Thereby, a peak concentration of 1.1 g PHBV per liter cell suspension, 40 w% of cell dry weight, was obtained at an aeration rate of 0.24 mol O₂/h·kg biomass. The yield of PHBV on the fatty acid concentration in the organic waste was 0.16 g polymer/g volatile organic matter. The process obtained, compares well with the commercial production process of PHBV based on glucose.