高烈度地震区隧道软硬围岩交接段刚柔并济抗减震技术研究*

为提高高烈度地震区隧道抗震性能，以某铁路隧道为研究背景，分析3种抗减震措施下隧道不同监测点隧道拱顶沉降、边墙收敛、衬砌结构PGA及最小安全系数，通过对比分析得到最优抗减震措施。结果表明:相比于工况1，工况2隧道拱顶沉降减小10.54%~81.10%，边墙收敛减小13.92%~78.77%，衬砌结构PGA减小31.42%~72.02%，最小安全系数增加18.04%~66.13%；相比于工况1，工况3结构拱顶沉降减小3.04%~18.02%，边墙收敛减小4.70%~32.00%，PGA增加13.95%~27.48%，最小安全系数增加7.49%~30.99%；工况4即“减震层+SFRC衬砌”刚柔并济法，相比于工况1，隧道拱顶沉降减小18.46%~83.98%，结构边墙收敛减小17.54%~85.47%，PGA减小30.00%~69.98%，最小安全系数增加47.95%~83.56%；4种工况抗减震性能由高到低依次为:工况4＞工况2＞工况3＞工况1。研究结果可为隧道软硬围岩交接段抗震设防提供理论参考。     

纵向通风对隧道竖井排烟影响的模拟研究

通过开展小尺寸实验以及FDS数值模拟实验,研究纵向通风对不同高度竖井的排烟影响并确定最佳通风风速。通过分析纵向通风风速、竖井高度对吸穿现象、边界层分离的影响规律,讨论了吸穿现象的临界条件。小尺寸实验中纵向通风风速考虑了0.096 m/s、0.226 m/s、0.356 m/s、0.485 m/s、0.629 m/s五种工况,竖井高度考虑了0.133 m、0.2 m、0.333 m、0.533 m四种工况。实验结果表明:当纵向通风风速为0.096 m/s、0.226 m/s、0.356 m/s(对应实际风速0.37 m/s、0.87 m/s、1.38 m/s)时,可抑制吸穿现象,但烟气边界层分离现象随着风速的增加而加剧。吸穿现象临界判据F_(critical)=1.5在本文所测试的纵向通风条件下不再适用,但Ri′_(critical)=1.5依然适用。数值模拟结果表明:当竖井高度为1 m、1.5 m、2 m时,排烟量随纵向通风的增加而降低,而当其为3 m、4 m、5 m时,排烟量先上升后降低,在测试风速为1.5 m/s时达到最高值。     

A proactive process risk assessment approach based on job hazard analysis and resilient engineering

Complex systems often experience a long period of incubation before accidents occur. Therefore, a proactive risk assessment is essential for process safety. The conventional job hazard analysis (JHA) method has been an effective tool to conduct a process risk assessment in the high-risk industrial field. However, the conventional JHA is inadequate for the proactive risk assessment since it is usually conducted during and before one specific operation process. Operations such as startup and maintenance are performed repeatedly on the lifecycle of a plant. Therefore, the risk reduction measures for the industrial process should include not only preventive actions obtained from the conventional JHA but also recovery ones. Resilience engineering (RE) has proven to be helpful for the recovery analysis of a complex system. The objective of this paper is to propose a proactive and comprehensive process risk assessment approach based on JHA and RE. The mechanism of applying RE to address operation process risk is illustrated. The integrated approach can provide guidelines to establish proactive risk reduction measures as well as maintain a low-risk level. Finally, a gas transmission startup process risk assessment case is presented to demonstrate its applicability.     

区域水战略方案选优的动态组合评价模型研究

水安全危机是人类进入新世纪以来在生存及发展方面所面临的最严重挑战之一。研究科学合理的水安全战略成为区域可持续发展的重大课题。针对区域水战略问题涉及众多因素且各因素之间动态关联的特点，提出了基于水战略方案优选的兼容度极大化动态组合评价模型（CMM—DCEM），并将其成功地应用于我国广东省北江下游及其三角洲地区水安全战略方案优选评价。评价结果及模型基于不确定性的敏感性分析结果证明：CMM—DCEM实现了主、客观赋权方法以及单一评价模型的融合，使用实码加速遗传算法求解目标函数，克服了传统的组合评价方法计算繁琐的不足，评价过程更加科学合理。     

Modelling Tracer Dispersion from Landfills

Several wind tunnel experiments of tracer dispersion from reduced-scale landfill models are presented in this paper. Different experimental set-ups, hot-wire anemometry, particle image velocimetry and tracer concentration measurements were used for the characterisation of flow and dispersion phenomena nearby the models. The main aim of these experiments is to build an extensive experimental data set useful for model validation purposes. To demonstrate the potentiality of the experimental data set, a validation exercise on several mathematical models was performed by means of a statistical technique. The experiments highlighted an increase in pollutant ground level concentrations immediately downwind from the landfill because of induced turbulence and mean flow deflection. This phenomenon turns out to be predominant for the dispersion process. Tests with a different set-up showed an important dependence of the dispersion phenomena from the landfill height and highlighted how complex orographic conditions downwind of the landfill do not affect significantly the dispersion behaviour. Validation exercises were useful for model calibration, improving code reliability, as well as evaluating performances. The Van Ulden model proved to give the most encouraging results.     

湖州市埭溪镇污水处理厂的工程设计

湖州市埭溪镇污水处理厂的设计规模，近期为2万m^2／d，远期为3万m^2／d，其污水处理工艺采用改良式A^2／O工艺，污泥处理工艺采用带式浓缩脱水一体机。文中着重介绍了工程设计参数、处理工艺流程及其设计特点。     

航班起飞过程的风险识别与控制

飞机起飞阶段是事故多发阶段,为了进行风险识别与控制,设计了定性判别方法和定量计算仿真算法,并以具体飞机坠毁事故为例分析了安全裕度.分别计算了飞机冲出跑道的速度、距离和逃生时间.中断起飞的速度与时间,是火灾发生后的判断关键,也构成了飞机起飞事故的裕度.结果表明,中断起飞的安全裕度比坠毁的大,且关于中断起飞的规定有矛盾之处;用于逃生的90 s规则高于中断起飞的决断速度的限制规定.该分析方法为处理危急时刻的两难决策问题提供了理论指导.     

贵阳地区基本地质环境和主要岩土工程问题综述

本文系笔者对贵阳地区主要地质环境和工程地质特点进行的初步总结,内容为贵阳地区主要岩土构成情况、分布范围及与之相应的岩土工程地质特点和主要的岩土工程地质问题的描述,旨在给同行提供宏观性的了解和方向性的参考。     

地震安全性评价工作在城市建设中的重要作用

地震安全性评价工作在城市建设中起着非常重要的作用,为工程抗震提供精确的设计依据,提供科学合理的地震动参数,提出科学合理的设防要求,能够在一定程度上避免破坏性地震造成的损失,从而达到有效减灾的目的。     

A profile of environmental science in China

This paper concisely introduced the eco-environmental survey in China and the Chinese scientific programme for environmental research which is being practiced or being planned. China has established a nation-wide system relating to environmental scientific research and environmental administration and has taken the following strategies for solving the environment problems: (1) a series of laws and regulations for environmental protection has been promulgated so as to strengthen the legal administration and economic punishment. (2) the idea of ecological construction has been proposed for the purpose of taking the environmental protection work into the consideration of the national and provincial (or regional) economic construction planning. (3) spreading ecological engineering and ecological technologies have reduced the pollutant sources and have increased the industrial and agricultural economic profit.