超滤处理洗涤污水循环利用的中试研究

采用不同材质国产超滤膜聚丙烯（PP）、聚丙烯腈（PAN）和聚砜（PS）,进行了洗涤污水处理循环利用的现场中试研究.结合超滤工艺出水水质和膜污染分析,3种膜材质中PAN膜较优,有效去除了水中浊度、悬浮物、油脂等污染物,一定程度保留了游离阴离子表面活性剂（LAS）,长期循环洗涤对衣物的白度无不良影响.根据相关性分析,超滤出水较高COD值很大程度上是由水中LAS引起的.超滤膜对细菌、大肠菌群的去除率较低,出水通过紫外消毒,当紫外线密度≥3?750 J/m²时,微生物水平能够达到国家饮用水水质标准.根据不同水力反冲洗条件下膜渗透通量和净产水量比较,PAN膜最佳水力反冲洗条件为0.5 h反冲洗2 min.长期运行时超滤膜化学清洗方法采用碱洗法方便有效.     

高效聚合氯化铝对超滤膜污染影响的中试研究

针对某水厂以超滤为核心的短流程水处理工艺,在通过聚氯乙烯(PVC)超滤膜之前选择不同投加量(5、10、15和20 mg/L)的高效聚合氯化铝(HPAC)对长江下游原水进行混凝处理。通过跨膜压差(TMP)增长趋势、CODMn的去除率以及混凝后的水质,可知HPAC的最优投加量为15 mg/L。在此投加量下,运用体积排阻色谱法分析原水、膜前水、膜后水中各相对分子质量有机物的变化,可以发现混凝去除有机物的效果要优于超滤截留的。继而将HPAC与另外4种常用混凝剂:硫酸铝(分析纯)、氯化铁(化学纯)、聚合氯化铝(PAC)、聚合硫酸铁进行对比,结果表明,在它们各自最优投加量下,HPAC能够更有效地减缓超滤膜TMP的增长率,从而降低膜污染。因此,认为HPAC是与PVC超滤合金膜契合效果最佳的混凝剂。     

混凝-超滤处理径流雨水效果——以华南地区为例

采用超滤膜(UF)为核心,以混凝作为预处理措施,对混凝-超滤工艺处理径流雨水的特性和膜通量变化与污染现象进行了研究,并对聚合硫酸铁(PFS)单独混凝、UF、PFS-UF组合工艺进行了对比;在优化混凝基础上,考察了混凝-UF对常规水质指标及总磷、生物可同化有机碳(AOC)、可生物降解溶解性有机碳(BDOC)等生物稳定性指标的去除效果.结果表明,混凝可有效去除TOC、UV254和总磷,混凝剂投加量与污染物去除近似呈线性关系.各混凝剂除浊效能均良好.综合考虑混凝处理效率与经济性,实验采用混凝方案为10 mg·L-1的PFS.PFS、UF、PFS-UF工艺除浊率均在95%以上,PFS和UF对TOC和UV254的去除较为接近,采用PFS-UF可提高去除率13%—15%;PFS-UF处理后雨水的AOC、BDOC分别降低至61.8μg·L-1、0.19 mg·L-1,残余总磷可降至3.8μg·L-1,雨水生物稳定性明显提高.PFS、UF和PFS-UF对颗粒物的去除率分别达80.5%、99.6%和99.9%.膜通量的变化和SEM图分析表明,混凝在一定程度上减轻了UF膜污染;形成的凝胶层具有一定整体强度,水力清洗时易于清除,膜通量恢复较好;但同时凝胶层的产生也增大了透膜阻力,PFS-UF工艺的周期内膜通量衰减有增加的趋势.     

聚醚砜超滤膜的研制

以聚醚砜为原料，二甲基乙酰胺为溶剂，研究了铸膜液组成和若干因素对膜性能的影响。选择适当的膜液组成和制备条件，可制得截留分子量分别为２０００，６０００，１００００的超滤膜，用该膜对α－干扰素进行分离。截留率均可达到９９％以上。     

SAFUIT/UF6环境评价模型验证与应用

作为核燃料循环过程中一种兼具辐射危害和化学毒性的中间产物,UF6的泄漏事故,特别是事故的环境评价技术越来越受到人们的重视.SAFUIT/UF6是专门针对此类事故的环境评价模型,目前已经开展了初步的验证工作.根据1987年法国UF6释放实验条件,对SAFUIT/UF6模型计算结果进行了误差分析,并与HG-SYSTEM/UF6模型进行了对比.初步认为SAFUIT/UF6模型可准确地模拟UF6扩散.此外,SAFUIT/UF6模型在某设施核事故应急评价系统中也得到了应用.     

Removal of organic matter and disinfection by-products precursors in a hybrid process combining ozonation with ceramic membrane ultrafiltration

The performance of an integrated process including coagulation, ozonation, ceramic ultrafiltration (UF) and biologic activated carbon (BAC) filtration was investigated for the removal of organic matter and disinfection by-products (DBPs) precursors from micro-polluted surface water. A pilot scale plant with the capacity of 120 m³ per day was set up and operated for the treatment of drinking water. Ceramic membranes were used with the filtration area of 50 m² and a pore size of 60 nm. Dissolved organic matter was divided into five fractions including hydrophobic acid (HoA), base (HoB) and neutral (HoN), weakly hydrophobic acid (WHoA) and hydrophilic matter (HiM) by DAX-8 and XAD-4 resins. The experiment results showed that the removal of organic matter was significantly improved with ozonation in advance. In sum, the integrated process removed 73% of dissolved organic carbon (DOC), 87% of UV₂₅₄, 77% of trihalomethane (THMs) precursors, 76% of haloacetic acid (HAAs) precursors, 83%of trichloracetic aldehyde (CH) precursor, 77% of dichloroacetonitrile (DCAN) precursor, 51% of trichloroacetonitrile (TCAN) precursor, 96% of 1,1,1-trichloroacetone (TCP) precursor and 63% of trichloronitromethane (TCNM) precursor. Hydrophobic organic matter was converted into hydrophilic organic matter during ozonation/UF, while the organic matter with molecular weight of 1000–3000 Da was remarkably decreased and converted into lower molecular weight organic matter ranged from 200–500 Da. DOC had a close linear relationship with the formation potential of DBPs.     

生物除锰技术研究进展与应用

文章简要阐述了生物除锰的机理,重点介绍生物除锰的工艺流程和应用,包括以生物滤池为核心的单极/多级工艺、复合MF/UF中空纤维膜工艺以及用于处理矿山废水的人工湿地工艺;同时介绍了国内外生物除锰的研究动态,如:同时去除NH4+、Fe、Mn的研究、生物滤池运行模式的研究等。分析了目前存在的问题,并对今后生物除锰的研究方向提出了一点看法。     

Aging of PVDF and PES ultrafiltration membranes by sodium hypochlorite: Effect of solution pH

Sodium hypochlorite (NaClO) is a commonly applied cleaning agent for ultrafiltration membranes in water and wastewater treatment. Long-term exposure to NaClO might change the properties and performance of polymeric membranes, and ultimately shorten membrane lifespan. Active species in NaClO solution vary with solution pH, and the aging effects can change depending on the membrane material. In this study, the aging of polyvinylidene fluoride (PVDF) and polyethersulfone (PES) membranes by NaClO at pH 3–11 was investigated by examining variations in chemical composition, surface charge, surface morphology, mechanical strength, permeability, and retention ability. Polyvinyl pyrrolidone (PVP), which was blended in both membranes, was oxidized and dislodged due to NaClO aging at all investigated pH values, but the oxidation products and dislodgement ratio of PVP varied with solution pH. For the PVDF membrane, NaClO aging at pH 3–11 caused a moderate increase in permeability and decreased retention due to the oxidation and release of PVP. The tensile strength decreased only at pH 11 because of the defluorination of PVDF molecules. For the PES membrane, NaClO aging at all investigated pH resulted in chain scission of PES molecules, which was favored at pH 7 and 9, potentially due to the formation of free radicals. Therefore, a decrease in tensile strength and retention ability, as well as an increase in permeability, occurred in the PES membrane for NaClO aging at pH 3–11. Overall, the results can provide a basis for selecting chemical cleaning conditions for PVDF and PES membranes.     

UF膜与混凝粉末活性炭联用处理微污染原水

采用混凝、粉末活性炭和UF膜分离的联用技术对黄浦江原水进行试验 ,结果表明 ,混凝、粉末活性炭可有效地去除溶解性有机物 .混凝处理主要去除大分子量的有机物 ,粉末活性炭主要去除低分子量的有机物 .混凝、粉末活性炭还能有效地去除三氯甲烷生成潜能 (THMFP) ,对于低分子量的THMFP ,混凝去除效果很差 ,而粉末活性炭去除很好 .试验还表明 ,混凝、粉末活性炭还可大大降低膜的滤饼层阻力 ,当混凝剂投加量为 4mg/L时 ,膜的滤饼层阻力最小 .     

渤海海水淡化反渗透法的预处理工艺

采用“消毒-混凝-澄清一砂滤”、“消毒-混凝-澄清-砂滤-超滤”以及“消毒-砂滤-超滤”三套海水淡化预处理工艺进行了试验对比。试验的目的在于获取可行的反渗透预处理工艺。表明,采用“消毒-混凝-澄清-砂滤-超滤”工艺或“消毒-砂滤-超滤”工艺是技术可行的反渗透预处理工艺,其中次氯酸钠为可选消毒剂,三氯化铁为较好的混凝剂,而超滤是不可或缺的单元处理工艺。