Effects of SO2 and H2O on low-temperature NO conversion over F-V2O5-WO3/TiO2 catalysts

F-V_2 O_5-WO3/Ti02 catalysts were prepared by the impregnation method.As the content of F ions increased from 0.00 to 0.35 wt.%,the NO conversion of F-V_2 O_5-WO_3/TiO_2 catalysts initially increased and then decreased.The 0.2 F-V_2 O_5-WO_3/TiO_2 catalyst(0.2 wt.% F ion)exhibited the best denitration(De-NOx) performance,with more than 95% NO conversion in the temperature range 160-360℃,and 99.0% N2 selectivity between 110 and 280℃.The addition of an appropriate amount of F ions eroded the surface morphology of the catalyst and reduced its grain size,thus enhancing the NO conversion at low temperature as well as the sulfur and water resistance of the V_2 O_5-WO3/Ti02 catalyst.After selective catalytic reduction(SCR) reaction in a gas flow containing SO_2 and H_2 O,the number of NH3 adsorption sites,active component content,specific surface area and pore volume decreased to different degrees.Ammonium sulfate species deposited on the catalyst surface,which blocked part of the active sites and reduced the NO conversion performance of the catalyst.On-line thermal regeneration could not completely recover the catalyst activity,although it prolonged the cumulative life of the catalyst.In addition,a mechanism for the effects of S02 and H_2 O on catalyst NO conversion was proposed.     

Identification of potential electrotrophic microbial community in paddy soils by enrichment of microbial electrolysis cell biocathodes

Electrotrophs are microbes that can receive electrons directly from cathode in a microbial electrolysis cell (MEC). They not only participate in organic biosynthesis, but also be crucial in cathode-based bioremediation. However, little is known about the electrotrophic community in paddy soils. Here, the putative electrotrophs were enriched by cathodes of MECs constructed from five paddy soils with various properties using bicarbonate as an electron acceptor, and identified by 16S rRNA-gene based Illumina sequencing. The electrons were gradually consumed on the cathodes, and 25%–45% of which were recovered to reduce bicarbonate to acetic acid during MEC operation. Firmicutes was the dominant bacterial phylum on the cathodes, and Bacillus genus within this phylum was greatly enriched and was the most abundant population among the detected putative electrotrophs for almost all soils. Furthermore, several other members of Firmicutes and Proteobacteria may also participate in electrotrophic process in different soils. Soil pH, amorphous iron and electrical conductivity significantly influenced the putative electrotrophic bacterial community, which explained about 33.5% of the community structural variation. This study provides a basis for understanding the microbial diversity of putative electrotrophs in paddy soils, and highlights the importance of soil properties in shaping the community of putative electrotrophs.     

硅胶表面TEOS疏水化改性及吸附VOCs特性

以正硅酸乙酯（TEOS）为疏水改性剂,通过硅胶表面的羟基接枝反应,得到具备一定疏水性的改性硅胶;利用BET、FT-IR、XRD和TG-DTG等手段对改性硅胶的结构及稳定性进行了表征;在此基础上考察了改性硅胶对各类有机废气的吸附性能.结果表明,TEOS成功接枝在了硅胶表面,改性硅胶不仅具备一定的疏水性,而且机械强度增加到原来的66.85%,稳定性也都得到了提高; 550℃空气下焙烧后的改性硅胶仍具有疏水性且吸附容量是焙烧之前的2倍;在高湿度高浓度的废气治理中,TEOS改性硅胶表现出更高的吸附能力和优良的热再生性能.高浓度下改性硅胶的吸附容量是低浓度下的10倍且不受水汽的影响;改性硅胶循环10次的吸附/脱附几乎不变,且在一定条件下,15~30min就达到90%的脱附率.     

磁性氧化石墨处理乳化含油废水及磁致增强效应

以高铁酸钾为氧化剂,基于改进Hummers法制备了新型磁性氧化石墨材料,在SEM、FTIR、氮气吸脱附和表面接触角表征基础上,探究了该材料处理乳化含油废水的效果及磁致增强效应.结果表明：相较于石墨,磁性氧化石墨比表面积增大,表面有卷曲结构并负载着Fe₃O₄颗粒,具有含氧官能团,存在疏水性较强的微观孔隙结构.在外加磁场条件下,磁性氧化石墨团聚,形成疏水性宏观孔隙结构,利于乳化油滴的吸附和附着.磁性氧化石墨处理乳化含油废水的能力远好于石墨与粉末活性炭,且处理效率与磁场强度成正相关,COD去除率可达95%以上.使用后的磁性氧化石墨进行溶剂萃取或热处理,可以循环使用.磁性氧化石墨经过4次循环使用,热再生效率为92%,溶剂萃取再生效率为86%.以上研究为乳化含油废水的处理提供了一种有效的方法.     

废旧塑料回收利用技术

从我国废塑料回收利用的现状出发 ,分析了今后我国废塑料回收利用技术的发展趋势和应采取的措施 ,指出了废塑料回收利用的重要性。     

电解-CASS工艺处理制药废水工艺研究与设计

采用电解 CASS工艺处理制药厂废水 ,实现了处理效率高 ,占地面积小 ,工程投资低等优点 ,处理后各项污染指标均达到国家《污水综合排放》(GB8978— 1996)的二级排放标准     

铁炭内电解法处理染料废水的试验

文章采用铁屑一活性炭内电解法作为光合细菌生化处理染料废水的预处理方法，考查了3个主要影响因素（铁炭比、停留时间、初始pH值）。结果表明，最佳的处理条件为：铁炭比为7：3，pH值为5，停留时间为60min。在上述最佳处理条件下，对初始COD为6790mg／L的染料废水处理效率可以达到66．1％，并且废水经预处理后可生化性得到大大提高，有利于后续生化处理的进行。     

铁屑/焦炭/H_2O_2法预处理焦化废水的试验研究

采用铁屑/焦炭/H2O2法对焦化废水进行处理,通过单因素试验法考察了铁炭比、铁炭用量、H2O2用量、废水pH以及反应时间对处理效果的影响,并确定了最适工艺条件。结果表明,铁屑/焦炭/H2O2法与常规的铁屑内电解法相比,可显著提高焦化废水的预处理效果,并缩短反应时间。铁屑/焦炭/H2O2法处理焦化废水的最适条件为:铁炭比为4,铁炭用量为300mg/L铁屑+75mg/L焦炭,H2O2用量为1000mg/L,pH为3,反应时间20min。在此条件下,COD、色度、NH3-N和CN-的去除效率分别可达61.2%、74.0%、56.2%和74.3%,B/C比由处理前的0.189提高到0.387,处理水可生化性良好。铁屑/焦炭/H2O2可作为焦化废水的一种有效的预处理方法。     

陶瓷微滤膜过滤黑液的清洗与再生

对无机陶瓷微滤膜过滤草桨黑液的膜清洗及再生的方法进行了研究。考察了物理和化学方法的再生效果、单种清洗剂的清洗效果、复合方法的清洗效果和效果的可重复性。结果表明物理冲洗、高温灼烧、单一的化学清洗剂清洗均可以提高陶瓷膜的再生通量；但是复合方法对陶瓷微滤膜的再生效果较好，其中按氢氧化钠溶液清洗、硝酸溶液清洗、次氯酸钠溶液清洗的实验步骤，膜的再生渗透通量高．且重复性强，可望在工业生产的在线清洗中应用。     

电解-SBR联合技术处理硝基苯废水的试验

采用电解-SBR联合技术对硝基苯生产废水进行降解处理。考察了电流强度、反应时间对有机物去除率的影响,以及电解对废水可生化性的影响。通过试验确定了后续SBR反应器的操作方式和运行参数。结果表明,电解-SBR联合技术对硝基苯废水具有较好的处理效果。