Effects of environmental factors on the production and release of matrix-bound phosphine from lake sediments

Effects of pH, temperature, and oxygen on the production and release of phosphine in eutrophic lake sediments were investigated under laboratory tests. Results indicated that the elimination of matrix-bound phosphine was accelerated under initial pH 1 or 12. Phosphine levels could reach maximum under initial pH 10. The contents of phosphine increased with the addition of alkali under pH 4–12. The rates of phosphine production and release from lake sediments varied with temperature. 20°C was the most favorable temperature for the production of matrix-bound phosphine. Oxygen showed little effect on matrix-bound phosphine. Matrix-bound phosphine concentrations in lake sediments were concluded to be dependent on a balance of natural generation and depletion processes. Translated from Acta Scientise Circumstantiae, 2005, 25(5): 681–685 [译自: 环境科学学报]     

双室火灾烟气特性的实验研究

本文在１／２缩尺建筑模型中，取双室－走廊结构，以标准木垛为火源，对建筑火灾的初始阶段进行了实验模拟。着重研究了火灾初期的烟气特性及其变化，包括烟气温度及烟气中ＣＯ＿２气体和炭颗粒浓度。本文目的在于在探索和发展中等尺寸火灾实验模拟手段和方法的同时，定性地确定火源功率对烟气特性的影响，并积累一定的实验数据，为建筑火灾的分析和模化提供实验基础和依据。     

氧化亚铁硫杆菌对酸化铅锌尾矿中Zn、As淋溶释放的影响

以青海某铅锌尾矿为研究对象进行酸预处理加速模拟静态淋溶实验,重点研究了氧化亚铁硫杆菌（At.f菌）接种量变化对尾矿中重金属Zn、As迁移释放的影响。结果表明,随时间延长,接种量变化均可导致淋溶体系pH值下降、电导率上升,氧化还原电位先上升后下降。At.f菌可明显促进Zn、As的释放,不同接种量对重金属的迁移释放作用不同;At.f菌存在下,Zn的释放能力大于As,Zn优先于As溶出,Zn、As浓度均表现为快速释放和缓慢释放并趋于平稳两个阶段,Evolich模型和Guass模型可分别描述Zn、As的释放过程。通过对细菌淋溶前后残渣SEM-EDS及XRD图谱分析发现,淋溶后尾矿颗粒结构疏松,表面腐蚀明显,生成了CaSO4、钙磷石等不溶物,使Zn、As后期释放减慢。     

潮间带沉积物/大气Hg的释放的模拟研究

研究了潮间带沉积物中的Hg向大气的释放,结果表明光照造成沉积物中的Hg快速向大气释放.光照8 h后,海泊河口和黄河口沉积物释放到大气中的Hg分别占58%和51%,其释放通量总体上遵循先升高后降低的规律,前者在13:00～14:00达到最大值2 830μg/(m2·h),后者在12:00～13:00达到最大值73μg/(m2·h);海泊河口沉积物Hg的释放通量与大气温度、沉积物温度和光照强度的相关系数分别为0.83(P＜0.05)、0.98(P＜0.01)和0.73(P＜0.05),黄河口沉积物Hg的释放通量与大气温度、沉积物温度和光照强度的相关系数分别为0.73(P＜0.05)、0.80(P＜0.05)和0.81(P＜0.01),温度、光照对沉积物Hg的释放有重要的影响.     

废物水泥窑共处置产品中重金属释放量研究

通过模拟煅烧实验制取水泥熟料,并采用国标GB/T 17671-1999制取混凝土样品.选用EA NEN7371和EA NEN7375浸出方法,利用基于菲克扩散第二定律的一维扩散模型对废物水泥窑共处置产品（混凝土）中重金属长期累积释放量进行了研究.结果表明,混凝土中重金属的最大释放量低于总量;各种重金属在混凝土中的扩散系数不同,且Cr>As>Ni>Cd; Cr、As、Ni和Cd 30a的累积释放量分别为4.43、 0.46、 1.50和0.02 mg/kg,释放率（累积释放量/最大释放量）分别为27.0%、 18.0%、 3.0%和0.2%;扩散系数是影响重金属累积释放量的重要因素,且两者表现出较好的相关性;Cr和As的扩散系数较大（分别为1.15E-15 m²/s和6.42E-16 m²/s）,应重点控制其进入水泥窑处置过程的总量.     

Relation of lead adsorption on birnessites with different average oxidation states of manganese and release of Mn^2＋/H^＋/K^＋

The characteristics of Pb2+ adsorption on the surface of birnessites with different average oxidation states (AOS) of Mn, synthesized under acidic and alkali conditions, were investigated. The results indicated that the amount of adsorbed Pb2+ increased with the increase of Mn AOS in birnessites. The amount of Pb2+ adsorbed positively correlated with the amount of released Mn2+, H+, and K+ (r = 0.9962 > 0.6614, n = 14, α = 0.01). The released Mn2+, H+, and K+ were derived mostly from the corresponding catio...     

酸性条件下剩余污泥中Ca2＋和Mg2＋溶出对磷回收的影响

为了在酸性条件下实现剩余污泥中磷的高效回收,对pH=3时剩余污泥水解酸化过程中氨氮、正磷酸盐和钙镁离子的溶出现象以及磷回收进行了研究分析。结果表明：当pH=3时,所溶出的氨氮、镁离子和钙离子与磷酸盐的摩尔比均大于1,能满足采用鸟粪石沉淀法或者羟磷灰石沉淀法回收磷的要求;但所溶出的钙镁离子的摩尔比大于1,会对鸟粪石沉淀法回收磷的顺利进行有较大影响;有无外加镁剂对磷回收率影响不大。采用改型后的镁型强酸性阳离子交换树脂进行离子交换可以得到较高纯度的鸟粪石沉淀产品,通过XRD检测其纯度为95％以上。     

温度及外加碳源对生物脱氮除磷过程的影响

针对污水处理厂普遍面临的进水碳源不足及冬季低温时出水氮磷不能稳定达标的问题,研究了温度(21、15和10℃)和外加碳源(乙酸)对活性污泥缺氧条件下反硝化及释磷过程的影响。结果表明,在缺氧条件下投加乙酸,释磷与反硝化反应可同时进行,且乙酸投量的增加仅延长快速碳源反硝化阶段及缺氧释磷阶段的反应时间;温度降低为15℃和10℃时,快速碳源反硝化阶段反硝化速率及缺氧释磷速率较21℃分别降低了约29.2%、42.2%和26.1%、32.3%。当硝态氮目标去除量与磷酸盐目标释放量之比超过5时,乙酸的最优投量以满足反硝化要求为准,计算得出21、15和10℃时常州某城镇污水处理厂乙酸最优投加量计算值约为30、39和46 mg/L。     

四平市二龙湖底泥磷释放研究

采用室内实验模拟法对四平市二龙湖富营养化限制因子磷的底泥释放速率及释放量进行了研究,并研究在种环境因子(温度、pH、DO和扰动因素)影响下底泥磷的释放规律。结果表明,(1)二龙湖年平均底泥释磷量为208·78g,最大释磷率为0·889μg/g(T=20℃,pH=8,DO为4·68mg/L);(2)自然和人为的扰动因素会促进底泥的磷释放;(3)H在弱酸至中性范围内底泥释磷量最小,酸性和碱性条件都有利于磷的释放;(4)随着温度的升高底泥释磷量增大;(5)厌条件比好氧条件更有利于磷的释放。     

Development of controlled release nanoformulations of carbendazim employing amphiphilic polymers and their bioefficacy evaluation against Rhizoctonia solani

Controlled release nanoformulations of carbendazim (Methyl 1H-benzimidazol-2-ylcarbamate), a systemic fungicide, have been prepared using laboratory synthesized poly(ethylene glycols) (PEGs)-based functionalized amphiphilic copolymers. The release kinetics of carbendazim from developed controlled release (CR) formulations was studied and compared with that of the commercially available 50% Wettable Powder (WP). Further, the bioefficacy evaluation of developed formulations was done against plant pathogenic fungi Rhizoctonia solani by the poison food technique method. The release of maximum amount of carbendazim from developed formulations was dependent on the molecular weight of PEGs and was found to increase with increasing molecular weights. The range of carbendazim release was found to be between 10th to 35th day as compared to commercial formulation which was up to 7th day. The diffusion exponent (n value) of carbendazim in water ranged from 0.37 to 0.52 in the tested formulations. The half-release (t_1/2) values ranged between 9.47 and 24.20 days, and the period of optimum availability (POA) of carbendazim ranged from 9.15 to 26.63 days. Also, ED₅₀ values of the developed formulations vary from 0.40 to 0.74 mg L^?1. These formulations can be used to optimize the release of carbendazim to achieve disease control for the desired period depending on the matrix of the polymer used.