基于EFDC的长江常州段污水排江浓度场数值模拟

长江感潮河段水流与污染排放引起的浓度场复杂多变,基于EFDC(Environmental Fluid Dynamic Code)模型,采用正交曲线网格拟合自然河道边界,建立了长江常州段的水动力和水质模型。采用现场同步实测资料,与计算结果比对,证明该模型在水动力和水质两个方面都与实测数据吻合较好,满足了实际工程的需要;同时由于长江水流运动较快,一阶降解动力学已经满足了化学需氧量(COD)、氨氮(NH3-N)和总磷(TP)浓度计算要求,可以不考虑它们复杂的生化反应过程。     

Ti3C2纳米层状材料对废水中Cr（Ⅵ）的光催化去除性能

以Ti₃AlC₂为原料,采用HF刻蚀工艺制备出12种Ti₃C₂纳米层状材料,对其形貌进行了表征,并考察了以其作为光催化剂对废水中Cr（Ⅵ）的处理效果。实验结果表明：HF体积分数为80%、刻蚀时间为48 h时得到的MX-80-48的形貌较好;MX-80-48具有类似石墨烯的二维层状结构,纳米层厚度约20~50 nm,孔径2~10 nm,比表面积14.8 m²/g,在400~700 nm可见光范围内表现出强烈的吸光性;当Cr（Ⅵ）的初始质量浓度为40.00 mg/L、MX-80-48投加量为200 mg/L、pH=2、反应时间4 h（暗反应1 h+光照3 h）时,Cr（Ⅵ）去除率可达100%。     

简述排污许可制下火电行业现状及发展

实施排污许可制度,是强化排污者责任、提高固定污染源环境管理效能、改善环境质量的重要制度保障。火电行业作为典型的高架固定源,先行试点实施排污许可制度。通过分析火电行业发展和环保现状,结合排污许可管理要点,简述排污许可制对火电行业发展的影响。     

Challenges for modelling and integrating environmental performances in concept design: the case of an automotive component lightweighting

The objective of this paper is to discuss the main barriers for modelling and integrating the environmental performances in the automotive concept design. Incorporating environmental assessment in the early design phase of a vehicle component is known as an important challenge that car makers need to face in order to develop more sustainable design solutions; in this regard, the Life Cycle Assessment is the most widespread methodology for the environmental assessment and comparison of alternatives. The present work illustrates the combination of such methodology with the traditional design procedure at two different levels of the component design phase, material choice and concept design. In particular, the potential benefits originated by a lightweight solution for the automotive component Throttle Body are evaluated by considering environmental and technical implications at the same level. The case study shows that a multi-disciplinary approach for design effectively allows the integration of the environmental issue in the company’s established procedures. However, interpretation of results is still a challenging aspect due to the inevitable contradicting elements which should not discourage to develop comprehensive sustainability assessment within the early design stage.     

The Thermal Discharges From Nuclear Power Plants in Taiwan

The increasing use of sea water for industrial cooling presents a real threat to the ecological environment in the ocean. in Taiwan where many electric power plants along the coast take sea water for cooling, people are concerned seriously about nuclear power plants. There are three nuclear power plants in Taiwan. Each plant has two units for generating power. the first two are located along the northern coast of Taiwan. the third is located in Kenting National Park along the coast of southernmost Taiwan. the plants take sea water for cooling, and discharge their heated effluents to the ocean surface from the coast. the thermal effluents have variable effects on the ecological environment near the plants. Fishermen living near the power plants complain that the heated water affects the inshore fishery catch. in addition, the thermal water from the second plant is easily accumulated near the coastal zone to influence the nearby swimming area in the summer-time. the thermal water from the third plant bleaches or kills some corals in shallow water near the outlet, and this conflicts with the interests of Kenting National Park.     

Effects of bed materials on the performance of an anaerobic sequencing batch biofilm reactor treating domestic sewage

The objective of this study was to determine the best performance of an anaerobic sequencing batch biofilm reactor (AnSBBR) based on the use of four different bed materials as support for biomass immobilization. The bed materials utilized were polyurethane foam (PU), vegetal carbon (VC), synthetic pumice (SP), and recycled low-density polyethylene (PE). The AnSBBR, with a total volume of 7.2L, was operated in 8-h batch cycles over 10 months, and fed with domestic sewage with an average influent chemical oxygen demand (COD) of 358+/-110mg/L. The average effluent COD values were 121+/-31, 208+/-54, 233+/-52, and 227+/-51mg/L, for PU, VC, SP, and PE, respectively. A modified first-order kinetic model was adjusted to temporal profiles of COD during a batch cycle, and the apparent kinetic constants were 0.52+/-0.05, 0.37+/-0.05, 0.80+/-0.04, and 0.30+/-0.02h(-1) for PU, VC, SP, and PE, respectively. Specific substrate utilization rates of 1.08, 0.11, and 0.86mg COD/mgVS day were obtained for PU, VC, and PE, respectively. Although SP yielded the highest kinetic coefficient, PU was considered the best support, since SP presented loss of chemical constituents during the reactor's operational phase. In addition, findings on the microbial community were associated with the reactor's performance data. Although PE did not show a satisfactory performance, an interesting microbial diversity was found on its surface. Based on the morphology and denaturing gradient gel electrophoresis (DGGE) results, PE showed the best capacity for promoting the attachment of methanogenic organisms, and is therefore a material that merits further analysis. PU was considered the most suitable material showing the best performance in terms of efficiency of solids and COD removal.     

Isotope tracing of submarine groundwater discharge offshore Ubatuba, Brazil: results of the IAEA–UNESCO SGD project

Results of groundwater and seawater analyses for radioactive (³H, ²²²Rn, ²²³Ra, ²²⁴Ra, ²²⁶Ra, and ²²⁸Ra) and stable (D and ¹⁸O) isotopes are presented together with in situ spatial mapping and time series ²²²Rn measurements in seawater, direct seepage measurements using manual and automated seepage meters, pore water investigations using different tracers and piezometric techniques, and geoelectric surveys probing the coast. This study represents first time that such a new complex arsenal of radioactive and non-radioactive tracer techniques and geophysical methods have been used for simultaneous submarine groundwater discharge (SGD) investigations. Large fluctuations of SGD fluxes were observed at sites situated only a few meters apart (from 0 cm d⁻¹ to 360 cm d⁻¹; the unit represents cm³/cm²/day), as well as during a few hours (from 0 cm d⁻¹ to 110 cm d⁻¹), strongly depending on the tidal fluctuations. The average SGD flux estimated from continuous ²²²Rn measurements is 17 ± 10 cm d⁻¹. Integrated coastal SGD flux estimated for the Ubatuba coast using radium isotopes is about 7 × 10³ m³ d⁻¹ per km of the coast. The isotopic composition (δD and δ¹⁸O) of submarine waters was characterised by significant variability and heavy isotope enrichment, indicating that the contribution of groundwater in submarine waters varied from a small percentage to 20%. However, this contribution with increasing offshore distance became negligible. Automated seepage meters and time series measurements of ²²²Rn activity concentration showed a negative correlation between the SGD rates and tidal stage. This is likely caused by sea level changes as tidal effects induce variations of hydraulic gradients. The geoelectric probing and piezometric measurements contributed to better understanding of the spatial distribution of different water masses present along the coast. The radium isotope data showed scattered distributions with offshore distance, which imply that seawater in a complex coast with many small bays and islands was influenced by local currents and groundwater/seawater mixing. This has also been confirmed by a relatively short residence time of 1–2 weeks for water within 25 km offshore, as obtained by short-lived radium isotopes. The irregular distribution of SGD seen at Ubatuba is a characteristic of fractured rock aquifers, fed by coastal groundwater and recirculated seawater with small admixtures of groundwater, which is of potential environmental concern and has implications on the management of freshwater resources in the region.     

A Marine Pollution Study of Northeast Coastal Water Off Taiwan Island

The coastal water of northeast Taiwan island, called 'Yin-Yang Hai' for its distinct yellow colour compared with blue offshore water, was investigated from 1989 to 1990 by the authors. Biological study showed the dominant species of plankton to be Copepoda, Cladocera, planktonic eggs and Diatoma. Dominant species of benthos were young crabs, Amphipoda and Annelida, with Amphipoda usually occurring in heavily polluted areas. Heavy metal data showed that the concentration of copper was high. the copper and iron concentration in algae of the intertidal zone was also high. the concentrations of iron and copper in inshore water were also higher than in offshore water. By comparison of the pH and salinity distribution of this area, we conclude that this coastal water has been polluted by acid waste water from coastal industry. the suspended solids concentration in sea water is high. Flocculation occurring at the boundary of fresh and saline water might be a reason for the distinct yellow colour of the water of this area. Further study is required.     

石期河流域地下水化学特征及物质来源分析

为明确典型岩溶溶丘洼(谷)地区域地下水化学特征及其成因,以石期河流域为研究对象,运用Gibbs图、Piper图、端元分析及离子比例系数等方法,对地下水水化学特征及物质来源进行了定性和定量分析.结果表明,研究区内地下水pH值介于6.06～8.07之间,Ca~(2+)、 Mg~(2+)和HCO~-_3是地下水中的主要离子,其质量浓度范围分别为2.61～108.7、 0.54～27.61和8.1～370.74mg·L~(-1),符合岩溶水高钙弱碱性特征;地下水物质成分中, Ca~(2+)和Mg~(2+)主要受到碳酸参与的灰岩和白云岩风化作用的控制, Na~+主要来源于硅酸盐岩的溶解,同时, Ca~(2+)和Na~+在地下水流动过程中进行阳离子交替吸附作用; K~+、 Cl~-和NO~-_3主要受到农业化肥施放和生活废水排放的影响.此外,大气降水作为该区域地下水的主要补给来源,对当地地下水化学特征和物质来源也有一定的影响.     

磁性氧化石墨处理乳化含油废水及磁致增强效应

以高铁酸钾为氧化剂,基于改进Hummers法制备了新型磁性氧化石墨材料,在SEM、FTIR、氮气吸脱附和表面接触角表征基础上,探究了该材料处理乳化含油废水的效果及磁致增强效应.结果表明：相较于石墨,磁性氧化石墨比表面积增大,表面有卷曲结构并负载着Fe₃O₄颗粒,具有含氧官能团,存在疏水性较强的微观孔隙结构.在外加磁场条件下,磁性氧化石墨团聚,形成疏水性宏观孔隙结构,利于乳化油滴的吸附和附着.磁性氧化石墨处理乳化含油废水的能力远好于石墨与粉末活性炭,且处理效率与磁场强度成正相关,COD去除率可达95%以上.使用后的磁性氧化石墨进行溶剂萃取或热处理,可以循环使用.磁性氧化石墨经过4次循环使用,热再生效率为92%,溶剂萃取再生效率为86%.以上研究为乳化含油废水的处理提供了一种有效的方法.